JFJian Fang

Jian Fang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jian Fang has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Integrated High- and Low-Frequency Current Ripple Suppressions in a Single-Phase Onboard Charger for EVs

    by Yun Zhang, Jian Fang, Fei Gao, Shenghan Gao, Daniel J. Rogers, Xinshan Zhu

    Current ripples produced in single-phase onboard charging systems of electric vehicles (EVs) impact the lifetime of their batteries. In this paper, an isolated multi-functional charger topology is proposed. The charging system can be used to charge the auxiliary batteries or serve as an active filter (AF) for the power battery charger. By time-sharing multiplexing it, the high frequency (HF) and low frequency (LF/second harmonic) current ripple can be suppressed in driving and parking charging mode respectively. The proposed topology can also achieve zero voltage switching (ZVS) for all power switches under a full load range in driving charging mode. In addition, the integration and the power density of the charging system can be improved due to the reconstruction of the capacitive energy storage AF in parking charging mode. Finally, a 400W experimental prototype is developed and the experimental results are presented to validate the performance and feasibility of the proposed topology.


  • Research on Fault Location Method of Distribution Network Line Based on Energy Discharge Function

    by Jian Fang, Hang Zhang, Hongbing Wang, Yong Wang

    Aiming at the problem that the traditional method has poor reliability and low sensitivity on locating the position of single-phase ground fault, this paper proposes a method based on energy discharge function. This method uses the waveform information of fault phase, based on the analysis of action characteristics of arc suppression coil and influence on phase voltage. For the non-fault section, the energy discharge function remain nearly unchanged when the system runs normally or during the process of fault happen. The value is a very small positive number. For the fault section, the trend of energy discharge function rises first and then goes down. It reaches the maximum value when the coil takes action and produce stable compensation current. Therefore, we can use the value of energy discharge function to decide the fault section. Finally, the feasibility, reliability and sensitivity of the method are verified by PSCAD/EMTDC software simulation.


  • Second-Harmonic Ripple Voltage Suppression of Integrated Single-Phase Pulsewidth Modulation Rectifier Charging System for EVs

    by Yun Zhang, Jian Fang, Fei Gao, Tianbao Song, Shenghan Gao, Daniel J. Rogers

    In single-phase AC battery chargers, pulsating power at twice of the line frequency is delivered by the AC source resulting in second-harmonic ripple voltage on the DC-link if additional passive or active filter circuits are not used. In this paper, an inductance-based active filter (AF) using the leakage inductance of the machine windings along with a current compensation control method is proposed. No additional passive components are required. The machine used in this paper has a double-layer winding with a center tap in each phase and the winding structure of the machine is special in that the pulsating magnetomotive force of the whole phase winding can be cancelled when currents flow into the central tap. In this paper, the operating principle and control strategy of the AF with the inductive energy storage are analyzed. Finally, a 400W experimental prototype is developed and the experimental results are used to validate the performance and feasibility of the proposed converter and control strategy.


  • Channel-resolved ultrafast dissociation dynamics of NO2 molecules studied via femtosecond time-resolved ion imaging

    by Qin-Xin Wang, Dan-Dan Shi, Jun-Feng Zhang, Xue Wang, Yu Si, Chun-Bin Gao, Jian Fang, Si-Zuo Luo

    The ultrafast dissociation dynamics of NO2 molecules was investigated by femtosecond laser pump-probe mass spectra and ion images. The results show that the kinetic energy release of NO+ ions has two components, 0.05 eV and 0.25 eV, and the possible dissociation channels have been assigned. The channel resolved transient measurement of NO+ provides a method to disentangle the contribution of ultrafast dissociation pathways, and the transient curves of NO+ ions at different kinetic energy release are fitted by a biexponential function. The fast component with a decay time of 0.25 ps is generated from the evolution of Rydberg states. The slow component is generated from two competitive channels, one of the channel is absorbing one 400 nm photon to the excited state A2B2, which has a decay time of 30.0 ps, and the other slow channel is absorbing three 400 nm photons to valence type Rydberg states which have a decay time less than 7.2 ps. The channel and time resolved experiment present the potential of sorting out the complex ultrafast dissociation dynamics of molecules.


  • A Novel Cross-Over CMR Transformer Technology for Magnetic Isolation Gate Driver Applications

    by Yunzhong Luo, Jian Fang, Erli Zhang, Ming Li, Bo Zhang

    A novel Cross-Over CMR transformer technology is proposed. The CMR (common-mode rejection) problem of magnetic isolation signal transmission is solved by the secondary Cross-Over differential coils and ANPTM (alternating narrow pulse transmission mode). Based on CSMC 1um BCD technology platform, the simulation results show that compared with the traditional magnetic isolation, the CODT (Cross-Over differential transformer) technique has a lower mismatch and smaller area. The circuit transmission delay reduces by 30% to 23ns with signal transmission frequency as high as 10MHz. The isolation voltage reaches 5kV while improving CMR (CMR greater than 50 kV/μ s). The proposed technology can be applied in high voltage floating gate driver for IGBT, CoolMOS, and even GaN HMET devices.


  • A novel 4H-SiC trench MOSFET with double shielding structures and ultralow gate-drain charge

    by Xiaorong Luo, Tian Liao, Jie Wei, Jian Fang, Fei Yang, Bo Zhang

    A new ultralow gate–drain charge (Q GD) 4H-SiC trench MOSFET is presented and its mechanism is investigated by simulation. The novel MOSFET features double shielding structures (DS-MOS): one is the grounded split gate (SG), the other is the P+ shielding region (PSR). Both the SG and the PSR reduce the coupling effect between the gate and the drain, and transform the most part of the gate–drain capacitance (C GD) into the gate–source capacitance (C GS) and drain–source capacitance (C DS) in series. Thus the C GD is reduced and the proposed DS-MOS obtains ultralow Q GD. Compared with the double-trench MOSFET (DT-MOS) and the conventional trench MOSFET (CT-MOS), the proposed DS-MOS decreases the Q GD by 85% and 81%, respectively. Moreover, the figure of merit (FOM), defined as the product of specific on-resistance (R on, sp) and Q GD (R on, sp Q GD), is reduced by 84% and 81%, respectively.