Karen M. Lewis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Karen M. Lewis has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Brandon Tingley
Aarhus University
2 shared publications Penny D. Sackett
2 shared publications- Penny D. Sackett
The Australian National University Mount Stromlo Observatory Cotter Road Weston Creek 2611 ACT Australia
2 shared publications - Brad K. Gibson
E.A. Milne Centre for Astrophysics, University of Hull, Hull, HU6 7RX
1 shared publication Daniel D. R. Bayliss
1 shared publication- Daniel D. R. Bayliss
Research School of Astronomy and Astrophysics, Australian National University, Canberra, ACT 2611, Australia
1 shared publication
Latest Publications
- 15 May 2015
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 805 (1)
EXTRASOLAR BINARY PLANETS. II. DETECTABILITY BY TRANSIT OBSERVATIONS
- 15 May 2015
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 805 (1)
EXTRASOLAR BINARY PLANETS. II. DETECTABILITY BY TRANSIT OBSERVATIONS
- 18 April 2013
- Published by American Astronomical Society in The Astrophysical Journal Letters
- Vol. 768 (1) , L19
DECODING THE MESSAGE FROM METEORITIC STARDUST SILICON CARBIDE GRAINS
- 18 April 2013
- Published by American Astronomical Society in The Astrophysical Journal Letters
- Vol. 768 (1) , L19
DECODING THE MESSAGE FROM METEORITIC STARDUST SILICON CARBIDE GRAINS
- Open Access
- 7 February 2013
- Published by Oxford University Press (OUP) in Monthly Notices of the Royal Astronomical Society
- Vol. 430 (3) , 1473-1485
Detecting exo-moons with photometric transit timing – I. Effect of realistic stellar noise
The timing errors for individual planetary transits using the photometric transit timing technique (TTVp) are derived for light curves contaminated with either white additive noise, realistic stellar noise or filtered stellar noise. For the case of white noise, the timing errors are derived analytically, while timing errors for realistic and filtered noise are numerically derived using solar data from the Solar and Heliospheric Observatory satellite. These results are then used to explore the conjecture that moons of transiting planets become easier to detect using the TTVp method the farther their planet is from the star. Using transit duration as a proxy for planet–star distance, it is found that in the case of realistic stellar noise, an increase in star–planet distance/transit duration does not necessarily lead to an increase in moon detectability.
- 7 February 2013
- Published by Oxford University Press (OUP) in Monthly Notices of the Royal Astronomical Society
- Vol. 430 (3) , 1473-1485
Open AccessDetecting exo-moons with photometric transit timing – I. Effect of realistic stellar noise
The timing errors for individual planetary transits using the photometric transit timing technique (TTVp) are derived for light curves contaminated with either white additive noise, realistic stellar noise or filtered stellar noise. For the case of white noise, the timing errors are derived analytically, while timing errors for realistic and filtered noise are numerically derived using solar data from the Solar and Heliospheric Observatory satellite. These results are then used to explore the conjecture that moons of transiting planets become easier to detect using the TTVp method the farther their planet is from the star. Using transit duration as a proxy for planet–star distance, it is found that in the case of realistic stellar noise, an increase in star–planet distance/transit duration does not necessarily lead to an increase in moon detectability.
- Open Access
- 16 February 2011
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 11, 01009
Effect of realistic and filtered stellar photometric noise on the detection of moons using photometric transit timing
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 16 February 2011
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 11, 01009
Open AccessEffect of realistic and filtered stellar photometric noise on the detection of moons using photometric transit timing
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- Open Access
- 16 February 2011
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 11, 04003
Moon formation and orbital evolution in extrasolar planetary systems - A literature review
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- 16 February 2011
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 11, 04003
Open AccessMoon formation and orbital evolution in extrasolar planetary systems - A literature review
EPJ Web of Conferences, open-access proceedings in physics and related sciences
- Open Access
- 6 April 2009
- Published by American Astronomical Society in The Astronomical Journal
- Vol. 137 (5) , 4368-4376
THE LUPUS TRANSIT SURVEY FOR HOT JUPITERS: RESULTS AND LESSONS
- 6 April 2009
- Published by American Astronomical Society in The Astronomical Journal
- Vol. 137 (5) , 4368-4376
Open AccessTHE LUPUS TRANSIT SURVEY FOR HOT JUPITERS: RESULTS AND LESSONS
- Open Access
The Lupus Transit Survey For Hot Jupiters: Results and Lessons
We present the results of a deep, wide-field transit survey targeting Hot Jupiter planets in the Lupus region of the Galactic plane conducted over 53 nights concentrated in two epochs separated by a year. Using the Australian National University 40-inch telescope at Siding Spring Observatory (SSO), the survey covered a 0.66 sq. deg. region close to the Galactic Plane (b=11 deg.) and monitored a total of 110,372 stars (15.0<V<22.0). Using difference imaging photometry, 16,134 light curves with a photometric precision of sigma<0.025 mag were obtained. These light curves were searched for transits, and four candidates were detected that displayed low-amplitude variability consistent with a transiting giant planet. Further investigations, including spectral typing and radial velocity measurements for some candidates, revealed that of the four, one is a true planetary companion (Lupus-TR-3), two are blended systems (Lupus-TR-1 and 4), and one is a binary (Lupus-TR-2). The results of this successful survey are instructive for optimizing the observational strategy and follow-up procedure for deep searches for transiting planets, including an upcoming survey using the SkyMapper telescope at SSO.
Open AccessThe Lupus Transit Survey For Hot Jupiters: Results and Lessons
We present the results of a deep, wide-field transit survey targeting Hot Jupiter planets in the Lupus region of the Galactic plane conducted over 53 nights concentrated in two epochs separated by a year. Using the Australian National University 40-inch telescope at Siding Spring Observatory (SSO), the survey covered a 0.66 sq. deg. region close to the Galactic Plane (b=11 deg.) and monitored a total of 110,372 stars (15.0<V<22.0). Using difference imaging photometry, 16,134 light curves with a photometric precision of sigma<0.025 mag were obtained. These light curves were searched for transits, and four candidates were detected that displayed low-amplitude variability consistent with a transiting giant planet. Further investigations, including spectral typing and radial velocity measurements for some candidates, revealed that of the four, one is a true planetary companion (Lupus-TR-3), two are blended systems (Lupus-TR-1 and 4), and one is a binary (Lupus-TR-2). The results of this successful survey are instructive for optimizing the observational strategy and follow-up procedure for deep searches for transiting planets, including an upcoming survey using the SkyMapper telescope at SSO.
- Open Access
- 9 September 2008
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 685 (2) , L153-L156
Possibility of Detecting Moons of Pulsar Planets through Time-of-Arrival Analysis
The perturbation caused by planet-moon binarity on the time-of-arrival signal of a pulsar with an orbiting planet is derived for the case in which the orbits of the moon and the planet-moon barycenter are both circular and coplanar. The signal consists of two sinusoids with frequency (2n_p - 3n_b) and (2n_p - n_b ), where n_p and n_b are the mean motions of the planet and moon around their barycenter, and the planet-moon system around the host, respectively. The amplitude of the signal is equal to the fraction sin I[9(M_p M_m)/16(M_p + M_m)^2] [r/R]^5 of the system crossing time R/c, where M_p and M_m are the the masses of the planet and moon, r is their orbital separation, R is the distance between the host pulsar and planet-moon barycenter, I is the inclination of the orbital plane of the planet, and c is the speed of light. The analysis is applied to the case of PSR B1620-26 b, a pulsar planet, to constrain the orbital separation and mass of any possible moons. We find that a stable moon orbiting this pulsar planet could be detected, if the moon had a separation of about one fiftieth of that of the orbit of the planet around the pulsar, and a mass ratio to the planet of ~5% or larger.Comment: 11 pages, 3 figure
- 9 September 2008
- Published by American Astronomical Society in The Astrophysical Journal
- Vol. 685 (2) , L153-L156
Open AccessPossibility of Detecting Moons of Pulsar Planets through Time-of-Arrival Analysis
The perturbation caused by planet-moon binarity on the time-of-arrival signal of a pulsar with an orbiting planet is derived for the case in which the orbits of the moon and the planet-moon barycenter are both circular and coplanar. The signal consists of two sinusoids with frequency (2n_p - 3n_b) and (2n_p - n_b ), where n_p and n_b are the mean motions of the planet and moon around their barycenter, and the planet-moon system around the host, respectively. The amplitude of the signal is equal to the fraction sin I[9(M_p M_m)/16(M_p + M_m)^2] [r/R]^5 of the system crossing time R/c, where M_p and M_m are the the masses of the planet and moon, r is their orbital separation, R is the distance between the host pulsar and planet-moon barycenter, I is the inclination of the orbital plane of the planet, and c is the speed of light. The analysis is applied to the case of PSR B1620-26 b, a pulsar planet, to constrain the orbital separation and mass of any possible moons. We find that a stable moon orbiting this pulsar planet could be detected, if the moon had a separation of about one fiftieth of that of the orbit of the planet around the pulsar, and a mass ratio to the planet of ~5% or larger.Comment: 11 pages, 3 figure
- Open Access
Possibility of Detecting Moons of Pulsar Planets Through Time-of-Arrival Analysis
The perturbation caused by planet-moon binarity on the time-of-arrival signal of a pulsar with an orbiting planet is derived for the case in which the orbits of the moon and the planet-moon barycenter are both circular and coplanar. The signal consists of two sinusoids with frequency (2n_p - 3n_b) and (2n_p - n_b ), where n_p and n_b are the mean motions of the planet and moon around their barycenter, and the planet-moon system around the host, respectively. The amplitude of the signal is equal to the fraction sin I[9(M_p M_m)/16(M_p + M_m)^2] [r/R]^5 of the system crossing time R/c, where M_p and M_m are the the masses of the planet and moon, r is their orbital separation, R is the distance between the host pulsar and planet-moon barycenter, I is the inclination of the orbital plane of the planet, and c is the speed of light. The analysis is applied to the case of PSR B1620-26 b, a pulsar planet, to constrain the orbital separation and mass of any possible moons. We find that a stable moon orbiting this pulsar planet could be detected, if the moon had a separation of about one fiftieth of that of the orbit of the planet around the pulsar, and a mass ratio to the planet of ~5% or larger.
Open AccessPossibility of Detecting Moons of Pulsar Planets Through Time-of-Arrival Analysis
The perturbation caused by planet-moon binarity on the time-of-arrival signal of a pulsar with an orbiting planet is derived for the case in which the orbits of the moon and the planet-moon barycenter are both circular and coplanar. The signal consists of two sinusoids with frequency (2n_p - 3n_b) and (2n_p - n_b ), where n_p and n_b are the mean motions of the planet and moon around their barycenter, and the planet-moon system around the host, respectively. The amplitude of the signal is equal to the fraction sin I[9(M_p M_m)/16(M_p + M_m)^2] [r/R]^5 of the system crossing time R/c, where M_p and M_m are the the masses of the planet and moon, r is their orbital separation, R is the distance between the host pulsar and planet-moon barycenter, I is the inclination of the orbital plane of the planet, and c is the speed of light. The analysis is applied to the case of PSR B1620-26 b, a pulsar planet, to constrain the orbital separation and mass of any possible moons. We find that a stable moon orbiting this pulsar planet could be detected, if the moon had a separation of about one fiftieth of that of the orbit of the planet around the pulsar, and a mass ratio to the planet of ~5% or larger.