Nurul Ashikin Binti Daud
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nurul Ashikin Binti Daud has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Tomohiro Tetsumoto
Keio Univ. (Japan)
7 shared publications Yuta Ooka
Department of Electronics and Electrical Engineering, Faculty of Science and Technology, Keio University, 3-14-1, Hiyoshi, Kohoku-ku, Yokohama 223-8522, Japan
7 shared publicationsTakasumi Tanabe
Department of Electronics and Electrical Engineering, Faculty of Science and Technology, Keio University, 3-14-1, Hiyoshi, Kohoku-ku, Yokohama 223-8522, Japan
5 shared publications- Takasumi Tanabe
Keio University
3 shared publications Tomohisa Tabata
Department of Electronics and Electrical Engineering, Faculty of Science and Technology, Keio University, 3-14-1, Hiyoshi, Kohoku-ku, Yokohama 223-8522, Japan
2 shared publicationsNoratiqah Binti Abdul Muin
Universiti Teknologi Malaysia,Faculty of Electrical Engineering,Johor,Malaysia
1 shared publication
Latest Publications
- 8 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 38, 142-145
Nanocavity Waveguide in Two-Dimensional Photonic Crystal Structure
In this paper, we design a nanocavity waveguide in a two-dimensional (2D) photonic crystal (PhC) structure. Defects have been introduced in the structure of the PhC, namely as cavities. To smoothly localize light in the cavity, the photonic bandgap, transmission spectrum, and resonance modes of the structure have been investigated. In this study, the photonic bandgap, transmission spectrum, and resonance modes of the cavity were analyzed using the Finite-Difference Time-Domain (FDTD) analysis technique. The quality (Q) factor values have been utilized to calculate the light confinement within the cavity structure. With 90 % transmission efficiency, we determined that the Q factor value is approximately ~10 5 . This device has the potential to be implemented as passive and active silicon photonics devices due to the advantages of strong light confinement and the small mode volume of the structure.
- 8 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 38, 142-145
Nanocavity Waveguide in Two-Dimensional Photonic Crystal Structure
In this paper, we design a nanocavity waveguide in a two-dimensional (2D) photonic crystal (PhC) structure. Defects have been introduced in the structure of the PhC, namely as cavities. To smoothly localize light in the cavity, the photonic bandgap, transmission spectrum, and resonance modes of the structure have been investigated. In this study, the photonic bandgap, transmission spectrum, and resonance modes of the cavity were analyzed using the Finite-Difference Time-Domain (FDTD) analysis technique. The quality (Q) factor values have been utilized to calculate the light confinement within the cavity structure. With 90 % transmission efficiency, we determined that the Q factor value is approximately ~10 5 . This device has the potential to be implemented as passive and active silicon photonics devices due to the advantages of strong light confinement and the small mode volume of the structure.
- Open Access
- 1 October 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (10) , 105224
Photolithographically fabricated silicon photonic crystal nanocavity photoreceiver with laterally integrated p-i-n diode
We fabricated a SiO2-clad all-silicon high-Q integration of p-i-n diode with photonic crystal nanocavity to demonstrate channel selective photoreceiver operation at a speed of 0.1 Gbs-1 for telecom wavelength light. This SiO2-clad device is photolithographically fabricated with a fabrication method compatible with that used for a complementary metal-oxide semiconductor, and the structure allows future mass production. The dark current is as small as 37.6 pA, which is possible because of the all-silicon structure clad with SiO2. As a result of the low noise, the minimum detectable optical power is −20 dBm, while the footprint of this integrated device is a very small 50 μm2. The characteristics of this device may allow us to use it as a compact monitoring device for optical networks.
- 1 October 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (10) , 105224
Open AccessPhotolithographically fabricated silicon photonic crystal nanocavity photoreceiver with laterally integrated p-i-n diode
We fabricated a SiO2-clad all-silicon high-Q integration of p-i-n diode with photonic crystal nanocavity to demonstrate channel selective photoreceiver operation at a speed of 0.1 Gbs-1 for telecom wavelength light. This SiO2-clad device is photolithographically fabricated with a fabrication method compatible with that used for a complementary metal-oxide semiconductor, and the structure allows future mass production. The dark current is as small as 37.6 pA, which is possible because of the all-silicon structure clad with SiO2. As a result of the low noise, the minimum detectable optical power is −20 dBm, while the footprint of this integrated device is a very small 50 μm2. The characteristics of this device may allow us to use it as a compact monitoring device for optical networks.
- 1 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
SiO2 clad active and passive photonic crystal nanocavity devices fabricated with photolithography: Toward future mass production of photonic crystal nanocavity devices
We describe the fabrication and a demonstration of passive and active photonic crystal nanocavity devices, namely an electro-optic modulator, an all-silicon photodetector and a DeMUX filter. This is the first demonstration of active and passive photonic crystal nanocavity devices fabricated with a photolithographic process that may lead to future mass production.
- 1 July 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
SiO2 clad active and passive photonic crystal nanocavity devices fabricated with photolithography: Toward future mass production of photonic crystal nanocavity devices
We describe the fabrication and a demonstration of passive and active photonic crystal nanocavity devices, namely an electro-optic modulator, an all-silicon photodetector and a DeMUX filter. This is the first demonstration of active and passive photonic crystal nanocavity devices fabricated with a photolithographic process that may lead to future mass production.
- Open Access
- 19 January 2017
- Published by Optica Publishing Group in Optics Express
- Vol. 25 (2) , 1521-1528
Ultrasmall in-plane photonic crystal demultiplexers fabricated with photolithography
We demonstrate ultrasmall demultiplexers based on photolithographic photonic crystals. The footprint of the demultiplexers is 110 μm2 per channel. Our in-plane demultiplexers are clad with silica, which makes them stable and easy to integrate with other silicon photonic devices. We describe two types of demultiplexers with spacings of 136 and 267 GHz between channels for application to dense wavelength division multiplexing. Integrated titanium nitride heaters allow us to precisely control the channel wavelength. We report a 2.5 Gbps transmittance experiment with sufficiently small crosstalk and discuss ways of achieving even lower crosstalk between channels.
- 19 January 2017
- Published by Optica Publishing Group in Optics Express
- Vol. 25 (2) , 1521-1528
Open AccessUltrasmall in-plane photonic crystal demultiplexers fabricated with photolithography
We demonstrate ultrasmall demultiplexers based on photolithographic photonic crystals. The footprint of the demultiplexers is 110 μm2 per channel. Our in-plane demultiplexers are clad with silica, which makes them stable and easy to integrate with other silicon photonic devices. We describe two types of demultiplexers with spacings of 136 and 267 GHz between channels for application to dense wavelength division multiplexing. Integrated titanium nitride heaters allow us to precisely control the channel wavelength. We report a 2.5 Gbps transmittance experiment with sufficiently small crosstalk and discuss ways of achieving even lower crosstalk between channels.
- 1 January 2017
- Published by Institute of Electronics, Information and Communications Engineers (IEICE) in IEICE Transactions on Electronics
- Vol. E100.C (8) , 670-674
Electro-Optic Modulator Based on Photolithography Fabricated p-i-n Integrated Photonic Crystal Nanocavity
- 1 January 2017
- Published by Institute of Electronics, Information and Communications Engineers (IEICE) in IEICE Transactions on Electronics
- Vol. E100.C (8) , 670-674
Electro-Optic Modulator Based on Photolithography Fabricated p-i-n Integrated Photonic Crystal Nanocavity
- 1 January 2017
- Published by Optica Publishing Group
- p. M1F.1
Robust CMOS compatible photonic crystal nanocavity and DEMUX filter
We photolithographically fabricate a high-Q photonic-crystal nanocavity with a silicon dioxide clad structure and demonstrate an electro-optic modulator, a photoreceiver, and a DEMUX, all of which are easy to integrate with other silicon photonic devices.
- 1 January 2017
- Published by Optica Publishing Group
- p. M1F.1
Robust CMOS compatible photonic crystal nanocavity and DEMUX filter
We photolithographically fabricate a high-Q photonic-crystal nanocavity with a silicon dioxide clad structure and demonstrate an electro-optic modulator, a photoreceiver, and a DEMUX, all of which are easy to integrate with other silicon photonic devices.
- Open Access
- 13 May 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (10) , 11199-11207
Compact resonant electro-optic modulator using randomness of a photonic crystal waveguide
We fabricate and demonstrate an electro-optic modulator that utilizes the randomness in a photonic crystal waveguide. We exploit a way of using random photonic crystals for device application that involves restricting the area influenced by the randomness. Our random photonic crystal waveguide is in a diffusive regime and the confinement of light is observed only for a W0.98 waveguide (98% of the original width) placed between W1.05 photonic crystal waveguides, where we obtained a transmittance spectrum with an ultra-high Q of 2.4 × 105. A numerical investigation revealed that the experimental yield rate of the appearance of the high-Q confined mode is larger than 80%, by properly designing the length of W0.98. Since the confinement location is predictable, we integrate a p-i-n structure and demonstrate a GHz electro-optic modulation.
- 13 May 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (10) , 11199-11207
Open AccessCompact resonant electro-optic modulator using randomness of a photonic crystal waveguide
We fabricate and demonstrate an electro-optic modulator that utilizes the randomness in a photonic crystal waveguide. We exploit a way of using random photonic crystals for device application that involves restricting the area influenced by the randomness. Our random photonic crystal waveguide is in a diffusive regime and the confinement of light is observed only for a W0.98 waveguide (98% of the original width) placed between W1.05 photonic crystal waveguides, where we obtained a transmittance spectrum with an ultra-high Q of 2.4 × 105. A numerical investigation revealed that the experimental yield rate of the appearance of the high-Q confined mode is larger than 80%, by properly designing the length of W0.98. Since the confinement location is predictable, we integrate a p-i-n structure and demonstrate a GHz electro-optic modulation.
- 1 January 2016
- Published by Optica Publishing Group
- p. FTu2D.3
Ultrasmall in-plane photonic crystal demultiplexer fabricated with photolithography
We demonstrate a demultiplexer with a small footprint, dense spacing and tunability obtained using a photolithographic photonic crystal. Eight-port demultiplexing with a 267 GHz spacing is demonstrated with high wavelength tunability.
- 1 January 2016
- Published by Optica Publishing Group
- p. FTu2D.3
Ultrasmall in-plane photonic crystal demultiplexer fabricated with photolithography
We demonstrate a demultiplexer with a small footprint, dense spacing and tunability obtained using a photolithographic photonic crystal. Eight-port demultiplexing with a 267 GHz spacing is demonstrated with high wavelength tunability.
- 1 January 2015
- Published by Optica Publishing Group
- p. FTu5C.6
Efficient electro-optic modulation of a weakly localized resonance in a photonic crystal waveguide
We demonstrate ultrahigh Q and electro-optic modulation of weakly localized photonic crystal resonance in a fluctuated waveguide, where the position of the mode is controlled by reducing the width of the waveguide locally.
- 1 January 2015
- Published by Optica Publishing Group
- p. FTu5C.6
Efficient electro-optic modulation of a weakly localized resonance in a photonic crystal waveguide
We demonstrate ultrahigh Q and electro-optic modulation of weakly localized photonic crystal resonance in a fluctuated waveguide, where the position of the mode is controlled by reducing the width of the waveguide locally.