Abdul Haqi Ibrahim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Abdul Haqi Ibrahim has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Li-Ngee Ho
Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis (UniMAP), Perlis, Malaysia
2 shared publications M.R. Taha
2 shared publications- Noradiba Nordin
Center for Frontier Materials Research, School of Materials Engineering, Universiti Malaysia Perlis, 02600, Arau, Perlis, Malaysia
2 shared publications Sin-Li Lee
School of Material Engineering, Universiti Malaysia Perlis, 02600, Arau, Perlis, Malaysia
2 shared publicationsSoon-An Ong
Water Research Group (WAREG), School of Environmental Engineering, Universiti Malaysia Perlis, 02600, Arau, Perlis, Malaysia
2 shared publications- Yee-Shian Wong
Faculty of Civil Engineering Technology, Universiti Malaysia Perlis, Arau, Malaysia
2 shared publications
Latest Publications
- Open Access
- 12 May 2023
- Published by African Journals Online (AJOL) in Ife Journal of Science
- Vol. 25 (1) , 175-184
Removal of toxic substances from cassava effluent using alum and Moringa oleifera seeds as coagulants: a comparative study towards improved agricultural practice
Cassava as a food is widely eaten in nearly all tropical countries. This has led to the emergence of many cassava processing centres, which consequently results in extensive ecological pollution due to the release of cassava processing wastewater into the environment. Wastewater treatment is mostly carried out using chemical coagulants, which are not environmental friendly. This study aims at providing non-chemical based alternative treatment procedures for cassava wastewater. The treatment procedures involved the use of alum and Moringa oleifera seeds as coagulants. The coagulants were used in combination with sodium hypochlorite at 25 and 50 mg/L for coagulation periods of 24 h and 48 h. Physicochemical parameters including, pH, biological oxygen demand (BOD), cyanide, coliform count and heavy metals [Ni, Zn, and Cr] were evaluated for both raw and treated wastewaters using standard methods. The data obtained were subjected to descriptive and inferential statistics. At 50 mg/L dose and 48 h coagulation period, the removal efficiencies of cyanide were 98.91% and 99.63% for alum and M. oleifera seeds, respectively. M. oleifera seeds reduced coliform in the effluent by 96.73% and decontaminated heavy metals [Ni, Zn, and Cr]. However, none of the two treatments could reduce BOD to a permissible level. The study concluded that M. oleifera seed is a potential coagulant, and could therefore be used as a substitute to synthetic coagulants.
- 12 May 2023
- Published by African Journals Online (AJOL) in Ife Journal of Science
- Vol. 25 (1) , 175-184
Open AccessRemoval of toxic substances from cassava effluent using alum and Moringa oleifera seeds as coagulants: a comparative study towards improved agricultural practice
Cassava as a food is widely eaten in nearly all tropical countries. This has led to the emergence of many cassava processing centres, which consequently results in extensive ecological pollution due to the release of cassava processing wastewater into the environment. Wastewater treatment is mostly carried out using chemical coagulants, which are not environmental friendly. This study aims at providing non-chemical based alternative treatment procedures for cassava wastewater. The treatment procedures involved the use of alum and Moringa oleifera seeds as coagulants. The coagulants were used in combination with sodium hypochlorite at 25 and 50 mg/L for coagulation periods of 24 h and 48 h. Physicochemical parameters including, pH, biological oxygen demand (BOD), cyanide, coliform count and heavy metals [Ni, Zn, and Cr] were evaluated for both raw and treated wastewaters using standard methods. The data obtained were subjected to descriptive and inferential statistics. At 50 mg/L dose and 48 h coagulation period, the removal efficiencies of cyanide were 98.91% and 99.63% for alum and M. oleifera seeds, respectively. M. oleifera seeds reduced coliform in the effluent by 96.73% and decontaminated heavy metals [Ni, Zn, and Cr]. However, none of the two treatments could reduce BOD to a permissible level. The study concluded that M. oleifera seed is a potential coagulant, and could therefore be used as a substitute to synthetic coagulants.
- 1 January 2021
- Published by Elsevier in Chemosphere
- Vol. 263, 128212
A highly sustainable hydrothermal synthesized MnO2 as cathodic catalyst in solar photocatalytic fuel cell
- 1 January 2021
- Published by Elsevier in Chemosphere
- Vol. 263, 128212
A highly sustainable hydrothermal synthesized MnO2 as cathodic catalyst in solar photocatalytic fuel cell
- 24 August 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (29) , 23331-23340
Influence of Amaranth dye concentration on the efficiency of hybrid system of photocatalytic fuel cell and Fenton process
A novel sustainable hybrid system of photocatalytic fuel cell (PFC) and Fenton process is an alternative wastewater treatment technology for energy-saving and efficient treatment of organic pollutants. The electrons generated from PFC photoanode are used to produce H2O2 in the Fenton reactor and react with the in situ generation of Fe2+ from sacrificial iron for hydroxyl radical formation. In this study, the effect of different initial Amaranth dye concentrations on degradation and electricity generation were investigated. ZnO/Zn photoanode was prepared by anodizing method and characterized by X-ray diffraction (XRD) and scanning electron microscope (SEM). Results revealed that the maximum power density (9.53 mW/m2) and current density (0.0178 mA/m2) were achieved at 10 mg/L of Amaranth. The correlation between dye degradation, voltage output, and kinetic photocatalytic degradation were also investigated and discussed.
- 24 August 2017
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 24 (29) , 23331-23340
Influence of Amaranth dye concentration on the efficiency of hybrid system of photocatalytic fuel cell and Fenton process
A novel sustainable hybrid system of photocatalytic fuel cell (PFC) and Fenton process is an alternative wastewater treatment technology for energy-saving and efficient treatment of organic pollutants. The electrons generated from PFC photoanode are used to produce H2O2 in the Fenton reactor and react with the in situ generation of Fe2+ from sacrificial iron for hydroxyl radical formation. In this study, the effect of different initial Amaranth dye concentrations on degradation and electricity generation were investigated. ZnO/Zn photoanode was prepared by anodizing method and characterized by X-ray diffraction (XRD) and scanning electron microscope (SEM). Results revealed that the maximum power density (9.53 mW/m2) and current density (0.0178 mA/m2) were achieved at 10 mg/L of Amaranth. The correlation between dye degradation, voltage output, and kinetic photocatalytic degradation were also investigated and discussed.
- 1 April 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 177, 135-141
Hybrid system of photocatalytic fuel cell and Fenton process for electricity generation and degradation of Reactive Black 5
- 1 April 2017
- Published by Elsevier in Separation and Purification Technology
- Vol. 177, 135-141
Hybrid system of photocatalytic fuel cell and Fenton process for electricity generation and degradation of Reactive Black 5
- Open Access
- 4 April 2014
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 495
Applicability of nano zero valent iron (nZVI) in sono – Fenton process
- 4 April 2014
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 495
Open AccessApplicability of nano zero valent iron (nZVI) in sono – Fenton process
- 1 March 2014
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 2 (1) , 1-8
Characterization of nano zero-valent iron (nZVI) and its application in sono-Fenton process to remove COD in palm oil mill effluent
- 1 March 2014
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 2 (1) , 1-8
Characterization of nano zero-valent iron (nZVI) and its application in sono-Fenton process to remove COD in palm oil mill effluent