D. I. Yusupov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
D. I. Yusupov has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Alexander S. Tyuftyaev
Joint Institute for High Temperatures, Russian Academy of Sciences, 125412 Moscow, Russia
3 shared publications - Makhach Kh. Gadzhiev
Joint Institute for High Temperatures, Russian Academy of Sciences, 125412 Moscow, Russia
3 shared publications - Andrey V. Chistolinov
Joint Institute for High Temperatures, Russian Academy of Sciences, 125412 Moscow, Russia
2 shared publications - Arsen E. Muslimov
Complex of Crystallography and Photonics, National Research Centre “Kurchatov Institute”, 119333 Moscow, Russia
2 shared publications - Ivan S. Volchkov
Complex of Crystallography and Photonics, National Research Centre “Kurchatov Institute”, 119333 Moscow, Russia
2 shared publications - Maksim V. Il’ichev
Joint Institute for High Temperatures, Russian Academy of Sciences, 125412 Moscow, Russia
2 shared publications
Latest Publications
- Open Access
Relationship of Luminescent, Thermo-Oxidative and Photocatalytic Properties of ZnO Micro and Nanostructures
In this work, a comprehensive analysis of the relationship between photoluminescent, thermo-oxidative, and photocatalytic (upon simulated sunlight exposure) properties of ZnO powders is performed. The correlation between the X-ray diffraction and microscopic data is studied. ZnO powders of various sizes and morphologies were used: pseudo-spherical nanoparticles (30–50 nm), submicron faceted crystallites (100–500 nm), and plate- and rod-like microstructures (up to 20 μm). The mean specific surface area values were 32 m2/g, 3.8 m2/g, and 2.6 m2/g for pseudo-spherical nanoparticles, submicron faceted crystallites, and plate- and rod-like microstructures, respectively. According to the XRD data, microstresses and carbon-based impurities were present in ZnO nanoparticles, which is characteristic of nanomaterials synthesized at low temperatures. According to the photoluminescence spectroscopy data, the emission in ZnO was reduced due to high defectiveness, and characteristic emission bands indicated the presence of organic impurities. Upon long signal registration times, an intensive luminescence band with an effective maximum at 579 nm occurred, which indicated the presence of long-term components exhibiting decay times τ ~300 μs. According to the XRD data, the crystal structure parameters of ZnO submicro- and microparticles were close, with no impurities present. In their photoluminescence spectra, pronounced UV and defect-related bands were present with intensity ratios of 11.6 and 6.88, respectively. The decrease in the UV and defect-related luminescence band intensity ratios indicates deviation from the stoichiometry toward an increased Zn over oxygen content. At long signal registration times, in submicron ZnO particles, a luminescence band with maxima at 425 and 490 nm is present, which decays rapidly. An emission band in the 530 nm region is also present, which decays for ≤80 μs, and a weak long-wavelength emission decaying for ~100 μs. At long delay and strobe times (up to milliseconds), only an emission in the 460 nm region is observed, which we connect to the triplet–singlet transition of a defect center (F*, F+*). At lower intensities, an emission connected to the surface contamination by organic impurities is observed. In photoluminescence spectra of ZnO microparticles, no long-wavelength emission components are observed. However, upon immersing into methylene blue solution, a modification of the surface and UV region of the spectra is observed with signs of charge carrier recombination rate acceleration. It is shown that the catalytic action of ZnO powders in polyethylene thermo-oxidation processes is determined by a combination of factors. In addition to dispersity and concentration, which are the key parameters, the morphology of ZnO particles, the presence of impurities, the surface state, and the distribution of active sites have a significant influence on catalysis. It has been experimentally demonstrated that these secondary factors can markedly affect the rate of radical formation in polyethylene films and alter their resistance to oxidation. ZnO nanoparticles exhibited low catalytic activity in both photocatalysis (rate constant 0.146 min−1) and thermocatalysis due to the high defect density of the crystallites and the presence of carbon-containing impurities. Submicron ZnO particles, owing to a high carrier generation rate and suppressed recombination (via trapping), demonstrated the highest photoactivity (rate constant 0.729 min−1). Submicron ZnO particles exhibit a catalytic effect on the thermo-oxidation of polyethylene (PE films); however, at concentrations above 8 wt.% a transition to an inhibiting effect is observed. ZnO microparticles catalyzed the oxidation of PE films over a broader concentration range (1–12 wt.%), with oxidation inhibition observed only at 18 wt.%. At the same time, they demonstrated moderate photocatalytic activity (rate constant 0.256 min−1). These characteristics of the samples correlate with data obtained by microscopy, photoluminescence spectroscopy, and X-ray diffraction analysis.
Open AccessRelationship of Luminescent, Thermo-Oxidative and Photocatalytic Properties of ZnO Micro and Nanostructures
In this work, a comprehensive analysis of the relationship between photoluminescent, thermo-oxidative, and photocatalytic (upon simulated sunlight exposure) properties of ZnO powders is performed. The correlation between the X-ray diffraction and microscopic data is studied. ZnO powders of various sizes and morphologies were used: pseudo-spherical nanoparticles (30–50 nm), submicron faceted crystallites (100–500 nm), and plate- and rod-like microstructures (up to 20 μm). The mean specific surface area values were 32 m2/g, 3.8 m2/g, and 2.6 m2/g for pseudo-spherical nanoparticles, submicron faceted crystallites, and plate- and rod-like microstructures, respectively. According to the XRD data, microstresses and carbon-based impurities were present in ZnO nanoparticles, which is characteristic of nanomaterials synthesized at low temperatures. According to the photoluminescence spectroscopy data, the emission in ZnO was reduced due to high defectiveness, and characteristic emission bands indicated the presence of organic impurities. Upon long signal registration times, an intensive luminescence band with an effective maximum at 579 nm occurred, which indicated the presence of long-term components exhibiting decay times τ ~300 μs. According to the XRD data, the crystal structure parameters of ZnO submicro- and microparticles were close, with no impurities present. In their photoluminescence spectra, pronounced UV and defect-related bands were present with intensity ratios of 11.6 and 6.88, respectively. The decrease in the UV and defect-related luminescence band intensity ratios indicates deviation from the stoichiometry toward an increased Zn over oxygen content. At long signal registration times, in submicron ZnO particles, a luminescence band with maxima at 425 and 490 nm is present, which decays rapidly. An emission band in the 530 nm region is also present, which decays for ≤80 μs, and a weak long-wavelength emission decaying for ~100 μs. At long delay and strobe times (up to milliseconds), only an emission in the 460 nm region is observed, which we connect to the triplet–singlet transition of a defect center (F*, F+*). At lower intensities, an emission connected to the surface contamination by organic impurities is observed. In photoluminescence spectra of ZnO microparticles, no long-wavelength emission components are observed. However, upon immersing into methylene blue solution, a modification of the surface and UV region of the spectra is observed with signs of charge carrier recombination rate acceleration. It is shown that the catalytic action of ZnO powders in polyethylene thermo-oxidation processes is determined by a combination of factors. In addition to dispersity and concentration, which are the key parameters, the morphology of ZnO particles, the presence of impurities, the surface state, and the distribution of active sites have a significant influence on catalysis. It has been experimentally demonstrated that these secondary factors can markedly affect the rate of radical formation in polyethylene films and alter their resistance to oxidation. ZnO nanoparticles exhibited low catalytic activity in both photocatalysis (rate constant 0.146 min−1) and thermocatalysis due to the high defect density of the crystallites and the presence of carbon-containing impurities. Submicron ZnO particles, owing to a high carrier generation rate and suppressed recombination (via trapping), demonstrated the highest photoactivity (rate constant 0.729 min−1). Submicron ZnO particles exhibit a catalytic effect on the thermo-oxidation of polyethylene (PE films); however, at concentrations above 8 wt.% a transition to an inhibiting effect is observed. ZnO microparticles catalyzed the oxidation of PE films over a broader concentration range (1–12 wt.%), with oxidation inhibition observed only at 18 wt.%. At the same time, they demonstrated moderate photocatalytic activity (rate constant 0.256 min−1). These characteristics of the samples correlate with data obtained by microscopy, photoluminescence spectroscopy, and X-ray diffraction analysis.
- Open Access
Plasmon-Enhanced Piezo-Photocatalytic Degradation of Metronidazole Using Ag-Decorated ZnO Microtetrapods
The development of advanced semiconductor-based catalysts for the rapid degradation of emerging pharmaceutical pollutants in water remains a critical challenge in environmental science. In this study, we present the synthesis, characterization, and catalytic performance of zinc oxide (ZnO) microtetrapods decorated with plasmonic Ag nanoparticles. These microtetrapods have been designed to enhance piezo-, photo-, and piezo-photocatalytic degradation of metronidazole (MNZ), a persistent antibiotic contaminant. ZnO microtetrapods were synthesized by high-temperature pyrolysis and using atmospheric-pressure microwave nitrogen plasma, followed by photochemical deposition of Ag nanoparticles at various precursor concentrations (0–1 mmol AgNO3). The structural integrity of the samples was confirmed through X-ray diffraction (XRD) analysis, while the morphology was examined using scanning electron microscopy with energy-dispersive X-ray analysis (SEM-EDX). Additionally, spectroscopic analysis, including Raman, electron paramagnetic resonance (EPR), and photoluminescence (PL) spectroscopy, was conducted to verify the successful formation of heterostructures with adjustable surface loading of Ag. It has been shown that ZnO microtetrapods decorated with plasmonic Ag nanoparticles exhibit Raman-active properties. A systematic evaluation under photocatalytic, piezocatalytic, and combined piezo-photocatalytic conditions revealed a pronounced volcano-type dependence of catalytic activity on Ag content, with the 0.75 mmol composition exhibiting optimal performance. In the presence of both light irradiation and ultrasonication, the optimized Ag/ZnO composite exhibited 93% degradation of MNZ within a span of 5 min, accompanied by an apparent rate constant of 0.56 min−1. This value stands as a significant improvement, surpassing the degradation rate of pristine ZnO by over 24-fold. The collective identification of defect modulation, plasmon-induced charge separation, and piezoelectric polarization as the predominant mechanisms driving enhanced reactive oxygen species (ROS) generation is a significant advancement in the field. These findings underscore the synergistic interplay between plasmonic and piezoelectric effects in oxide-based heterostructures and present a promising strategy for the efficient removal of recalcitrant water pollutants using multi-field activated catalysis.
Open AccessPlasmon-Enhanced Piezo-Photocatalytic Degradation of Metronidazole Using Ag-Decorated ZnO Microtetrapods
The development of advanced semiconductor-based catalysts for the rapid degradation of emerging pharmaceutical pollutants in water remains a critical challenge in environmental science. In this study, we present the synthesis, characterization, and catalytic performance of zinc oxide (ZnO) microtetrapods decorated with plasmonic Ag nanoparticles. These microtetrapods have been designed to enhance piezo-, photo-, and piezo-photocatalytic degradation of metronidazole (MNZ), a persistent antibiotic contaminant. ZnO microtetrapods were synthesized by high-temperature pyrolysis and using atmospheric-pressure microwave nitrogen plasma, followed by photochemical deposition of Ag nanoparticles at various precursor concentrations (0–1 mmol AgNO3). The structural integrity of the samples was confirmed through X-ray diffraction (XRD) analysis, while the morphology was examined using scanning electron microscopy with energy-dispersive X-ray analysis (SEM-EDX). Additionally, spectroscopic analysis, including Raman, electron paramagnetic resonance (EPR), and photoluminescence (PL) spectroscopy, was conducted to verify the successful formation of heterostructures with adjustable surface loading of Ag. It has been shown that ZnO microtetrapods decorated with plasmonic Ag nanoparticles exhibit Raman-active properties. A systematic evaluation under photocatalytic, piezocatalytic, and combined piezo-photocatalytic conditions revealed a pronounced volcano-type dependence of catalytic activity on Ag content, with the 0.75 mmol composition exhibiting optimal performance. In the presence of both light irradiation and ultrasonication, the optimized Ag/ZnO composite exhibited 93% degradation of MNZ within a span of 5 min, accompanied by an apparent rate constant of 0.56 min−1. This value stands as a significant improvement, surpassing the degradation rate of pristine ZnO by over 24-fold. The collective identification of defect modulation, plasmon-induced charge separation, and piezoelectric polarization as the predominant mechanisms driving enhanced reactive oxygen species (ROS) generation is a significant advancement in the field. These findings underscore the synergistic interplay between plasmonic and piezoelectric effects in oxide-based heterostructures and present a promising strategy for the efficient removal of recalcitrant water pollutants using multi-field activated catalysis.
- 16 July 2019
- Published by Springer Nature in Metallurgist
- Vol. 63 (3-4) , 228-237
Plasma Heating of Periclase-Carbonaceous Refractory for Lining of Steel Ladles
- 16 July 2019
- Published by Springer Nature in Metallurgist
- Vol. 63 (3-4) , 228-237
Plasma Heating of Periclase-Carbonaceous Refractory for Lining of Steel Ladles
- 22 September 2013
- Published by Springer Nature in Metallurgist
- Vol. 57 (5) , 427-433
Study of the microstructure and mechanical properties of steel cast using plasma heating in a CBCM tundish
- 22 September 2013
- Published by Springer Nature in Metallurgist
- Vol. 57 (5) , 427-433
Study of the microstructure and mechanical properties of steel cast using plasma heating in a CBCM tundish