Yang Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yang Yang has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- Wenjun Zhang
Department of Materials Science and Engineering & Center of Super-Diamond and Advanced Films (COSDAF), City University of Hong Kong, Hong Kong SAR 999077, China
7 shared publications - Peng Shi
Department of Biomedical Engineering, City University of Hong Kong, Hong Kong, China
3 shared publications - Xianfeng Chen
School of Engineering, Institute of Bioengineering, The University of Edinburgh, Edinburgh, UK
3 shared publications Fuxiang Wang
2 shared publicationsGuoguo Ye
2 shared publications- Hao Fan
JiangXi University of Chinese Medicine, Nan Chang, China
2 shared publications
Latest Publications
- 12 February 2024
- Published by American Chemical Society (ACS) in Accounts of Materials Research
- Vol. 5 (3) , 259-270
Exploring Diamond Nanoneedle Arrays: Fabrication and Emerging Applications in Biomedical Engineering
- 12 February 2024
- Published by American Chemical Society (ACS) in Accounts of Materials Research
- Vol. 5 (3) , 259-270
Exploring Diamond Nanoneedle Arrays: Fabrication and Emerging Applications in Biomedical Engineering
- 25 October 2022
- Published by Elsevier in Biomaterials
- Vol. 291, 121869
Discrete single-cell microRNA analysis for phenotyping the heterogeneity of acute myeloid leukemia
- 25 October 2022
- Published by Elsevier in Biomaterials
- Vol. 291, 121869
Discrete single-cell microRNA analysis for phenotyping the heterogeneity of acute myeloid leukemia
- Open Access
- 16 April 2022
- Published by Wiley in International Journal of Analytical Chemistry
- Vol. 2022, 1-8
A Novel Helper qPCR Assay for the Detection of miRNA Using Target/Helper Template for Primer Formation
A novel, simple, and sensitive quantitative polymerase chain reaction (qPCR) technology, which is termed as helper qPCR, was established to detect miRNA. In this assay, the target miRNA sequence was introduced as helper template for a reaction switch preforming two-step real-time qPCR strategy. Firstly, the reverse primer was reverse transcribed to form “mediator primer” after binding to the target miRNA. Then, the mediator primer was further extended to form “active template” with annealing to the mediator template. In the end, the active template was amplified and detected by the qPCR reaction system with the help of reverse and forward primers. The SYBR Green dye was used for fluorescence quantification, which is quicker and cheaper than the fluorescent probes, as the detection limit of this assay was 1 pM. This helper qPCR system can be used for different miRNAs detection by redesigning reverse primer for target, indicating this strategy could afford good performance in detecting multiple miRNAs and has a promising application prospect.
- 16 April 2022
- Published by Wiley in International Journal of Analytical Chemistry
- Vol. 2022, 1-8
Open AccessA Novel Helper qPCR Assay for the Detection of miRNA Using Target/Helper Template for Primer Formation
A novel, simple, and sensitive quantitative polymerase chain reaction (qPCR) technology, which is termed as helper qPCR, was established to detect miRNA. In this assay, the target miRNA sequence was introduced as helper template for a reaction switch preforming two-step real-time qPCR strategy. Firstly, the reverse primer was reverse transcribed to form “mediator primer” after binding to the target miRNA. Then, the mediator primer was further extended to form “active template” with annealing to the mediator template. In the end, the active template was amplified and detected by the qPCR reaction system with the help of reverse and forward primers. The SYBR Green dye was used for fluorescence quantification, which is quicker and cheaper than the fluorescent probes, as the detection limit of this assay was 1 pM. This helper qPCR system can be used for different miRNAs detection by redesigning reverse primer for target, indicating this strategy could afford good performance in detecting multiple miRNAs and has a promising application prospect.
- 16 July 2021
- Published by Wiley in Surface and Interface Analysis
- Vol. 53 (11) , 919-932
Tribolayer‐dependent origin of ultralow friction in nanocrystalline diamond films sliding against Si 3 N 4 ball
This study investigates the role of sliding counterbodies, which significantly affect the wear properties and friction of nanocrystalline diamond (NCD) film. The bearing steel balls exhibit a high friction coefficient of 0.12, whereas a ceramic ball of Si 3 N 4 achieves an ultralow friction coefficient of 0.06. The evolution of different friction coefficients with different counterbodies is associated with the formation of a tribolayer at the sliding interface. The decreased friction coefficient in NCD films sliding against Si 3 N 4 ball is likely linked to the occurrence of lubricating nanostructures, especially the silica‐like oxide compounds and graphite‐like carbon phases. The findings of this study may provide new avenues for the design and development of wear‐resistant and environment‐friendly hard carbon films.
- 16 July 2021
- Published by Wiley in Surface and Interface Analysis
- Vol. 53 (11) , 919-932
Tribolayer‐dependent origin of ultralow friction in nanocrystalline diamond films sliding against Si 3 N 4 ball
This study investigates the role of sliding counterbodies, which significantly affect the wear properties and friction of nanocrystalline diamond (NCD) film. The bearing steel balls exhibit a high friction coefficient of 0.12, whereas a ceramic ball of Si 3 N 4 achieves an ultralow friction coefficient of 0.06. The evolution of different friction coefficients with different counterbodies is associated with the formation of a tribolayer at the sliding interface. The decreased friction coefficient in NCD films sliding against Si 3 N 4 ball is likely linked to the occurrence of lubricating nanostructures, especially the silica‐like oxide compounds and graphite‐like carbon phases. The findings of this study may provide new avenues for the design and development of wear‐resistant and environment‐friendly hard carbon films.
- 1 June 2019
- Published by Elsevier in Materials Today Energy
- Vol. 12, 62-69
Nitrogen-doped braided-looking mesoporous carbonaceous nanotubes as an advanced oxygen reduction electrocatalyst
- 1 June 2019
- Published by Elsevier in Materials Today Energy
- Vol. 12, 62-69
Nitrogen-doped braided-looking mesoporous carbonaceous nanotubes as an advanced oxygen reduction electrocatalyst
- 1 June 2019
- Published by Elsevier in Materials Today Energy
- Vol. 12, 46-52
Hierarchically nanostructured ZnCo2O4 particles in 3D graphene networks for high-rate and long-life lithium ion batteries
- 1 June 2019
- Published by Elsevier in Materials Today Energy
- Vol. 12, 46-52
Hierarchically nanostructured ZnCo2O4 particles in 3D graphene networks for high-rate and long-life lithium ion batteries
- 1 December 2018
- Published by Elsevier in Nano Energy
- Vol. 54, 99-105
Modulation-doped ZnO as high performance electron-selective layer for efficient silicon heterojunction solar cells
- 1 December 2018
- Published by Elsevier in Nano Energy
- Vol. 54, 99-105
Modulation-doped ZnO as high performance electron-selective layer for efficient silicon heterojunction solar cells
- 18 November 2016
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 311 (1) , 637-642
The evaporation behaviors of rare-earth-doped FLiNaK melts during low-pressure distillation
- 18 November 2016
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 311 (1) , 637-642
The evaporation behaviors of rare-earth-doped FLiNaK melts during low-pressure distillation