Kelsey M. Stocker
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kelsey M. Stocker has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Joshua Daniel Gezelter
Department of Chemistry and Biochemistry, University of Notre Dame, 251 Nieuwland Science Hall, Notre Dame, Indiana 46556, United States
5 shared publications - George Chappell Schatz
Department of Chemistry Northwestern University Evanston Illinois USA
2 shared publications Charles F. Vardeman
Department of Chemistry and Biochemistry, University of Notre Dame, Notre Dame, Indiana 46556, United States
1 shared publication- Charles F. Vardeman
Center for Research Computing, University of Notre Dame, Notre Dame, IN, United States
1 shared publication - Christopher Joseph Fennell
Oklahoma State University
1 shared publication - Cody R. Drisko
Department of Chemistry and Biochemistry, University of Notre Dame, Notre Dame, IN, United States
1 shared publication
Latest Publications
- Open Access
- 1 November 2024
- Published by The Open Journal in Journal of Open Source Software
- Vol. 9 (103) , 7004
OpenMD: A parallel molecular dynamics engine for complex systems and interfaces
Molecular dynamics (MD) simulations help bridge the gap between quantum mechanical calculations, which trade computational resources and system size for chemical accuracy, and continuum simulations, which utilize bulk and surface material properties to make predictions. MD provides the ability to study emergent properties and dynamics for relatively large systems (∼ 10 6 atoms) over a span of nano-to micro-seconds. MD has been used for simulations of complex systems such as liquids, proteins, membranes, nanoparticles, interfaces, and porous materials, and the approximations used in MD simulations allow us to reach experimentallyrelevant time and length scales (Allen & Tildesley, 2017). A molecular dynamics engine leverages classical equations of motion to evolve atomic or molecular coordinates according to a well-defined potential energy function, known as a force field, which is a function of those atomic coordinates. There are a number of high quality molecular dynamics engines that specialize in materials (Thompson et al., 2022) or biomolecular (Brooks et al., 2009; Case et al., 2023) simulations or are models of computational efficiency (Abraham et al., 2015; Eastman et al., 2017). In this paper, we provide background on an open source molecular dynamics engine, OpenMD, which specializes in complex systems and interfaces and was just released into version 3.1.
- 1 November 2024
- Published by The Open Journal in Journal of Open Source Software
- Vol. 9 (103) , 7004
Open AccessOpenMD: A parallel molecular dynamics engine for complex systems and interfaces
Molecular dynamics (MD) simulations help bridge the gap between quantum mechanical calculations, which trade computational resources and system size for chemical accuracy, and continuum simulations, which utilize bulk and surface material properties to make predictions. MD provides the ability to study emergent properties and dynamics for relatively large systems (∼ 10 6 atoms) over a span of nano-to micro-seconds. MD has been used for simulations of complex systems such as liquids, proteins, membranes, nanoparticles, interfaces, and porous materials, and the approximations used in MD simulations allow us to reach experimentallyrelevant time and length scales (Allen & Tildesley, 2017). A molecular dynamics engine leverages classical equations of motion to evolve atomic or molecular coordinates according to a well-defined potential energy function, known as a force field, which is a function of those atomic coordinates. There are a number of high quality molecular dynamics engines that specialize in materials (Thompson et al., 2022) or biomolecular (Brooks et al., 2009; Case et al., 2023) simulations or are models of computational efficiency (Abraham et al., 2015; Eastman et al., 2017). In this paper, we provide background on an open source molecular dynamics engine, OpenMD, which specializes in complex systems and interfaces and was just released into version 3.1.
- Open Access
- 24 March 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (13) , 4663-4666
Mechanisms of Hydrogen-Assisted CO2 Reduction on Nickel
Mechanistic details of catalytic reactions are critical to the development of improved catalysts. Here, we perform high quality Born–Oppenheimer molecular dynamics simulations of the reaction mechanisms associated with hydrogen-assisted CO2 reduction on Ni(110). The simulation results show direct theoretical evidence for both associative and redox mechanisms in the reaction of atomic hydrogen with CO2. Because H2 is dissociatively chemisorbed on Ni(110) with nearly unit probability, the mechanisms we find are also relevant to the reverse water-gas shift reaction (H2 with adsorbed CO2). Furthermore, we provide the first real-time demonstration of both Eley–Rideal (ER) and hot atom (HA) mechanisms when H impinges on adsorbed CO2, and we show that both occur even for low kinetic energies. The trade-off between ER or HA mechanisms is found to be strongly dependent on CO2 coverage. The results are compared with recent gas/surface measurements.
- 24 March 2017
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 139 (13) , 4663-4666
Open AccessMechanisms of Hydrogen-Assisted CO2 Reduction on Nickel
Mechanistic details of catalytic reactions are critical to the development of improved catalysts. Here, we perform high quality Born–Oppenheimer molecular dynamics simulations of the reaction mechanisms associated with hydrogen-assisted CO2 reduction on Ni(110). The simulation results show direct theoretical evidence for both associative and redox mechanisms in the reaction of atomic hydrogen with CO2. Because H2 is dissociatively chemisorbed on Ni(110) with nearly unit probability, the mechanisms we find are also relevant to the reverse water-gas shift reaction (H2 with adsorbed CO2). Furthermore, we provide the first real-time demonstration of both Eley–Rideal (ER) and hot atom (HA) mechanisms when H impinges on adsorbed CO2, and we show that both occur even for low kinetic energies. The trade-off between ER or HA mechanisms is found to be strongly dependent on CO2 coverage. The results are compared with recent gas/surface measurements.
- 3 October 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (40) , 23061-23068
Reducing CO2 to CO and H2O on Ni(110): The Influence of Subsurface Hydrogen
- 3 October 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (40) , 23061-23068
Reducing CO2 to CO and H2O on Ni(110): The Influence of Subsurface Hydrogen
- 13 January 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 119 (2) , 025106
Interfacial thermal conductance of thiolate-protected gold nanospheres
Molecular dynamics simulations of thiolate-protected and solvated gold nanoparticles were carried out in the presence of a non-equilibrium heat flux between the solvent and the core of the particle. The interfacial thermal conductance (G) was computed for these interfaces, and the behavior of the thermal conductance was studied as a function of particle size, ligand flexibility, and ligand chain length. In all cases, thermal conductance of the ligand-protected particles was higher than the bare metal–solvent interface. A number of mechanisms for the enhanced conductance were investigated, including thiolate-driven corrugation of the metal surface, solvent ordering at the interface, solvent-ligand interpenetration, and ligand ordering relative to the particle surface. Only the smallest particles exhibited significant corrugation. All ligands permitted substantial solvent-ligand interpenetration, and ligand chain length has a significant influence on the orientational ordering of interfacial solvent. Solvent–ligand vibrational overlap, particularly in the low frequency range (−1), was significantly altered by ligand rigidity, and had direct influence on the interfacial thermal conductance.
- 13 January 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 119 (2) , 025106
Interfacial thermal conductance of thiolate-protected gold nanospheres
Molecular dynamics simulations of thiolate-protected and solvated gold nanoparticles were carried out in the presence of a non-equilibrium heat flux between the solvent and the core of the particle. The interfacial thermal conductance (G) was computed for these interfaces, and the behavior of the thermal conductance was studied as a function of particle size, ligand flexibility, and ligand chain length. In all cases, thermal conductance of the ligand-protected particles was higher than the bare metal–solvent interface. A number of mechanisms for the enhanced conductance were investigated, including thiolate-driven corrugation of the metal surface, solvent ordering at the interface, solvent-ligand interpenetration, and ligand ordering relative to the particle surface. Only the smallest particles exhibited significant corrugation. All ligands permitted substantial solvent-ligand interpenetration, and ligand chain length has a significant influence on the orientational ordering of interfacial solvent. Solvent–ligand vibrational overlap, particularly in the low frequency range (−1), was significantly altered by ligand rigidity, and had direct influence on the interfacial thermal conductance.
- 1 May 2014
- Published by American Chemical Society (ACS) in Journal of Chemical Theory and Computation
- Vol. 10 (5) , 1878-1886
A Method for Creating Thermal and Angular Momentum Fluxes in Nonperiodic Simulations
We present a new reverse nonequilibrium molecular dynamics method that can be used with nonperiodic simulation cells. This method applies thermal and/or angular momentum fluxes between two arbitrary regions of the simulation and is capable of creating stable temperature and angular velocity gradients while conserving total energy and angular momentum. One particularly useful application is the exchange of kinetic energy between two concentric spherical regions, which can be used to generate thermal transport between nanoparticles and the solvent that surrounds them. The rotational couple to the solvent (a measure of interfacial friction) is also available via this method. As tests of the new method, we have computed the thermal conductivities of gold nanoparticles and water clusters, the interfacial thermal conductivity (G) of a solvated gold nanoparticle, and the interfacial friction of a variety of solvated gold nanostructures.
- 1 May 2014
- Published by American Chemical Society (ACS) in Journal of Chemical Theory and Computation
- Vol. 10 (5) , 1878-1886
A Method for Creating Thermal and Angular Momentum Fluxes in Nonperiodic Simulations
We present a new reverse nonequilibrium molecular dynamics method that can be used with nonperiodic simulation cells. This method applies thermal and/or angular momentum fluxes between two arbitrary regions of the simulation and is capable of creating stable temperature and angular velocity gradients while conserving total energy and angular momentum. One particularly useful application is the exchange of kinetic energy between two concentric spherical regions, which can be used to generate thermal transport between nanoparticles and the solvent that surrounds them. The rotational couple to the solvent (a measure of interfacial friction) is also available via this method. As tests of the new method, we have computed the thermal conductivities of gold nanoparticles and water clusters, the interfacial thermal conductivity (G) of a solvated gold nanoparticle, and the interfacial friction of a variety of solvated gold nanostructures.
- 20 March 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (15) , 7605-7612
Simulations of Heat Conduction at Thiolate-Capped Gold Surfaces: The Role of Chain Length and Solvent Penetration
- 20 March 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (15) , 7605-7612
Simulations of Heat Conduction at Thiolate-Capped Gold Surfaces: The Role of Chain Length and Solvent Penetration
- Open Access
- 18 March 2011
- Published by American Chemical Society (ACS) in Journal of Chemical Theory and Computation
- Vol. 7 (4) , 834-842
The Langevin Hull: Constant Pressure and Temperature Dynamics for Nonperiodic Systems
We have developed a new isobaric-isothermal (NPT) algorithm which applies an external pressure to the facets comprising the convex hull surrounding the system. A Langevin thermostat is also applied to the facets to mimic contact with an external heat bath. This new method, the “Langevin Hull”, can handle heterogeneous mixtures of materials with different compressibilities. These systems are problematic for traditional affine transform methods. The Langevin Hull does not suffer from the edge effects of boundary potential methods, and allows realistic treatment of both external pressure and thermal conductivity due to the presence of an implicit solvent. We apply this method to several different systems including bare metal nanoparticles, nanoparticles in an explicit solvent, as well as clusters of liquid water. The predicted mechanical properties of these systems are in good agreement with experimental data and previous simulation work.
- 18 March 2011
- Published by American Chemical Society (ACS) in Journal of Chemical Theory and Computation
- Vol. 7 (4) , 834-842
Open AccessThe Langevin Hull: Constant Pressure and Temperature Dynamics for Nonperiodic Systems
We have developed a new isobaric-isothermal (NPT) algorithm which applies an external pressure to the facets comprising the convex hull surrounding the system. A Langevin thermostat is also applied to the facets to mimic contact with an external heat bath. This new method, the “Langevin Hull”, can handle heterogeneous mixtures of materials with different compressibilities. These systems are problematic for traditional affine transform methods. The Langevin Hull does not suffer from the edge effects of boundary potential methods, and allows realistic treatment of both external pressure and thermal conductivity due to the presence of an implicit solvent. We apply this method to several different systems including bare metal nanoparticles, nanoparticles in an explicit solvent, as well as clusters of liquid water. The predicted mechanical properties of these systems are in good agreement with experimental data and previous simulation work.