Carsten Plog
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Carsten Plog has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
- Ralf Moos
University of Bayreuth
10 shared publications W. Gerhard
Dornier System GmbH, Postfach 1360, D-7990 Friedrichshafen 1
8 shared publicationsJ. Haas
5 shared publications- Ulrich Simon
Institute of Inorganic Chemistry, RWTH Aachen University, Landoltweg 1A, 52074 Aachen, Germany
4 shared publications A. Benninghoven
3 shared publicationsAleksandar Knezevic
Daimler AG
3 shared publications
Latest Publications
- 14 April 2008
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Sensor for Directly Determining the State of a NOx Storage Catalyst
In order to control NOx reduction with NOx storing lean NOx traps (LNT), a gas sensor downstream of the LNT is presently preferred. It is a disadvantage that no means are available to gauge directly the LNT NOx loading level and the catalyst quality. The presented novel sensor consists of interdigital electrodes that are deposited on a planar substrate. On its reverse side, a temperature sensor is applied. Both sides are covered with the original catalyst coating, allowing detecting directly electrical impedance and temperature of the coating. Such sensors were integrated in different positions of an LNT. It is shown in synthetic exhausts as well as in engine tests that in-situ measurements of the electrical impedance of the LNT coating are appropriate to determine directly the catalyst status. Hence, the local degree of NOx loading as well as the local regeneration status can be measured. Furthermore, sulfur poisoning, desulfurization, and thermal ageing can be directly seen.
- 14 April 2008
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Sensor for Directly Determining the State of a NOx Storage Catalyst
In order to control NOx reduction with NOx storing lean NOx traps (LNT), a gas sensor downstream of the LNT is presently preferred. It is a disadvantage that no means are available to gauge directly the LNT NOx loading level and the catalyst quality. The presented novel sensor consists of interdigital electrodes that are deposited on a planar substrate. On its reverse side, a temperature sensor is applied. Both sides are covered with the original catalyst coating, allowing detecting directly electrical impedance and temperature of the coating. Such sensors were integrated in different positions of an LNT. It is shown in synthetic exhausts as well as in engine tests that in-situ measurements of the electrical impedance of the LNT coating are appropriate to determine directly the catalyst status. Hence, the local degree of NOx loading as well as the local regeneration status can be measured. Furthermore, sulfur poisoning, desulfurization, and thermal ageing can be directly seen.
- 1 December 2006
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 119 (2) , 441-448
Selective impedance based gas sensors for hydrocarbons using ZSM-5 zeolite films with chromium(III)oxide interface
- 1 December 2006
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 119 (2) , 441-448
Selective impedance based gas sensors for hydrocarbons using ZSM-5 zeolite films with chromium(III)oxide interface
- 1 November 2006
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 119 (1) , 57-63
Sensor for directly determining the exhaust gas recirculation rate—EGR sensor
- 1 November 2006
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 119 (1) , 57-63
Sensor for directly determining the exhaust gas recirculation rate—EGR sensor
- 1 July 2004
- Published by Springer Nature in Journal of Electroceramics
- Vol. 13 (1-3) , 733-738
Poisoning of Temperature Independent Resistive Oxygen Sensors by Sulfur Dioxide
- 1 July 2004
- Published by Springer Nature in Journal of Electroceramics
- Vol. 13 (1-3) , 733-738
Poisoning of Temperature Independent Resistive Oxygen Sensors by Sulfur Dioxide
- 22 October 2003
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 5 (23) , 5195-5198
Development and working principle of an ammonia gas sensor based on a refined model for solvate supported proton transport in zeolites
Some of the work relating to the development of a selective ammonia exhaust gas sensor are reported in this contribution. The sensor itself meets all the technological and economic demands of the automotive industry. As the gas-sensitive material the proton conducting zeolite H-ZSM-5 is used. The selective and concentration dependent interaction of the mobile protons with ammonia, i.e., the resulting change in proton conductivity, is detected directly by means of impedance spectroscopy. The sensor development was supported by a detailed picture of ammonia supported proton transport, deduced from impedance measurements on H-ZSM-5 with different SiO2/Al2O3 ratios in a wide temperature and frequency range. It provides understanding of the transport control parameters, e.g. temperature, composition of the zeolite structure and concentration of the guest molecules, respectively.
- 22 October 2003
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 5 (23) , 5195-5198
Development and working principle of an ammonia gas sensor based on a refined model for solvate supported proton transport in zeolites
Some of the work relating to the development of a selective ammonia exhaust gas sensor are reported in this contribution. The sensor itself meets all the technological and economic demands of the automotive industry. As the gas-sensitive material the proton conducting zeolite H-ZSM-5 is used. The selective and concentration dependent interaction of the mobile protons with ammonia, i.e., the resulting change in proton conductivity, is detected directly by means of impedance spectroscopy. The sensor development was supported by a detailed picture of ammonia supported proton transport, deduced from impedance measurements on H-ZSM-5 with different SiO2/Al2O3 ratios in a wide temperature and frequency range. It provides understanding of the transport control parameters, e.g. temperature, composition of the zeolite structure and concentration of the guest molecules, respectively.
- 17 October 2003
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 5 (23) , 5199-5202
Amperometric measurements with a nitrosyl cation conducting ceramic membrane
This work deals with the investigation of a gas-diffusion-controlled NO+ ion conducting ceramic membrane that is utilized for an amperometric solid-electrolyte NO sensor.
- 17 October 2003
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 5 (23) , 5199-5202
Amperometric measurements with a nitrosyl cation conducting ceramic membrane
This work deals with the investigation of a gas-diffusion-controlled NO+ ion conducting ceramic membrane that is utilized for an amperometric solid-electrolyte NO sensor.
- 1 August 2003
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 93 (1-3) , 36-42
Sulfur adsorber for thick-film exhaust gas sensors
- 1 August 2003
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 93 (1-3) , 36-42
Sulfur adsorber for thick-film exhaust gas sensors
- 1 August 2003
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 93 (1-3) , 43-50
Temperature-independent resistive oxygen exhaust gas sensor for lean-burn engines in thick-film technology
- 1 August 2003
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 93 (1-3) , 43-50
Temperature-independent resistive oxygen exhaust gas sensor for lean-burn engines in thick-film technology
- 1 March 2002
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 83 (1-3) , 181-189
Selective ammonia exhaust gas sensor for automotive applications
- 1 March 2002
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 83 (1-3) , 181-189
Selective ammonia exhaust gas sensor for automotive applications
- 24 September 2001
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Plasma-Enhanced Adsorption and Reduction on Lean NOx-Catalysts
The influence of adsorption and desorption processes on the non-thermal plasma enhanced catalytic reduction of NOx on NaZSM5- and Al2O3-based lean-NOx catalysts (Pt-NH4ZSM5, Cu-NaZSM5, Fe-NaZSM5, Pt-Al2O3, Pd-Al2O3, CuO-Al2O3, Ag-Al2O3) was investigated by temperature programmed reaction experiments in the temperature range from 100 °C to 600 °C. Dodecane was used as a reducing agent. Strong HC adsorption- and desorption effects were observed on the zeolite catalysts, which were not influenced by plasma-pretreatment. Adsorption of NO2 and desorption of NO occurred on Al2O3-based catalysts. By plasma-pretreatment adsorption of NO2 was induced at low temperatures. NOx-reduction rates of the catalysts Cu-NaZSM5, Fe-NaZSM5, and the Ag-Al2O3 were increased substantially by plasma-pretreatment. Both plasma-induced and catalytic oxidation of HCs were limiting factors of the NOx-reduction obtained on these catalysts.
- 24 September 2001
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Plasma-Enhanced Adsorption and Reduction on Lean NOx-Catalysts
The influence of adsorption and desorption processes on the non-thermal plasma enhanced catalytic reduction of NOx on NaZSM5- and Al2O3-based lean-NOx catalysts (Pt-NH4ZSM5, Cu-NaZSM5, Fe-NaZSM5, Pt-Al2O3, Pd-Al2O3, CuO-Al2O3, Ag-Al2O3) was investigated by temperature programmed reaction experiments in the temperature range from 100 °C to 600 °C. Dodecane was used as a reducing agent. Strong HC adsorption- and desorption effects were observed on the zeolite catalysts, which were not influenced by plasma-pretreatment. Adsorption of NO2 and desorption of NO occurred on Al2O3-based catalysts. By plasma-pretreatment adsorption of NO2 was induced at low temperatures. NOx-reduction rates of the catalysts Cu-NaZSM5, Fe-NaZSM5, and the Ag-Al2O3 were increased substantially by plasma-pretreatment. Both plasma-induced and catalytic oxidation of HCs were limiting factors of the NOx-reduction obtained on these catalysts.