Songwei Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Songwei Li has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
Chuntai Liu
National Engineering Research Center for Advanced Polymer Processing Technology, Key Laboratory of Materials Processing and Mold (Ministry of Education), Zhengzhou University, Zhengzhou, 450002, China
13 shared publications- Lu Shao
School of Chemistry and Chemical Engineering, Harbin Institute of Technology, Harbin 150001, China
12 shared publications Changyu Shen
11 shared publicationsPeipei Yang
10 shared publications- Chuntai Liu
Zhengzhou University
7 shared publications - Peipei Yang
National Engineering Research Center for Advanced Polymer Processing Technology, Key Laboratory of Materials Processing and Mold (Ministry of Education), Zhengzhou University, Zhengzhou, 450002, China
7 shared publications
Latest Publications
- 22 June 2026
- Published by Elsevier in Water Research
- Vol. 304, 126348
AOCOF-intercalated GO nanofiltration membranes with tailored hybrid nanochannels for high-performance dye separation
- 22 June 2026
- Published by Elsevier in Water Research
- Vol. 304, 126348
AOCOF-intercalated GO nanofiltration membranes with tailored hybrid nanochannels for high-performance dye separation
- 13 December 2025
- Published by Elsevier in Applied Surface Science
- Vol. 722
Functional polyvinylidene fluoride molecularly imprinted membranes with high stability and selectivity
- 13 December 2025
- Published by Elsevier in Applied Surface Science
- Vol. 722
Functional polyvinylidene fluoride molecularly imprinted membranes with high stability and selectivity
- 11 February 2025
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 17 (16) , 9764-9785
Membrane-based adsorbent materials for uranium extraction from seawater: recent progress and future prospects
This review summarizes recent studies on the use of membrane-based adsorbents for extracting uranium from seawater and the prospects for their development. Reproduced with permission - see article for full details.
- 11 February 2025
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 17 (16) , 9764-9785
Membrane-based adsorbent materials for uranium extraction from seawater: recent progress and future prospects
This review summarizes recent studies on the use of membrane-based adsorbents for extracting uranium from seawater and the prospects for their development. Reproduced with permission - see article for full details.
- 31 July 2024
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 677 (Pt A) , 435-445
Antimicrobial polymer-based zeolite imidazolate framework composite membranes for uranium extraction from wastewater and seawater
- 31 July 2024
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 677 (Pt A) , 435-445
Antimicrobial polymer-based zeolite imidazolate framework composite membranes for uranium extraction from wastewater and seawater
- 31 July 2024
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 11 (18) , 6156-6167
Graphene oxide/graphitic carbon nitride/polyamide oxime nanofibers for adsorption and photocatalytic reduction of uranium from seawater
The advancement of the extraction of uranium(VI) (U(VI)) from seawater holds significant strategic importance for the sustainable progression of nuclear energy. In this study, the photocatalyst heterojunction of graphene oxide/graphitic carbon nitride (GO/g-C3N4) was encapsulated by the spinning of fiber to obtain a graphene oxide/graphitic carbon nitride/polyamide oxime (GO/g-C3N4/PAO) film with adsorption and photoreduction ability toward U(VI). The enhanced adsorption capacity of the GO/g-C3N4/PAO nanofiber was achieved through the synergistic effects of the aminoxime group in PAO and the photocatalytic performance of GO/g-C3N4. The GO/g-C3N4/PAO composite exhibited an adsorption capacity of 190.7 mg g−1 (pH = 6, t = 600 min, C0 = 99.9 mg L−1, and m/v = 0.5 g L−1) under light conditions. GO/g-C3N4/PAO showed good recycling reproducibility following five cycles of adsorption. After 30 days of adsorption in natural seawater, the adsorption capacity of GO/g-C3N4/PAO for U(VI) was 10.39 mg g−1, representing a 38.6% increase compared to its performance in the absence of light. The favorable adsorption characteristics exhibited by the GO/g-C3N4/PAO composite suggest its potential as a viable option for the extraction of uranium from seawater.
- 31 July 2024
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 11 (18) , 6156-6167
Graphene oxide/graphitic carbon nitride/polyamide oxime nanofibers for adsorption and photocatalytic reduction of uranium from seawater
The advancement of the extraction of uranium(VI) (U(VI)) from seawater holds significant strategic importance for the sustainable progression of nuclear energy. In this study, the photocatalyst heterojunction of graphene oxide/graphitic carbon nitride (GO/g-C3N4) was encapsulated by the spinning of fiber to obtain a graphene oxide/graphitic carbon nitride/polyamide oxime (GO/g-C3N4/PAO) film with adsorption and photoreduction ability toward U(VI). The enhanced adsorption capacity of the GO/g-C3N4/PAO nanofiber was achieved through the synergistic effects of the aminoxime group in PAO and the photocatalytic performance of GO/g-C3N4. The GO/g-C3N4/PAO composite exhibited an adsorption capacity of 190.7 mg g−1 (pH = 6, t = 600 min, C0 = 99.9 mg L−1, and m/v = 0.5 g L−1) under light conditions. GO/g-C3N4/PAO showed good recycling reproducibility following five cycles of adsorption. After 30 days of adsorption in natural seawater, the adsorption capacity of GO/g-C3N4/PAO for U(VI) was 10.39 mg g−1, representing a 38.6% increase compared to its performance in the absence of light. The favorable adsorption characteristics exhibited by the GO/g-C3N4/PAO composite suggest its potential as a viable option for the extraction of uranium from seawater.
- Top Cited Papers
- 6 May 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 34 (32)
A Semi‐Interpenetrating Poly(Ionic Liquid) Network‐Driven Low Hysteresis and Transparent Hydrogel as a Self‐Powered Multifunctional Sensor
Conductive hydrogels are gaining significant attention as promising candidates for the fabrication materials for flexible electronics. Nevertheless, improving the tensile properties, hysteresis, durability, adhesion, and electrochemical properties of these hydrogels remains challenging. This work reports the development of a novel semi‐interpenetrating network poly(ionic liquid) hydrogel named PATV, via the in situ polymerization of acrylamide, N‐[Tris(hydroxymethyl)methyl] acrylamide, and 1‐vinyl‐3‐butylimidazolium tetrafluoroborate. The density functional theory calculations reveal that the poly(ionic liquid) in the hydrogel network acts as physical cross–linking points to construct hydrogen‐bond networks. Furthermore, the hydrogen‐bond networks dissipate energy efficiently and quickly, and thus stress concentration and hysteresis are avoided. The prepared hydrogel has a low hysteresis (9%), high tensile properties (900%), fast response (180 ms), high sensitivity (gauge factor = 10.4, pressure sensitivity = 0.14 kPa−1), and wide sensing range (tensile range: 1–600%, compression range: 0.1–20 kPa). A multifunctional sensor designed based on the designed hydrogel enables real‐time, rapid, and stable response‐ability for the detection of human movement, facial expression recognition, pronunciation, pulse, handwriting, and Morse code encryption. Furthermore, the assembled triboelectric nanogenerator displays an excellent energy harvesting capability, thus highlighting its potential application in self‐powered flexible wearable electronic devices.
- 6 May 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 34 (32)
Top Cited PapersA Semi‐Interpenetrating Poly(Ionic Liquid) Network‐Driven Low Hysteresis and Transparent Hydrogel as a Self‐Powered Multifunctional Sensor
Conductive hydrogels are gaining significant attention as promising candidates for the fabrication materials for flexible electronics. Nevertheless, improving the tensile properties, hysteresis, durability, adhesion, and electrochemical properties of these hydrogels remains challenging. This work reports the development of a novel semi‐interpenetrating network poly(ionic liquid) hydrogel named PATV, via the in situ polymerization of acrylamide, N‐[Tris(hydroxymethyl)methyl] acrylamide, and 1‐vinyl‐3‐butylimidazolium tetrafluoroborate. The density functional theory calculations reveal that the poly(ionic liquid) in the hydrogel network acts as physical cross–linking points to construct hydrogen‐bond networks. Furthermore, the hydrogen‐bond networks dissipate energy efficiently and quickly, and thus stress concentration and hysteresis are avoided. The prepared hydrogel has a low hysteresis (9%), high tensile properties (900%), fast response (180 ms), high sensitivity (gauge factor = 10.4, pressure sensitivity = 0.14 kPa−1), and wide sensing range (tensile range: 1–600%, compression range: 0.1–20 kPa). A multifunctional sensor designed based on the designed hydrogel enables real‐time, rapid, and stable response‐ability for the detection of human movement, facial expression recognition, pronunciation, pulse, handwriting, and Morse code encryption. Furthermore, the assembled triboelectric nanogenerator displays an excellent energy harvesting capability, thus highlighting its potential application in self‐powered flexible wearable electronic devices.
- 24 March 2024
- Published by Elsevier in International Journal of Biological Macromolecules
- Vol. 266 (Pt 2) , 130996
Carboxymethyl cellulose and metal-organic frameworks immobilized into polyacrylamide hydrogel for ultrahigh efficient and selective adsorption U(VI) from seawater
- 24 March 2024
- Published by Elsevier in International Journal of Biological Macromolecules
- Vol. 266 (Pt 2) , 130996
Carboxymethyl cellulose and metal-organic frameworks immobilized into polyacrylamide hydrogel for ultrahigh efficient and selective adsorption U(VI) from seawater
- 5 March 2024
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 94, 136-147
Noncovalent cross-linked engineering hydrogel with low hysteresis and high sensitivity for flexible self-powered electronics
- 5 March 2024
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 94, 136-147
Noncovalent cross-linked engineering hydrogel with low hysteresis and high sensitivity for flexible self-powered electronics