Piotr Bragiel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Piotr Bragiel has a total of 141 co-authors. Here are the top co-authors by number of shared publications:
- Michal Piasecki
Faculty of Science and Technology, Jan Długosz University, Armii Krajowej 13/15, 42-200 Czestochowa, Poland
22 shared publications - Nalluri Veeraiah
Department of Physics, Acharya Nagarjuna University, Nagarjuna Nagar, India
9 shared publications V. Ravi Kumar
7 shared publications- Marcin Nabialek
Department of Physics, Częstochowa University of Technology, 19 Armii Krajowej Av., 42-200 Częstochowa, Poland
6 shared publications - Agnieszka Łukiewska
Institute of Physics, Częstochowa University of Technology, Al. Armii Krajowej 19, 42-200 Częstochowa, Poland
5 shared publications - Jacek Olszewski
Institute of Physics, Częstochowa University of Technology, Al. Armii Krajowej 19, 42-200 Częstochowa, Poland
5 shared publications
Latest Publications
- Open Access
- 20 July 2026
- Published by Elsevier in Optical Materials: X
- Vol. 31
Refractive and vibrational properties of (NH4)3ZnCl5 crystal
- 20 July 2026
- Published by Elsevier in Optical Materials: X
- Vol. 31
Open AccessRefractive and vibrational properties of (NH4)3ZnCl5 crystal
- 19 February 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (11) , 16313-16341
Sodium silicate–CuSiO3 nanocrystal glass-ceramics for multifunctional and efficient electrical energy storage
- 19 February 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (11) , 16313-16341
Sodium silicate–CuSiO3 nanocrystal glass-ceramics for multifunctional and efficient electrical energy storage
- Open Access
- 22 September 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 129 (39) , 10193-10205
Raman, Dilatometric, and Dielectric Insights into Pr3+-Doped Pb–Sb Silicate Glasses toward Ion-Conducting Glass Electrolytes
This work reports new physical insights concerning the effect of red lead (Pb3O4) addition (10-35 mol %) on the structural, dilatometric, dielectric, and conductivity properties of Sb2O3-SiO2:Pr2O3 glasses for potential solid-state electrolyte applications. The melt-quenched glasses were scrutinized via Raman spectroscopy including a temperature-dependent evaluation revealing progressive polymerization of the glass network up to 30 mol % Pb3O4, followed by depolymerization at 35 mol %. Harmonizing with the structural evolution, thermal analysis by dilatometry showed that the thermal expansion coefficients/softening temperatures first decreased/increased from 10 to 30 mol % Pb3O4 and then increased/decreased for 35 mol % Pb3O4. The dielectric properties and ac conductivity were measured over 0.02-1 MHz and 20-240 °C. An increase in Pb3O4 from 10 to 30 mol % led to reduced dielectric constant and conductivity, which is attributed to a more compact and polymerized structure that limits ion mobility. Here, conduction is primarily polaronic, supported by mixed-valence Pb2+/Pb4+ and Sb3+/Sb5+ ions. At 35 mol % Pb3O4, network depolymerization introduced nonbridging oxygens and structural disorder, enhancing the free volume and ion migration pathways. Consequently, ionic conduction, particularly of Pb2+, becomes dominant, significantly boosting the conductivity. Although Pb2+ ions are relatively immobile compared to Li+ or Na+, the insights gained offer a foundational understanding and guide the development of similar glass systems doped with lighter and more mobile alkali ions for practical battery applications.
- 22 September 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 129 (39) , 10193-10205
Open AccessRaman, Dilatometric, and Dielectric Insights into Pr3+-Doped Pb–Sb Silicate Glasses toward Ion-Conducting Glass Electrolytes
This work reports new physical insights concerning the effect of red lead (Pb3O4) addition (10-35 mol %) on the structural, dilatometric, dielectric, and conductivity properties of Sb2O3-SiO2:Pr2O3 glasses for potential solid-state electrolyte applications. The melt-quenched glasses were scrutinized via Raman spectroscopy including a temperature-dependent evaluation revealing progressive polymerization of the glass network up to 30 mol % Pb3O4, followed by depolymerization at 35 mol %. Harmonizing with the structural evolution, thermal analysis by dilatometry showed that the thermal expansion coefficients/softening temperatures first decreased/increased from 10 to 30 mol % Pb3O4 and then increased/decreased for 35 mol % Pb3O4. The dielectric properties and ac conductivity were measured over 0.02-1 MHz and 20-240 °C. An increase in Pb3O4 from 10 to 30 mol % led to reduced dielectric constant and conductivity, which is attributed to a more compact and polymerized structure that limits ion mobility. Here, conduction is primarily polaronic, supported by mixed-valence Pb2+/Pb4+ and Sb3+/Sb5+ ions. At 35 mol % Pb3O4, network depolymerization introduced nonbridging oxygens and structural disorder, enhancing the free volume and ion migration pathways. Consequently, ionic conduction, particularly of Pb2+, becomes dominant, significantly boosting the conductivity. Although Pb2+ ions are relatively immobile compared to Li+ or Na+, the insights gained offer a foundational understanding and guide the development of similar glass systems doped with lighter and more mobile alkali ions for practical battery applications.
- 11 April 2025
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 348
TlInP2Se6 single crystal: Electronic, optical and vibrational properties
- 11 April 2025
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 348
TlInP2Se6 single crystal: Electronic, optical and vibrational properties
- 26 October 2020
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
- Vol. 235 (9) , 1129-1175
Non-linear optical properties of polystyrene and polyvinyl alcohol composites with 4-methoxy-1-naphthol
The analysis of the NLO properties of 4-methoxy-1-naphthol (4M1N) reveals that this molecule has the value of polarizability tensor, α, more than 340% greater than that obtained, at the same level of theory, for urea molecule. This improvement grows to 500% when the second-order hyperpolarizability is considered. Calculations performed within LR-PCM-B3LYP/6-311+G(3d,2p) model proved that embedding of 4M1N in the polymer matrix significantly improved these results suggesting applications of 4M1N as the cheap and effective NLO material. The molecule was also studied, both theoretically and experimentally, to determine its full vibrational characterisation and structural description. Calculations were performed with HF, MP2, SVWN and B3LYP methods, in two, varying in size, basis sets, to find optimized structures, conformational isomers and UV–VIS, IR and Raman spectra. The accordance of simulated oscillation and absorption spectra with experimental ones is very good; IR values are slightly red-shifted. NBO charge distribution analysis was made to generate frontier orbitals and find most reactive parts of the molecule.
- 26 October 2020
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
- Vol. 235 (9) , 1129-1175
Non-linear optical properties of polystyrene and polyvinyl alcohol composites with 4-methoxy-1-naphthol
The analysis of the NLO properties of 4-methoxy-1-naphthol (4M1N) reveals that this molecule has the value of polarizability tensor, α, more than 340% greater than that obtained, at the same level of theory, for urea molecule. This improvement grows to 500% when the second-order hyperpolarizability is considered. Calculations performed within LR-PCM-B3LYP/6-311+G(3d,2p) model proved that embedding of 4M1N in the polymer matrix significantly improved these results suggesting applications of 4M1N as the cheap and effective NLO material. The molecule was also studied, both theoretically and experimentally, to determine its full vibrational characterisation and structural description. Calculations were performed with HF, MP2, SVWN and B3LYP methods, in two, varying in size, basis sets, to find optimized structures, conformational isomers and UV–VIS, IR and Raman spectra. The accordance of simulated oscillation and absorption spectra with experimental ones is very good; IR values are slightly red-shifted. NBO charge distribution analysis was made to generate frontier orbitals and find most reactive parts of the molecule.
- 1 April 2018
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 38 (4) , 2010-2016
Positron annihilation exploration of voids in zinc zirconium borate glass ceramics entrenched with ZnZrO3 perovskite crystal phases
- 1 April 2018
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 38 (4) , 2010-2016
Positron annihilation exploration of voids in zinc zirconium borate glass ceramics entrenched with ZnZrO3 perovskite crystal phases
- 1 February 2018
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1154, 27-38
Structural, spectroscopic and NLO features of the 4-chloro-1-naphthol
- 1 February 2018
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1154, 27-38
Structural, spectroscopic and NLO features of the 4-chloro-1-naphthol
- Open Access
- 20 December 2017
- Published by Walter de Gruyter GmbH in Materials Science-Poland
- Vol. 35 (4) , 760-766
Are the phosphorus-rich Na2O–CaO–B2O3–SiO2–P2O5glasses bioactive and what is an influence of doping with manganese oxide?
A series of glasses of the composition 20Na2-O-15CaO-5B2O3-5SiO2-(55 - x) P2O5:xMnO2, was prepared and characterized by XRD, DSC, SEM, and Raman techniques. The samples were later immersed in simulated body fluid (SBF) for checking the potential growth of hydroxyapatite layer (HA). Experiments confirmed that addition of manganese oxide leads to structural changes of the glasses. With increasing content of MnO2, the surface of the samples became more congenial for improving the growth of HA. The formation of HA layer on the surface of the samples was confirmed just after seven days of immersion. The growth rate of HA has gradually increased with the increase of MnO2content.
- 20 December 2017
- Published by Walter de Gruyter GmbH in Materials Science-Poland
- Vol. 35 (4) , 760-766
Open AccessAre the phosphorus-rich Na2O–CaO–B2O3–SiO2–P2O5glasses bioactive and what is an influence of doping with manganese oxide?
A series of glasses of the composition 20Na2-O-15CaO-5B2O3-5SiO2-(55 - x) P2O5:xMnO2, was prepared and characterized by XRD, DSC, SEM, and Raman techniques. The samples were later immersed in simulated body fluid (SBF) for checking the potential growth of hydroxyapatite layer (HA). Experiments confirmed that addition of manganese oxide leads to structural changes of the glasses. With increasing content of MnO2, the surface of the samples became more congenial for improving the growth of HA. The formation of HA layer on the surface of the samples was confirmed just after seven days of immersion. The growth rate of HA has gradually increased with the increase of MnO2content.