Shin-Ichi Machida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shin-Ichi Machida has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
Hisao Ishii
12 shared publicationsYasuo Nakayama
9 shared publications- Yasuo Nakayama
Chiba University
6 shared publications - Hisao Ishii
Graduate School of Science and Engineering Chiba University Chiba 263‐8522 Japan
5 shared publications Yutaka Noguchi
Graduate School of Advanced Integration Science, Chiba University 1–33 Yayoi‐cho Inage‐ku Chiba 263–8522 Japan
5 shared publicationsHiroumi Kinjo
4 shared publications
Latest Publications
- 22 December 2017
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 20 (3) , 1373-1380
Energy level diagram of HC(NH2)2PbI3 single crystal evaluated by electrical and optical analyses
Energy level diagram of the HC(NH2)2PbI3 single crystal evaluated in this study.
- 22 December 2017
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 20 (3) , 1373-1380
Energy level diagram of HC(NH2)2PbI3 single crystal evaluated by electrical and optical analyses
Energy level diagram of the HC(NH2)2PbI3 single crystal evaluated in this study.
- 4 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (1) , 229-235
A 2.1-Mpixel Organic Film-Stacked RGB-IR Image Sensor With Electrically Controllable IR Sensitivity
This paper describes an RGB-infrared (IR) organic CMOS image sensor with electrically controllable IR sensitivity. The sensitivities of all the pixels in the image sensor, which has the structure of two directly stacked organic layers with a high resistance ratio, are simultaneously controlled by changing the applied voltage to the organic films. The fabricated image sensor, with a pixel pitch of 3 μm, has 2.1 Mpixels (1920 x 1080) in both the RGB and IR regions. The sensor can switch between color imaging and IR imaging modes frame by frame without requiring a mechanically retractable IR-cut filter.
- 4 December 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 53 (1) , 229-235
A 2.1-Mpixel Organic Film-Stacked RGB-IR Image Sensor With Electrically Controllable IR Sensitivity
This paper describes an RGB-infrared (IR) organic CMOS image sensor with electrically controllable IR sensitivity. The sensitivities of all the pixels in the image sensor, which has the structure of two directly stacked organic layers with a high resistance ratio, are simultaneously controlled by changing the applied voltage to the organic films. The fabricated image sensor, with a pixel pitch of 3 μm, has 2.1 Mpixels (1920 x 1080) in both the RGB and IR regions. The sensor can switch between color imaging and IR imaging modes frame by frame without requiring a mechanically retractable IR-cut filter.
- 6 March 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 78-79
4.7 A 2.1Mpixel organic-film stacked RGB-IR image sensor with electrically controllable IR sensitivity
The use of infrared (IR) imaging to view scenes otherwise invisible to the human eye, simultaneously with visible-spectrum imaging, is increasingly of interest for various applications for such as in-vehicle, surveillance, and agricultural security cameras. The loss of spatial resolution in conventional RGB-IR sensors causes aliasing, because IR pixels are segmented within the provided effective pixel area [1,2]. 3-D stacking of photodiode arrays has been reported as another strategy for RGB-IR capture [3]; however, the need for bonding accuracy limits pixel size. Silicon's weak IR light absorptivity also results in relatively lower IR sensitivity on the part of these image sensors.
- 6 March 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 78-79
4.7 A 2.1Mpixel organic-film stacked RGB-IR image sensor with electrically controllable IR sensitivity
The use of infrared (IR) imaging to view scenes otherwise invisible to the human eye, simultaneously with visible-spectrum imaging, is increasingly of interest for various applications for such as in-vehicle, surveillance, and agricultural security cameras. The loss of spatial resolution in conventional RGB-IR sensors causes aliasing, because IR pixels are segmented within the provided effective pixel area [1,2]. 3-D stacking of photodiode arrays has been reported as another strategy for RGB-IR capture [3]; however, the need for bonding accuracy limits pixel size. Silicon's weak IR light absorptivity also results in relatively lower IR sensitivity on the part of these image sensors.
- 1 December 2014
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 197, 17-21
Maximum probing depth of low-energy photoelectrons in an amorphous organic semiconductor film
- 1 December 2014
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 197, 17-21
Maximum probing depth of low-energy photoelectrons in an amorphous organic semiconductor film
- 19 November 2014
- Published by Springer Nature
- p. 131-155
Photoelectron Yield Spectroscopy for Organic Materials and Interfaces
- 19 November 2014
- Published by Springer Nature
- p. 131-155
Photoelectron Yield Spectroscopy for Organic Materials and Interfaces
- 9 May 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (19)
Erratum: Interfacial properties at the organic-metal interface probed using quantum well states [Phys. Rev. B86, 155453 (2012)]
DOI: http://dx.doi.org/10.1103/PhysRevB.89.199902Published 9 May 2014Received 1 May 2014©2014 American Physical Society
- 9 May 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (19)
Erratum: Interfacial properties at the organic-metal interface probed using quantum well states [Phys. Rev. B86, 155453 (2012)]
DOI: http://dx.doi.org/10.1103/PhysRevB.89.199902Published 9 May 2014Received 1 May 2014©2014 American Physical Society
- 31 December 2013
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 53 (1S) , 01AD03
Determination of the highest occupied molecular orbital energy of pentacene single crystals by ultraviolet photoelectron and photoelectron yield spectroscopies
The electronic structures of pentacene single crystals (SCs) were elucidated by ultraviolet photoelectron spectroscopy (UPS) and photoelectron yield spectroscopy (PYS). An asymmetric HOMO peak profile of the pentacene SCs obtained by UPS exhibits a close similarity to the k-projected density-of-states of the valence band that has been predicted by a theoretical calculation [H. Yoshida and N. Sato, Phys. Rev. B 77, 235205 (2008)]. The ionization energy of the pentacene SCs is successfully determined to be 4.95 (± 0.03) eV which is evidently greater than that of the bulk films of pentacene [4.90 (± 0.02) eV].
- 31 December 2013
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 53 (1S) , 01AD03
Determination of the highest occupied molecular orbital energy of pentacene single crystals by ultraviolet photoelectron and photoelectron yield spectroscopies
The electronic structures of pentacene single crystals (SCs) were elucidated by ultraviolet photoelectron spectroscopy (UPS) and photoelectron yield spectroscopy (PYS). An asymmetric HOMO peak profile of the pentacene SCs obtained by UPS exhibits a close similarity to the k-projected density-of-states of the valence band that has been predicted by a theoretical calculation [H. Yoshida and N. Sato, Phys. Rev. B 77, 235205 (2008)]. The ionization energy of the pentacene SCs is successfully determined to be 4.95 (± 0.03) eV which is evidently greater than that of the bulk films of pentacene [4.90 (± 0.02) eV].
- 4 December 2013
- Published by Wiley in Advanced Energy Materials
- Vol. 4 (7) , 1301354
Complete Demonstration of the Valence Electronic Structure Inside a Practical Organic Solar Cell Probed by Low Energy Photoemission
The complete electronic structure inside a practical organic photovoltaic (OPV) device consisting of a trilayer structure of copper‐phthalocyanine (CuPc), fullerene (C60), and bathocuproine (BCP) is demonstrated using low‐energy ultraviolet photoelectron spectroscopy (LE‐UPS) and photoelectron yield spectroscopy (PYS). The molecular orbital energy alignment and electrostatic potential distribution throughout the entire device is illustrated based on the LE‐UPS results. A favorable potential gradient to carry the photogenerated holes and electrons is manifested to be built spontaneously in the CuPc and BCP layers, respectively. Furthermore, the ultrahigh sensitivity measurements of LE‐UPS clearly unveil the distributions of faint density‐of‐states in the energy‐gap region in the organic films. Substantially barrierless contacts to both electrodes are fulfilled by the existence of these gap states. The electronic structure under simulated sunlight illumination is examined for the purpose of elucidating the electronic structures inside the working devices in the open‐circuit condition. These results indicate experimentally the electronic functionalities of each organic material, in particular of the BCP buffer layer, on the cell efficiency.
- 4 December 2013
- Published by Wiley in Advanced Energy Materials
- Vol. 4 (7) , 1301354
Complete Demonstration of the Valence Electronic Structure Inside a Practical Organic Solar Cell Probed by Low Energy Photoemission
The complete electronic structure inside a practical organic photovoltaic (OPV) device consisting of a trilayer structure of copper‐phthalocyanine (CuPc), fullerene (C60), and bathocuproine (BCP) is demonstrated using low‐energy ultraviolet photoelectron spectroscopy (LE‐UPS) and photoelectron yield spectroscopy (PYS). The molecular orbital energy alignment and electrostatic potential distribution throughout the entire device is illustrated based on the LE‐UPS results. A favorable potential gradient to carry the photogenerated holes and electrons is manifested to be built spontaneously in the CuPc and BCP layers, respectively. Furthermore, the ultrahigh sensitivity measurements of LE‐UPS clearly unveil the distributions of faint density‐of‐states in the energy‐gap region in the organic films. Substantially barrierless contacts to both electrodes are fulfilled by the existence of these gap states. The electronic structure under simulated sunlight illumination is examined for the purpose of elucidating the electronic structures inside the working devices in the open‐circuit condition. These results indicate experimentally the electronic functionalities of each organic material, in particular of the BCP buffer layer, on the cell efficiency.
- 1 July 2013
- Published by Elsevier in Organic Electronics
- Vol. 14 (7) , 1825-1832
Valence band structure of rubrene single crystals in contact with an organic gate dielectric
- 1 July 2013
- Published by Elsevier in Organic Electronics
- Vol. 14 (7) , 1825-1832
Valence band structure of rubrene single crystals in contact with an organic gate dielectric
- 1 February 2013
- Published by IOP Publishing in Applied Physics Express
- Vol. 6 (2) , 025801
Low-Energy Photoemission Study of C60/Rubrene/Au Interfaces in Practical Device Thickness
Low-energy photoelectron spectroscopy combined with photoelectron yield spectroscopy was developed to investigate the buried organic interfaces in the practical device thickness. Ultralow background signal and charging durability were achieved by utilizing monochromatic low-energy photons. C60/rubrene/Au interfaces were studied as a prototypical system of organic solar cells. The low density of gap states was detected in the rubrene film and a small feature due to the C60-induced morphological change was observed in the C60/rubrene interface.
- 1 February 2013
- Published by IOP Publishing in Applied Physics Express
- Vol. 6 (2) , 025801
Low-Energy Photoemission Study of C60/Rubrene/Au Interfaces in Practical Device Thickness
Low-energy photoelectron spectroscopy combined with photoelectron yield spectroscopy was developed to investigate the buried organic interfaces in the practical device thickness. Ultralow background signal and charging durability were achieved by utilizing monochromatic low-energy photons. C60/rubrene/Au interfaces were studied as a prototypical system of organic solar cells. The low density of gap states was detected in the rubrene film and a small feature due to the C60-induced morphological change was observed in the C60/rubrene interface.