AKAnna Kiełbus-Rąpała

Anna Kiełbus-Rąpała

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Anna Kiełbus-Rąpała has a total of 3 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of different factors on momentum transfer in mechanically agitated multiphase systems

    by Magdalena Cudak, Anna Kiełbus-Rąpała, Marta Major-Godlewska, Joanna Karcz

    A comparative analysis concerning the influence of different factors on momentum transfer in mechanically agitated systems was carried out on the basis of experimental results for solid-liquid, gas-liquid and gas-solid-liquid systems. The effects of the impeller - baffles system geometry, scale of the agitated vessel, type and number of impellers and their off-bottom clearance, as well as physical properties of the multiphase systems on the critical impeller speeds needed to produce suspension or dispersion, power consumption and gas hold-up were analysed and evaluated.


  • Experimental analysis of the hydrodynamics of a three-phase system in a vessel with two impellers

    by Anna Kiełbus-Rąpała, Joanna Karcz

    Results of experimental analysis concerning gas hold-up and average residence time of gas bubbles in a three-phase gas-solid-liquid system produced in a baffled, double-impeller vessel are presented. Measurements were carried out in a vessel with the internal diameter of 0.288 m. Two different double-impeller configurations were used for agitation: Rushton turbine (lower) — A 315 (upper) and Rushton turbine (lower) — HE 3 (upper). Upper impellers differed in the fluid pumping mode. Coalescing and non-coalescing systems were tested. Liquid phases were distilled water (coalescing system) and aqueous solutions of NaCl (non-coalescing systems). The ability of gas bubbles to coalesce in the liquid was described using parameter Y. Dispersed phases were air and particles of sea sand. The experiments were conducted at seven different gas flow rates and two particle loadings. Effects of the ability of gas bubbles to coalesce (liquid phase properties), operating parameters (superficial gas velocity, impeller speed, solids loadings), and of the type of the impeller configuration on the investigated parameters were determined. The results were approximated mathematically. For both impeller configurations tested, significantly higher gas hold-up values were obtained in the non-coalescing gas-solid-liquid systems compared to the coalescing one. Out of the tested impeller systems, the RT-A 315 configuration proved to have better performance ensuring good gas dispersion in the liquid in the three-phase systems.


  • The effect of the physical properties of the liquid phase on the gas-liquid mass transfer coefficient in two- and three-phase agitated systems

    by Anna Kiełbus-Rąpała, Joanna Karcz, Magdalena Cudak

    The results of studies concerning two- and three-phase systems in an agitated vessel are presented. The aim of our research was to investigate the effect of the physical properties of the liquid phase on the value of the volumetric gas-liquid mass transfer coefficient in mechanically agitated gas-liquid and gas-solid-liquid systems. Our experimental studies were conducted in a vessel with an internal diameter of 0.288 m. The flat bottom vessel, equipped with four baffles, was filled with liquid up to a height equal to the inner diameter. The liquid volume was 0.02 m3. Three high-speed impellers of a diameter equal to 0.33 of the vessel diameter were used: Rushton turbine (RT), Smith turbine (CD 6), or A 315 impeller. The measurements were carried out in coalescing and non-coalescing systems. Distilled water and aqueous solutions of an electrolyte (sodium chloride) of two different concentrations were used as the liquid phase. The gas phase was air. In the three-phase system, particles of sea sand were used as solid phase. The measurements were conducted at five different gas-flow rates and three particle loadings. Volumetric gas-liquid mass transfer coefficients were measured using the dynamic method. The presence and concentration of an electrolyte strongly affected the value of the gas-liquid mass transfer coefficient in both two- and three-phase systems. For all agitators used, significantly higher k l a coefficient values were obtained in the 0.4 kmol m−3 and 0.8 kmol m−3 aqueous NaCl solutions compared with the data for a coalescing system (with distilled water as the liquid phase). The k l a coefficient did not exhibit a linear relationship with the electrolyte concentration. An increase in the sodium chloride concentration from 0.4 kmol m−3 to 0.8 kmol m−3 caused a considerable decrease in the volumetric mass transfer coefficient in both the two-phase and three-phase systems. It was concluded that the mass transfer processes improved at a certain concentration of ions; however, above this concentration no further increase in k l a could be achieved.


  • Transport phenomena in an agitated vessel with an eccentrically located impeller

    by Magdalena Cudak, Joanna Karcz, Anna Kiełbus-Rąpała

    The paper presents results of an experimental analysis of the transport phenomena at the vicinity of the wall of an unbaffled agitated vessel with an eccentrically located impeller. Distributions of the transport coefficients were experimentally studied using an electrochemical method within the turbulent regime of the Newtonian liquid flow. Measurements were carried out in an agitated vessel with the inner diameter T = 0.3 m. Liquid height in the vessel was equal to the inner diameter, H = T. The agitated vessel was equipped with a Rushton or a Smith turbine or an A 315 impeller. Eccentricity of the impeller shaft was varied from 0 to 0.53. Local values of the dimensionless shear rate, shear stress, dynamic velocity and friction coefficient were integrated numerically for the whole surface area of the cylindrical wall of the vessel. Averaged values of these quantities were correlated with the impeller eccentricity and modified Reynolds number. The proposed Eqs. (5)–(8), with the coefficients given in Table 2, have no equivalent in open literature concerning this subject. Distributions of the shear rate, γ/n, and friction coefficient, f, at the vicinity of the cylindrical wall of the unbaffled vessel equipped with eccentric Rushton or Smith turbine or A 315 impeller are very uneven and they depend significantly on the impeller eccentricity, e/R. Maximum local values of these variables are located on the wall section closest to the impeller blades. From among the tested impellers, the greatest effects of the impeller eccentricity, e/R, and the liquid turbulence (described by the modified Reynolds number Re P,M) on the averaged dimensionless shear rate (γ/n)m and friction coefficient, f m, are found for the radial-flow Rushton turbine located eccentrically in an unbaffled agitated vessel.


  • Solid suspension and gas dispersion in gas-solid-liquid agitated systems

    by Anna Kiełbus-Rąpała, Joanna Karcz

    The aim of the research work was to investigate the effect of superficial gas velocity and solids concentration on the critical agitator speed, gas hold-up and averaged residence time of gas bubbles in an agitated gas-solid-liquid system. Experimental studies were conducted in a vessel of the inner diameter of 0.634 m. Different high-speed impellers: Rushton and Smith turbines, A 315 and HE 3 impellers, were used for agitation. The measurements were conducted in systems with different physical parameters of the continuous phase. Liquid phases were: distilled water (coalescing system) or aqueous solutions of NaCl (non-coalescing systems). The experiments were carried out at five different values of solids concentration and gas flow rate. Experimental analysis of the conditions of gas bubbles dispersion and particles suspension in the vessel with a flat bottom and four standard baffles showed that both gas and solid phases strongly affected the critical agitation speed necessary to produce a three-phase system. On the basis of experimental studies, the critical agitator speed for all agitators working in the gas-solid-liquid systems was found. An increase of superficial gas velocity caused a significant increase of the gas hold-up in both coalescing and non-coalescing three-phase systems. The type of the impeller strongly affected the parameters considered in this work. Low values of the critical impeller speed together with the relatively short average gas bubbles residence time tR in three phase systems were characteristic for the A 315 impeller. Radial flow Rushton and Smith turbines are high-energy consuming impellers but they enable to maintain longer gas bubbles residence time and to obtain higher values of the gas hold-up in the three-phase systems. Empirical correlations were proposed for the critical agitator speed, mean specific energy dissipated and the gas hold-up prediction. Its parameters were fitted using experimental data.


  • Influence of suspended solid particles on gas-liquid mass transfer coefficient in a system stirred by double impellers

    by Anna Kiełbus-Rąpała, Joanna Karcz

    The aim of the research work was to investigate the effect of the presence and concentration of solid particles on the gas-liquid volumetric mass transfer coefficient in a mechanically stirred gas-solid-liquid system. Experimental studies were conducted in a tall vessel of the diameter of 0.288 m, equipped with two designs of double stirrers. Three high-speed stirrers were used: A 315, Smith turbine, and Rushton turbine. The following operating parameters were changed: gas flow rate, stirrer speed, and solid concentration. The volumetric mass transfer coefficient was determined using the dynamic gassing-out method. In the range of the measurements conducted, this coefficient was strongly affected by both the presence and the concentration of particles in the system. Generally, a low concentration of particles in the system, equal to 0.5 mass %, caused an increase of the volumetric mass transfer coefficient values for both stirrer configurations compared to a system without solids whilst more particles (2.5 mass %) caused a decrease of this coefficient. It could be supposed that an increase of slurry viscosity affected the decrease of the volumetric mass transfer coefficient at higher solid concentration. An empirical correlation was proposed for volumetric mass transfer coefficient prediction. Its parameters were fitted using experimental data.