Jafar Al-Hakkak
Research Subjects
Jafar Al-Hakkak has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Neil R. Edmonds
University of Auckland
4 shared publications- Warren James Grigsby
Manufacturing and Bioproducts, Scion, Rotorua 3010, New Zealand
4 shared publications Chunhua Luo
National Laboratory for Infrared Physics; Shanghai Institute of Technical Physics, Chinese Academy of Sciences, Shanghai, China, and Department of Chemistry, University of Auckland; New Zealand
3 shared publicationsKalyani Kathirgamanathan
University of Auckland
2 shared publicationsAfsaneh Alishahi
1 shared publicationAllan Easteal
Department of Chemistry, University of Auckland, Auckland, New Zealand
1 shared publication
Latest Publications
- 5 September 2017
- Published by Springer Nature in Cellulose
- Vol. 24 (11) , 5261-5265
Molecular weight fractionation of high polydispersity native celluloses
- 5 September 2017
- Published by Springer Nature in Cellulose
- Vol. 24 (11) , 5261-5265
Molecular weight fractionation of high polydispersity native celluloses
- Open Access
- 1 January 2015
- Published by Wiley in International Journal of Polymer Science
- Vol. 2015, 1-9
Two-Dimensional FTIR as a Tool to Study the Chemical Interactions within Cellulose-Ionic Liquid Solutions
In this study two-dimensional FTIR analysis was applied to understand the temperature effects on processing cellulose solutions in imidazolium-based ionic liquids. Analysis of the imidazolium ionνC2–H peak revealed hydrogen bonding within cellulose solutions to be dynamic on heating and cooling. The extent of hydrogen bonding was stronger on heating, consistent with greater ion mobility at higher temperature when the ionic liquid network structure is broken. At ambient temperatures a blue shiftedνC2–H peak was indicative of greater cation-anion interactions, consistent with the ionic liquid network structure. Both cellulose and water further impact the extent of hydrogen bonding in these solutions. The FTIR spectral changes appeared gradual with temperature and contrast shear induced rheology changes which were observed on heating above 70°C and cooling below 40°C. The influence of cellulose on solution viscosity was not distinguished on initial heating as the ionic liquid network structure dominates rheology behaviour. On cooling, the quantity of cellulose has a greater influence on solution rheology. Outcomes suggest processing cellulose in ionic liquids above 40°C and to reduce the impacts of cation-anion effects and enhance solubilisation, processing should be done at 70°C.
- 1 January 2015
- Published by Wiley in International Journal of Polymer Science
- Vol. 2015, 1-9
Open AccessTwo-Dimensional FTIR as a Tool to Study the Chemical Interactions within Cellulose-Ionic Liquid Solutions
In this study two-dimensional FTIR analysis was applied to understand the temperature effects on processing cellulose solutions in imidazolium-based ionic liquids. Analysis of the imidazolium ionνC2–H peak revealed hydrogen bonding within cellulose solutions to be dynamic on heating and cooling. The extent of hydrogen bonding was stronger on heating, consistent with greater ion mobility at higher temperature when the ionic liquid network structure is broken. At ambient temperatures a blue shiftedνC2–H peak was indicative of greater cation-anion interactions, consistent with the ionic liquid network structure. Both cellulose and water further impact the extent of hydrogen bonding in these solutions. The FTIR spectral changes appeared gradual with temperature and contrast shear induced rheology changes which were observed on heating above 70°C and cooling below 40°C. The influence of cellulose on solution viscosity was not distinguished on initial heating as the ionic liquid network structure dominates rheology behaviour. On cooling, the quantity of cellulose has a greater influence on solution rheology. Outcomes suggest processing cellulose in ionic liquids above 40°C and to reduce the impacts of cation-anion effects and enhance solubilisation, processing should be done at 70°C.
- 1 December 2014
- Published by Elsevier in Journal of Food Engineering
- Vol. 142, 138-145
Effect of mixing speed and time on some textural and physicochemical properties of wheat starch gels
- 1 December 2014
- Published by Elsevier in Journal of Food Engineering
- Vol. 142, 138-145
Effect of mixing speed and time on some textural and physicochemical properties of wheat starch gels
- 6 June 2013
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 299 (1) , 65-74
Rubber-Like Materials Prepared from Copolymerization of Tannin Fatty Acid Conjugates and Vegetable Oils
- 6 June 2013
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 299 (1) , 65-74
Rubber-Like Materials Prepared from Copolymerization of Tannin Fatty Acid Conjugates and Vegetable Oils
- 1 February 2013
- Published by Elsevier in Acta Biomaterialia
- Vol. 9 (2) , 5226-5233
Vegetable oil thermosets reinforced by tannin–lipid formulations
- 1 February 2013
- Published by Elsevier in Acta Biomaterialia
- Vol. 9 (2) , 5226-5233
Vegetable oil thermosets reinforced by tannin–lipid formulations
- 1 September 2010
- Published by Elsevier in Journal of Food Engineering
- Vol. 100 (1) , 152-159
Functional egg white–pectin conjugates prepared by controlled Maillard reaction
- 1 September 2010
- Published by Elsevier in Journal of Food Engineering
- Vol. 100 (1) , 152-159
Functional egg white–pectin conjugates prepared by controlled Maillard reaction
- 30 March 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 117 (1) , 352-360
Synthesis, characterization, and thermal behaviors of tannin stearates prepared from quebracho and pine bark extracts
Reported is the preparation of various condensed tannin stearates and the associated chemical characterization and thermal properties of these products. Stearate esters of condensed tannins from both quebracho and pine bark extracts were prepared in generally high, isolated yields from reaction with stearic acid chloride. Tannin esterification was confirmed by both Fourier transform infrared and nuclear magnetic resonance (NMR), and the average degree of stearate substitution was calculated from 1H‐NMR analysis. Product degree of substitution (DS) was observed to proportionately increase with higher stearic acid chloride ratio with maximum DS values of 4.0 and 5.1 achieved for quebracho and pine tannins, respectively. Thermal analysis revealed that tannin stearate products have increased thermal stability with a degradation onset at significantly higher temperature for those samples possessing relatively greater DS. Analysis using differential scanning calorimetry revealed isolated products to consist of multiple components which exhibit interesting melt behaviors, a likely result from their work up on isolation. However, multiple melt features of the individual components in products were lost on heating to give single, broad melt endotherms due to coalescence of sample components. Furthermore, tannin stearate samples with high DS show relatively greater endothermic melting at higher temperature than those samples with lower DS. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 30 March 2010
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 117 (1) , 352-360
Synthesis, characterization, and thermal behaviors of tannin stearates prepared from quebracho and pine bark extracts
Reported is the preparation of various condensed tannin stearates and the associated chemical characterization and thermal properties of these products. Stearate esters of condensed tannins from both quebracho and pine bark extracts were prepared in generally high, isolated yields from reaction with stearic acid chloride. Tannin esterification was confirmed by both Fourier transform infrared and nuclear magnetic resonance (NMR), and the average degree of stearate substitution was calculated from 1H‐NMR analysis. Product degree of substitution (DS) was observed to proportionately increase with higher stearic acid chloride ratio with maximum DS values of 4.0 and 5.1 achieved for quebracho and pine tannins, respectively. Thermal analysis revealed that tannin stearate products have increased thermal stability with a degradation onset at significantly higher temperature for those samples possessing relatively greater DS. Analysis using differential scanning calorimetry revealed isolated products to consist of multiple components which exhibit interesting melt behaviors, a likely result from their work up on isolation. However, multiple melt features of the individual components in products were lost on heating to give single, broad melt endotherms due to coalescence of sample components. Furthermore, tannin stearate samples with high DS show relatively greater endothermic melting at higher temperature than those samples with lower DS. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
- 28 March 2007
- Published by Wiley in Starch - Stärke
- Vol. 59 (3-4) , 117-124
New Non‐destructive Method using Gluten to Isolate Starch from Plant Materials other than Wheat
A new non‐destructive patented method for separating starch of high purity from plant flour or “comminutates” (fine particles) is described. The method can be applied to all plant materials that have a mixture of starch and protein in their flour, including cereals such as barley, oats and rye; legumes such as peas, chickpeas and lentils; and seeds such as amaranths. The basic principle of the method is to add wheat gluten to the desired plant flour in a ratio of 10–20% (w/w) gluten/flour. Water is then added to the mixture. Upon hydration, wheat protein aggregates, and a gluten network is formed when the mixture is kneaded. This gluten network is stabilised by the disulfide bonds and other bonds that form between the protein and other flour material. The dough is left to prove for 1 h to allow protein agglomeration to proceed. The starch is then washed out of the mixed protein network with water and the suspension is separated from the protein mass with bolt cloth. The starch is recovered by centrifugation and air dried, freeze‐dried or oven dried. The method is versatile and effective in producing starch of high purity. Furthermore, the technique has already been used to separate wheat starch on an industrial scale. After experimenting with adding salt, ascorbic acid, and various percentages of gluten, we conclude that when using 18% gluten and 3% salt a good yield of starch of acceptable purity can be isolated by this method, whilst ascorbic acid does not noticeably improve yield.
- 28 March 2007
- Published by Wiley in Starch - Stärke
- Vol. 59 (3-4) , 117-124
New Non‐destructive Method using Gluten to Isolate Starch from Plant Materials other than Wheat
A new non‐destructive patented method for separating starch of high purity from plant flour or “comminutates” (fine particles) is described. The method can be applied to all plant materials that have a mixture of starch and protein in their flour, including cereals such as barley, oats and rye; legumes such as peas, chickpeas and lentils; and seeds such as amaranths. The basic principle of the method is to add wheat gluten to the desired plant flour in a ratio of 10–20% (w/w) gluten/flour. Water is then added to the mixture. Upon hydration, wheat protein aggregates, and a gluten network is formed when the mixture is kneaded. This gluten network is stabilised by the disulfide bonds and other bonds that form between the protein and other flour material. The dough is left to prove for 1 h to allow protein agglomeration to proceed. The starch is then washed out of the mixed protein network with water and the suspension is separated from the protein mass with bolt cloth. The starch is recovered by centrifugation and air dried, freeze‐dried or oven dried. The method is versatile and effective in producing starch of high purity. Furthermore, the technique has already been used to separate wheat starch on an industrial scale. After experimenting with adding salt, ascorbic acid, and various percentages of gluten, we conclude that when using 18% gluten and 3% salt a good yield of starch of acceptable purity can be isolated by this method, whilst ascorbic acid does not noticeably improve yield.
- 1 November 2002
- Published by Elsevier in International Congress Series
- Vol. 1245, 491-499
Improvement of emulsification properties of sodium caseinate by conjugating to pectin through the Maillard reaction
- 1 November 2002
- Published by Elsevier in International Congress Series
- Vol. 1245, 491-499
Improvement of emulsification properties of sodium caseinate by conjugating to pectin through the Maillard reaction
- 1 July 2002
- Published by Springer Nature in Euphytica
- Vol. 126 (1) , 135-142
Amylase, falling number, polysaccharide, protein and ash relationships in wheat millstreams
- 1 July 2002
- Published by Springer Nature in Euphytica
- Vol. 126 (1) , 135-142
Amylase, falling number, polysaccharide, protein and ash relationships in wheat millstreams