Elsadig. O. Eltai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Elsadig. O. Eltai has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
E.V. Koroleva
3 shared publicationsJ.D. Scantlebury
3 shared publicationsE. Mahdi
2 shared publicationsA. Al-Ryashi
Qatar University
1 shared publication- A. Rauf1 shared publication
- Abdel Magid Salem Hamouda
College of Engineering, Qatar University, Doha, Qatar
1 shared publication
Latest Publications
- Open Access
Towards the Development of Novel Hybrid Composite Steel Pipes: Electrochemical Evaluation of Fiber-Reinforced Polymer Layered Steel against Corrosion
Corrosion remains one of the major and most costly challenges faced by the steel industry. Various fiber-reinforced polymer coating systems have been proposed to protect metallic piping distribution networks against corrosion. Despite increasing interest among scientific and industrial communities, there is only limited predictive capability for selecting the optimum composite system for a given corrosive condition. In this study, we present a comprehensive evaluation of the electrochemical behavior of two different fiber-reinforced polymer composite systems against the corrosion of carbon steel pipes under a wide range of acidic and corrosive solutions. The composites were made of glass and Kevlar fibers with an epoxy resin matrix and were subjected to corrosive solutions of 0.5 M NaCl, 0.5 M HCl, and 0.5 M H2SO4. The kinetics of the corrosion reactions were evaluated using potentiodynamic polarization (PDP) tests. In addition, electrochemical impedance spectroscopy (EIS) tests were carried out at open circuit potentials (OCPs). It was demonstrated that the glass fiber-reinforced polymer coating system offered the best protection against corrosion, with a high stability against deterioration when compared with epoxy and Kevlar fiber-reinforced polymer coating systems. Scanning electron microscopy images revealed cracks and deteriorated embedded fibers due to acid attack, sustained/assisted by the diffusion of the corrosion species.
Open AccessTowards the Development of Novel Hybrid Composite Steel Pipes: Electrochemical Evaluation of Fiber-Reinforced Polymer Layered Steel against Corrosion
Corrosion remains one of the major and most costly challenges faced by the steel industry. Various fiber-reinforced polymer coating systems have been proposed to protect metallic piping distribution networks against corrosion. Despite increasing interest among scientific and industrial communities, there is only limited predictive capability for selecting the optimum composite system for a given corrosive condition. In this study, we present a comprehensive evaluation of the electrochemical behavior of two different fiber-reinforced polymer composite systems against the corrosion of carbon steel pipes under a wide range of acidic and corrosive solutions. The composites were made of glass and Kevlar fibers with an epoxy resin matrix and were subjected to corrosive solutions of 0.5 M NaCl, 0.5 M HCl, and 0.5 M H2SO4. The kinetics of the corrosion reactions were evaluated using potentiodynamic polarization (PDP) tests. In addition, electrochemical impedance spectroscopy (EIS) tests were carried out at open circuit potentials (OCPs). It was demonstrated that the glass fiber-reinforced polymer coating system offered the best protection against corrosion, with a high stability against deterioration when compared with epoxy and Kevlar fiber-reinforced polymer coating systems. Scanning electron microscopy images revealed cracks and deteriorated embedded fibers due to acid attack, sustained/assisted by the diffusion of the corrosion species.
- 1 January 2021
- Published by Elsevier in Materials Today: Proceedings
- Vol. 46, 1600-1607
Permeation of different cations through cathodically protected coated API X-120 steel at elevated temperature
- 1 January 2021
- Published by Elsevier in Materials Today: Proceedings
- Vol. 46, 1600-1607
Permeation of different cations through cathodically protected coated API X-120 steel at elevated temperature
- 1 April 2016
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 689, 148-153
Investigating the Corrosion under Insulation (CUI) on Steel Pipe Exposed to Arabian Gulf Sea Water Drops
This paper is an endeavor to investigate an insulated mild steel pipe that exposed to three sea water drops rate (10, 30, and 50 drops/minute) at room temperature. Various experimental strategies were employed including visual inspection; scanning electron microscopy (SEM) with EDAX. After removing the insulation material, it was observed that pipes were corroded. However, the extent of corrosion was varied which was attributed to the drop rates, it was revealed that corrosion process was initiated due to water and ions penetration through the insulation, such revelation highlighted the necessity to properly examine the pipe and the insulating material. Results also revealed that severity of corrosion is proportional to the drops rates. EDAX analysis of the pipe surface and the insulating material shows the presence of difference ions including Na+, Cl-, Mg2+, Si2+ and others, the results highlighted the importance of material selection and the necessity for early detection strategy in order to avoid catastrophic failure.
- 1 April 2016
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 689, 148-153
Investigating the Corrosion under Insulation (CUI) on Steel Pipe Exposed to Arabian Gulf Sea Water Drops
This paper is an endeavor to investigate an insulated mild steel pipe that exposed to three sea water drops rate (10, 30, and 50 drops/minute) at room temperature. Various experimental strategies were employed including visual inspection; scanning electron microscopy (SEM) with EDAX. After removing the insulation material, it was observed that pipes were corroded. However, the extent of corrosion was varied which was attributed to the drop rates, it was revealed that corrosion process was initiated due to water and ions penetration through the insulation, such revelation highlighted the necessity to properly examine the pipe and the insulating material. Results also revealed that severity of corrosion is proportional to the drops rates. EDAX analysis of the pipe surface and the insulating material shows the presence of difference ions including Na+, Cl-, Mg2+, Si2+ and others, the results highlighted the importance of material selection and the necessity for early detection strategy in order to avoid catastrophic failure.
- 1 April 2015
- Published by American Scientific Publishers in Journal of Biobased Materials and Bioenergy
- Vol. 9 (2) , 173-181
Effect of Water Absorption on the Mechanical Properties of Long Date Palm Leaf Fiber Reinforced Epoxy Composites
- 1 April 2015
- Published by American Scientific Publishers in Journal of Biobased Materials and Bioenergy
- Vol. 9 (2) , 173-181
Effect of Water Absorption on the Mechanical Properties of Long Date Palm Leaf Fiber Reinforced Epoxy Composites
- 1 June 2014
- Published by Elsevier in Corrosion Science
- Vol. 83, 48-58
Effect of temperature and erosion on pitting corrosion of X100 steel in aqueous silica slurries containing bicarbonate and chloride content
- 1 June 2014
- Published by Elsevier in Corrosion Science
- Vol. 83, 48-58
Effect of temperature and erosion on pitting corrosion of X100 steel in aqueous silica slurries containing bicarbonate and chloride content
- 1 April 2013
- Published by Elsevier in Progress in Organic Coatings
- Vol. 76 (4) , 548-554
The effects of zinc ions on the performance of epoxy coated mild steel under cathodic protection (CP)
- 1 April 2013
- Published by Elsevier in Progress in Organic Coatings
- Vol. 76 (4) , 548-554
The effects of zinc ions on the performance of epoxy coated mild steel under cathodic protection (CP)
- 1 September 2012
- Published by Elsevier in Progress in Organic Coatings
- Vol. 75 (1-2) , 79-85
The effects of different ionic migration on the performance of intact unpigmented epoxy coated mild steel under cathodic protection
- 1 September 2012
- Published by Elsevier in Progress in Organic Coatings
- Vol. 75 (1-2) , 79-85
The effects of different ionic migration on the performance of intact unpigmented epoxy coated mild steel under cathodic protection
- 1 January 2012
- Published by Elsevier in Progress in Organic Coatings
- Vol. 73 (1) , 8-13
Protective properties of intact unpigmented epoxy coated mild steel under cathodic protection
- 1 January 2012
- Published by Elsevier in Progress in Organic Coatings
- Vol. 73 (1) , 8-13
Protective properties of intact unpigmented epoxy coated mild steel under cathodic protection