PWPeter H. Williams

Peter H. Williams

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Peter H. Williams has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Erratum to: Future Circular Collider Feasibility Study Report

    by M. Benedikt, F. Zimmermann, B. Auchmann, W. Bartmann, J. P. Burnet, C. Carli, A. Chancé, P. Craievich, M. Giovannozzi, C. Grojean, et al.

  • Top Cited Papers
    Open Access

    Future Circular Collider Feasibility Study Report

    by M. Benedikt, F. Zimmermann, B. Auchmann, W. Bartmann, J. P. Burnet, C. Carli, A. Chancé, P. Craievich, M. Giovannozzi, C. Grojean, et al.

    Volume 1 of the FCC Feasibility Report presents an overview of the physics case, experimental programme, and detector concepts for the Future Circular Collider (FCC). This volume outlines how FCC would address some of the most profound open questions in particle physics, from precision studies of the Higgs and EW bosons and of the top quark, to the exploration of physics beyond the Standard Model. The report reviews the experimental opportunities offered by the staged implementation of FCC, beginning with an electron-positron collider (FCC-ee), operating at several centre-of-mass energies, followed by a hadron collider (FCC-hh). Benchmark examples are given of the expected physics performance, in terms of precision and sensitivity to new phenomena, of each collider stage. Detector requirements and conceptual designs for FCC-ee experiments are discussed, as are the specific demands that the physics programme imposes on the accelerator in the domains of the calibration of the collision energy, and the interface region between the accelerator and the detector. The report also highlights advances in detector, software and computing technologies, as well as the theoretical tools/reconstruction techniques that will enable the precision measurements and discovery potential of the FCC experimental programme. The content and structure of this report are guided by the scope and priorities defined in the mandate of the FCC Feasibility Study. It is therefore not intended to serve as an exhaustive review of the full physics potential of FCC. Several topics, already covered in earlier reports such as the FCC CDR, are not reiterated here or are addressed only briefly, in alignment with the study’s focus. This volume reflects the outcome of a global collaborative effort involving hundreds of scientists and institutions, aided by a dedicated community-building coordination, and provides a targeted assessment of the scientific opportunities and experimental foundations of the FCC programme.


  • Open Access

    Balance of bunch compression and emittance preservation for high-brightness x-ray free electron laser injectors

    by C. Davut, O. Apsimon, B. R. Hounsell, B. L. Militsyn, L. S. Cowie, F. Yaman, A. D. Brynes, P. H. Williams

    This paper presents two conceptual low-energy injector configurations optimized for high-brightness, high-repetition-rate XFELs. The designs were evaluated at a nominal bunch charge of 150 pC using multiobjective optimization techniques and further assessed through start-to-end simulations incorporating collective effects to determine their suitability for delivering high-brightness beams under FEL-relevant conditions. One of the injector design configurations employs a hybrid rf and magnetic compression scheme, while the second relies solely on two-stage rf compression. Start-to-end simulations through the main linac, including collective effects, were performed to assess the suitability of each design for meeting XFEL requirements. The results highlight the critical role of longitudinal charge distribution symmetry in maintaining beam quality during acceleration and compression, and demonstrate that appropriately balancing compressibility, emittance preservation, and phase space linearity is essential for meeting the stringent demands of XFEL operation.


  • Open Access

    Beam breakup instability studies of powerful energy recovery linac for experiments

    by S. Setiniyaz, R. Apsimon, P. H. Williams, C. Barbagallo, S. A. Bogacz, R. M. Bodenstein, K. Deitrick

    The maximum achievable beam current in an energy recovery linac (ERL) is often constrained by beam breakup (BBU) instability. Our previous research highlighted that filling patterns have a substantial impact on BBU instabilities in multipass ERLs. In this study, we extend our investigation to the eight-cavity model of the Powerful ERL for Experiment (PERLE). We evaluate its requirements for damping cavity higher order modes (HOMs) and propose optimal filling patterns and bunch timing strategies. Our findings reveal a significant new insight: while filling patterns are crucial, the timing of bunches also plays a critical role in mitigating HOM beam loading and BBU instability. This previously underestimated factor is essential for effective BBU control. We estimated the PERLE threshold current using both analytical and numerical models, incorporating the designed PERLE HOM dampers. During manufacturing, HOM frequencies are expected to vary slightly. Our study found no significant difference in BBU suppression for relative rms frequency jitters of 0.001, 0.002, and 0.005 for the same HOM. Introducing a jitter of 0.001 into our models, we found that the dampers effectively suppressed BBU instability, achieving a threshold current an order of magnitude higher than the design requirement. Our results offer new insights into ERL BBU beam dynamics and have important implications for the design of future ERLs.


  • Open Access

    Reduction of arrival time jitter or energy spread with arclike variable bunch compressors

    by Adam Dixon, Peter Williams, Sara Thorin, Tessa Charles, Andrzej Wolski

    Synchronizing free-electron laser pulses for time-resolved experiments is necessary as an unsynchronized system reduces the effective repetition rate of the experiment. Additionally, free-electron laser longitudinal coherence and spectral brightness are limited by electron beam energy spread. In this paper, a variable bunch compressor design and compression schemes were developed to: reduce klystron-induced arrival time jitter by 85% while preserving peak current and transverse emittance and to minimize electron beam correlated energy spread for potential self-seeding or HB-SASE modes. Published by the American Physical Society 2024


  • Open Access

    Beam Breakup Instability Studies of Powerful Energy Recovery Linac for Experiments

    by Sadiq Setiniyaz, R. Apsimon, P. H. Williams, C. Barbagallo, S. A. Bogacz, R. M. Bodenstei, K. Deitrick

    The maximum achievable beam current in an Energy Recovery Linac (ERL) is often constrained by Beam Breakup (BBU) instability. Our previous research highlighted that filling patterns have a substantial impact on BBU instabilities in multi-pass ERLs. In this study, we extend our investigation to the 8-cavity model of the Powerful ERL for Experiment (PERLE). We evaluate its requirements for damping cavity Higher Order Modes (HOMs) and propose optimal filling patterns and bunch timing strategies. Our findings reveal a significant new insight: while filling patterns are crucial, the timing of bunches also plays a critical role in mitigating HOM beam loading and BBU instability. This previously underestimated factor is essential for effective BBU control. We estimated the PERLE threshold current using both analytical and numerical models, incorporating the designed PERLE HOM dampers. During manufacturing, HOM frequencies are expected to vary slightly, with an assumed RMS frequency jitter of 0.001 between cavities for the same HOM. Introducing this jitter into our models, we found that the dampers effectively suppressed BBU instability, achieving a threshold current an order of magnitude higher than the design requirement. Our results offer new insights into ERL BBU beam dynamics and have important implications for the design of future ERLs.

  • Open Access

    Attosecond-Angstrom free-electron-laser towards the cold beam limit

    by A. F. Habib, G. G. Manahan, P. Scherkl, T. Heinemann, A. Sutherland, R. Altuiri, B. M. Alotaibi, M. Litos, J. Cary, T. Raubenheimer, et al.

    Electron beam quality is paramount for X-ray pulse production in free-electron-lasers (FELs). State-of-the-art linear accelerators (linacs) can deliver multi-GeV electron beams with sufficient quality for hard X-ray-FELs, albeit requiring km-scale setups, whereas plasma-based accelerators can produce multi-GeV electron beams on metre-scale distances, and begin to reach beam qualities sufficient for EUV FELs. Here we show, that electron beams from plasma photocathodes many orders of magnitude brighter than state-of-the-art can be generated in plasma wakefield accelerators (PWFAs), and then extracted, captured, transported and injected into undulators without significant quality loss. These ultrabright, sub-femtosecond electron beams can drive hard X-FELs near the cold beam limit to generate coherent X-ray pulses of attosecond-Angstrom class, reaching saturation after only 10 metres of undulator. This plasma-X-FEL opens pathways for advanced photon science capabilities, such as unperturbed observation of electronic motion inside atoms at their natural time and length scale, and towards higher photon energies.


  • A route to greener Big Science

    by Peter Williams

  • Open Access

    Transverse phase space tomography in an accelerator test facility using image compression and machine learning

    by A. Wolski, M. A. Johnson, M. King, B. L. Militsyn, P. H. Williams

    We describe a novel technique, based on image compression and machine learning, for transverse phase space tomography in two degrees of freedom in an accelerator beamline. The technique has been used in the CLARA accelerator test facility at Daresbury Laboratory: results from the machine learning method are compared with those from a conventional tomography algorithm (algebraic reconstruction) and applied to the same data. The use of machine learning allows reconstruction of the 4D phase space distribution of the beam to be carried out much more rapidly than using conventional tomography algorithms and also enables the use of image compression to reduce significantly the size of the data sets involved in the analysis. Results from the machine learning technique are at least as good as those from the algebraic reconstruction tomography in characterizing the beam behavior, in terms of the variation of the beam size in response to variation of the quadrupole strengths.


  • Open Access

    Transverse phase space tomography in the CLARA accelerator test facility using image compression and machine learning

    by Andrzej Wolski, Mark A. Johnson, Matthew King, Boris L. Militsyn, Peter H. Williams

    We describe a novel technique, based on image compression and machine learning, for transverse phase space tomography in two degrees of freedom in an accelerator beamline. The technique has been used in the CLARA accelerator test facility at Daresbury Laboratory: results from the machine learning method are compared with those from a conventional tomography algorithm (algebraic reconstruction), applied to the same data. The use of machine learning allows reconstruction of the 4D phase space distribution of the beam to be carried out much more rapidly than using conventional tomography algorithms, and also enables the use of image compression to reduce significantly the size of the data sets involved in the analysis. Results from the machine learning technique are at least as good as those from the algebraic reconstruction tomography in characterising the beam behaviour, in terms of the variation of the beam size in response to variation of the quadrupole strengths.