Aleksander V. Baranov
Research Subjects
Research Interests
Aleksander V. Baranov has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
A.L. Kozikov
1 shared publication- Igor Viktorovich Fetyukhin
Don State Agrarian University
1 shared publication Баранов А. В
АО «НПП “Салют”
1 shared publicationБаранов А.в.
АО «НПП “Салют”
1 shared publication
Latest Publications
- 1 January 2026
- Published by Publishing house "Radiotekhnika" in Radioengineering
- p. 171-179
Modification of the J-class power amplifier
Introduction. There are known J-class power amplifiers, which, although are not switching devices, are quite correspond to high-efficiency devices. The transistor current in J-class amplifiers is described by cosine pulses with certain cut-off angles, and the voltage across it is selected so that the amplifier load has inductive reactance in order to compensate the transistor output capacitance at the fundamental frequency. Unfortunately, the choice of voltage form is not unambiguously defined for such a load. Aim. In the process of creating load with inductive reactance, uncertainty should be eliminated when choosing the voltage form by proposing a modification of a J-class power amplifier, in which the output capacitance of its transistor is directly taken into account. Materials and methods. Based on the proposed model of a J-class power amplifier, waveforms of current and voltage are obtained, in which the influence of the transistor output capacitance is considered by means of dimensionless parameter. Results. The electronic efficiency of a J-class power amplifier and the normalized impedances of its loads at the fundamental frequency and its harmonics are calculated. For the received loads, a formula has been established for recalculating their normalized and non-normalized values. Using the calculated data, the input and output circuits of the J-class power amplifier are designed. Based on the results of machine modeling of these circuits, a device prototype has been made. It operates at a frequency of 915 MHz and has a supply voltage of +10 V. The dependences of its drain efficiency, output power, and consumption current on input power have been experimentally obtained. So, with a drain efficiency of ≈71% and a current of ~1A, the device prototype provides an output power of ~7 Watts with a compression of its amplitude characteristic of ~0.6 dB, and with a lower output power of ~6 Watts, it is a linear device. Conclusion. A modification of a J-class power amplifier is proposed, in which the transistor output capacity is directly taken into account. The possibility of developing such amplifiers with relatively linear and broadband characteristics and with drain efficiency approaching the theoretical limit of 78.5%, which typical for class B and AB amplifiers, has been confirmed.
- 1 January 2026
- Published by Publishing house "Radiotekhnika" in Radioengineering
- p. 171-179
Modification of the J-class power amplifier
Introduction. There are known J-class power amplifiers, which, although are not switching devices, are quite correspond to high-efficiency devices. The transistor current in J-class amplifiers is described by cosine pulses with certain cut-off angles, and the voltage across it is selected so that the amplifier load has inductive reactance in order to compensate the transistor output capacitance at the fundamental frequency. Unfortunately, the choice of voltage form is not unambiguously defined for such a load. Aim. In the process of creating load with inductive reactance, uncertainty should be eliminated when choosing the voltage form by proposing a modification of a J-class power amplifier, in which the output capacitance of its transistor is directly taken into account. Materials and methods. Based on the proposed model of a J-class power amplifier, waveforms of current and voltage are obtained, in which the influence of the transistor output capacitance is considered by means of dimensionless parameter. Results. The electronic efficiency of a J-class power amplifier and the normalized impedances of its loads at the fundamental frequency and its harmonics are calculated. For the received loads, a formula has been established for recalculating their normalized and non-normalized values. Using the calculated data, the input and output circuits of the J-class power amplifier are designed. Based on the results of machine modeling of these circuits, a device prototype has been made. It operates at a frequency of 915 MHz and has a supply voltage of +10 V. The dependences of its drain efficiency, output power, and consumption current on input power have been experimentally obtained. So, with a drain efficiency of ≈71% and a current of ~1A, the device prototype provides an output power of ~7 Watts with a compression of its amplitude characteristic of ~0.6 dB, and with a lower output power of ~6 Watts, it is a linear device. Conclusion. A modification of a J-class power amplifier is proposed, in which the transistor output capacity is directly taken into account. The possibility of developing such amplifiers with relatively linear and broadband characteristics and with drain efficiency approaching the theoretical limit of 78.5%, which typical for class B and AB amplifiers, has been confirmed.
- Open Access
- 29 December 2025
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 28 (4) , 27-34
Optimization of A-class power amplifiers in terms of efficiency
Background. Typical A-class power amplifiers usually have low electronic efficiency values, since their operating conditions do not always correspond to the optimal efficiency mode. The Aim of the article is to optimize the efficiency of an A–class power amplifier, in the model of which the output capacity of its transistor is directly taken into account. Methods. For the proposed model of an A-class power amplifier, the waveforms of its current and voltage are obtained, as well as the formula for the parameter that takes into account the output capacitance of its transistor. Results. For the considered A-class power amplifier, the efficiency and normalized impedances of its loads at the fundamental frequency and its harmonics are calculated. The formula for recalculating the normalized and non-normalized values of the load impedances of the amplifier is also obtained. Conclusion. Using calculated data and simulation results, the values of drain efficiency close to the theoretical limit for the A-class power amplifier were achieved in the model of the A-class power amplifier. Moreover, the developed layout has the same linearity and broadband characteristics as those of A-class amplifiers. The possibility of using the proposed efficiency optimization technique in matched monolithic amplifiers has also been confirmed.
- 29 December 2025
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 28 (4) , 27-34
Open AccessOptimization of A-class power amplifiers in terms of efficiency
Background. Typical A-class power amplifiers usually have low electronic efficiency values, since their operating conditions do not always correspond to the optimal efficiency mode. The Aim of the article is to optimize the efficiency of an A–class power amplifier, in the model of which the output capacity of its transistor is directly taken into account. Methods. For the proposed model of an A-class power amplifier, the waveforms of its current and voltage are obtained, as well as the formula for the parameter that takes into account the output capacitance of its transistor. Results. For the considered A-class power amplifier, the efficiency and normalized impedances of its loads at the fundamental frequency and its harmonics are calculated. The formula for recalculating the normalized and non-normalized values of the load impedances of the amplifier is also obtained. Conclusion. Using calculated data and simulation results, the values of drain efficiency close to the theoretical limit for the A-class power amplifier were achieved in the model of the A-class power amplifier. Moreover, the developed layout has the same linearity and broadband characteristics as those of A-class amplifiers. The possibility of using the proposed efficiency optimization technique in matched monolithic amplifiers has also been confirmed.
- Open Access
- 31 December 2022
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 25 (4) , 46-51
Phase frequency characteristics evaluation for E-class devices output circuits
Based on the unitarity of the E-class device circuit [S]-matrix, the phase frequency characteristics are estimated for the output circuit at any harmonic of the fundamental frequency. Formulas are derived for approximate phase frequency characteristics of an E-class device model with a switch that operates in two states corresponding to either zero or infinite active resistances. Using the example of the presented phase-frequency characteristics of the E-class power amplifier layout, the validity of the formulas obtained is confirmed. Taking into account the conclusions drawn from the formulas, recommendations are formulated for making additions to the well-known methods of designing E-class devices. These techniques can be supplemented by the introduction of parameter settings of the elements of the output circuits, for which the established estimated values of the phase frequency characteristics of the output circuit on harmonics are most respected with the maximum possible number of them.
- 31 December 2022
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 25 (4) , 46-51
Open AccessPhase frequency characteristics evaluation for E-class devices output circuits
Based on the unitarity of the E-class device circuit [S]-matrix, the phase frequency characteristics are estimated for the output circuit at any harmonic of the fundamental frequency. Formulas are derived for approximate phase frequency characteristics of an E-class device model with a switch that operates in two states corresponding to either zero or infinite active resistances. Using the example of the presented phase-frequency characteristics of the E-class power amplifier layout, the validity of the formulas obtained is confirmed. Taking into account the conclusions drawn from the formulas, recommendations are formulated for making additions to the well-known methods of designing E-class devices. These techniques can be supplemented by the introduction of parameter settings of the elements of the output circuits, for which the established estimated values of the phase frequency characteristics of the output circuit on harmonics are most respected with the maximum possible number of them.
- Open Access
- 25 June 2022
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 25 (2) , 15-21
Peculiarities of the Norton conversions application when matching impedances with different transformation coefficients
The paper studies the features and consequences of the use of Norton conversions in the process of broadband and narrowband matching of circuit impedances based on filter theory in cases with different transformation ratios. For Norton circuits conversions with different transformation ratios (greater than and less than one), an additional rule is formulated. Using the generalized form of recording the Norton consequence conversions, two examples of reducing the number of elements in bandpass filters are demonstrated. In addition, the consequences that are characteristic of narrow-band applications of transformations are established. Formulas for calculating transformation ratios that depend on frequency are obtained for direct and mirror Г-shaped circuits with different reactivities. It is shown that these circuits can be combined with similar reactivities of Г-shaped circuits with frequency independent transformation ratios. On the basis of the established for the Norton conversions consequences, the step-up and step-down matching circuits of the combined type are synthesized.
- 25 June 2022
- Published by Povolzhskiy State University of Telecommunications and Informatics in Physics of Wave Processes and Radio Systems
- Vol. 25 (2) , 15-21
Open AccessPeculiarities of the Norton conversions application when matching impedances with different transformation coefficients
The paper studies the features and consequences of the use of Norton conversions in the process of broadband and narrowband matching of circuit impedances based on filter theory in cases with different transformation ratios. For Norton circuits conversions with different transformation ratios (greater than and less than one), an additional rule is formulated. Using the generalized form of recording the Norton consequence conversions, two examples of reducing the number of elements in bandpass filters are demonstrated. In addition, the consequences that are characteristic of narrow-band applications of transformations are established. Formulas for calculating transformation ratios that depend on frequency are obtained for direct and mirror Г-shaped circuits with different reactivities. It is shown that these circuits can be combined with similar reactivities of Г-shaped circuits with frequency independent transformation ratios. On the basis of the established for the Norton conversions consequences, the step-up and step-down matching circuits of the combined type are synthesized.
- Open Access
- 7 January 2020
- Published by St. Petersburg Electrotechnical University LETI in Journal of the Russian Universities. Radioelectronics
- Vol. 22 (6) , 64-74
Low-Noise Voltage Controlled Oscillator with Coupled Microstrip Lines of Different Lengths
Малошумящий перестраиваемый автогенератор со связанными микрополосковыми линиями передач разной длины
- 7 January 2020
- Published by St. Petersburg Electrotechnical University LETI in Journal of the Russian Universities. Radioelectronics
- Vol. 22 (6) , 64-74
Open AccessLow-Noise Voltage Controlled Oscillator with Coupled Microstrip Lines of Different Lengths
Малошумящий перестраиваемый автогенератор со связанными микрополосковыми линиями передач разной длины
- Open Access
- 3 March 2019
- Published by FSBSI Agricultural Research Center Donskoy in Grain Economy of Russia
- No. 1
Integrated protection of winter wheat from weeds
- 3 March 2019
- Published by FSBSI Agricultural Research Center Donskoy in Grain Economy of Russia
- No. 1
Open AccessIntegrated protection of winter wheat from weeds
- Open Access
- 2 December 2018
- Published by Paediatrician Publishers LLC in Current Pediatrics
- Vol. 17 (5) , 367-370
20 Years of the Research Center for Children’s Health: Results and Development Prospects (Speach at the meeting of the Academic Council on 14 September 2018)
Научному центру здоровья детей — 20 лет: итоги и перспективы развития (выступление на Ученом совете 14.09.2018 г.)
- 2 December 2018
- Published by Paediatrician Publishers LLC in Current Pediatrics
- Vol. 17 (5) , 367-370
Open Access20 Years of the Research Center for Children’s Health: Results and Development Prospects (Speach at the meeting of the Academic Council on 14 September 2018)
Научному центру здоровья детей — 20 лет: итоги и перспективы развития (выступление на Ученом совете 14.09.2018 г.)