B. Kondraivendhan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
B. Kondraivendhan has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Uppara Raghu Babu
Sardar Vallabhbhai National Institute of Technology
6 shared publications - Akshay Ramesh Bura
Department of Civil Engineering, Sardar Vallabhbhai National Institute of Technology, Surat, India
5 shared publications - Anita Nivrutti Borade
Research Scholar
3 shared publications B. Bhattacharjee
3 shared publications- A. V. Ghogare
Civil Engineering Department, S. V. National Institute of Technology, Surat, India
1 shared publication B. Sabet Divsholi
School of Civil and Environmental Engineering, Nanyang Technological University, Singapore
1 shared publication
Latest Publications
- Open Access
- 12 February 2026
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 9 (1) , 92
Investigation on axial compression behavior of concrete columns wrapped with ferro-geopolymer composites
- 12 February 2026
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 9 (1) , 92
Open AccessInvestigation on axial compression behavior of concrete columns wrapped with ferro-geopolymer composites
- 20 October 2025
- Published by Springer Nature
- p. 245-255
Investigation into Carbonation Induced Corrosion of Concrete Containing Natural Zeolite Using Harmonic Analysis Technique
- 20 October 2025
- Published by Springer Nature
- p. 245-255
Investigation into Carbonation Induced Corrosion of Concrete Containing Natural Zeolite Using Harmonic Analysis Technique
- 13 October 2025
- Published by Springer Nature
- p. 29-40
Compressive Strength and Corrosion Performance of Reinforced Geopolymer Concrete
- 13 October 2025
- Published by Springer Nature
- p. 29-40
Compressive Strength and Corrosion Performance of Reinforced Geopolymer Concrete
- 2 July 2025
- Published by Springer Nature
- p. 131-152
Employability of Permanent Formwork in Functionally Graded Concrete: A Review
- 2 July 2025
- Published by Springer Nature
- p. 131-152
Employability of Permanent Formwork in Functionally Graded Concrete: A Review
- 7 February 2025
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 10 (3) , 1-25
Influence of zeolite additives and an innovative accelerated carbonation technique on the mechanical and corrosion properties of carbonated concrete
- 7 February 2025
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 10 (3) , 1-25
Influence of zeolite additives and an innovative accelerated carbonation technique on the mechanical and corrosion properties of carbonated concrete
- Open Access
- 11 July 2023
- Published by University of Zilina in Communications - Scientific letters of the University of Zilina
- Vol. 25 (3) , D71-D90
Mechanical Properties Investigation and Optimization of Ambiently Cured Alkali-Activated Concrete
The mechanical, microstructural and statical interpretation of the Alkali Activated Concrete (AAC), prepared using fly ash with crushed granulated corex slag as the binder ingredient, are examined in this work. Here, cast in-situ alkali-activa...
- 11 July 2023
- Published by University of Zilina in Communications - Scientific letters of the University of Zilina
- Vol. 25 (3) , D71-D90
Open AccessMechanical Properties Investigation and Optimization of Ambiently Cured Alkali-Activated Concrete
The mechanical, microstructural and statical interpretation of the Alkali Activated Concrete (AAC), prepared using fly ash with crushed granulated corex slag as the binder ingredient, are examined in this work. Here, cast in-situ alkali-activa...
- 16 May 2022
- Published by Taylor & Francis in Australian Journal of Civil Engineering
- Vol. 21 (1) , 50-67
Effect of elevated temperature on the calcined clay-limestone and marble stone blended cement concrete
The impact of high temperatures on calcined clay-limestone cement concrete (LC3) and calcined clay-marble stone cement concrete (MC3) is studied in this paper. In the present study, M25 and M35 grades of concrete was prepared using LC3 and MC3 cement and ordinary Portland cement (OPC). After 28 days of moist curing, prepared cubes of size 100 × 100 × 100 mm3, which were subjected to 100°C, 200°C, 400°C, 600°C and 800°C temperatures. Scanning electron microscopy (SEM), mass loss, surface texture and compressive strength (CS) were studied before and after specified temperatures. The X-ray diffraction (XRD) patterns, thermogravimetric analysis (TGA) and Fourier transformed infrared (FTIR) spectroscopy have been studied over M25-OPC, M25-LC3 and M25-MC3 concrete. The result shows that when the temperature exceeds 400°C, the mass loss in OPC was more than LC3 and MC3 concrete. CS was more in LC3 and MC3 concrete than OPC concrete at all high temperatures. The SEM results reveal that M25-LC3 and M25-MC3 concrete specimens have a sound structured C–S–H gel at high temperatures as compared to M25-OPC concrete specimens.
- 16 May 2022
- Published by Taylor & Francis in Australian Journal of Civil Engineering
- Vol. 21 (1) , 50-67
Effect of elevated temperature on the calcined clay-limestone and marble stone blended cement concrete
The impact of high temperatures on calcined clay-limestone cement concrete (LC3) and calcined clay-marble stone cement concrete (MC3) is studied in this paper. In the present study, M25 and M35 grades of concrete was prepared using LC3 and MC3 cement and ordinary Portland cement (OPC). After 28 days of moist curing, prepared cubes of size 100 × 100 × 100 mm3, which were subjected to 100°C, 200°C, 400°C, 600°C and 800°C temperatures. Scanning electron microscopy (SEM), mass loss, surface texture and compressive strength (CS) were studied before and after specified temperatures. The X-ray diffraction (XRD) patterns, thermogravimetric analysis (TGA) and Fourier transformed infrared (FTIR) spectroscopy have been studied over M25-OPC, M25-LC3 and M25-MC3 concrete. The result shows that when the temperature exceeds 400°C, the mass loss in OPC was more than LC3 and MC3 concrete. CS was more in LC3 and MC3 concrete than OPC concrete at all high temperatures. The SEM results reveal that M25-LC3 and M25-MC3 concrete specimens have a sound structured C–S–H gel at high temperatures as compared to M25-OPC concrete specimens.
- 24 March 2022
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 7 (3) , 1-14
An accelerated carbonation and its effect on concrete containing natural zeolite
- 24 March 2022
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 7 (3) , 1-14
An accelerated carbonation and its effect on concrete containing natural zeolite
- 1 September 2020
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 5 (3) , 1-10
Influence of bauxite residue (red mud) on corrosion of rebar in concrete
- 1 September 2020
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 5 (3) , 1-10
Influence of bauxite residue (red mud) on corrosion of rebar in concrete
- 14 April 2020
- Published by Springer Nature
- p. 535-543
Study on Fresh and Harden Properties of Limestone Calcined Clay Cement (LC3) Production by Marble Stone Powder
- 14 April 2020
- Published by Springer Nature
- p. 535-543
Study on Fresh and Harden Properties of Limestone Calcined Clay Cement (LC3) Production by Marble Stone Powder