Alison Martín
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alison Martín has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Crispin Celis
Department of Chemistry, Pontificia Universidad Javeriana, Carrera 7 No. 43-82, Bogotá 110231, Colombia
4 shared publications - Camilo Venegas
Microbiological Quality of Water and Sludge Laboratory, Environmental and Industrial Biotechnology Research Group-GBAI, Department of Microbiology, Faculty of Sciences, Pontificia Universidad Javeriana, Bogotá 110231, Colombia
3 shared publications - Alejandro Pérez
Department of Chemistry, Research Line in Environmental and Materials Technology (ITAM), Pontificia Universidad Javeriana, Carrera 7 No. 43-82, Bogotá 110231, Colombia
2 shared publications - Fidson-Juarismy Vesga
Microbiological Quality of Water and Sludge Laboratory, Environmental and Industrial Biotechnology Research Group-GBAI, Department of Microbiology, Faculty of Sciences, Pontificia Universidad Javeriana, Bogotá 110231, Colombia
2 shared publications - Lorena Lugo
Department of Chemistry, Research Line in Environmental and Materials Technology (ITAM), Pontificia Universidad Javeriana, Carrera 7 No. 43-82, Bogotá 110231, Colombia
2 shared publications - A. E. Ortiz-Ardila
Department of Hydraulic and Environmental Engineering, Pontificia Universidad Catolica de Chile, Santiago, Chile
1 shared publication
Latest Publications
- Open Access
- 13 December 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (24) , 7172
Ecotoxicology Evaluation of a Fenton—Type Process Catalyzed with Lamellar Structures Impregnated with Fe or Cu for the Removal of Amoxicillin and Glyphosate
Antibiotics and pesticides, as well as various emerging contaminants that are present in surface waters, raise significant environmental concerns. Advanced oxidation processes, which are employed to eliminate these substances, have demonstrated remarkable effectiveness. However, during the degradation process, by-products that are not completely mineralized are generated, posing a substantial risk to aquatic ecosystem organisms; therefore, it is crucial to assess effluent ecotoxicity following treatment. This study aimed to assess the toxicity of effluents produced during the removal of amoxicillin and glyphosate with a Fenton-type process using a laminar structure catalyzed with iron (Fe) and copper (Cu). The evaluation included the use of Daphnia magna, Selenastrum capricornutum, and Lactuca sativa, and mutagenicity testing was performed using strains TA98 and TA100 of Salmonella typhimurium. Both treated and untreated effluents exhibited inhibitory effects on root growth in L. sativa, even at low concentrations ranging from 1% to 10% v/v. Similarly, negative impacts on the growth of algal cells of S. capricornutum were observed at concentrations as low as 0.025% v/v, particularly in cases involving amoxicillin–copper (Cu) and glyphosate with copper (Cu) and iron (Fe). Notably, in the case of D. magna, mortality was noticeable even at concentrations of 10% v/v. Additionally, the treatment of amoxicillin with double-layer hydroxides of Fe and Cu resulted in mutagenicity (IM ≥ 2.0), highlighting the necessity to treat the effluent further from the advanced oxidation process to reduce ecological risks.
- 13 December 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (24) , 7172
Open AccessEcotoxicology Evaluation of a Fenton—Type Process Catalyzed with Lamellar Structures Impregnated with Fe or Cu for the Removal of Amoxicillin and Glyphosate
Antibiotics and pesticides, as well as various emerging contaminants that are present in surface waters, raise significant environmental concerns. Advanced oxidation processes, which are employed to eliminate these substances, have demonstrated remarkable effectiveness. However, during the degradation process, by-products that are not completely mineralized are generated, posing a substantial risk to aquatic ecosystem organisms; therefore, it is crucial to assess effluent ecotoxicity following treatment. This study aimed to assess the toxicity of effluents produced during the removal of amoxicillin and glyphosate with a Fenton-type process using a laminar structure catalyzed with iron (Fe) and copper (Cu). The evaluation included the use of Daphnia magna, Selenastrum capricornutum, and Lactuca sativa, and mutagenicity testing was performed using strains TA98 and TA100 of Salmonella typhimurium. Both treated and untreated effluents exhibited inhibitory effects on root growth in L. sativa, even at low concentrations ranging from 1% to 10% v/v. Similarly, negative impacts on the growth of algal cells of S. capricornutum were observed at concentrations as low as 0.025% v/v, particularly in cases involving amoxicillin–copper (Cu) and glyphosate with copper (Cu) and iron (Fe). Notably, in the case of D. magna, mortality was noticeable even at concentrations of 10% v/v. Additionally, the treatment of amoxicillin with double-layer hydroxides of Fe and Cu resulted in mutagenicity (IM ≥ 2.0), highlighting the necessity to treat the effluent further from the advanced oxidation process to reduce ecological risks.
- Open Access
- 3 June 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (11) , 6840
Identification and Evaluation of Determining Factors and Actors in the Management and Use of Biosolids through Prospective Analysis (MicMac and Mactor) and Social Networks
The reuse of biosolids in agriculture and its inclusion within the circular economy model requires evaluating and analyzing factors that intervene in its management. The objective of the study was to analyze those factors that influence the management and use of biosolids. Fifty-three actors were questioned, and their answers were analyzed using two prospective methods and Social Network Analysis (SNA) identifying between 14 and 19 variables. Six should be prioritized due to their criticality and potential in management and reuse scenarios. It was observed that the formulation of objectives, such as the improvement of infrastructure, creation of an institutional policy, and the establishment of definitions for the kinds of biosolids, are opposed by internal agents. Seven key actors and four to six determining agents were identified in the scenarios. The network of management and use of biosolids in agriculture presented low density (0.28) and the exclusive action of three key actors. Consequently, the participation of a greater number of better-connected actors is required to project networks with a higher density (between 0.49 and 0.57), facilitating the diffusion of information and the inclusion of new actors not previously contemplated. The application of prospective and SNA methodologies focused on biosolids allows the prioritization of determinants, the evaluation of the level of involvement and communication between actors, and other aspects that have not been considered previously in the management of WWTPs in Colombia.
- 3 June 2022
- Published by MDPI AG in Sustainability
- Vol. 14 (11) , 6840
Open AccessIdentification and Evaluation of Determining Factors and Actors in the Management and Use of Biosolids through Prospective Analysis (MicMac and Mactor) and Social Networks
The reuse of biosolids in agriculture and its inclusion within the circular economy model requires evaluating and analyzing factors that intervene in its management. The objective of the study was to analyze those factors that influence the management and use of biosolids. Fifty-three actors were questioned, and their answers were analyzed using two prospective methods and Social Network Analysis (SNA) identifying between 14 and 19 variables. Six should be prioritized due to their criticality and potential in management and reuse scenarios. It was observed that the formulation of objectives, such as the improvement of infrastructure, creation of an institutional policy, and the establishment of definitions for the kinds of biosolids, are opposed by internal agents. Seven key actors and four to six determining agents were identified in the scenarios. The network of management and use of biosolids in agriculture presented low density (0.28) and the exclusive action of three key actors. Consequently, the participation of a greater number of better-connected actors is required to project networks with a higher density (between 0.49 and 0.57), facilitating the diffusion of information and the inclusion of new actors not previously contemplated. The application of prospective and SNA methodologies focused on biosolids allows the prioritization of determinants, the evaluation of the level of involvement and communication between actors, and other aspects that have not been considered previously in the management of WWTPs in Colombia.
- Open Access
Evaluation of the Effect of Gold Mining on the Water Quality in Monterrey, Bolívar (Colombia)
Gold mining uses chemicals that are discharged into rivers without any control when there are no good mining practices, generating environmental and public health problems, especially for downstream inhabitants who use the water for consumption, as is the case in Monterrey township, where the Boque River water is consumed. In this study, we evaluate Boque River water quality analyzing some physicochemical parameters such as pH, heavy metals, Hg, and cyanide; bioassays (Lactuca sativa, Hydra attenuata, and Daphnia magna), mutagenicity (Ames test), and microbiological assays. The results show that some physicochemical parameters exceed permitted concentrations (Hg, Cd, and cyanide). D. magna showed sensitivity and L. sativa showed inhibition and excessive growth in the analyzed water. Mutagenic values were obtained for all of the sample stations. The presence of bacteria and somatic coliphages in the water show a health risk to inhabitants. In conclusion, the presence of Cd, Hg, and cyanide in the waters for domestic consumption was evidenced in concentrations that can affect the environment and the health of the Monterrey inhabitants. The mutagenic index indicates the possibility of mutations in the population that consumes this type of water. Bioassays stand out as an alert system when concentrations of chemical contaminants cannot be analytically detected.
Open AccessEvaluation of the Effect of Gold Mining on the Water Quality in Monterrey, Bolívar (Colombia)
Gold mining uses chemicals that are discharged into rivers without any control when there are no good mining practices, generating environmental and public health problems, especially for downstream inhabitants who use the water for consumption, as is the case in Monterrey township, where the Boque River water is consumed. In this study, we evaluate Boque River water quality analyzing some physicochemical parameters such as pH, heavy metals, Hg, and cyanide; bioassays (Lactuca sativa, Hydra attenuata, and Daphnia magna), mutagenicity (Ames test), and microbiological assays. The results show that some physicochemical parameters exceed permitted concentrations (Hg, Cd, and cyanide). D. magna showed sensitivity and L. sativa showed inhibition and excessive growth in the analyzed water. Mutagenic values were obtained for all of the sample stations. The presence of bacteria and somatic coliphages in the water show a health risk to inhabitants. In conclusion, the presence of Cd, Hg, and cyanide in the waters for domestic consumption was evidenced in concentrations that can affect the environment and the health of the Monterrey inhabitants. The mutagenic index indicates the possibility of mutations in the population that consumes this type of water. Bioassays stand out as an alert system when concentrations of chemical contaminants cannot be analytically detected.
- Open Access
Implementation of Modified Acacia Tannin by Mannich Reaction for Removal of Heavy Metals (Cu, Cr and Hg)
The modified tannin by Mannich reaction was investigated for wastewater treatment. The removal of heavy metals, such as copper, chromium and mercury, in industrial wastewater was evaluated through the coagulation–flocculation technique, using modified Acacia tannin (MAT) as a coagulant agent. The successful tannin modification was evaluated by infrared spectopometry (FTIR), nuclear magnetic resonance (NMR); monitoring the removal of heavy metals was performed by atomic absorption (AA) and a direct mercury analyzer (DMA). Additionally, the parameters of water quality, total suspended solids (TSS), turbidity and chemical oxygen demand (COD) were assessed. Different doses of MAT were evaluated (375 ppm, 750 ppm, 1250 ppm and 1625 ppm) and three different levels of pH (4, 7 and 10). The highest percentages of removal obtained were copper 60%, chromium 87%, mercury 50%–80%, COD 88%, TSS 86% and turbidity 94%, which were achieved with the dose of 375 ppm of MAT at pH 10. The coagulation–flocculation process with the modified Acacia tannin is efficient for the removal of conventional parameters and for a significant removal of the metals studied.
Open AccessImplementation of Modified Acacia Tannin by Mannich Reaction for Removal of Heavy Metals (Cu, Cr and Hg)
The modified tannin by Mannich reaction was investigated for wastewater treatment. The removal of heavy metals, such as copper, chromium and mercury, in industrial wastewater was evaluated through the coagulation–flocculation technique, using modified Acacia tannin (MAT) as a coagulant agent. The successful tannin modification was evaluated by infrared spectopometry (FTIR), nuclear magnetic resonance (NMR); monitoring the removal of heavy metals was performed by atomic absorption (AA) and a direct mercury analyzer (DMA). Additionally, the parameters of water quality, total suspended solids (TSS), turbidity and chemical oxygen demand (COD) were assessed. Different doses of MAT were evaluated (375 ppm, 750 ppm, 1250 ppm and 1625 ppm) and three different levels of pH (4, 7 and 10). The highest percentages of removal obtained were copper 60%, chromium 87%, mercury 50%–80%, COD 88%, TSS 86% and turbidity 94%, which were achieved with the dose of 375 ppm of MAT at pH 10. The coagulation–flocculation process with the modified Acacia tannin is efficient for the removal of conventional parameters and for a significant removal of the metals studied.