JKJae-Hoon Kim

Jae-Hoon Kim

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jae-Hoon Kim has a total of 83 co-authors. Here are the top co-authors by number of shared publications:

  • You-Jin Lee

    Department of Electronic Engineering, Hanyang University, Seoul 133-791, South Korea

    12 shared publications
  • Jin Seog Gwag

    Department of Physics, Yeungnam University, Gyeongsan 712-749, Korea

    11 shared publications
  • Hak-Rin Kim

    School of Electrical Engineering and Computer Science, Kyungpook National University , Daegu, Korea

    10 shared publications
  • You‐Jin Lee

    Department of Electronic Engineering Hanyang University Seoul 04763 Republic of Korea

    9 shared publications
  • Chang-Jae Yu

    Department of Electronic Engineering, Hanyang University, Seoul 133-791, South Korea

    8 shared publications
  • Jong‐Wook Jung

    Department of Electronics and Computer Engineering , Hanyang University , 17 Haengdang‐dong, Seongdong‐gu, Seoul, 133–791, Korea

    8 shared publications

Latest Publications

  • Effects of molecular ordering on circularly polarized emission from a twisted mesogenic conjugated polymer

    by Dong-Min Lee, Gi-Eun Kim, Jae-Hoon Kim, Chang-Jae Yu

    The measured ELgfactors (symbols) were fitted with a quadratic equation of the order parameter in the twisted configuration of a mesogenic conjugate polymer (F8BT) doped with various concentrations of a chiral dopant (R5011).


  • Circularly Polarized Emission from Mixture of Vacuum‐Evaporated Mesogenic Luminophores

    by Chang‐Jae Yu, Dong‐Myung Lee, Jin‐Kyung Han, You‐Jin Lee, Sa‐Wook Kim, E‐Joon Choi, Jae‐Hoon Kim

    Direct circular polarized (CP) emission from a twisted mesogenic luminophore is one of the promising approaches for generating high degree of CP light since device parameters governing the degree of CP emission are easily controlled. Most high CP emissions have been performed by solution process since a twisted structure of mesogenic luminophore is easily achieved. However, since solution process has been impeded by the limitation of low resolution and efficiency, vacuum evaporation has been commonly used in display industries to obtain high performance and resolution. Here, high CP electroluminescence (CPEL) with a dissymmetric factor of 0.914 is demonstrated through the sequential vacuum evaporation of two mesogenic luminophores and chiral agent. The sequentially evaporated luminophores and chiral agent are converted into a mixture by thermal annealing, and the luminophore mixture constructs a twisted structure and generates resultantly high CPEL. The electroluminescence device fabricated with the mixture exhibits three times higher luminance and two times higher efficiency than the devices with each single luminophore. Further, the dissymmetric factors according to the device parameters based on the Stokes parameter analysis are theoretically investigated. It is anticipated that the approach paves the way toward improving CPEL performance.


  • Direct Emission of Continuously Varying Polarization of Light by Surface Treatment of a Mesogenic Luminophore

    by Young‐Kyo Seo, You‐Jin Lee, Jae‐Hoon Kim, Chang‐Jae Yu

    Control of the polarized light generated from a luminophore has been intensively studied in organic light emitting diodes due to an enhancement of light intensity. The direct emission of highly circularly polarized light has been reported in a twist stacking of an achiral conjugated polymer by boundary surface effect without any chiral dopant. Although the twisted configuration of the emitting layer was obtained by applying different boundary conditions to two interfaces of the conjugated polymer, little study has been performed on the effect of the interfaces of the mesogenic polymer so far. Here, twist‐angle‐varying configuration in a single luminophore is designed and demonstrated to investigate an interfacial effect such as surface anchoring phenomena of conjugated mesogenic polymer. The continuously varying twisted configuration is fabricated by applying the circularly and unidirectionally rubbing method to the lower and the upper interfaces of the mesogenic luminophore, respectively. The surface anchoring and bulk elastic properties of luminophores are systematically analyzed to investigate twist deformation. Furthermore, a self‐luminous light source generating continuously varying polarization of light is demonstrated. The proposed light source can generate multi‐polarization states including linearly polarized, right‐handed circularly polarized, and left‐handed circularly polarized light in a single substrate.


  • Open Access

    Simultaneous emission of orthogonal handedness in circular polarization from a single luminophore

    by Kyungmin Baek, Dong-Myung Lee, Yu-Jin Lee, Hyunchul Choi, Jeongdae Seo, Inbyeong Kang, Chang-Jae Yu, Jae-Hoon Kim

    The direct emission of circularly polarized (CP) light improves the efficiency of an organic light-emitting diode and characterizes the secondary structure of proteins. In most cases, CP light is generated from a luminescent layer containing chiral characteristics, thereby generating only one kind of CP light in an entire device. Here, we propose direct CP light emissions using a twisted achiral conjugate polymer without any chiral dopant as an emitting layer (EML). The twisted structure is induced in the mesogenic conjugate polymer due to its elasticity by applying different alignment directions to its upper and lower interfaces. Furthermore, we demonstrate the simultaneous emission of orthogonal CP light in a single luminescent device by patterning different alignment directions on the surfaces of the EML. The light source with multipolarization including the orthogonal CP states is applicable to many applications in biosensors and optical devices.


  • Control of Circularly Polarized Electroluminescence in Induced Twist Structure of Conjugate Polymer

    by Dong‐Myung Lee, Jin‐Wook Song, Yu‐Jin Lee, Chang‐Jae Yu, Jae‐Hoon Kim

    An extremely high degree of circularly polarized photoluminescence (CPPL) and electroluminescence (CPEL) (dissymmetry factor values: |gPL| = 0.72 and |gEL| = 1.13) are generated from twisted stacking of achiral conjugated polymer induced by nonemitting chiral dopant of high helical twisting power for the first time. Using a theoretical analysis incorporating the Stokes parameter, the twisting angle and birefringence of the aligned conjugated polymer, and the degree of linear polarization in the emitted light are found to make a roughly equal contribution to the degree of CPEL as to the degree of CPPL. Moreover, it is also found that the location of the recombination zone within the emitting layer is a crucial parameter for determining the difference in the dissymmetry factor between CPEL and CPPL. This result is applied to an organic light‐emitting display to improve the luminous efficiency by 60%.


  • Reduction of the operating voltage of a nanoencapsulated liquid crystal display by using a half-wall structure

    by You-Jin Lee, Minho Park, Dong-Myung Lee, Chang-Jae Yu, Jae-Hoon Kim

    We proposed a half-wall structure in the in-plane switching (IPS) configuration of the nanoencapsulated liquid crystal (LC) display for reducing a driving voltage. The IPS electrodes were fabricated on top of the half-walls to enhance electric field strength through the whole LC layer. In addition, we demonstrated a self-masking process for the half-wall structure and the IPS electrodes without any additional mask-aligning process.


  • Open Access

    Polarizer-free liquid crystal display with double microlens array layers and polarization-controlling liquid crystal layer

    by You-Jin Lee, Chang-Jae Yu, Jae-Hoon Kim

    We propose a polarizer-free liquid crystal display (LCD) consisting of two microlens array (MLA) layers, a twisted nematic (TN) LC layer, and two light-blocking masks. By changing the polarization state, focal length of the LCD can be controlled. Since two light-blocking masks have a circular stop pattern and a complementary open pattern, entire gray-scale spectrum may be realized by controlling the intensity of light passing through masks. Ultimately, fast response time characteristics could be achieved due to the alignment of LC molecules on the flat MLA surface.


  • Open Access

    Realization of Multi-Stable Ground States in a Nematic Liquid Crystal by Surface and Electric Field Modification

    by Jin Seog Gwag, Young-Ki Kim, Chang Hoon Lee, Jae-Hoon Kim

    Owing to the significant price drop of liquid crystal displays (LCDs) and the efforts to save natural resources, LCDs are even replacing paper to display static images such as price tags and advertising boards. Because of a growing market demand on such devices, the LCD that can be of numerous surface alignments of directors as its ground state, the so-called multi-stable LCD, comes into the limelight due to the great potential for low power consumption. However, the multi-stable LCD with industrial feasibility has not yet been successfully performed. In this paper, we propose a simple and novel configuration for the multi-stable LCD. We demonstrate experimentally and theoretically that a battery of stable surface alignments can be achieved by the field-induced surface dragging effect on an aligning layer with a weak surface anchoring. The simplicity and stability of the proposed system suggest that it is suitable for the multi-stable LCDs to display static images with low power consumption and thus opens applications in various fields.


  • Fast Response and Wide Viewing Angle Vertical Alignment Mode with X-Shape Electrode

    by Soo In Jo, Chang-Jae Yu, Jae-Hoon Kim

    We proposed the fast response and high transmittance vertical alignment mode by generating the axial symmetry of the liquid crystal (LC) director. To control the LC director, we adopt the x-shaped slit electrode on the only pixel electrode. Using a polymerization of the reactive mesogens (RMs) mixed into the alignment layers, we can memorize the falling direction of LCs and thus the fast switching characteristics can be achieved. Owing to infinite LC domains with the axial symmetry, wide viewing angle characteristics was achieved and high transmittance also was obtained by introducing a quarter wave plate.


  • Optically-isotropic nanoencapsulated liquid crystal displays based on Kerr effect

    by Seung-Gon Kang, Jae-Hoon Kim

    An innovative liquid crystal display (LCD), incorporating in-plane switching mechanism with LC nanoencapsulation, is developed and its electro-optic (EO) performances are characterized. The nanoencapsulated LCDs exhibit electric-field induced transitions from an optically-isotropic state to an anisotropic one based on Kerr effect. Extremely small size of LC droplets embedded in the nanoencapsulated layer, less than a quarter of wavelength of incident light, appear transparent in the voltage-off state and gradually becomes birefringent in response to applied voltage, exhibiting the optical behavior of uniaxial retarder. Due to optically-isotropic nature and a large Kerr effect, they show wide viewing angle characteristics and good EO performances.