Jahaziel Amaya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jahaziel Amaya has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Llamosa Pérez
Grupo de Investigación Fundamental y Aplicada en Materiales GIFAM, Facultad de Ciencias, Universidad Antonio Nariño, Carrera 3 Este # 47 A-15, Bogotá 110231, Colombia
8 shared publications - Indry Milena Saavedra Gaona
Grupo de Física de Materiales, Escuela de Física, Universidad Pedagógica y Tecnológica de Colombia, Tunja, Colombia
4 shared publications - Rafael Molina
Estado Sólido y Catálisis Ambiental Departamento de Química Facultad de Ciencias Universidad Nacional de Colombia Ciudad Universitaria AK 30 No. 45‐03 Bogotá D.C. 11001 Colombia
3 shared publications - Rolando Javier Rincón-Ortiz
GIBICS Group, Faculty of Sciences, Universidad Antonio Nariño, Cra. 1 Este #47a15, Bogotá D.C., 110231, Colombia
3 shared publications - Sonia Moreno
Estado Sólido y Catálisis Ambiental (ESCA), Departamento de Química, Universidad Nacional de Colombia, Bogotá, Colombia
3 shared publications Alejandro Pérez Flórez
2 shared publications
Latest Publications
- 14 September 2026
- Published by Elsevier in Forensic Science International
- Vol. 389
Physicochemical markers of thermal exposure in teeth with orthodontic brackets: An integrated forensic analytical approach
- 14 September 2026
- Published by Elsevier in Forensic Science International
- Vol. 389
Physicochemical markers of thermal exposure in teeth with orthodontic brackets: An integrated forensic analytical approach
- 13 July 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 97
Energy-assisted control of nano-interface structure and stability in CTAB-stabilized gold nanoparticles
- 13 July 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 97
Energy-assisted control of nano-interface structure and stability in CTAB-stabilized gold nanoparticles
- Open Access
- 20 April 2026
- Published by MDPI AG in Condensed Matter
- Vol. 11 (2) , 13
Magnetic Nanocomposite-Driven Harvesting of Chlorella vulgaris: Enhancing Microalgal Biomass Recovery Using Fe3O4 and Fe3O4@PEG Nanoparticles
This study investigates magnetic harvesting of Chlorella vulgaris cultivated under saline and wastewater conditions using Fe3O4 and polyethylene-glycol-coated Fe3O4 (Fe3O4@PEG) nanoparticles synthesized by ultrasound-assisted coprecipitation. TEM showed agglomerated, quasi-spherical particles with mean diameters of 13 ± 1 nm (Fe3O4) and 15 ± 1 nm (Fe3O4@PEG). FTIR confirmed the Fe–O vibrational bands of magnetite and the characteristic PEG vibrations in the coated sample. VSM measurements indicated superparamagnetic behavior, with saturation magnetizations of 72.74 emu/g for Fe3O4 and 32.25 emu/g for Fe3O4@PEG. SEM–EDX of native and functionalized cells verified nanoparticle attachment on the algal surface. Magnetic separation experiments (OD684) showed a decrease in supernatant absorbance with increasing nanoparticle dose, consistent with biomass removal; the PEG-coated system showed a lower apparent biomass concentration after functionalization.
- 20 April 2026
- Published by MDPI AG in Condensed Matter
- Vol. 11 (2) , 13
Open AccessMagnetic Nanocomposite-Driven Harvesting of Chlorella vulgaris: Enhancing Microalgal Biomass Recovery Using Fe3O4 and Fe3O4@PEG Nanoparticles
This study investigates magnetic harvesting of Chlorella vulgaris cultivated under saline and wastewater conditions using Fe3O4 and polyethylene-glycol-coated Fe3O4 (Fe3O4@PEG) nanoparticles synthesized by ultrasound-assisted coprecipitation. TEM showed agglomerated, quasi-spherical particles with mean diameters of 13 ± 1 nm (Fe3O4) and 15 ± 1 nm (Fe3O4@PEG). FTIR confirmed the Fe–O vibrational bands of magnetite and the characteristic PEG vibrations in the coated sample. VSM measurements indicated superparamagnetic behavior, with saturation magnetizations of 72.74 emu/g for Fe3O4 and 32.25 emu/g for Fe3O4@PEG. SEM–EDX of native and functionalized cells verified nanoparticle attachment on the algal surface. Magnetic separation experiments (OD684) showed a decrease in supernatant absorbance with increasing nanoparticle dose, consistent with biomass removal; the PEG-coated system showed a lower apparent biomass concentration after functionalization.
- Open Access
- 12 December 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (58) , 50151-50165
A nanocarrier delivery system of oxaliplatin for glioblastoma: synthesis and cytotoxicity of Fe 3 O 4 @SiO 2 /OXA nanocomposites
Among the available treatments for glioblastoma multiforme (GBM), chemotherapy is the most widely used because anticancer drugs can help shrink the tumour.
- 12 December 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (58) , 50151-50165
Open AccessA nanocarrier delivery system of oxaliplatin for glioblastoma: synthesis and cytotoxicity of Fe 3 O 4 @SiO 2 /OXA nanocomposites
Among the available treatments for glioblastoma multiforme (GBM), chemotherapy is the most widely used because anticancer drugs can help shrink the tumour.
- 30 October 2025
- Published by Elsevier in Solid State Communications
- Vol. 406
Synthesis of magnetite nanoparticles (Fe3O4) through an ultra-sonically assisted coprecipitation method
- 30 October 2025
- Published by Elsevier in Solid State Communications
- Vol. 406
Synthesis of magnetite nanoparticles (Fe3O4) through an ultra-sonically assisted coprecipitation method
- 11 October 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 75
Microwave-synthesized carbon quantum dots for efficient photocatalytic degradation of malachite green, congo red, and safranin
- 11 October 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 75
Microwave-synthesized carbon quantum dots for efficient photocatalytic degradation of malachite green, congo red, and safranin
- Open Access
- 7 July 2025
- Published by MDPI AG in Condensed Matter
- Vol. 10 (3) , 36
Ultrasound-Assisted Synthesis for the Control of Silver Nanoparticle Size: A Preliminary Study on the Influence of Pressure and pH
The use of plasmonic nanoparticles for biosensor technology is dependent on nanoparticle size and morphology. This study determined the effect of pH and pressure on synthesizing silver nanoparticle size. In Method 1, a mixture of NaBH4 and sodium citrate was added to a solution of AgNO3 monodispersed by ultrasound energy. In Method 2, the reducer was added to the precursor–dispersant mixture solution. The effect of pH was evaluated by using buffer solutions at pH 4.0, pH 7.0, and pH 10.0 and water as control. To determine the effect of pressure, AgNPs were subjected to 0, 4, and 23 h to 1.75 MPa at 200 °C. AgNPs produced with Method 1 showed a more symmetric SPR and a smaller nanoparticle diameter (±6 nm). The SPR with Method 1 at pH 10.0 produced a higher UV peak with a shift around 20 nm. In the case of the pressure treatment, a shift of approximately 20 nm was observed at all time conditions studied, and a higher AgNP diameter was found in contrast to Method 1. Finally, EDX and Raman analysis confirm the presence of AgNPs and a mild oxidation of these. These results suggest that alkalinity and pressure can affect the diameter of AgNPs.
- 7 July 2025
- Published by MDPI AG in Condensed Matter
- Vol. 10 (3) , 36
Open AccessUltrasound-Assisted Synthesis for the Control of Silver Nanoparticle Size: A Preliminary Study on the Influence of Pressure and pH
The use of plasmonic nanoparticles for biosensor technology is dependent on nanoparticle size and morphology. This study determined the effect of pH and pressure on synthesizing silver nanoparticle size. In Method 1, a mixture of NaBH4 and sodium citrate was added to a solution of AgNO3 monodispersed by ultrasound energy. In Method 2, the reducer was added to the precursor–dispersant mixture solution. The effect of pH was evaluated by using buffer solutions at pH 4.0, pH 7.0, and pH 10.0 and water as control. To determine the effect of pressure, AgNPs were subjected to 0, 4, and 23 h to 1.75 MPa at 200 °C. AgNPs produced with Method 1 showed a more symmetric SPR and a smaller nanoparticle diameter (±6 nm). The SPR with Method 1 at pH 10.0 produced a higher UV peak with a shift around 20 nm. In the case of the pressure treatment, a shift of approximately 20 nm was observed at all time conditions studied, and a higher AgNP diameter was found in contrast to Method 1. Finally, EDX and Raman analysis confirm the presence of AgNPs and a mild oxidation of these. These results suggest that alkalinity and pressure can affect the diameter of AgNPs.
- Open Access
A Review for the Design and Optimization of Catalysts: The Use of Statistics as a Powerful Tool for Literature Analysis
In this study, a statistical analysis of results reported in the literature was conducted through a 2n experimental design on the synthesis of bifunctional catalysts used in the production of lighter fuels, aiming for optimization while considering factors such as support (bentonite and vermiculite), acidity modifier (zirconium and cerium), metal (tungsten and molybdenum), metal content (5% and 10%), promoter (nickel and cobalt), and heteropolyacids (tungstophosphoric acid and molybdophosphoric acid), identifying their influence on textural properties and catalytic performance. Regarding the textural properties, vermiculite proved to be the most favorable support due to its high porosity. It was also established that the implemented metals impart positive characteristics to the catalysts due to their various properties; however, incorporating large amounts led to an adverse effect by clogging the pores. Catalytic performance was analyzed in isomerization and cracking reactions, which were enhanced by the use of cerium due to the presence of Brønsted acid sites and molybdenum for its stability. In this way, the statistical analysis conducted in this study was crucial for identifying the influence of key factors on the textural properties and catalytic performance of bifunctional catalysts. Using a 2n experimental design allowed for a systematic evaluation of variables reported in the literature, such as support, acidity modifiers, metals, metal content, promoters, and heteropolyacids.
Open AccessA Review for the Design and Optimization of Catalysts: The Use of Statistics as a Powerful Tool for Literature Analysis
In this study, a statistical analysis of results reported in the literature was conducted through a 2n experimental design on the synthesis of bifunctional catalysts used in the production of lighter fuels, aiming for optimization while considering factors such as support (bentonite and vermiculite), acidity modifier (zirconium and cerium), metal (tungsten and molybdenum), metal content (5% and 10%), promoter (nickel and cobalt), and heteropolyacids (tungstophosphoric acid and molybdophosphoric acid), identifying their influence on textural properties and catalytic performance. Regarding the textural properties, vermiculite proved to be the most favorable support due to its high porosity. It was also established that the implemented metals impart positive characteristics to the catalysts due to their various properties; however, incorporating large amounts led to an adverse effect by clogging the pores. Catalytic performance was analyzed in isomerization and cracking reactions, which were enhanced by the use of cerium due to the presence of Brønsted acid sites and molybdenum for its stability. In this way, the statistical analysis conducted in this study was crucial for identifying the influence of key factors on the textural properties and catalytic performance of bifunctional catalysts. Using a 2n experimental design allowed for a systematic evaluation of variables reported in the literature, such as support, acidity modifiers, metals, metal content, promoters, and heteropolyacids.