AZAiqun Zhang

Aiqun Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Aiqun Zhang has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dexterity Based Viscous Resistance Optimization of a Deep-Sea Manipulator

    by Yunfei Bai, Qifeng Zhang, Aiqun Zhang

    With persistent ocean exploration, the complexity of deep-sea intervention is gradually increasing. The deep-sea manipulator is the primary tool to complete complex intervention. The manipulator dexterity determines the complexity of the task it can perform. First, a dynamic dexterity evaluation method is proposed based on the kinematics and dynamics characteristics of the deep-sea manipulator. This method takes into account the dynamic torque boundary and Jacobian mapping constraint, which are different from terrestrial manipulators. The concepts of the dynamic dexterity ellipsoid and dynamic dexterity measure are defined. Second, the effect of viscosity resistance on dexterity is analyzed. The viscosity resistance is optimized by selecting the most suitable compensation oil. Finally, the methods of dynamic dexterity evaluation and viscosity resistance optimization are verified by a simulated deep-sea experiment. The method proposed in this paper effectively improves the dynamic dexterity of the deep-sea manipulator by optimizing the viscosity resistance. The proposed method can also be used to evaluate and improve the dexterity of other underwater manipulators.


  • Open Access

    Model-Aided Localization and Navigation for Underwater Gliders Using Single-Beacon Travel-Time Differences

    by Jie Sun, Feng Hu, Wenming Jin, Jin Wang, Xu Wang, Yeteng Luo, Jiancheng Yu, Aiqun Zhang

    An accurate motion model and reliable measurements are required for autonomous underwater vehicle localization and navigation in underwater environments. However, without a propeller, underwater gliders have limited maneuverability and carrying capacity, which brings difficulties for modeling and measuring. In this paper, an extended Kalman filter (EKF)-based method, combining a modified kinematic model of underwater gliders with the travel-time differences between signals received from a single beacon, is proposed for estimating the glider positions in a predict-update cycle. First, to accurately establish a motion model for underwater gliders moving in the ocean, we introduce two modification parameters, the attack and drift angles, into a kinematic model of underwater gliders, along with depth-averaged current velocities. The attack and drift angles are calculated based on the coefficients of hydrodynamic forces and the sensor-measured angle variation over time. Then, instead of satisfying synchronization requirements, the travel-time differences between signals received from a single beacon, multiplied by the sound speed, are taken as the measurements. To further reduce the EKF estimation error, the Rauch-Tung-Striebel (RTS) smoothing method is merged into the EKF system. The proposed method is tested in a virtual spatiotemporal environment from an ocean model. The experimental results show that the performance of the RTS-EKF estimate is improved when compared with the motion model estimate, especially by 46% at the inflection point, at least in the particular study developed in this article.


  • Open Access

    Distributed Traversability Analysis of Flow Field Under Communication Constraints

    by Shijie Liu, Jie Sun, Jiancheng Yu, Aiqun Zhang, Fumin Zhang

    Traversability analysis, previously developed for ground robots, is extended to be performed by a group of marine vehicles over ocean flow fields. To enable distributed path planning against flow, a systematic method is developed to determine a flow map that is significant for sharing among vehicles. Using traversability analysis, each vehicle finds a set of support vectors to approximate the boundary of flow regions with strong average flow speed. These support vectors, together with the parameters determined by the traversability analysis, are then shared over the communication links. The shared information is used by each vehicle to construct a flow map that supports path planning algorithms running on each vehicle. Underwater communication limits the amount of information contained in a map that can be shared among vehicles. A novel method for information reduction is developed so that only reduced flow maps are shared. The length of the data packets can be adjusted through an optimization process that balance between the fidelity of the approximated boundary and the number of bits that need to be transmitted. Simulation results demonstrate that the flow maps constructed from the shared information can have sufficient quality to allow near-optimal paths to be generated.


  • Open Access

    Identifying Rhodamine Dye Plume Sources in Near-Shore Oceanic Environments by Integration of Chemical and Visual Sensors

    by Yu Tian, Xiaodong Kang, Yunyi Li, Wei Li, Aiqun Zhang, Jiangchen Yu, Yiping Li

    This article presents a strategy for identifying the source location of a chemical plume in near-shore oceanic environments where the plume is developed under the influence of turbulence, tides and waves. This strategy includes two modules: source declaration (or identification) and source verification embedded in a subsumption architecture. Algorithms for source identification are derived from the moth-inspired plume tracing strategies based on a chemical sensor. The in-water test missions, conducted in November 2002 at San Clemente Island (California, USA) in June 2003 in Duck (North Carolina, USA) and in October 2010 at Dalian Bay (China), successfully identified the source locations after autonomous underwater vehicles tracked the rhodamine dye plumes with a significant meander over 100 meters. The objective of the verification module is to verify the declared plume source using a visual sensor. Because images taken in near shore oceanic environments are very vague and colors in the images are not well-defined, we adopt a fuzzy color extractor to segment the color components and recognize the chemical plume and its source by measuring color similarity. The source verification module is tested by images taken during the CPT missions.


  • Open Access

    Improved Design and Control Experiments of an Underwater Electric Manipulator

    by Qifeng Zhang, Aiqun Zhang, Kuichen Yan

    Autonomous/semi-autonomous working underwater vehicle is a development trend of underwater vehicles. This paper briefly analyzes the requirements of underwater electric manipulator to be equipped on autonomous underwater vehicles, and designs a three-function underwater electric manipulator test-bed. The test-bed has the characteristics of compact configuration, complete function and with big moment output. But exterior cable layout increases the possibility to arise malfunction especially when the manipulator working in water. An improved design of the manipulator with inner cable layout is also presented in this paper. Based on the frequency characteristics of the rotary joint driven module, the PI correction is designed to control the shoulder and elbow joint's angular rate. Then the angle error is regarded as the input of angular rate control loop after a PID controller, and a non-regressor adaptive controller, which has been widely adopted as an effective means in underwater vehicle control, is also used to control the manipulator as a selective method. Experiment results demonstrate the good effect of the PID and the adaptive controllers in controlling joint angle, and with the inner control loop, the non-regressor adaptive controller is more robust than that without inner-loop, and it is a more appropriate controller than PID controller especially in protecting the manipulator's motors from saturated voltage