Mariana Abreu

The cork industry generates valuable by-products and residues with significant potential within a circular bioeconomy framework. This study evaluated the energy-driven valorization of two post-consumer cork residues—natural cork stoppers (NCS) and technical cork stoppers (TCS)—through anaerobic digestion and pyrolysis. Both NCS and TCS exhibited low moisture and ash content, a high heating value of 25.14 and 29.88 MJ/kg, respectively, a carbon content exceeding 58 wt% and low nitrogen, sulfur and chlorine concentrations. These characteristics highlight the suitability of NCS and TCS for energy recovery applications. Anaerobic digestion produced biogas containing 68.5 vol% of methane after alkaline pretreatment of TCS. However, the maximum biochemical methane potential was low, reaching only 19.5 L CH₄/kg VS. The resulting digestates contained nitrogen, phosphorus and potassium at levels compatible with agricultural use. Slow pyrolysis of the cork residues resulted in high biochar yields, with NCS achieving an average yield of 64.8 wt%. Combined with carbon contents of up to 66.3 wt%, the biochars produced from NCS and TCS show strong potential for valorization as solid energy carriers, as well as for applications such as activated carbon production and soil amendment. Overall, thermochemical conversion via pyrolysis proved to be the most effective pathway for energy valorization of the tested cork residues, whereas the performance of anaerobic digestion remained limited unless more intensive pretreatment strategies were applied.

A methodology was developed to assess the allocation of different types of endogenous waste biomass to eight technologies for producing electricity, heat, biogas and advanced biofuels. It was based on the identification of key physicochemical parameters for each conversion process and the definition of limit values for each parameter, applied to two different matrices of waste biomass. This enabled the creation of one Admissibility Grid with target values per type of waste biomass and conversion technology, applicable to a decision process in the routing to energy production. The construction of the grid was based on the evaluation of 24 types of waste biomass, corresponding to 48 sets of samples tested, for which a detailed physicochemical characterization and an admissibility assessment were made. The samples were collected from Municipal Solid Waste treatment facilities, sewage sludges, agro-industrial companies, poultry farms, and pulp and paper industries. The conversion technologies and energy products considered were (trans)esterification to fatty acid methyl esters, anaerobic digestion to methane, fermentation to bioethanol, dark fermentation to biohydrogen, combustion to electricity and heat, gasification to syngas, and pyrolysis and hydrothermal liquefaction to bio-oils. The validation of the Admissibility Grid was based on the determination of conversion rates and product yields over 23 case studies that were selected according to the best combinations of waste biomass type versus technological solution and energy product.

Energy crops are dedicated cultures directed for biofuels, electricity, and heat production. Due to their tolerance to contaminated lands, they can alleviate and remediate land pollution by the disposal of toxic elements and polymetallic agents. Moreover, these crops are suitable to be exploited in marginal soils (e.g., saline), and, therefore, the risk of land-use conflicts due to competition for food, feed, and fuel is reduced, contributing positively to economic growth, and bringing additional revenue to landowners. Therefore, further study and investment in R&D is required to link energy crops to the implementation of biorefineries. The main objective of this study is to present a review of the potential of selected energy crops for bioenergy and biofuels production, when cultivated in marginal/degraded/contaminated (MDC) soils (not competing with agriculture), contributing to avoiding Indirect Land Use Change (ILUC) burdens. The selected energy crops are Cynara cardunculus, Arundo donax, Cannabis sativa, Helianthus tuberosus, Linum usitatissimum, Miscanthus × giganteus, Sorghum bicolor, Panicum virgatum, Acacia dealbata, Pinus pinaster, Paulownia tomentosa, Populus alba, Populus nigra, Salix viminalis, and microalgae cultures. This article is useful for researchers or entrepreneurs who want to know what kind of crops can produce which biofuels in MDC soils.

The main objective of the Portuguese project “CONVERTE-Biomass Potential for Energy” is to support the transition to a low-carbon economy, identifying biomass typologies in mainland Portugal, namely agri-forest waste, energy crops and microalgae. Therefore, the aim was to design and construct a georeferenced (mapping) database for mainland Portugal, to identify land availability for the implementation of energy crops and microalgae cultures, and to locate agricultural and forestry production areas (including their residues) with potential for sustainable exploitation for energy. The ArcGIS software was used as a Geographic Information System (GIS) tool, introducing the data corresponding to the type of soil, water needs and edaphoclimatic conditions in shapefile and raster data type, to assess the areas for the implantation of the biomass of interest. After analysing the data of interest in each map in ArcGIS, the intersection of all maps is presented, suggesting adequate areas and predicting biomass productions for the implementation of each culture in mainland Portugal. Under the conditions of the study, cardoon (72 kha, 1085 kt), paulownia (81 kha, 26 kt) and microalgae (29 kha, 1616 kt) presented the greater viability to be exploited as biomass to energy in degraded and marginal soils.