Tianjun Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Tianjun Wu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Huihua Liu
University of Electronic Science and Technology of China
5 shared publications - Xiaoning Zhang
School of Electronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu, China
4 shared publications - Chenxi Zhao
University of Electronic Science and Technology of China
3 shared publications - Kai Kang
University of Electronic Science and Technology of China
3 shared publications - Yiming Yu
University of Electronic Science and Technology of China
3 shared publications - Yunqiu Wu
University of Electronic Science and Technology of China
3 shared publications
Latest Publications
- 22 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 72 (3) , 1643-1656
A 20–43-GHz Low Phase Variation VGA With Feedforward Signal Suppression and Impedance-Invariant Techniques in 65-nm CMOS
A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .
- 22 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 72 (3) , 1643-1656
A 20–43-GHz Low Phase Variation VGA With Feedforward Signal Suppression and Impedance-Invariant Techniques in 65-nm CMOS
A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .
- 12 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 69 (4) , 2371-2385
A 60-GHz Variable Gain Phase Shifter With 14.8-dB Gain Tuning Range and 6-Bit Phase Resolution Across −25 °C–110 °C
This article presents a 60-GHz variable gain phase shifter (VGPS) with orthogonal phase and gain control technique and linear phase control technique in 65-nm CMOS. Using the orthogonal phase and gain control technique, the proposed VGPS has the ability of gain tuning without extra variable gain block, significantly reducing the size of conventional phased arrays. The linear phase control technique is proposed to greatly improve the accuracy and robustness of phase control against temperature variation. As results, the VGPS achieves 6-bit phase resolution across -25 °C to 110 °C and continuous gain tuning range of 14.8 dB. The measured 3-dB bandwidth is 52-64 GHz. As the gain of VGPS is -22.4 to -dB, the measured root-mean-square (rms) phase errors are 1.3°-3.3°, while the measured rms gain errors are 0.2-0.5 dB in 3-dB bandwidth. Across -25 °C to 110 °C, the variations of rms phase and gain errors are below 1.2° and 0.1 dB, respectively. With supply voltage varying from 1.0 to 1.2 V, the variations of rms phase and gain errors are below 1.1° and 0.2 dB, respectively. During the measurement with different combinations of temperature and supply voltage, no gain and phase calibrations are conducted. The measured input-referred P 1 dB at the maximum gain state (-7.6 dB) is about -3.8 dBm. The chip consumes 16.4 mA from a 1.1-V voltage supply and the core area of the VGPS is 720 μm ×560 μm.
- 12 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 69 (4) , 2371-2385
A 60-GHz Variable Gain Phase Shifter With 14.8-dB Gain Tuning Range and 6-Bit Phase Resolution Across −25 °C–110 °C
This article presents a 60-GHz variable gain phase shifter (VGPS) with orthogonal phase and gain control technique and linear phase control technique in 65-nm CMOS. Using the orthogonal phase and gain control technique, the proposed VGPS has the ability of gain tuning without extra variable gain block, significantly reducing the size of conventional phased arrays. The linear phase control technique is proposed to greatly improve the accuracy and robustness of phase control against temperature variation. As results, the VGPS achieves 6-bit phase resolution across -25 °C to 110 °C and continuous gain tuning range of 14.8 dB. The measured 3-dB bandwidth is 52-64 GHz. As the gain of VGPS is -22.4 to -dB, the measured root-mean-square (rms) phase errors are 1.3°-3.3°, while the measured rms gain errors are 0.2-0.5 dB in 3-dB bandwidth. Across -25 °C to 110 °C, the variations of rms phase and gain errors are below 1.2° and 0.1 dB, respectively. With supply voltage varying from 1.0 to 1.2 V, the variations of rms phase and gain errors are below 1.1° and 0.2 dB, respectively. During the measurement with different combinations of temperature and supply voltage, no gain and phase calibrations are conducted. The measured input-referred P 1 dB at the maximum gain state (-7.6 dB) is about -3.8 dBm. The chip consumes 16.4 mA from a 1.1-V voltage supply and the core area of the VGPS is 720 μm ×560 μm.
- 23 January 2021
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 63 (6) , 1652-1656
A 21.5 ~ 25 GHz 7‐bit phase shifter with passive vector‐sum topology
- 23 January 2021
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 63 (6) , 1652-1656
A 21.5 ~ 25 GHz 7‐bit phase shifter with passive vector‐sum topology
- 29 August 2020
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 63 (2) , 411-416
A 8.5 to 11.6 GHz digitally controlled variable gain amplifier with 15‐dB gain range and 1‐dB step
A X‐band variable gain amplifier (VGA) with low phase variation and high control resolution is presented in 180‐nm CMOS. The linear gain VGA and current‐type digital‐to‐analog converter (DAC) are implemented to improve the accuracy of gain control and the robustness against process, supply voltage, and temperature variations (PVT). The measured peak gain and 3‐dB bandwidth are 8 dB and 8.5 to 11.6 GHz, respectively. The gain range is 15 dB with a gain step of 1 dB. With a supply voltage varying from 1.6 to 2.0 V, the root‐mean‐square (RMS) gain and phase errors in 3‐dB bandwidth are <0.62 dB and <1.5°, respectively. With supply of 1.8 V, the measured root‐mean‐square (RMS) gain and phase errors across −25 to 110°C are <0.65 dB and <1.7°, respectively. Comparing the measurement results of five chips, the variation of RMS gain error is <0.24 dB, and the RMS phase errors are almost the same. The measurement results demonstrate the proposed VGA is very suitable for phased arrays in X‐band.
- 29 August 2020
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 63 (2) , 411-416
A 8.5 to 11.6 GHz digitally controlled variable gain amplifier with 15‐dB gain range and 1‐dB step
A X‐band variable gain amplifier (VGA) with low phase variation and high control resolution is presented in 180‐nm CMOS. The linear gain VGA and current‐type digital‐to‐analog converter (DAC) are implemented to improve the accuracy of gain control and the robustness against process, supply voltage, and temperature variations (PVT). The measured peak gain and 3‐dB bandwidth are 8 dB and 8.5 to 11.6 GHz, respectively. The gain range is 15 dB with a gain step of 1 dB. With a supply voltage varying from 1.6 to 2.0 V, the root‐mean‐square (RMS) gain and phase errors in 3‐dB bandwidth are <0.62 dB and <1.5°, respectively. With supply of 1.8 V, the measured root‐mean‐square (RMS) gain and phase errors across −25 to 110°C are <0.65 dB and <1.7°, respectively. Comparing the measurement results of five chips, the variation of RMS gain error is <0.24 dB, and the RMS phase errors are almost the same. The measurement results demonstrate the proposed VGA is very suitable for phased arrays in X‐band.
- Open Access
- 13 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 29311-29318
A Ku-Band 6-Bit Vector-Sum Phase Shifter With Half-Quadrant Control Technique
- 13 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 29311-29318
Open AccessA Ku-Band 6-Bit Vector-Sum Phase Shifter With Half-Quadrant Control Technique