Yu Qi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yu Qi has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Chen Shiqiang
School of Resources, Environment and Safety Engineering, Hunan University of Science and Technology, Xiangtan 411201, China
1 shared publicationChunyu Liu
School of Civil Engineering, Hunan University of Science and Technology, Xiangtan, China
1 shared publicationLi Xun
School of Civil Engineering, Hunan University of Science and Technology, Xiangtan 411201, China
1 shared publication- Licheng Wang
University of Queensland, Brisbane, QLD, Australia
1 shared publication - Meng-Ya Wang
Cell Electrophysiology Laboratory, Wannan Medical College, Wuhu, Anhui 241002, China
1 shared publication - Shiqiang Chen
Sanya Institute of Hunan University of Science and Technology, Sanya, China
1 shared publication
Latest Publications
- 1 November 2021
- Published by Elsevier in Powder Technology
- Vol. 393, 143-153
Study on the mass and heat transfer of gas-liquid two-phase flow in the porous media based on the 3D reconstruction model
- 1 November 2021
- Published by Elsevier in Powder Technology
- Vol. 393, 143-153
Study on the mass and heat transfer of gas-liquid two-phase flow in the porous media based on the 3D reconstruction model
- Open Access
- 1 June 2020
- Published by IWA Publishing in Water Practice & Technology
- Vol. 15 (2) , 416-425
Experimental study of the flux Law of flat ceramic membranes under different pressures
The flux performance of ceramic membranes is the basis for their efficient use. To study ceramic membrane flux variation, different filtration operating conditions were tested and the functional relationship between the membrane's clean water flux and the operating pressure within a given range obtained. The membrane's critical pressure and flux were determined by using pressure increments, and the flux variation law under different pressures determined experimentally. Analysis of the flux law and the membrane parameters enabled establishment of the flux model of filtration process and a model of flux stabilization after the deposition layer formed. The applicability of the model was proved by comparing and verifying the experimental data.
- 1 June 2020
- Published by IWA Publishing in Water Practice & Technology
- Vol. 15 (2) , 416-425
Open AccessExperimental study of the flux Law of flat ceramic membranes under different pressures
The flux performance of ceramic membranes is the basis for their efficient use. To study ceramic membrane flux variation, different filtration operating conditions were tested and the functional relationship between the membrane's clean water flux and the operating pressure within a given range obtained. The membrane's critical pressure and flux were determined by using pressure increments, and the flux variation law under different pressures determined experimentally. Analysis of the flux law and the membrane parameters enabled establishment of the flux model of filtration process and a model of flux stabilization after the deposition layer formed. The applicability of the model was proved by comparing and verifying the experimental data.
- Open Access
- 16 February 2020
- Published by SAGE Publications in Energy Exploration & Exploitation
- Vol. 39 (2) , 657-668
Effects of co-current airflow on water atomization in a curved diffuser
To explore the effect of airflow on water atomization mechanism in mine exhaust heat recovery system, an experimental study of the dispersed phase fraction for droplets is conducted by Malvern laser particle size analyzer. This paper focuses on the influence of gas disturbance on water atomization in a curved diffuser in a ventilation system. With the theory of liquid breakup, it shows how liquid sheet occurs in primary breakup under different operating conditions. In case that the spray flows in the same direction as the airflow, the dominant factor affecting the breakup length of liquid film near the atomizing nozzle is the injection pressure. At a long distance from the nozzle, the droplet goes through vibrational shape oscillation and eventually further breakup in the complete atomization area. The main conclusions are as follows: (1) the dispersed phase fraction for droplets reaches maximum when the airflow is 3.2 m3/s; (2) droplets achieve the optimal atomization effect of the spray; (3) the heat and moisture should be fully exchanged.
- 16 February 2020
- Published by SAGE Publications in Energy Exploration & Exploitation
- Vol. 39 (2) , 657-668
Open AccessEffects of co-current airflow on water atomization in a curved diffuser
To explore the effect of airflow on water atomization mechanism in mine exhaust heat recovery system, an experimental study of the dispersed phase fraction for droplets is conducted by Malvern laser particle size analyzer. This paper focuses on the influence of gas disturbance on water atomization in a curved diffuser in a ventilation system. With the theory of liquid breakup, it shows how liquid sheet occurs in primary breakup under different operating conditions. In case that the spray flows in the same direction as the airflow, the dominant factor affecting the breakup length of liquid film near the atomizing nozzle is the injection pressure. At a long distance from the nozzle, the droplet goes through vibrational shape oscillation and eventually further breakup in the complete atomization area. The main conclusions are as follows: (1) the dispersed phase fraction for droplets reaches maximum when the airflow is 3.2 m3/s; (2) droplets achieve the optimal atomization effect of the spray; (3) the heat and moisture should be fully exchanged.