Ke Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ke Yang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Bin Li
Tianjin University
1 shared publication - Guan Wang
Heilongjiang University (China)
1 shared publication - Jiebei Zhu
School of Electrical and Information Engineering, Tianjin University, Tianjin, China
1 shared publication - Shangjian Zhang
Research Center for Microwave Photonics, School of Optoelectronic Science and Engineering, University of Electronic Science and Technology of China, Chengdu, China
1 shared publication Shuxu Liao
Univ. of Electronic Science and Technology of China (China)
1 shared publication- Xi Chen
School of Electrical and Information Engineering, Tianjin University, Nankai District, Tianjin, China
1 shared publication
Latest Publications
- 9 October 2021
- Published by SPIE-Intl Soc Optical Eng
- Vol. 11891, 24-126
Optical frequency comb generation by mutual injection in twin-stripe semiconductor laser
In this paper, we propose and numerically investigate a novel method to generate optical frequency comb (OFC) based on mutual injection in a twin-stripe semiconductor laser (a cell array integrating two lasers on one chip in parallel). Because of the existence of optical confinement factors and the small waveguide spacing, considerable lateral coupling or mutual injection occurs between the two paralleling neighbors. The twin-stripe semiconductor laser will be driven into complex nonlinear dynamic states and can be employed to generate OFCs. The proposed mutual-injection-induced OFC generation method does not need any external microwave sources or modulators. Moreover, the compact OFC generator is free of any auxiliary optical passive devices required in the typical master-slave injection configuration. The numerical results show that the mutual-injection-induced OFC can be flexibly adjusted by changing the bias currents and the mutual injection parameters.
- 9 October 2021
- Published by SPIE-Intl Soc Optical Eng
- Vol. 11891, 24-126
Optical frequency comb generation by mutual injection in twin-stripe semiconductor laser
In this paper, we propose and numerically investigate a novel method to generate optical frequency comb (OFC) based on mutual injection in a twin-stripe semiconductor laser (a cell array integrating two lasers on one chip in parallel). Because of the existence of optical confinement factors and the small waveguide spacing, considerable lateral coupling or mutual injection occurs between the two paralleling neighbors. The twin-stripe semiconductor laser will be driven into complex nonlinear dynamic states and can be employed to generate OFCs. The proposed mutual-injection-induced OFC generation method does not need any external microwave sources or modulators. Moreover, the compact OFC generator is free of any auxiliary optical passive devices required in the typical master-slave injection configuration. The numerical results show that the mutual-injection-induced OFC can be flexibly adjusted by changing the bias currents and the mutual injection parameters.
- Open Access
- 13 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 35038-35047
Enabling the Smart and Flexible Management of Energy Prosumers via the Energy Router With Parallel Operation Mode
With the increasing penetration of renewable distributed generations (DGs), large numbers of “energy prosumers” are emerging rapidly. There will be severe impacts on the utility grid if these renewable DGs are not managed properly. Smart electrical power devices which enable high flexibility in energy management, alleviation in harmonic pollutions and friendly interactions with the utility grid are needed urgently. To meet all these requirements, a novel energy router which enables a unique parallel operation mode to the energy prosumer is presented. Facilitated with a bi-directional DC/AC converter, a switch array module and a fuzzy logic based hierarchical control strategy, the presented energy router enables plug-and-play connections and reliable energy management for the energy prosumer. The switch array and the parallel mode enable the loads to be flexibly scheduled to reduce energy cost and improve system performance. MATLAB/Simulink model of the energy prosumer is set up and a fuzzy logic based hierarchical control strategy is implemented for transient power balance control in various operation modes. Simulation results have demonstrated high flexibility, stability and feasibility of the proposed energy router in energy management of the prosumer, which will contribute to the better utilization of the ever-growing renewable energies.
- 13 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 35038-35047
Open AccessEnabling the Smart and Flexible Management of Energy Prosumers via the Energy Router With Parallel Operation Mode
With the increasing penetration of renewable distributed generations (DGs), large numbers of “energy prosumers” are emerging rapidly. There will be severe impacts on the utility grid if these renewable DGs are not managed properly. Smart electrical power devices which enable high flexibility in energy management, alleviation in harmonic pollutions and friendly interactions with the utility grid are needed urgently. To meet all these requirements, a novel energy router which enables a unique parallel operation mode to the energy prosumer is presented. Facilitated with a bi-directional DC/AC converter, a switch array module and a fuzzy logic based hierarchical control strategy, the presented energy router enables plug-and-play connections and reliable energy management for the energy prosumer. The switch array and the parallel mode enable the loads to be flexibly scheduled to reduce energy cost and improve system performance. MATLAB/Simulink model of the energy prosumer is set up and a fuzzy logic based hierarchical control strategy is implemented for transient power balance control in various operation modes. Simulation results have demonstrated high flexibility, stability and feasibility of the proposed energy router in energy management of the prosumer, which will contribute to the better utilization of the ever-growing renewable energies.