Manas Ranjan Tripathy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Manas Ranjan Tripathy has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Satyabrata Jit
Indian Institute of Technology (BHU)
3 shared publications - Ashish Kumar Singh
Department of Electronics and Communication Engineering, Graphic Era (Deemed to be University), Dehradun, India
2 shared publications - Kamalaksha Baral
Department of Electronics and Communication Engineering, VIT-AP University, Amravathi, India
2 shared publications - A. Samad
Department of Electronics Engineering, IIT (BHU) Varanasi, Varanasi 221005, India
1 shared publication Prince Kumar Singh
Department of Electronics Engineering, IIT (BHU) Varanasi, Varanasi 221005, India
1 shared publicationSweta Chander
Department of Electronics Engineering, IIT (BHU) Varanasi, Varanasi 221005, India
1 shared publication
Latest Publications
- 27 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (9) , 5185-5192
GaSb/GaAs Type-II Heterojunction TFET on SELBOX Substrate for Dielectric Modulated Label-Free Biosensing Application
A novel GaSb/GaAs type-II heterojunction TFET on SELBOX substrate (HJ-STFET)-based dielectric-modulated ultrasensitive label-free biosensor has been demonstrated in this article. The SELBOX substrate has been used in the proposed TFET-based sensor to reduce the lattice heat and improve the$\textit{I}_{\biosub{on}}$ /$\textit{I}_{\biosub{off}}$ ratio. Cavities in the gate oxide of the TFET are created to form dual-cavity (DC) HJ-STFET structure. These cavities contain the biomolecules to be sensed through the principle of gate-dielectric modulation. To validate the results, the analytical modeling of surface potential has been compared to simulated outcomes for different dielectric constant values of biomolecules. The threshold voltage sensitivity ($\textit{S}_{\text{VT}}$ ) and$\textit{I}_{\biosub{on}}/\textit{I}_{\biosub{off}}$ sensitivity parameters of the proposed DC-HJ-STFET structure have been thoroughly investigated considering different biomolecules. The proposed DC-HJ-TFET structure is shown to have a higher current sensitivity ($\sim $ 6.67$\times$ 10$^{\text{11}}$ ) and threshold voltage sensitivity (0.37 V) values over some recently reported TFET-based biosensors. Finally, we have verified the drain and back gate biasing, as well as linearity fit verification, on the proposed biosensor’s performance.- 27 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 69 (9) , 5185-5192
GaSb/GaAs Type-II Heterojunction TFET on SELBOX Substrate for Dielectric Modulated Label-Free Biosensing Application
A novel GaSb/GaAs type-II heterojunction TFET on SELBOX substrate (HJ-STFET)-based dielectric-modulated ultrasensitive label-free biosensor has been demonstrated in this article. The SELBOX substrate has been used in the proposed TFET-based sensor to reduce the lattice heat and improve the$\textit{I}_{\biosub{on}}$ /$\textit{I}_{\biosub{off}}$ ratio. Cavities in the gate oxide of the TFET are created to form dual-cavity (DC) HJ-STFET structure. These cavities contain the biomolecules to be sensed through the principle of gate-dielectric modulation. To validate the results, the analytical modeling of surface potential has been compared to simulated outcomes for different dielectric constant values of biomolecules. The threshold voltage sensitivity ($\textit{S}_{\text{VT}}$ ) and$\textit{I}_{\biosub{on}}/\textit{I}_{\biosub{off}}$ sensitivity parameters of the proposed DC-HJ-STFET structure have been thoroughly investigated considering different biomolecules. The proposed DC-HJ-TFET structure is shown to have a higher current sensitivity ($\sim $ 6.67$\times$ 10$^{\text{11}}$ ) and threshold voltage sensitivity (0.37 V) values over some recently reported TFET-based biosensors. Finally, we have verified the drain and back gate biasing, as well as linearity fit verification, on the proposed biosensor’s performance.- 1 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 21 (3) , 372-378
Lateral and Vertical Gate Oxide Stacking Impact on Noise Margins and Delays for the 8T SRAM Designed With Source Pocket Engineered GaSb/Si Heterojunction Vertical TFET: A Reliability Study
This work investigates the impact of gate-oxide stacking on the performance of source-pocket engineered (SPE) GaSb/Si heterojunction (HJ) vertical TFETs (VTFETs) based 8T SRAMs. The 8T SRAMs circuits are designed using the SPE-HJ-VTFETs with three different gate-oxide engineered structures: laterally stacked HfO2/Al2O3 gate-oxide, vertically stacked Al2O3/HfO2 gate-oxide and only Al2O3 as gate-oxide. The surface potential, electric field, transfer characteristics, drain characteristics and intrinsic capacitances of all three types of VTFETs considered in this paper are compared. The read static noise margin (RSNM), write margin (WM), read delay as well as write delay of the SRAMs designed by three forms of the SPE GaSb/Si HJ-VTFETs structures have been compared. It is shown that the intrinsic capacitances originated from different stacking-based gate-oxide structures affect the performance of the SRAM significantly. The read delay is significantly the highest for the 8T SRAM designed by laterally stacked gate-oxide based SPE-HJ-VTFETs than the other two 8T SRAMs under consideration. Electrical performance analysis of the VTFETs under study has been studied using commercially available SILVACO ATLASTM TCAD tool whereas performance analysis of the 8T SRAMs have been carried out utilizing CADENCE Virtuoso tool by virtue of Verilog A code.
- 1 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Device and Materials Reliability
- Vol. 21 (3) , 372-378
Lateral and Vertical Gate Oxide Stacking Impact on Noise Margins and Delays for the 8T SRAM Designed With Source Pocket Engineered GaSb/Si Heterojunction Vertical TFET: A Reliability Study
This work investigates the impact of gate-oxide stacking on the performance of source-pocket engineered (SPE) GaSb/Si heterojunction (HJ) vertical TFETs (VTFETs) based 8T SRAMs. The 8T SRAMs circuits are designed using the SPE-HJ-VTFETs with three different gate-oxide engineered structures: laterally stacked HfO2/Al2O3 gate-oxide, vertically stacked Al2O3/HfO2 gate-oxide and only Al2O3 as gate-oxide. The surface potential, electric field, transfer characteristics, drain characteristics and intrinsic capacitances of all three types of VTFETs considered in this paper are compared. The read static noise margin (RSNM), write margin (WM), read delay as well as write delay of the SRAMs designed by three forms of the SPE GaSb/Si HJ-VTFETs structures have been compared. It is shown that the intrinsic capacitances originated from different stacking-based gate-oxide structures affect the performance of the SRAM significantly. The read delay is significantly the highest for the 8T SRAM designed by laterally stacked gate-oxide based SPE-HJ-VTFETs than the other two 8T SRAMs under consideration. Electrical performance analysis of the VTFETs under study has been studied using commercially available SILVACO ATLASTM TCAD tool whereas performance analysis of the 8T SRAMs have been carried out utilizing CADENCE Virtuoso tool by virtue of Verilog A code.
- Top Cited Papers
- 5 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (3) , 1285-1292
Device and Circuit-Level Assessment of GaSb/Si Heterojunction Vertical Tunnel-FET for Low-Power Applications
This article investigates the performance of a vertically grown GaSb/Si tunnel field effect transistor (V-TFET) with a source pocket to enhance the performance of the device. The commercially available Silvaco TCAD has been used for simulating the proposed V-TFET structure. A low bandgap material, GaSb, is used in the source region for the first time to enhance the carrier tunneling through the source (GaSb)-channel (Si) heterojunction. The proposed V-TFET with a pocket shows the improved subthreshold swing (SS) of 26 mV/decade at VDS= 0.5 V over the V-TFET without any pocket. The effects of temperature on SS and ION/IOFF ratio along with the analog/RF figures of merit (FOMs) are also analyzed for V-TFETs with and without a pocket. The results are also compared with some recently reported TFETs. The dc and analog/RF performances of V-TFET with a pocket are shown to be better than those of the V-TFET without a pocket and other reported TFET structures. Finally, the applications of V-TFETs with and without a pocket in designing inverter and ring oscillator circuits have been demonstrated. The dc and transient responses of the V-FET-based inverter and ring oscillator circuits have been analyzed using the Verilog-A model in the CADENCE tool.
- 5 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 67 (3) , 1285-1292
Top Cited PapersDevice and Circuit-Level Assessment of GaSb/Si Heterojunction Vertical Tunnel-FET for Low-Power Applications
This article investigates the performance of a vertically grown GaSb/Si tunnel field effect transistor (V-TFET) with a source pocket to enhance the performance of the device. The commercially available Silvaco TCAD has been used for simulating the proposed V-TFET structure. A low bandgap material, GaSb, is used in the source region for the first time to enhance the carrier tunneling through the source (GaSb)-channel (Si) heterojunction. The proposed V-TFET with a pocket shows the improved subthreshold swing (SS) of 26 mV/decade at VDS= 0.5 V over the V-TFET without any pocket. The effects of temperature on SS and ION/IOFF ratio along with the analog/RF figures of merit (FOMs) are also analyzed for V-TFETs with and without a pocket. The results are also compared with some recently reported TFETs. The dc and analog/RF performances of V-TFET with a pocket are shown to be better than those of the V-TFET without a pocket and other reported TFET structures. Finally, the applications of V-TFETs with and without a pocket in designing inverter and ring oscillator circuits have been demonstrated. The dc and transient responses of the V-FET-based inverter and ring oscillator circuits have been analyzed using the Verilog-A model in the CADENCE tool.