Reddithota J. Krupadam
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Reddithota J. Krupadam has a total of 66 co-authors. Here are the top co-authors by number of shared publications:
Madhu D. Sharma
Environmental Materials Division, CSIR-National Environmental Engineering Research Institute, Nehru Marg, Nagpur, 440020, India; Academy of Scientific & Innovative Research, Sector 19, Kamla Nehru Nagar, Gaziabad, 201002, India
6 shared publicationsSadhana S. Rayalu
Environmental Materials Division, CSIR-National Environmental Engineering Research Institute, Jawaharlal Nehru Marg, Nagpur 440020, India
6 shared publicationsAnshika Yadav
5 shared publicationsJuili S. Mankar
Environmental Materials Division, CSIR-National Environmental Engineering Research Institute, Nehru Marg, Nagpur, 440020, India
5 shared publicationsMuntazir S. Khan
Environmental Impact & Risk Assessment Division, National Environmental Engineering Research Institute, Nehru Marg, Nagpur 440 020, India.
4 shared publicationsBhagyashree Bhagat
National Environmental Engineering Research Institute
3 shared publications
Latest Publications
- 24 April 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (16)
Optimizing CO 2 Adsorption on Fe–BTC: Understanding the Effect of Amine Functionalization and Flue Gas Compatibility
The utilization of microporous metal‐organic frameworks (MOFs) is pivotal for greenhouse gas (GHG) mitigation. In this study, a highly microporous Fe‐BTC material with a distinct oblate spheroid morphology was prepared via a microwave‐assisted synthesis route. The material has shown BET surface area of 1264 m 2 g −1 with a total pore volume of 1.21 cm 3 g −1 and an average pore diameter of 1.72 nm. The adsorption capacity of Fe‐BTC was 2.62 mmol g −1 at 298 K/1 bar. Amine functionalization of Fe‐BTC with different amines, i.e., primary, secondary, and tertiary amines, in a one‐pot synthesis improved the adsorption capacity of Fe‐BTC up to 60% as compared to unfunctionalized Fe‐BTC. The primary amine‐functionalized Fe‐BTC achieved the highest adsorption capacity, while the tertiary amine‐functionalized Fe‐BTC exhibited the highest CO 2 /N 2 selectivity. The functionalized Fe‐BTCs were regenerated for up to 15 cycles without significant loss of structural integrity or CO 2 adsorption capacity. The study demonstrates the potential of amine‐functionalized Fe‐BTC as a sustainable and efficient material for CO 2 capture, offering a trade‐off between adsorption capacity, energy efficiency, and regeneration potential.
- 24 April 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (16)
Optimizing CO 2 Adsorption on Fe–BTC: Understanding the Effect of Amine Functionalization and Flue Gas Compatibility
The utilization of microporous metal‐organic frameworks (MOFs) is pivotal for greenhouse gas (GHG) mitigation. In this study, a highly microporous Fe‐BTC material with a distinct oblate spheroid morphology was prepared via a microwave‐assisted synthesis route. The material has shown BET surface area of 1264 m 2 g −1 with a total pore volume of 1.21 cm 3 g −1 and an average pore diameter of 1.72 nm. The adsorption capacity of Fe‐BTC was 2.62 mmol g −1 at 298 K/1 bar. Amine functionalization of Fe‐BTC with different amines, i.e., primary, secondary, and tertiary amines, in a one‐pot synthesis improved the adsorption capacity of Fe‐BTC up to 60% as compared to unfunctionalized Fe‐BTC. The primary amine‐functionalized Fe‐BTC achieved the highest adsorption capacity, while the tertiary amine‐functionalized Fe‐BTC exhibited the highest CO 2 /N 2 selectivity. The functionalized Fe‐BTCs were regenerated for up to 15 cycles without significant loss of structural integrity or CO 2 adsorption capacity. The study demonstrates the potential of amine‐functionalized Fe‐BTC as a sustainable and efficient material for CO 2 capture, offering a trade‐off between adsorption capacity, energy efficiency, and regeneration potential.
- 27 September 2025
- Published by Elsevier in Science of The Total Environment
- Vol. 1002, 180571
Methane emissions from cattle manure in India: A scenario-based comprehensive study
- 27 September 2025
- Published by Elsevier in Science of The Total Environment
- Vol. 1002, 180571
Methane emissions from cattle manure in India: A scenario-based comprehensive study
- 31 May 2025
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 32 (24) , 14810-14826
Removal of traces of highly explosive trinitrotoluene from TNT red water by using graphene nanocomposites prepared from solid wastes: an example of circular economy
The defence munition is primarily composed of high-intensity explosive chemicals such as trinitrotoluene (TNT) and the manufacturing of TNT generates highly intense red-colored effluents consisting of TNT and its derivatives, sulfonates, and nitrobenzene. As of date, there is no comprehensive treatment for TNT red water. In this study, we propose to treat TNT from red water using different graphene nanocomposites, i.e., GN-G and GN-S, synthesized from graphite and sludge, respectively. The sludge used in the preparation of GN-S was obtained from the chemical coagulation of TNT red water using a mixture of organic acid coagulants. Both these graphene nanocomposites (GNCs) were intercalated with iron salts to produce layered GNCs, and by using atomic force microscopy distance between layers was determined. The GN-S showed high surface area and pore volume of 748 m2 g−1 and 0.55 cm3 g−1 respectively. Owing to these textural properties, GN-S have shown adsorption capacity of 242.3 mg g−1 for TNT from TNT red water. The sludge generated during the treatment of TNT red water was utilized for GN-S preparation, which has proven to be an efficient and reusable adsorbent. Furthermore, the process of preparing GN-S and treating TNT red water aligns with the concept of circular economy. Graphical Abstract
- 31 May 2025
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 32 (24) , 14810-14826
Removal of traces of highly explosive trinitrotoluene from TNT red water by using graphene nanocomposites prepared from solid wastes: an example of circular economy
The defence munition is primarily composed of high-intensity explosive chemicals such as trinitrotoluene (TNT) and the manufacturing of TNT generates highly intense red-colored effluents consisting of TNT and its derivatives, sulfonates, and nitrobenzene. As of date, there is no comprehensive treatment for TNT red water. In this study, we propose to treat TNT from red water using different graphene nanocomposites, i.e., GN-G and GN-S, synthesized from graphite and sludge, respectively. The sludge used in the preparation of GN-S was obtained from the chemical coagulation of TNT red water using a mixture of organic acid coagulants. Both these graphene nanocomposites (GNCs) were intercalated with iron salts to produce layered GNCs, and by using atomic force microscopy distance between layers was determined. The GN-S showed high surface area and pore volume of 748 m2 g−1 and 0.55 cm3 g−1 respectively. Owing to these textural properties, GN-S have shown adsorption capacity of 242.3 mg g−1 for TNT from TNT red water. The sludge generated during the treatment of TNT red water was utilized for GN-S preparation, which has proven to be an efficient and reusable adsorbent. Furthermore, the process of preparing GN-S and treating TNT red water aligns with the concept of circular economy. Graphical Abstract
- 25 April 2025
- Published by Springer Nature in MRS Communications
- Vol. 15 (3) , 483-492
Highly efficient imprinted polymers for capture of environmental carcinogens
- 25 April 2025
- Published by Springer Nature in MRS Communications
- Vol. 15 (3) , 483-492
Highly efficient imprinted polymers for capture of environmental carcinogens
- Open Access
- 25 November 2024
- Published by Springer Nature in Research Square
Removal of traces of highly explosive trinitrotoluene from TNT Red Water by using Graphene Nanocomposites prepared from Solid Wastes: An Example of Circular Economy
The defence munition is primarily composed of high-intensity explosive chemicals such as trinitrotoluene (TNT) and the manufacturing of TNT generates highly intense red-coloured effluents consisting of TNT and its derivatives, sulfonates, and nitrobenzene. As of date, the comprehensive treatment for TNT red water remediation is not reported. In this study, TNT from red water was removed by using graphene nanocomposites (GNCs) prepared from graphite and sludge. The sludge used in the preparation of GNCs was obtained from the chemical coagulation of TNT red water using a mixture of organic acids as coagulant. The GNCs were intercalated with iron to produce few layered high surface area with high microporosity GNCs. The GNC prepared from sludge (GN-S) have shown high surface area and pore volume of 748 m2g-1 and 0.55 cm3 g, respectively. Owing to these textural properties, high adsorption capacity of 151.6 mg g-1 for TNT from TNT red water was achieved. The sludge generated during the treatment of TNT red water was used for GN-S preparation and this GN-S was proven as an efficient reusable adsorbent. The process of preparing GN-S from sludge and removing TNT from red water by adsorption onto GN-S aligns with the concept of circular economy.
- 25 November 2024
- Published by Springer Nature in Research Square
Open AccessRemoval of traces of highly explosive trinitrotoluene from TNT Red Water by using Graphene Nanocomposites prepared from Solid Wastes: An Example of Circular Economy
The defence munition is primarily composed of high-intensity explosive chemicals such as trinitrotoluene (TNT) and the manufacturing of TNT generates highly intense red-coloured effluents consisting of TNT and its derivatives, sulfonates, and nitrobenzene. As of date, the comprehensive treatment for TNT red water remediation is not reported. In this study, TNT from red water was removed by using graphene nanocomposites (GNCs) prepared from graphite and sludge. The sludge used in the preparation of GNCs was obtained from the chemical coagulation of TNT red water using a mixture of organic acids as coagulant. The GNCs were intercalated with iron to produce few layered high surface area with high microporosity GNCs. The GNC prepared from sludge (GN-S) have shown high surface area and pore volume of 748 m2g-1 and 0.55 cm3 g, respectively. Owing to these textural properties, high adsorption capacity of 151.6 mg g-1 for TNT from TNT red water was achieved. The sludge generated during the treatment of TNT red water was used for GN-S preparation and this GN-S was proven as an efficient reusable adsorbent. The process of preparing GN-S from sludge and removing TNT from red water by adsorption onto GN-S aligns with the concept of circular economy.
- 1 April 2022
- Published by Elsevier in Science of The Total Environment
- Vol. 816, 151522
Reduced graphene oxide -MnO2 nanocomposite for CO2 capture from flue gases at elevated temperatures
- 1 April 2022
- Published by Elsevier in Science of The Total Environment
- Vol. 816, 151522
Reduced graphene oxide -MnO2 nanocomposite for CO2 capture from flue gases at elevated temperatures
- 1 December 2021
- Published by Elsevier in Chemosphere
- Vol. 284, 131405
High performance CO2 capture at elevated temperatures by using cenospheres prepared from solid waste, fly ash
- 1 December 2021
- Published by Elsevier in Chemosphere
- Vol. 284, 131405
High performance CO2 capture at elevated temperatures by using cenospheres prepared from solid waste, fly ash