Li Weiwei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Li Weiwei has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Jie Yang
College of Chemistry and Chemical Engineering Xinxiang University 453003 Xinxiang China
2 shared publications- Lu Yao
College of Chemistry and Chemical Engineering, Xinxiang University, Xinxiang, Henan, China
2 shared publications Jiangju Si
College of Chemistry and Chemical Engineering, Xinxiang University, Xinxiang, China
1 shared publication- Jiangju Si
School of Chemistry and Materials Engineering, Xinxiang University, Xinxiang 453003, China
1 shared publication Jiang‐Ju Si
College of Chemistry and Chemical Engineering Xinxiang University 453003 Xinxiang China
1 shared publicationLang Wuke
College of Chemistry and Chemical Engineering, Xinxiang University, Xinxiang, Henan, China
1 shared publication
Latest Publications
- 5 August 2020
- Published by Taylor & Francis in Integrated Ferroelectrics
- Vol. 210 (1) , 1-6
Effect of Na Doping on Electrochemical Properties of Cobalt-Free Li-Rich Mn-Based Cathode Materials
Na doping is introduced to improve the electrochemical properties of Li1.2Mn0.6Ni0.2O2 cathode material, which is synthesized by sol–gel method. The effect of Na doping on the morphological, structural and electrochemical properties was systematically studied and analyzed. These results illustrate that lattice layer spacing is enlarged by Na doping, which is beneficial for the diffusion of Li-ion, and the voltage fading is successfully suppressed. The best electrochemical properties were obtained when Na doping amount is approximately 1%, which is attributed to the stronger structural stability and better reversibility of Li+ during the initial charge and discharge process.
- 5 August 2020
- Published by Taylor & Francis in Integrated Ferroelectrics
- Vol. 210 (1) , 1-6
Effect of Na Doping on Electrochemical Properties of Cobalt-Free Li-Rich Mn-Based Cathode Materials
Na doping is introduced to improve the electrochemical properties of Li1.2Mn0.6Ni0.2O2 cathode material, which is synthesized by sol–gel method. The effect of Na doping on the morphological, structural and electrochemical properties was systematically studied and analyzed. These results illustrate that lattice layer spacing is enlarged by Na doping, which is beneficial for the diffusion of Li-ion, and the voltage fading is successfully suppressed. The best electrochemical properties were obtained when Na doping amount is approximately 1%, which is attributed to the stronger structural stability and better reversibility of Li+ during the initial charge and discharge process.
- 4 July 2020
- Published by Wiley in Rare Metals
- Vol. 40 (7) , 1719-1726
TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 cathode materials with enhanced cycle performance for Li‐ion batteries
Ni‐rich cathode material is one of the most promising materials for Li‐ion batteries in electric vehicles. However, fading capacity, poor cyclic stability and high pH value are still major challenges, which suppress its practical application. In this study, spherical LiNi 0.9 Co 0.08 Al 0.02 O 2 powders with 0.4 wt% TiO 2 coating layer were prepared by impregnation–hydrolysis method. Scanning electron microscopy (SEM), high‐resolution transmission electron microscopy (HRTEM) and X‐ray diffraction (XRD) results show that TiO 2 is uniformly coated on the surface of LiNi 0.9 Co 0.08 Al 0.02 O 2 particle and slightly embedded into LiNi 0.9 Co 0.08 Al 0.02 O 2 particles. After 100 cycles at 2.0C, 0.4 wt% TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode delivers much higher discharge capacity retention (77.0%) than the pristine LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode (63.3%). The excellent cycling performance of 0.4 wt% TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode at a high discharge ratio is due to a TiO 2 coating layer which can effectively reduce the direct contact between cathode material and electrolyte, suppress the oxidation of electrolyte, improve electrical conductivity of the electrode and increase the stability of the structure.
- 4 July 2020
- Published by Wiley in Rare Metals
- Vol. 40 (7) , 1719-1726
TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 cathode materials with enhanced cycle performance for Li‐ion batteries
Ni‐rich cathode material is one of the most promising materials for Li‐ion batteries in electric vehicles. However, fading capacity, poor cyclic stability and high pH value are still major challenges, which suppress its practical application. In this study, spherical LiNi 0.9 Co 0.08 Al 0.02 O 2 powders with 0.4 wt% TiO 2 coating layer were prepared by impregnation–hydrolysis method. Scanning electron microscopy (SEM), high‐resolution transmission electron microscopy (HRTEM) and X‐ray diffraction (XRD) results show that TiO 2 is uniformly coated on the surface of LiNi 0.9 Co 0.08 Al 0.02 O 2 particle and slightly embedded into LiNi 0.9 Co 0.08 Al 0.02 O 2 particles. After 100 cycles at 2.0C, 0.4 wt% TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode delivers much higher discharge capacity retention (77.0%) than the pristine LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode (63.3%). The excellent cycling performance of 0.4 wt% TiO 2 ‐coated LiNi 0.9 Co 0.08 Al 0.02 O 2 electrode at a high discharge ratio is due to a TiO 2 coating layer which can effectively reduce the direct contact between cathode material and electrolyte, suppress the oxidation of electrolyte, improve electrical conductivity of the electrode and increase the stability of the structure.
- Open Access
- 4 March 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (4) , 1-8
The effect of chelating agent on synthesis and electrochemical properties of LiNi0.6Co0.2Mn0.2O2
- 4 March 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (4) , 1-8
Open AccessThe effect of chelating agent on synthesis and electrochemical properties of LiNi0.6Co0.2Mn0.2O2