Payel Choudhury
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Payel Choudhury has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Biswanath Bhunia
Bioproducts Processing Research Laboratory (BPRL), Department of Bio Engineering, National Institute of Technology, Agartala 799046, India
6 shared publications Tarun Kanti Bandyopadhyay
6 shared publicationsRup Narayan Ray
5 shared publications- Tarun Kanti Bandyopadhyay
Department of Chemical Engineering, National Institute of Technology, Agartala, India
3 shared publications Uma Shankar Prasad Uday
3 shared publicationsBiswanath Bhunia
Department of Bioengineering, National Institute of Technology Agartala, Agartala-799046, India
2 shared publications
Latest Publications
- 26 April 2022
- Published by Elsevier in Journal of the Indian Chemical Society
- Vol. 99 (6) , 100489
Optimization for the improvement of power in equal volume of single chamber microbial fuel cell using dairy wastewater
- 26 April 2022
- Published by Elsevier in Journal of the Indian Chemical Society
- Vol. 99 (6) , 100489
Optimization for the improvement of power in equal volume of single chamber microbial fuel cell using dairy wastewater
- Open Access
- 24 August 2021
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 11 (4) , 279-289
Comparative study between synthetic and dairy wastewaters in single chamber microbial fuel cell for power generation
To investigate the performance of microbial fuel cell (MFC) with a single-chamber membrane, Pseudomonas aeruginosa is used as a bio catalyst for various synthetic wastewaters rich in carbohydrate and is compared with real dairy wastewater in this experiment. Therefore, the choice of appropriate carbon, nitrogen, NaCl, inoculum content, temperature, and pH process parameters are used for preparing synthetic wastewater was agreed upon by one-variable-at-a time approach. Maximum levels of voltage generation attained from the synthetic wastewater was 485 mV when supplemented with 1.5 % of lactose as a source of carbon, 0.3 % of ammonium chloride as a decent nitrogen source, 0.03 % of NaCl, inoculum concentration of 3 %, the temperature at 37 oC and pH 7. On the other hand, the maximum voltage attained with real dairy wastewater was 561 mV with high chemical oxygen demand (COD) value of 801 mg l-1. The maximum power density obtained from dairy wastewater was 73.54 mW m-2. Thus, High voltage achieved for MFC operating with real dairy wastewater suggests that it can be used not only for the industrial application to generate more renewable power, but also for the wastewater treatment carried out at the same time.
- 24 August 2021
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 11 (4) , 279-289
Open AccessComparative study between synthetic and dairy wastewaters in single chamber microbial fuel cell for power generation
To investigate the performance of microbial fuel cell (MFC) with a single-chamber membrane, Pseudomonas aeruginosa is used as a bio catalyst for various synthetic wastewaters rich in carbohydrate and is compared with real dairy wastewater in this experiment. Therefore, the choice of appropriate carbon, nitrogen, NaCl, inoculum content, temperature, and pH process parameters are used for preparing synthetic wastewater was agreed upon by one-variable-at-a time approach. Maximum levels of voltage generation attained from the synthetic wastewater was 485 mV when supplemented with 1.5 % of lactose as a source of carbon, 0.3 % of ammonium chloride as a decent nitrogen source, 0.03 % of NaCl, inoculum concentration of 3 %, the temperature at 37 oC and pH 7. On the other hand, the maximum voltage attained with real dairy wastewater was 561 mV with high chemical oxygen demand (COD) value of 801 mg l-1. The maximum power density obtained from dairy wastewater was 73.54 mW m-2. Thus, High voltage achieved for MFC operating with real dairy wastewater suggests that it can be used not only for the industrial application to generate more renewable power, but also for the wastewater treatment carried out at the same time.
- 1 May 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (31) , 16815-16822
Kinetics and performance evaluation of microbial fuel cell supplied with dairy wastewater with simultaneous power generation
- 1 May 2021
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 46 (31) , 16815-16822
Kinetics and performance evaluation of microbial fuel cell supplied with dairy wastewater with simultaneous power generation
- Open Access
- 10 March 2021
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 11 (2) , 129-142
Screening technique on the selection of potent microorganisms for operation in microbial fuel cell for generation of power
This paper focuses on determination of the influence of electrochemically active microorganisms on the transmission of electrons from the respiratory enzymes to the electrode and assembling of exoelectrogens to the simulated wastewater medium. In this study, the total of eight microorganisms were experimentally tested to exhibit growth and high iron-reducing ability in the absence of mediators. A major connection was observed between the growth and iron-reduction ability of the microorganism. The growth and iron-reduction ability were monitored experimentally over time. Based on output data, the screening was done among eight different microorganisms, where Escherichia coli -K-12 was chosen as the most potent microorganism for its wide application in a microbial fuel cell (MFC). In the present study, various biochemical process factors were optimized statistically using Taguchi methodology for the rapid development of growth and iron-reducing assay conditions. The design of various experimental trials was carried out using five process factors at three levels with orthogonal arrays (OA) layout of L18. Five process factors, including quantity of lactose, volume of trace element solution, inoculum percentage, pH, and temperature, were taken into consideration as imperative process factors and optimized for evaluation of growth of bacteria and iron reduction ability. The larger-is-best signal to noise (S/N) ratio, together with analysis of variance ANOVA, were used during optimization. Anticipated results demonstrated that the enhanced bacterial growth of 124.50 % and iron reduction ability of 112.6 % can be achieved with 8 g/L of lactose, 2 ml of trace element solution, 4 % (v/v) of inoculum, pH 7, and temperature of 35 oC. Furthermore, the growth and iron reduction time profiles of Escherichia coli-K12 were performed to determine its feasibility in MFC. Open circuit voltage of 0.555 V was obtained over batch study on a single chamber microbial fuel cell (SCMFC).
- 10 March 2021
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 11 (2) , 129-142
Open AccessScreening technique on the selection of potent microorganisms for operation in microbial fuel cell for generation of power
This paper focuses on determination of the influence of electrochemically active microorganisms on the transmission of electrons from the respiratory enzymes to the electrode and assembling of exoelectrogens to the simulated wastewater medium. In this study, the total of eight microorganisms were experimentally tested to exhibit growth and high iron-reducing ability in the absence of mediators. A major connection was observed between the growth and iron-reduction ability of the microorganism. The growth and iron-reduction ability were monitored experimentally over time. Based on output data, the screening was done among eight different microorganisms, where Escherichia coli -K-12 was chosen as the most potent microorganism for its wide application in a microbial fuel cell (MFC). In the present study, various biochemical process factors were optimized statistically using Taguchi methodology for the rapid development of growth and iron-reducing assay conditions. The design of various experimental trials was carried out using five process factors at three levels with orthogonal arrays (OA) layout of L18. Five process factors, including quantity of lactose, volume of trace element solution, inoculum percentage, pH, and temperature, were taken into consideration as imperative process factors and optimized for evaluation of growth of bacteria and iron reduction ability. The larger-is-best signal to noise (S/N) ratio, together with analysis of variance ANOVA, were used during optimization. Anticipated results demonstrated that the enhanced bacterial growth of 124.50 % and iron reduction ability of 112.6 % can be achieved with 8 g/L of lactose, 2 ml of trace element solution, 4 % (v/v) of inoculum, pH 7, and temperature of 35 oC. Furthermore, the growth and iron reduction time profiles of Escherichia coli-K12 were performed to determine its feasibility in MFC. Open circuit voltage of 0.555 V was obtained over batch study on a single chamber microbial fuel cell (SCMFC).
- Open Access
- 28 February 2021
- Published by The Korean Electrochemical Society - English Journal in Journal of Electrochemical Science and Technology
- Vol. 12 (1) , 101-111
The Overall Performance Improvement of Microbial Fuel Cells Connected in Series with Dairy Wastewater Treatment
- 28 February 2021
- Published by The Korean Electrochemical Society - English Journal in Journal of Electrochemical Science and Technology
- Vol. 12 (1) , 101-111
Open AccessThe Overall Performance Improvement of Microbial Fuel Cells Connected in Series with Dairy Wastewater Treatment
- 3 March 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (6) , 4451-4461
Rapid Protocol for Screening of Biocatalyst for Application in Microbial Fuel Cell: A Study with Shewanella algae
- 3 March 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (6) , 4451-4461
Rapid Protocol for Screening of Biocatalyst for Application in Microbial Fuel Cell: A Study with Shewanella algae
- 1 January 2018
- Published by Inderscience Publishers in International Journal of Renewable Energy Technology
- Vol. 9 (1/2) , 191
To study the effect of glucose feeding rate for sustainable voltage generation from microbial fuel cell containing wastewaters
The sustainable voltage generation was extensively experimented through semi batch using isolated pure microorganism. Though higher voltage generation of 911 mV can be possible through optimisation of process parameters by batch fermentation, however, sustainable power generation was not found in batch process. Therefore, the potential influence of several parameters for voltage generation was addressed by semi continuous fermentation process. In this present work sustainable voltage generation (550 mV) was achieved through fed batch mode when initial glucose was kept 8 g/L in the production medium. However, 18 g/L of glucose (25 ml) was consecutively fed at interval of 72 and 108 h during semi continuous fermentation.
- 1 January 2018
- Published by Inderscience Publishers in International Journal of Renewable Energy Technology
- Vol. 9 (1/2) , 191
To study the effect of glucose feeding rate for sustainable voltage generation from microbial fuel cell containing wastewaters
The sustainable voltage generation was extensively experimented through semi batch using isolated pure microorganism. Though higher voltage generation of 911 mV can be possible through optimisation of process parameters by batch fermentation, however, sustainable power generation was not found in batch process. Therefore, the potential influence of several parameters for voltage generation was addressed by semi continuous fermentation process. In this present work sustainable voltage generation (550 mV) was achieved through fed batch mode when initial glucose was kept 8 g/L in the production medium. However, 18 g/L of glucose (25 ml) was consecutively fed at interval of 72 and 108 h during semi continuous fermentation.
- 28 April 2017
- Published by Taylor & Francis in Bioengineered
- Vol. 8 (5) , 471-487
Performance improvement of microbial fuel cell (MFC) using suitable electrode and Bioengineered organisms: A review
There is an urgent need to find an environment friendly and sustainable technology for alternative energy due to rapid depletion of fossil fuel and industrialization. Microbial Fuel Cells (MFCs) have operational and functional advantages over the current technologies for energy generation from organic matter as it directly converts electricity from substrate at ambient temperature. However, MFCs are still unsuitable for high energy demands due to practical limitations. The overall performance of an MFC depends on microorganism, appropriate electrode materials, suitable MFC designs, and optimizing process parameters which would accelerate commercialization of this technology in near future. In this review, we put forth the recent developments on microorganism and electrode material that are critical for the generation of bioelectricity generation. This would give a comprehensive insight into the characteristics, options, modifications, and evaluations of these parameters and their effects on process development of MFCs.
- 28 April 2017
- Published by Taylor & Francis in Bioengineered
- Vol. 8 (5) , 471-487
Performance improvement of microbial fuel cell (MFC) using suitable electrode and Bioengineered organisms: A review
There is an urgent need to find an environment friendly and sustainable technology for alternative energy due to rapid depletion of fossil fuel and industrialization. Microbial Fuel Cells (MFCs) have operational and functional advantages over the current technologies for energy generation from organic matter as it directly converts electricity from substrate at ambient temperature. However, MFCs are still unsuitable for high energy demands due to practical limitations. The overall performance of an MFC depends on microorganism, appropriate electrode materials, suitable MFC designs, and optimizing process parameters which would accelerate commercialization of this technology in near future. In this review, we put forth the recent developments on microorganism and electrode material that are critical for the generation of bioelectricity generation. This would give a comprehensive insight into the characteristics, options, modifications, and evaluations of these parameters and their effects on process development of MFCs.
- 1 January 2016
- Published by Elsevier in International Journal of Biological Macromolecules
- Vol. 82, 1041-1054
Classification, mode of action and production strategy of xylanase and its application for biofuel production from water hyacinth
- 1 January 2016
- Published by Elsevier in International Journal of Biological Macromolecules
- Vol. 82, 1041-1054
Classification, mode of action and production strategy of xylanase and its application for biofuel production from water hyacinth