Pascale Armand
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Pascale Armand has a total of 72 co-authors. Here are the top co-authors by number of shared publications:
Philippe Papet
7 shared publicationsAdrien Lignie
Institut Charles Gerhardt Montpellier, UMR CNRS 5253, Université de Montpellier, 34095 Montpellier Cedex 5, France
6 shared publications- Bertrand Ménaert
Université Grenoble Alpes, Institut Néel, F38402 Grenoble Cedex 9, France
4 shared publications - Julien Haines
Institut Charles Gerhardt Montpellier, Université de Montpellier, CNRS, ENSCM, 34293 Montpellier, France
4 shared publications - Monique Tillard
Institut Charles Gerhardt, AIME, UMR CNRS 5253 CC15, Université de Montpellier II, Sciences et Techniques du Languedoc, 2 Place Eugène Bataillon, 34095 Montpellier Cédex 5, France
4 shared publications Patrick Hermet
4 shared publications
Latest Publications
- Open Access
- 21 July 2026
- Published by Elsevier in SSRN Electronic Journal
Optical properties study of amorphous antimony chalcogenide (Se, Te)thick films: effect of composition and chalcogen nature
The influence of chemical composition and chalcogen type on the room-temperature optical properties of amorphous antimony chalcogenide thick films, Sb1-xChx (Ch = Se, Te) with 0.41 ≤ x ≤ 0.82, was investigated. X-ray diffraction confirmed the amorphous structure of all samples prepared by a co-evaporation technique. Their chemical compositions were determined using energy-dispersive X-ray spectroscopy. Optical properties were studied by transmission spectroscopy at normal incidence. A straightforward analysis proposed by Swanepoel was used to determine both the refractive index n and the film thickness. Using a two-form Cauchy equation, the refractive-index dispersions as a function of wavelength were obtained. These alloys exhibit ultra-high refractive indices (n: Sb1-xTex > Sb1-xSex > 2.9) that decrease monotonically with increasing Ch content x. The absorption coefficients α as a function of incident photon energy E were calculated, and from a Tauc analysis, both direct and indirect optical band gaps were obtained. The optical results were discussed in terms of atomic electronegativity, electronic polarizability, and atomic packing of the amorphous network.
- 21 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessOptical properties study of amorphous antimony chalcogenide (Se, Te)thick films: effect of composition and chalcogen nature
The influence of chemical composition and chalcogen type on the room-temperature optical properties of amorphous antimony chalcogenide thick films, Sb1-xChx (Ch = Se, Te) with 0.41 ≤ x ≤ 0.82, was investigated. X-ray diffraction confirmed the amorphous structure of all samples prepared by a co-evaporation technique. Their chemical compositions were determined using energy-dispersive X-ray spectroscopy. Optical properties were studied by transmission spectroscopy at normal incidence. A straightforward analysis proposed by Swanepoel was used to determine both the refractive index n and the film thickness. Using a two-form Cauchy equation, the refractive-index dispersions as a function of wavelength were obtained. These alloys exhibit ultra-high refractive indices (n: Sb1-xTex > Sb1-xSex > 2.9) that decrease monotonically with increasing Ch content x. The absorption coefficients α as a function of incident photon energy E were calculated, and from a Tauc analysis, both direct and indirect optical band gaps were obtained. The optical results were discussed in terms of atomic electronegativity, electronic polarizability, and atomic packing of the amorphous network.
- Open Access
The Temperature Sensitivity of the Piezoelectric Thickness Shear Mode of α-GeO2 Single Crystals
This paper focuses on identifying temperature-compensated Y-cuts (using a Cartesian coordinate system) in a piezoelectric α-GeO2 single crystal, which is isostructural–quartz α-SiO2. The study aims to minimize the frequency drift of the thickness shear mode by analyzing the resonant frequency’s first- and second-order temperature coefficients Tf(1) and Tf(2). To obtain these, the first-order, TCij(1), and second-order, TCij(2), temperature coefficients of the elastic constant, Cij, previously obtained from room temperature up to 900 °C, were calculated. Upon heating, the thermal behavior of the elastic constants indicated that some, such as C11 and C33, are stable over a range of temperatures, while others, such as C44 and C66, increase with the temperature. This paper also explores a family of singly and doubly rotated Y-cuts of α-GeO2, revealing cuts with a potential application for temperature compensation and/or linear dependence over the temperature range. The results are compared with those of the well-known piezoelectric isomorph material α-SiO2. The findings highlight that α-GeO2 is a promising material for piezoelectric devices in high-temperature environments, outperforming α-SiO2 (α-quartz), which is limited by a solid–solid phase transition at 573 °C.
Open AccessThe Temperature Sensitivity of the Piezoelectric Thickness Shear Mode of α-GeO2 Single Crystals
This paper focuses on identifying temperature-compensated Y-cuts (using a Cartesian coordinate system) in a piezoelectric α-GeO2 single crystal, which is isostructural–quartz α-SiO2. The study aims to minimize the frequency drift of the thickness shear mode by analyzing the resonant frequency’s first- and second-order temperature coefficients Tf(1) and Tf(2). To obtain these, the first-order, TCij(1), and second-order, TCij(2), temperature coefficients of the elastic constant, Cij, previously obtained from room temperature up to 900 °C, were calculated. Upon heating, the thermal behavior of the elastic constants indicated that some, such as C11 and C33, are stable over a range of temperatures, while others, such as C44 and C66, increase with the temperature. This paper also explores a family of singly and doubly rotated Y-cuts of α-GeO2, revealing cuts with a potential application for temperature compensation and/or linear dependence over the temperature range. The results are compared with those of the well-known piezoelectric isomorph material α-SiO2. The findings highlight that α-GeO2 is a promising material for piezoelectric devices in high-temperature environments, outperforming α-SiO2 (α-quartz), which is limited by a solid–solid phase transition at 573 °C.
- Open Access
Effect of Te doping in GeSe parent thick film by experimental in situ temperature-dependent structural investigation
As-deposited and unencapsulated GeSe$_{1-x}$Te$_x$ ($x = 0, 0.25$) 3-$μ$m-thick amorphous films on Si(001) were obtained via the co-evaporation technique to study the effect of selenium (Se) substitution for tellurium (Te) on the GeSe parent structure in the function of the heating temperature. In situ, grazing-incidence X-ray scattering (XRS), and fluorescence X-ray Absorption Near Edge Structure (XANES) data were collected in isochronal annealing conditions under nitrogen flow. The results show that the onset temperature of crystallization $T_c$ and the crystallized phase symmetry are susceptible to the Te 25 at. % doping. Furthermore, Ge and Se K-edge XANES analyses reveal significant alterations in the local atomic environments surrounding Ge and Se atoms during the transition from the amorphous to the crystalline state. These modifications are accompanied by an observable increase in local structural disorder upon substitution with Te atoms.Open AccessEffect of Te doping in GeSe parent thick film by experimental in situ temperature-dependent structural investigation
As-deposited and unencapsulated GeSe$_{1-x}$Te$_x$ ($x = 0, 0.25$) 3-$μ$m-thick amorphous films on Si(001) were obtained via the co-evaporation technique to study the effect of selenium (Se) substitution for tellurium (Te) on the GeSe parent structure in the function of the heating temperature. In situ, grazing-incidence X-ray scattering (XRS), and fluorescence X-ray Absorption Near Edge Structure (XANES) data were collected in isochronal annealing conditions under nitrogen flow. The results show that the onset temperature of crystallization $T_c$ and the crystallized phase symmetry are susceptible to the Te 25 at. % doping. Furthermore, Ge and Se K-edge XANES analyses reveal significant alterations in the local atomic environments surrounding Ge and Se atoms during the transition from the amorphous to the crystalline state. These modifications are accompanied by an observable increase in local structural disorder upon substitution with Te atoms. - 24 December 2024
- Published by Elsevier in Materials Research Bulletin
- Vol. 185
Effect of Te doping in GeSe parent thick film by experimental in situ temperature-dependent structural investigation
- 24 December 2024
- Published by Elsevier in Materials Research Bulletin
- Vol. 185
Effect of Te doping in GeSe parent thick film by experimental in situ temperature-dependent structural investigation
- 27 May 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (22) , 15027-15035
BaCoO2 with Tetrahedral Cobalt Coordination: The Missing Element to Understand Energy Storage and Conversion Applications in BaCoO3−δ-Based Materials
Barium-cobaltate-based perovskite (BaCoO3-δ) and barium-cobaltate-based nanocomposites have been intensively studied in energy storage and conversion devices mainly due to flexible oxygen stoichiometry and tunable nonprecious transition metal oxidation states. Although a rich and complex family of structural polymorphs has already been reported for these perovskites in the literature, the potential structural evolution that may occur during the oxygen reduction reaction and the oxygen evolution reaction has not been investigated so far. In this study, we synthesized and characterized the lowest Co-oxidation state possible in the compound, BaCoO2, which exhibits a quartz-derived, trigonal structure with a helicoidally corner-sharing, CoO4-tetrahedral-framework as already proposed by Spitsbergen et al. Oxygen can reversibly be inserted in such a crystal structure to form BaCoO3-δ, i.e., with 0 ≤ δ ≤ 1, based on the results of an in situ coupled thermogravimetric - neutron diffraction study and which presents therefore giant oxygen capacity storage due to the extreme tunability of the electronic configuration of the cobalt cations which defines the fundamental origins of the materials performance. The reversible conversion of BaCoO2 to BaCoO3-δ associated with a similar electronic conductivity above 900 K permits to clarify the high potential of BaCoO3-δ-based energy storage and conversion devices.
- 27 May 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (22) , 15027-15035
BaCoO2 with Tetrahedral Cobalt Coordination: The Missing Element to Understand Energy Storage and Conversion Applications in BaCoO3−δ-Based Materials
Barium-cobaltate-based perovskite (BaCoO3-δ) and barium-cobaltate-based nanocomposites have been intensively studied in energy storage and conversion devices mainly due to flexible oxygen stoichiometry and tunable nonprecious transition metal oxidation states. Although a rich and complex family of structural polymorphs has already been reported for these perovskites in the literature, the potential structural evolution that may occur during the oxygen reduction reaction and the oxygen evolution reaction has not been investigated so far. In this study, we synthesized and characterized the lowest Co-oxidation state possible in the compound, BaCoO2, which exhibits a quartz-derived, trigonal structure with a helicoidally corner-sharing, CoO4-tetrahedral-framework as already proposed by Spitsbergen et al. Oxygen can reversibly be inserted in such a crystal structure to form BaCoO3-δ, i.e., with 0 ≤ δ ≤ 1, based on the results of an in situ coupled thermogravimetric - neutron diffraction study and which presents therefore giant oxygen capacity storage due to the extreme tunability of the electronic configuration of the cobalt cations which defines the fundamental origins of the materials performance. The reversible conversion of BaCoO2 to BaCoO3-δ associated with a similar electronic conductivity above 900 K permits to clarify the high potential of BaCoO3-δ-based energy storage and conversion devices.
- 8 April 2023
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 953
In situ study of the crystallization in GeTe0.26 Se0.74 thick film by synchrotron X-ray diffraction
- 8 April 2023
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 953
In situ study of the crystallization in GeTe0.26 Se0.74 thick film by synchrotron X-ray diffraction
- 1 February 2022
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 306
Structure, characterization, and properties of BaMoO4 and BaKYb(MoO4)3 flux-grown single-crystals
- 1 February 2022
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 306
Structure, characterization, and properties of BaMoO4 and BaKYb(MoO4)3 flux-grown single-crystals
- 1 January 2022
- Published by Elsevier in Solid State Sciences
- Vol. 123
Growth, crystal structure, and properties of the Li3Ba2Ln3(MoO4)8 (Ln = Er, Tm) molybdates
- 1 January 2022
- Published by Elsevier in Solid State Sciences
- Vol. 123
Growth, crystal structure, and properties of the Li3Ba2Ln3(MoO4)8 (Ln = Er, Tm) molybdates
- 6 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 884, 161074
Structure, vibrational and magnetic characteristics of LiYbX2O8 (X = W, Mo) single-crystals
- 6 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 884, 161074
Structure, vibrational and magnetic characteristics of LiYbX2O8 (X = W, Mo) single-crystals