Jiayan Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jiayan Wu has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Zhenyu Liu
Guangdong University of Technology
4 shared publications - Siyuan Yang
The School of Information Engineering Guangdong University of Technology Guangzhou China
3 shared publications - Wei Lu
School of Information Engineering, Guangdong University of Technology, Guangzhou, China
3 shared publications - Guangping Li
School of Information Engineering, Guangdong University of Technology, Guangzhou, China
1 shared publication - Songyi Li
School of Information Engineering, Guangdong University of Technology, Guangzhou, China
1 shared publication - Xin Zhang
School of Information Engineering, Guangdong University of Technology, 47870 Guangzhou, Guangdong China
1 shared publication
Latest Publications
- 28 August 2021
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 49 (11) , 3719-3732
An accelerated architecture of change‐point detection for FMCW radar mutual interference based on FPGA
- 28 August 2021
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 49 (11) , 3719-3732
An accelerated architecture of change‐point detection for FMCW radar mutual interference based on FPGA
- 19 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
DOA Estimation Method Based on EMD and MUSIC for Mutual Interference in FMCW Automotive Radars
Mutual interference in automotive radar will reduce the signal-to-noise ratio (SNR) of the received signals. It is difficult to accurately distinguish the signal subspace and the noise subspace for low SNR signals, which will degrade the direction of arrival (DOA) estimation performance of the multiple signal classification (MUSIC) algorithm. To solve this problem, this letter proposes a DOA estimation method for automotive radar based on empirical mode decomposition (EMD) and MUSIC in the case of interference. In our method, the interference signals are suppressed before the DOA estimation. The received signals of the receiving antennas affected by the interference are decomposed into several components by using EMD, and then the interference signals in the interference components are suppressed. Finally, all the received signals are used for the DOA estimation. The results of the simulation and field experiments show that the proposed method can obtain an accurate DOA estimation when the received signals contain the interference signals, and the performance of the proposed method is better than the existing DOA estimation algorithms.
- 19 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Geoscience and Remote Sensing Letters
- Vol. 19 (1545598X) , 1-5
DOA Estimation Method Based on EMD and MUSIC for Mutual Interference in FMCW Automotive Radars
Mutual interference in automotive radar will reduce the signal-to-noise ratio (SNR) of the received signals. It is difficult to accurately distinguish the signal subspace and the noise subspace for low SNR signals, which will degrade the direction of arrival (DOA) estimation performance of the multiple signal classification (MUSIC) algorithm. To solve this problem, this letter proposes a DOA estimation method for automotive radar based on empirical mode decomposition (EMD) and MUSIC in the case of interference. In our method, the interference signals are suppressed before the DOA estimation. The received signals of the receiving antennas affected by the interference are decomposed into several components by using EMD, and then the interference signals in the interference components are suppressed. Finally, all the received signals are used for the DOA estimation. The results of the simulation and field experiments show that the proposed method can obtain an accurate DOA estimation when the received signals contain the interference signals, and the performance of the proposed method is better than the existing DOA estimation algorithms.
- 25 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 27 (10709908) , 1745-1749
Vital Sign Extraction in the Presence of Radar Mutual Interference
Respiratory and heartbeat signals are faint vital signs that provide diagnostic and prophylactic information for detecting physiological state. With the increasing number of scenes equipped with frequency modulated continuous wave radar, the probability of mutual interference between radars increases. Mutual interference may raise the noise floor level, which easily affects the extraction of respiratory and heartbeat signals. To solve this issue, we propose a method for extracting vital signs. First, we use the improved pruned exact linear time algorithm to determine the position of the interference signal. Then, the interference signal is restored by the autoregressive model. Finally, the residual noise is removed by bandpass filtering and ensemble empirical mode decomposition to obtain vital signs. The experimental results show that the proposed method can significantly improve the signal-to-noise ratio of vital signs and effectively extract vital signs from the interference signal.
- 25 September 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 27 (10709908) , 1745-1749
Vital Sign Extraction in the Presence of Radar Mutual Interference
Respiratory and heartbeat signals are faint vital signs that provide diagnostic and prophylactic information for detecting physiological state. With the increasing number of scenes equipped with frequency modulated continuous wave radar, the probability of mutual interference between radars increases. Mutual interference may raise the noise floor level, which easily affects the extraction of respiratory and heartbeat signals. To solve this issue, we propose a method for extracting vital signs. First, we use the improved pruned exact linear time algorithm to determine the position of the interference signal. Then, the interference signal is restored by the autoregressive model. Finally, the residual noise is removed by bandpass filtering and ensemble empirical mode decomposition to obtain vital signs. The experimental results show that the proposed method can significantly improve the signal-to-noise ratio of vital signs and effectively extract vital signs from the interference signal.
- Open Access
- 28 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 45108-45118
A PELT-KCN Algorithm for FMCW Radar Interference Suppression Based on Signal Reconstruction
In frequency-modulated continuous-wave (FMCW) radar interference suppression based on signal reconstruction, the pruned exact linear time (PELT) algorithm is used to detect the time positions of the interference. Due to the uncertain penalty factor of the PELT algorithm, the exactness of the position detection is reduced; thus, the suppression performance is degraded. We propose a PELT algorithm with a known change number (PELT-KCN), where a known change number is used to calculate the optimal penalty factor such that the high accuracy of the algorithm can be guaranteed. After interference recognition, the beat signal is separated into two parts: the undamaged signal and the damaged signal. The former is utilized to restore the latter through an autoregressive (AR) model. In simulations and field experiments, we applied our proposed PELT-KCN algorithm to the interference suppression method and verified its performance. Our method can accurately detect the time positions of interference and effectively improve the signal-tonoise ratio (SNR) of the detected targets.
- 28 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 45108-45118
Open AccessA PELT-KCN Algorithm for FMCW Radar Interference Suppression Based on Signal Reconstruction
In frequency-modulated continuous-wave (FMCW) radar interference suppression based on signal reconstruction, the pruned exact linear time (PELT) algorithm is used to detect the time positions of the interference. Due to the uncertain penalty factor of the PELT algorithm, the exactness of the position detection is reduced; thus, the suppression performance is degraded. We propose a PELT algorithm with a known change number (PELT-KCN), where a known change number is used to calculate the optimal penalty factor such that the high accuracy of the algorithm can be guaranteed. After interference recognition, the beat signal is separated into two parts: the undamaged signal and the damaged signal. The former is utilized to restore the latter through an autoregressive (AR) model. In simulations and field experiments, we applied our proposed PELT-KCN algorithm to the interference suppression method and verified its performance. Our method can accurately detect the time positions of interference and effectively improve the signal-tonoise ratio (SNR) of the detected targets.