Long Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Long Zhu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Danhui Liu
School of Logistics Engineering, Wuhan University of Technology, Wuhan, China
1 shared publication- Guoxian Wang
School of Transportation and Logistics Engineering, Wuhan University of Technology, Wuhan 430063, China
1 shared publication Qiaoxin Zhang
School of Mechanical and Electronic Engineering, Wuhan University of Technology, Wuhan, China
1 shared publicationWei Feng
Shenzhen Institutes of Advanced Technology Chinese Academy of Sciences, Shenzhen, Guangdong, CHINA
1 shared publicationXinhong Xiong
School of Logistics Engineering, Wuhan University of Technology, Wuhan, Hubei, China
1 shared publication
Latest Publications
- Open Access
- 20 March 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (6) , 066504
Microstructure and properties of n-type Bi2Te3-based thermoelectric material fabricated by selective laser sintering
An n-type Bi2Te3-based thermoelectric material Bi2Te2.85Se0.15 was prepared through an SLS (Selective Laser Sintering) process with E12/Bi2Te2.85Se0.15 as composite powder (weight ratio 1:7), from which E12 was degreased after the SLS process. It was studied the effect of laser power, scanning speed and scanning interval on the density and thermoelectric properties of the sintered samples. The laser power was found the most important influential factor, while the scanning interval was the second and the scanning speed the least. The maximum dimensionless thermoelectric figure of merit ZT is about 0.88 in the condition when the laser power, scanning interval and scanning speed were 20W, 0.26mm and 3000mm/s, respectively.
- 20 March 2020
- Published by IOP Publishing in Materials Research Express
- Vol. 7 (6) , 066504
Open AccessMicrostructure and properties of n-type Bi2Te3-based thermoelectric material fabricated by selective laser sintering
An n-type Bi2Te3-based thermoelectric material Bi2Te2.85Se0.15 was prepared through an SLS (Selective Laser Sintering) process with E12/Bi2Te2.85Se0.15 as composite powder (weight ratio 1:7), from which E12 was degreased after the SLS process. It was studied the effect of laser power, scanning speed and scanning interval on the density and thermoelectric properties of the sintered samples. The laser power was found the most important influential factor, while the scanning interval was the second and the scanning speed the least. The maximum dimensionless thermoelectric figure of merit ZT is about 0.88 in the condition when the laser power, scanning interval and scanning speed were 20W, 0.26mm and 3000mm/s, respectively.