Baohui Yin

Although carbonyl compounds are a key species with atmospheric oxidation capacity, their concentrations and sources have not been sufficiently characterized in various atmospheres, especially in desert areas. In this study, atmospheric carbonyl compounds were measured from 16 May to 15 June 2018 in Tazhong in the central Taklimakan Desert, Xinjiang Uygur Autonomous Region, China. Concentrations, chemical compositions, and sources of carbonyl compounds were investigated and compared with those of different environments worldwide. The average concentration of total carbonyls during the sampling period was 11.79 ± 4.03 ppbv. Formaldehyde, acetaldehyde, and acetone were the most abundant carbonyls, with average concentrations of 6.08 ± 2.37, 1.68 ± 0.78, and 2.52 ± 0.68 ppbv, respectively. Strong correlations between formaldehyde and other carbonyls were found, indicating same or similar sources and sinks. A hybrid single-particle Lagrangian integrated trajectory was used to analyze 72 h back trajectories. The values of C1/C2 (formaldehyde to acetaldehyde, 3.22–4.59) and C2/C3 (acetaldehyde to propionaldehyde, 15.00–17.03) from different directions and distances of the trajectories were consistent with the characteristics of a remote area. Relative to various environments, the carbonyl concentration in the Tazhong desert site was lower than that in urban areas and higher than that in suburban and remote areas, implying contributions from local primary and secondary sources. The obtained data can be used to improve the source and sink estimation of carbonyls at the regional scale.

Urban and suburban PM_2.5 samples were collected simultaneously during selected periods representing each season in 2019 in Zibo, China. Samples were analysed for water-soluble inorganic ions, carbon components, and elements. A chemical mass balance model and health risk assessment model were used to investigate the source contributions to PM_2.5 and the human health risks posed by various pollution sources via the inhalation pathway. Almost 50% of the PM_2.5 samples exceeded the secondary standard of China’s air quality concentration limit (75 µg/m³, 24 h). Water-soluble inorganic ions were the main component of PM_2.5 in Zibo, accounting for 50 ± 8% and 56 ± 11% of PM_2.5 at the urban and suburban sites, respectively. OC and OC/EC decreased significantly in the past few years due to enhanced energy restructuring. Pearson correlation analysis showed that traffic emissions were the main source of heavy metals. The Cr(VI) concentrations were 1.53 and 1.92 ng/m³ for urban and suburban sites, respectively, exceeding the national ambient air quality standards limit of 0.025 ng/m³. Secondary inorganic aerosols, traffic emissions, and secondary organic aerosols were the dominant contributors to PM_2.5 in Zibo, with the total contributions from these three sources accounting for approximately 80% of PM_2.5 and the remaining 20% attributed to traffic emissions. The non-carcinogenic risks from crustal dust for children were 2.23 and 1.15 in urban and suburban areas, respectively, exceeding the safe limit of 1.0 in both locations, as was the case for adults in urban areas. Meanwhile, the carcinogenic risks were all below the safe limit, with the non-carcinogenic and carcinogenic risks from traffic emissions being just below the limits. Strict control of precursor emissions, such as SO₂, NOx, and VOCs, is a good way to reduce PM_2.5 pollution resulting from secondary aerosols. Traffic control, limiting or preventing outdoor activities, and wearing masks during haze episodes may be also helpful in reducing PM_2.5 pollution and its non-carcinogenic and carcinogenic health impacts in Zibo.

To better understand the source and health risk of metal elements in PM_2.5, a field study was conducted from May to December 2018 in the central region of the Liaoning province, China, including the cities of Shenyang, Anshan, Fushun, Benxi, Yingkou, Liaoyang, and Tieling. 24 metal elements (Na, K, V, Cr, Mn, Co, Ni, Cu, Zn, As, Mo, Cd, Sn, Sb, Pb, Bi, Al, Sr, Mg, Ti, Ca, Fe, Ba, and Si) in PM_2.5 were measured by ICP-MS and ICP-OES. They presented obvious seasonal variations, with the highest levels in winter and lowest in summer for all seven cities. The sum of 24 elements were ranged from to in these cities. The element mass concentration ratio was the highest in Yingkou in the spring (26.15%), and the lowest in Tieling in winter (3.63%). The highest values of elements in PM_2.5 were mostly found in Anshan and Fushun among the studied cities. Positive matrix factorization (PMF) modelling revealed that coal combustion, industry, traffic emission, soil dust, biomass burning, and road dust were the main sources of measured elements in all cities except for Yingkou. In Yingkou, the primary sources were identified as coal combustion, metal smelting, traffic emission, soil dust, and sea salt. Health risk assessment suggested that Mn had non-carcinogenic risks for both adults and children. As for Cr, As, and Cd, there was carcinogenic risks for adults and children in most cities. This study provides a clearer understanding of the regional pollution status of industrial urban agglomeration.

Emissions from biomass burning are very serious in Southeast Asia and South Asia in April. In order to explore the effect of long-range transport of biomass emissions from the Indochina Peninsula in Southwest China during the period of the southeast monsoon season and to find out the main pollution sources in local atmospheric PM_2.5, a field campaign was conducted from 6–26 April 2011 in Lijiang, China. Twenty-four-hour PM₁₀ and PM_2.5 filter samples were collected, and inorganic ions, elements, and carbonaceous components (including organic carbon (OC) and elemental carbon (EC), polycyclic aromatic hydrocarbons (PAHs) and nitrated PAHs (NPAHs)) were measured. The monthly mean mass concentrations of particulate matter (PM) were 40.4 and 14.4 μg/m³ for PM₁₀ and PM_2.5, respectively. The monthly mean concentrations of OC and EC in PM₁₀ were 6.2 and 1.6 μg/m³, respectively. The weekly mean concentrations of ∑PAHs and ∑NPAHs were 11.9 ng/m³ and 289 pg/m³, respectively, in atmospheric PM₁₀ of Lijiang. The diagnostic ratios of PAH and NPAH isomers were used to analyze the sources of PAHs and NPAHs in PM₁₀. The ratios of Benz(a)anthracene/(Chrysene+Benz(a)anthracen), Fluoranthene/(Fluoranthene+Pyrene) and Indeno(1,2,3-cd)pyrene/(Benzo(g,h,i)perylene+Indeno(1,2,3-cd)pyrene) were 0.45 ± 0.04, 0.61 ± 0.01, and 0.53 ± 0.03, respectively, indicating the contribution from coal combustion and biomass burning. The 1-nitropyrene/Pyrene (1-NP/Pyr) ratio was 0.004 ± 0.001, suggesting that the contribution to NPAHs mainly came from coal combustion. Sulfate was the most prominent inorganic ionic species, with monthly mean levels of 2.28 and 1.39 μg/m³ in PM₁₀ and PM_2.5, respectively. The monthly mean mass ratios of NO₃⁻/SO₄²⁻ were 0.40 and 0.23 in PM₁₀ and PM_2.5, respectively, indicating that the contribution of atmospheric anions from coal combustion sources was much more important than that from other sources. Based on the relatively high SO₄²⁻ concentrations and low NO₃⁻/SO₄²⁻ ratios, combined with the data analysis of isomer ratios of PAHs and NPAHs, we can conclude that coal combustion, traffic, and dust were the major contributors to local atmospheric PM in Lijiang city, while biomass burning may also have contributed to local atmospheric PM in Lijiang city to some degree.

A city with light industry in China was selected for the study of the chemical characteristics of PM_2.5 and to assess its impact on inhalation health risks. During the period from May 2017 to February 2018, a total of 382 PM_2.5 filter samples were collected across four seasons (15–20 days for each season). The results showed that the daily average PM_2.5 concentration ranged from 21 to 255 µg/m³, with an annual average of 73 ± 49 µg/m³. SO₄²⁻, NO₃⁻, NH₄⁺, and organic matter (OM) were the dominant components, accounting for 13%, 20%, 11%, and 20% of annual PM_2.5 mass loading, respectively. Compared with the clean periods, the meteorology of the pollution periods were mostly characterized by high relatively humidity, high temperature, and low wind speeds. Based on positive matrix factorization (PMF), the major source of PM_2.5 was identified as secondary aerosols, contributing 28% and 49% on clean days and polluted days, respectively. The health risk assessment of heavy metals showed that non-carcinogenic hazard is not expected to occur, while Cr contributed the highest cancer risk. This study is helpful for the advancement of our scientific understanding of PM_2.5 pollution and its impact on health in cities with light industries.