Xiao Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xiao Li has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Liu Huan
2 shared publications- Zhijian Hu
Department of Bridge Engineering, School of Transportation and Logistics Engineering, Wuhan University of Technology, Wuhan 430063, China
2 shared publications Bo Xu
CNCEC Construction Engineering Co., Ltd, Suzhou, China
1 shared publicationCao Wenquan
1 shared publication- Fayuan Sun
China Railway 18th, Bureau Group Co., Ltd, Tianjin, China
1 shared publication Guojun Wu
State Key Laboratory of Geotechnical Mechanics and Engineering, Chinese Academy of Sciences Wuhan Institute of Rock and Soil Mechanics
1 shared publication
Latest Publications
- Open Access
- 7 October 2026
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 30 (12)
Self-rotating intelligent launching construction and stability analysis of long-span steel-concrete composite girder bridges
- 7 October 2026
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 30 (12)
Open AccessSelf-rotating intelligent launching construction and stability analysis of long-span steel-concrete composite girder bridges
- Open Access
- 30 September 2026
- Published by Springer Nature in Journal of Engineering and Applied Science
- Vol. 73 (1) , 390
Investigation of construction settlement for super-long bidirectional circular pipe jacking - launching shaft structure
This study addresses construction disturbances caused by dense surface traffic and complex water-rich strata in urban underground construction. Based on the full-scale Taicang Port central heating pipeline project, it investigates large-diameter bidirectional circular pipe jacking and launching shaft excavation. A three-dimensional finite element model was developed in ABAQUS and validated against field monitoring data. The effects of three key parameters—pipe diameter-to-shaft diameter ratio, vertical alignment deviation, and jacking force coefficient—on the deformation and stability of the shaft–soil system were examined. A load-ratio-modified hyperbolic settlement prediction model was proposed, in which the model coefficients were calibrated and updated using construction-stage monitoring data to support settlement prediction and early warning. The combined effects of multiple parameters on the underground structures were analyzed, and a design-construction-monitoring control framework was applied in the project. The results provide a practical reference for similar urban underground projects in water-rich strata. The main contributions are the validated full-process simulation of a super-long bidirectional circular pipe jacking launching shaft, the identification of key parameters affecting shaft–soil deformation, and a monitoring-calibrated settlement prediction method for similar projects.
- 30 September 2026
- Published by Springer Nature in Journal of Engineering and Applied Science
- Vol. 73 (1) , 390
Open AccessInvestigation of construction settlement for super-long bidirectional circular pipe jacking - launching shaft structure
This study addresses construction disturbances caused by dense surface traffic and complex water-rich strata in urban underground construction. Based on the full-scale Taicang Port central heating pipeline project, it investigates large-diameter bidirectional circular pipe jacking and launching shaft excavation. A three-dimensional finite element model was developed in ABAQUS and validated against field monitoring data. The effects of three key parameters—pipe diameter-to-shaft diameter ratio, vertical alignment deviation, and jacking force coefficient—on the deformation and stability of the shaft–soil system were examined. A load-ratio-modified hyperbolic settlement prediction model was proposed, in which the model coefficients were calibrated and updated using construction-stage monitoring data to support settlement prediction and early warning. The combined effects of multiple parameters on the underground structures were analyzed, and a design-construction-monitoring control framework was applied in the project. The results provide a practical reference for similar urban underground projects in water-rich strata. The main contributions are the validated full-process simulation of a super-long bidirectional circular pipe jacking launching shaft, the identification of key parameters affecting shaft–soil deformation, and a monitoring-calibrated settlement prediction method for similar projects.
- Open Access
- 25 November 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 41868
Investigation of the impact of cable corrosion on the ultimate strength and fatigue life of stay cable bridges
To investigate the coupled effects of cable corrosion on the ultimate strength and fatigue performance of cable-stayed bridges, sophisticated numerical simulations incorporating established corrosion mechanisms were conducted. Corrosion-induced degradation was modeled through cross-sectional area reduction and material property deterioration, with specific emphasis on wire elongation capacity attenuation. Three finite element models representing steel cable-stayed bridges with distinct spans (300 m, 600 m, and 900 m) were subjected to progressive collapse analysis and fatigue assessment. The results indicate that: (1) Structural failure consistently manifested through plastic hinge formation and fracture at the mid-span girder across all models, accompanied by partial plastification at the tower base; (2) Increased span length elevated cable stress at failure, thereby amplifying the influence of cross-sectional area reduction on ultimate strength; (3) Reduction of wire elongation rate from 4% to 3% or 2% resulted in marginal ultimate strength reductions, whereas attenuation to 1% induced precipitous capacity decline; (4) Under concurrent minimum cable area and elongation rate conditions, the ultimate load-bearing capacity of all bridge configurations experienced an approximate 50% reduction; (5) Corrosion significantly compromised fatigue performance at all cable positions, with localized pitting corrosion exacerbating stress concentration effects and accelerating cross-sectional degradation, consequently diminishing fatigue life.
- 25 November 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 41868
Open AccessInvestigation of the impact of cable corrosion on the ultimate strength and fatigue life of stay cable bridges
To investigate the coupled effects of cable corrosion on the ultimate strength and fatigue performance of cable-stayed bridges, sophisticated numerical simulations incorporating established corrosion mechanisms were conducted. Corrosion-induced degradation was modeled through cross-sectional area reduction and material property deterioration, with specific emphasis on wire elongation capacity attenuation. Three finite element models representing steel cable-stayed bridges with distinct spans (300 m, 600 m, and 900 m) were subjected to progressive collapse analysis and fatigue assessment. The results indicate that: (1) Structural failure consistently manifested through plastic hinge formation and fracture at the mid-span girder across all models, accompanied by partial plastification at the tower base; (2) Increased span length elevated cable stress at failure, thereby amplifying the influence of cross-sectional area reduction on ultimate strength; (3) Reduction of wire elongation rate from 4% to 3% or 2% resulted in marginal ultimate strength reductions, whereas attenuation to 1% induced precipitous capacity decline; (4) Under concurrent minimum cable area and elongation rate conditions, the ultimate load-bearing capacity of all bridge configurations experienced an approximate 50% reduction; (5) Corrosion significantly compromised fatigue performance at all cable positions, with localized pitting corrosion exacerbating stress concentration effects and accelerating cross-sectional degradation, consequently diminishing fatigue life.
- 1 January 2025
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 62, 1-13
Investigation on asymmetric dynamic response characteristics of anchored surrounding rock under blasting excavation of inclined layered rock tunnel
The dynamic response stability analysis of the anchored surrounding rock during blasting construction is crucial to ensure the safety of construction. Taking the Wuwan Tunnel in Luoyang as the engineering background, combined with methods such as physical simulation experiments, numerical simulation experiments, and on-site experiments, the asymmetric effects of layered rock mass on the surrounding rock and support structure during blasting excavation were studied. The asymmetric effects of tunnel blasting excavation on the surrounding rock and support system under the condition of a bedding angle of 30° were analyzed and summarized. The results indicate that when the blasting stress wave passes through the bedding plane, the stress wave will undergo significant attenuation. The strain generated by the anchor rod passing through the bedding plane exhibits asymmetry due to the reflection and weakening of the blasting stress wave after passing through the bedding plane.
- 1 January 2025
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 62, 1-13
Investigation on asymmetric dynamic response characteristics of anchored surrounding rock under blasting excavation of inclined layered rock tunnel
The dynamic response stability analysis of the anchored surrounding rock during blasting construction is crucial to ensure the safety of construction. Taking the Wuwan Tunnel in Luoyang as the engineering background, combined with methods such as physical simulation experiments, numerical simulation experiments, and on-site experiments, the asymmetric effects of layered rock mass on the surrounding rock and support structure during blasting excavation were studied. The asymmetric effects of tunnel blasting excavation on the surrounding rock and support system under the condition of a bedding angle of 30° were analyzed and summarized. The results indicate that when the blasting stress wave passes through the bedding plane, the stress wave will undergo significant attenuation. The strain generated by the anchor rod passing through the bedding plane exhibits asymmetry due to the reflection and weakening of the blasting stress wave after passing through the bedding plane.
- 1 November 2023
- Published by Wiley in Structural Concrete
- Vol. 25 (2) , 796-809
Bearing capacity of UHPC‐NC connection structure in negative moment zone of PC beam bridges
A new type of UHPC‐NC (normal concrete) structure in the negative moment zone was proposed to improve the bearing capacity of the connection structure in the negative moment zone of prefabricated prestressed concrete (PC) beam bridges. First, the distribution characteristics of the crack, cracking load, ultimate moment, and ductility coefficient of the new structure were obtained by the 1:4 scale model tests. The feasibility of the connection structure is verified. Then, the value ranges of critical structural parameters affecting the bearing capacity of the connection structure based on the plane section assumption analysis, including the reasonable thickness of the UHPC layer, the reinforcement ratio of the longitudinal tensile reinforcement, and the diameter of the reinforcement, are obtained. At the same time, based on the verification of the finite element model, the influence of crucial research parameters on the bending capacity of the connection structure is obtained by using the finite element method. Finally, a theoretical method for the bending moment capacity of the connection structure of the UHPC‐NC structure is proposed, considering the high ductility characteristics of UHPC materials. The average relative error between the calculation results and the finite element method is within 7.2%, which verifies the reliability of the calculation method in this paper and provides a reference for its design and engineering application.
- 1 November 2023
- Published by Wiley in Structural Concrete
- Vol. 25 (2) , 796-809
Bearing capacity of UHPC‐NC connection structure in negative moment zone of PC beam bridges
A new type of UHPC‐NC (normal concrete) structure in the negative moment zone was proposed to improve the bearing capacity of the connection structure in the negative moment zone of prefabricated prestressed concrete (PC) beam bridges. First, the distribution characteristics of the crack, cracking load, ultimate moment, and ductility coefficient of the new structure were obtained by the 1:4 scale model tests. The feasibility of the connection structure is verified. Then, the value ranges of critical structural parameters affecting the bearing capacity of the connection structure based on the plane section assumption analysis, including the reasonable thickness of the UHPC layer, the reinforcement ratio of the longitudinal tensile reinforcement, and the diameter of the reinforcement, are obtained. At the same time, based on the verification of the finite element model, the influence of crucial research parameters on the bending capacity of the connection structure is obtained by using the finite element method. Finally, a theoretical method for the bending moment capacity of the connection structure of the UHPC‐NC structure is proposed, considering the high ductility characteristics of UHPC materials. The average relative error between the calculation results and the finite element method is within 7.2%, which verifies the reliability of the calculation method in this paper and provides a reference for its design and engineering application.
- 8 September 2022
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 48 (4) , 4795-4804
Cracking Resistance of UHPC-NC Structure in Negative Moment Zone of Prestressed Concrete Beam Bridges
- 8 September 2022
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 48 (4) , 4795-4804
Cracking Resistance of UHPC-NC Structure in Negative Moment Zone of Prestressed Concrete Beam Bridges
- Open Access
- 9 April 2022
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 26 (8) , 3460-3470
Simplified Method for Lateral Distribution Factor of the Live Load of Prefabricated Concrete Box-Girder Bridges with Transverse Post-tensioning
- 9 April 2022
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 26 (8) , 3460-3470
Open AccessSimplified Method for Lateral Distribution Factor of the Live Load of Prefabricated Concrete Box-Girder Bridges with Transverse Post-tensioning