JZJiquan Zhang

Jiquan Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jiquan Zhang has a total of 49 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Electro-optical sampling-based frequency response characterization of photodetectors beyond 120 GHz using a fiber-optic frequency comb

    by Jiquan Zhang, Yesheng Gao, Xingang Zhuang, Chao Liu, Liming Mao, Pengfei Wang, Chengping Ying, Chengcheng Hou, Bin Wu, Hengkui Wu, et al.

    With the rapid development of high-speed data transmission and fiber-optic communication, the frequency response range of high-speed photodetectors is gradually moving towards higher frequencies. The electro-optical sampling-based frequency response characterization technique is considered a terahertz-band-oriented characterization technique with the advantages of wide bandwidth, high accuracy, high spatial resolution, and the possibility of simultaneous time–frequency-domain measurements. To further expand the measurement capability and optimize the measurement stability, in this work, electro-optical sampling-based frequency response characterization of high-speed photodetectors at 90, 100, and 145 GHz is conducted using a femtosecond fiber-optic frequency comb and a LiTaO3 electro-optic crystal coplanar waveguide. The experimental results show that the quasi-all-fiber measurement system has good accuracy and stability and is expected to break through the accurate frequency response metrology beyond 120 GHz.

  • Laser operation at 1.2 µm in Ho3+-doped ZBYA glass fibers

    by Changjun Xu, Xiaoxu Li, Yanfei Shen, Jiquan Zhang, Shijie Jia, Gerald Farrell, Shunbin Wang, Pengfei Wang

    Powerful 1.2-µm laser operation was produced in Ho3+-doped single-cladding, in-house fabricated ZrF4-BaF2-YF3-AlF3 (ZBYA) glass fibers. The fibers were fabricated based on ZBYA glass with a composition of ZrF4-BaF2-YF3-AlF3. Pumped by an 1150-nm Raman fiber laser, the maximum combined laser output power emitted from both sides of a 0.5-mol% Ho3+-doped ZBYA fiber was 6.7 W, with a slope efficiency of 40.5%. We also observed lasing at 2.9 µm with an output power of 350 mW, which was ascribed to the transition of Ho3+:5I6 → 5I7. The effect of rare earth (RE) doping concentration and the length of the gain fiber were also investigated to determine their effect on laser performance at 1.2 µm and 2.9 µm.


  • Recent advances in luminescence and lasing research in ZBYA glass

    by Changjun Xu, Jiquan Zhang, Mo Liu, Haiyan Zhao, Fengzi Ling, Shijie Jia, Gerald Farrell, Shunbin Wang, Pengfei Wang

    In the last few decades, fluoride glasses have attracted a growing interest due to their unique advantages compared to multi-component oxide glasses. Among them, the most studied and widely used were fluorozirconate glasses, represented by ZrF4–BaF2–LaF3–AlF3–NaF (ZBLAN) glasses. However, compared with ZBLAN glasses, a kind of fluorozirconate glass with the components ZrF4–BaF2–YF3–AlF3 (ZBYA) has higher thermal and chemical stability. In this paper, we first introduce the advantages of ZBYA glasses compared to ZBLAN glasses. Then we review and discuss recent advances in research on luminescence and lasing in ZBYA glass and fiber. These studies suggest that ZBYA glass has strong potential for use as a gain medium material in high power mid-infrared fiber lasers.


  • Open Access

    Direct Femtosecond Laser Inscription of High-Order Bragg Gratings in Fluoroaluminate Glass Fiber

    by Lin She, Niannian Xu, Pengfei Wang, Jiquan Zhang, Mo Liu, Nian Lv, Ruoning Wang, Zhenrui Li, Shijie Jia, Shunbin Wang, et al.

    This letter reports the fabrication of fiber Bragg gratings (FBGs) within in-house fabricated fluoroaluminate (AlF 3 ) glass fibers using femtosecond (fs) laser inscription at 800 nm. The grating strength of the FBGs was investigated for different pulse energies and different orders, and a 3rd-order FBG with Bragg wavelength at 1557 nm was found to have the highest reflectivity of 99.5%. In addition, the reflectivity of the mid-IR grating peaks for different orders was also studied, and a 2nd-order FBG with a reflectivity of 98.8% was obtained at 2864 nm. Finally, the temperature characteristics of a mid-IR FBG were studied between 30 °C and 150 °C, showing a linear wavelength dependence and an excellent stability for the refractive index modulation. Such highly reflectivity FBGs in AlF 3 fiber have significant potential for applications in the development of compact all-fiber mid-IR fiber lasers.


  • Two-watt mid-infrared laser emission in robust fluorozirconate fibers

    by Changjun Xu, Jiquan Zhang, Xiaotong Zhao, Haiyan Zhao, Fengzi Ling, Shijie Jia, Gerald Farrell, Shunbin Wang, Pengfei Wang

    To the best of our knowledge, we report here the first demonstration of 2.9 µm laser emission from in-house fabricated Ho3+/Pr3+ co-doped ZBYA glass fiber. The fiber was fabricated based on the ZBYA glass with compositions of ZrF4–BaF2–YF3–AlF3–PbF2–HoF3-PrF3. Under the pump of a 1150 nm Raman fiber laser, the maximum unsaturated output power of 2.16 W was obtained in a 15 cm long gain fiber with a slope efficiency of 24%. The influence of rare-earth doping concentration on laser performance was also investigated. The result indicates that ZBYA glass fibers have potential for using as a fluorozirconate glass gain fiber for mid-infrared fiber lasers.


  • Direct femtosecond laser inscription of Bragg gratings in Ho3+/Pr3+ co-doped AlF3-based glass fibers for a 2.86 µm laser

    by Niannian Xu, Zhiyong Yang, Jiquan Zhang, Nian Lv, Mo Liu, Ruoning Wang, Zhenrui Li, Shijie Jia, Gilberto Brambilla, Shunbin Wang, et al.

    In this Letter, we report the fabrication of fiber Bragg gratings (FBGs) in home-made Ho3+/Pr3+ co-doped single-cladding fluoroaluminate (AlF3) glass fibers and its application in watt-level lasing at the mid-infrared (MIR) wavelength of 2.86 µm. The FBGs were inscribed using an 800 nm femtosecond (fs) laser direct-writing technique. The FBG properties were investigated for different pulse energies, inscription speeds, grating orders, and transversal lengths. A second-order FBG with a high reflectivity of 99% was obtained at one end of a 16.5-cm-long gain fiber. Under 1150 nm laser pumping, this fiber yielded a power exceeding 1 W at 2863.9 nm with an overall laser efficiency of 17.7%. The fiber laser showed a FWHM bandwidth of 0.46 nm and long-term spectral stability.


  • Praseodymium mid-infrared emission in AlF3-based glass sensitized by ytterbium

    by Jiquan Zhang, Mo Liu, Jin Yu, Ruicong Wang, Shijie Jia, Zijun Liu, Gerald Farrell, Shunbin Wang, Pengfei Wang

    Broadband emission was obtained over 2.6 to 4.1 μm (Pr3+: 1G4→3F4, 3F3) in AlF3-based glass samples doped with different concentrations of praseodymium and 1 mol% ytterbium using a 976 nm laser pump. An efficient energy transfer process from Yb3+: 2F5/2 to Pr3+: 1G4 was analyzed through emission spectra and fluorescence lifetime values. The absorption and emission cross-sections were calculated by Füchtbauer-Ladenburg and McCumber theories and a positive gain can be obtained when P>0.3. To the best of the authors’ knowledge, this work represents the first report of broadband mid-infrared emission of Pr3+ in an AlF3-based glass. The results show that praseodymium doped AlF3-based glass sensitized by ytterbium could be a promising candidate for fiber lasers operating in mid-infrared region.


  • Room-temperature watt-level and tunable ∼3 µm lasers in Ho3+/Pr3+ co-doped AlF3-based glass fiber

    by Mo Liu, Jiquan Zhang, Niannian Xu, Xinwei Tian, Shijie Jia, Shunbin Wang, Gilberto Brambilla, Pengfei Wang

    A room-temperature watt-level continuous-wave-output power mid-infrared fiber laser operating at λ ∼ 3 µ m is demonstrated using a H o 3 + / P r 3 + co-doped A l F 3 based glass fiber as a gain fiber. This fixed-wavelength laser had maximum output power of 1.13 W with a slope efficiency of 10.3% and a long-term operating stability of > 40 min without any additional packaging or active thermal management. A fiber laser with tunability from 2.842 to 2.938 µm showed a maximum output power of 110 mW.


  • A tellurite glass optical microbubble resonator

    by Jibo Yu, Jiquan Zhang, Ruicong Wang, Angzhen Li, Meng Zhang, Shunbin Wang, Pengfei Wang, Jonathan Ward, Sile Nic Chormaic

    We present a method for making microbubble whispering gallery resonators (WGRs) from tellurite, which is a soft glass, using a CO2 laser. The customized fabrication process permits us to process glasses with low melting points into microbubbles with loaded quality factors as high as 2.3 × 106. The advantage of soft glasses is that they provide a wide range of refractive index, thermo-optical, and optomechanical properties. The temperature and air pressure dependent optical characteristics of both passive and active tellurite microbubbles are investigated. For passive tellurite microbubbles, the measured temperature and air pressure sensitivities are 4.9 GHz/K and 7.1 GHz/bar, respectively. The large thermal tuning rate is due to the large thermal expansion coefficient of 1.9 × 10−5 K−1 of the tellurite microbubble. In the active Yb3+-Er3+ co-doped tellurite microbubbles, C-band single-mode lasing with a threshold of 1.66 mW is observed with a 980 nm pump and a maximum wavelength tuning range of 1.53 nm is obtained. The sensitivity of the laser output frequency to pressure changes is 6.5 GHz/bar. The microbubbles fabricated using this method have a low eccentricity and uniform wall thickness, as determined from electron microscope images and the optical spectra. The compound glass microbubbles described herein have the potential for a wide range of applications, including sensing, nonlinear optics, tunable microcavity lasers, and integrated photonics.


  • Open Access

    An Experimental and Theoretical Investigation of a 2 μm Wavelength Low-Threshold Microsphere Laser

    by Jibo Yu, Xin Wang, Wenhao Li, Meng Zhang, Jiquan Zhang, Ke Tian, Yanqiu Du, Sile Nic Chormaic, Pengfei Wang

    We present our results on an experimental and theoretical investigation into a glass microsphere laser emitting at 2 μm wavelength. First, we fabricated Ho 3+ -doped tellurite glass fiber and measured the absorption and emission spectra, and the fluorescence lifetime. Using this fiber, a tellurite glass microsphere with a Q-factor of 2 × 10 6 was also prepared, and a single-mode laser output with a low threshold of 342 μW was observed using a 1150 nm laser as the pump source. The dynamic characteristics of the microsphere laser were studied theoretically by considering rare-earth ion spectroscopy, the rate equation of the rare-earth energy level, and the light-matter interactions in the microsphere. This work can be used to study laser emissions with low thresholds in rare-earth doped compound glass microresonators for a wide range of applications, such as gas sensing, integrated photonics, and medical surgery.