DBDominik Benz

Dominik Benz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dominik Benz has a total of 44 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Dual promotional effect of CuxO clusters grown with atomic layer deposition on TiO2 for photocatalytic hydrogen production

    by Saeed Saedy, Nico Hiemstra, Dominik Benz, Hao Van Bui, Michael Nolan, J. Ruud van Ommen

    The depletion zone formed around the CuxO clusters is the main photocatalytically active area, and the H2 production rate depends on surface coverage with this area; however, the overlap of these areas suppresses the photocatalyst activity.


  • Open Access

    Biocompatible Graphene Oxide Nanosheets Densely Functionalized with Biologically Active Molecules for Biosensing Applications

    by Benjamin A. E. Lehner, Dominik Benz, Stanislav A. Moshkalev, Anne S. Meyer, Monica A. Cotta, Richard Janissen


  • Open Access

    Iron can be microbially extracted from Lunar and Martian regolith simulants and 3D printed into tough structural materials

    by Sofie M. Castelein, Tom F. Aarts, Juergen Schleppi, Ruud Hendrikx, Amarante J. Böttger, Dominik Benz, Maude Marechal, Advenit Makaya, Stan J. Brouns, Martin Schwentenwein, et al.

    In-situ resource utilization (ISRU) is increasingly acknowledged as an essential requirement for the construction of sustainable extra-terrestrial colonies. Even with decreasing launch costs, the ultimate goal of establishing colonies must be the usage of resources found at the destination of interest. Typical approaches towards ISRU are often constrained by the mass and energy requirements of transporting processing machineries, such as rovers and massive reactors, and the vast amount of consumables needed. Application of self-reproducing bacteria for the extraction of resources is a promising approach to avoid these pitfalls. In this work, the bacterium Shewanella oneidensis was used to reduce three different types of Lunar and Martian regolith simulants, allowing for the magnetic extraction of iron-rich materials. The quantity of bacterially extracted material was up to 5.8 times higher and the total iron concentration was up to 43.6% higher in comparison to untreated material. The materials were 3D printed into cylinders and the mechanical properties were tested, resulting in a 396 ± 115% improvement in compressive strength in the bacterially treated samples. This work demonstrates a proof of concept for the on-demand production of construction and replacement parts in space exploration.


  • Open Access

    Synthesis of a Rationally Designed Multi-Component Photocatalyst Pt:SiO2:TiO2(P25) with Improved Activity for Dye Degradation by Atomic Layer Deposition

    by Dominik Benz, Hao Van Bui, Hubertus T. Hintzen, Michiel T. Kreutzer, J. Ruud van Ommen

    Photocatalysts for water purification typically lack efficiency for practical applications. Here we present a multi-component (Pt:SiO2:TiO2(P25)) material that was designed using knowledge of reaction mechanisms of mono-modified catalysts (SiO2:TiO2, and Pt:TiO2) combined with the potential of atomic layer deposition (ALD). The deposition of ultrathin SiO2 layers on TiO2 nanoparticles, applying ALD in a fluidized bed reactor, demonstrated in earlier studies their beneficial effects for the photocatalytic degradation of organic pollutants due to more acidic surface Si–OH groups which benefit the generation of hydroxyl radicals. Furthermore, our investigation on the role of Pt on TiO2(P25), as an improved photocatalyst, demonstrated that suppression of charge recombination by oxygen adsorbed on the Pt particles, reacting with the separated electrons to superoxide radicals, acts as an important factor for the catalytic improvement. Combining both materials into the resulting Pt:SiO2:TiO2(P25) nanopowder exceeded the dye degradation performance of both the individual SiO2:TiO2(P25) (1.5 fold) and Pt:TiO2(P25) (4-fold) catalysts by 6-fold as compared to TiO2(P25). This approach thus shows that by understanding the individual materials’ behavior and using ALD as an appropriate deposition technique enabling control on the nano-scale, new materials can be designed and developed, further improving the photocatalytic activity. Our research demonstrates that ALD is an attractive technology to synthesize multicomponent catalysts in a precise and scalable way.


  • Sub-nanoscale Surface Engineering of TiO2 Nanoparticles by Molecular Layer Deposition of Poly(ethylene terephthalate) for Suppressing Photoactivity and Enhancing Dispersibility

    by Damiano La Zara, Maximilian R. Bailey, Peter-Leon Hagedoorn, Dominik Benz, Michael J. Quayle, Staffan Folestad, J. Ruud van Ommen

    In this work, we report molecular layer deposition (MLD) of ultrathin poly(ethylene terephthalate) (PET) films on gram-scale batches of ultrafine particles for the first time. TiO2 P25 nanoparticles (NPs) are coated up to 50 cycles in an atmospheric-pressure fluidized-bed reactor at ∼150 °C using terephthaloyl chloride and ethylene glycol as precursors. Ex-situ diffuse reflectance infrared Fourier transform spectroscopy, thermogravimetric analysis, and transmission electron microscopy show the linear growth at ∼0.05 nm/cycle of uniform and conformal PET films, which are unattainable with conventional wet-phase approaches. The sub-nanoscale and nanoscale PET films not only suppress the photocatalytic activity of TiO2 NPs by hindering the access of water and reactant molecules to the TiO2 surface but also improve the dispersibility of TiO2 NPs in both organic and aqueous media. Still, the bulk optical properties, electronic structure, and surface area of TiO2 are essentially unaffected by the MLD process. This study demonstrates the industrial relevance of MLD to simultaneously suppress the photoactivity and enhance the dispersibility of commercial TiO2 P25 nanopowders, which is crucial for their use for example as UV-screening agents in sunscreens and as white pigments in paints. Moreover, by rapidly modifying the surface properties of particles in a controlled manner at the sub-nanometer scale, particle MLD can serve many other applications ranging from nanofluids to emulsions to polymer nanocomposites.


  • Open Access

    Multitarget Evaluation of the Photocatalytic Activity of P25-SiO2 Prepared by Atomic Layer Deposition

    by Miguel Martín-Sómer, Dominik Benz, J. Ruud van Ommen, Javier Marugán

    This work presents the evaluation of the photocatalytic activity of P25 TiO2 particles, coated with SiO2, using atomic layer deposition (ALD) for the photocatalytic removal of methylene blue, oxidation of methanol and inactivation of Escherichia coli bacteria in water and its comparative evaluation with bare P25 TiO2. Two different reactor configurations were used, a slurry reactor with the catalyst in suspension, and a structured reactor with the catalyst immobilized in macroporous foams, that enables the long-term operation of the process in continuous mode, without the necessity of separation of the particles. The results show that the incorporation of SiO2 decreases the efficiency of the photocatalytic oxidation of methanol, whereas a significant improvement in the removal of methylene blue is achieved, and no significant changes are observed in the photocatalytic inactivation of bacteria. Adsorption tests showed that the improvements, observed in the removal of methylene blue by the incorporation of SiO2, was mainly due to an increase in its adsorption. The improvement in the adsorption step as part of the global photocatalytic process led to a significant increase in its removal efficiency. Similar conclusions were reached for bacterial inactivation where the loss of photocatalytic efficiency, suggested by the methanol oxidation tests, was counteracted with a better adherence of bacteria to the catalyst that improved its elimination. With respect to the use of macroporous foams as support, a reduction in the photocatalytic efficiency is observed, as expected from the decrease in the available surface area. Nevertheless, this lower efficiency can be counteracted by the operational improvement derived from the easy catalyst reuse.


  • Open Access

    Thermal atomic layer deposition of gold nanoparticles: controlled growth and size selection for photocatalysis

    by Fatemeh Sadat Minaye Hashemi, Fabio Grillo, Vikram R. Ravikumar, Dominik Benz, Ankit Shekhar, Matthew B. E. Griffiths, Seán T. Barry, J. Ruud van Ommen

    Thermal atomic layer deposition of Au nanoparticles on titania in a fluidized bed reactor. Effects of precursor pulse time on Au nanoparticle size and loading.


  • Open Access

    Assessing the Role of Pt Clusters on TiO2 (P25) on the Photocatalytic Degradation of Acid Blue 9 and Rhodamine B

    by Dominik Benz, Kevin M. Felter, Jan Koeser, Jorg Thöming, Guido Mul, Ferdinand C. Grozema, Hubertus T. (Bert) Hintzen, Michiel Thijs Kreutzer, J. Ruud van Ommen

    The role of Pt on photocatalytic substrates such as TiO2 (P25) for the decomposition of organic pollutants is still controversial in the scientific community. The well-observed behavior of an optimum catalytic activity as a function of the Pt loading is usually explained by the shift from charge separation to charge recombination behavior of Pt clusters. However, experiments supporting this explanation are still lacking to give a concise understanding of the effect of Pt on the photocatalytic activity. Here, we present an experimental study that tries to discriminate the different effects influencing the photocatalytic activity. Using atomic layer deposition (ALD) in a fluidized bed reactor, we prepared TiO2 (P25) samples with Pt loadings ranging from 0.04 wt. % to around 3 wt. %. In order to reveal the mechanism behind the photocatalytic behaviour of Pt on P25, we investigated the different aspects (i.e., surface area, reactant adsorption, light absorption, charge transfer, reaction pathway) of heterogeneous photocatalysis individually. In contrast to the often proposed prolonged life-time of charge carriers in Pt loaded TiO2 , we found that after collecting the excited electrons, Pt acts more as a recombination center independent of the amount of Pt deposited. Only when dissolved O2 is present in the solution, charge recombination is suppressed by the subsequential consumption of electrons at the surface of the Pt clusters with the dissolved O2 benefited by the improved O2 adsorption on the Pt surface.