Antonio Jesús Santos
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Antonio Jesús Santos has a total of 88 co-authors. Here are the top co-authors by number of shared publications:
- Francisco Miguel Morales
IMEYMAT: Institute of Research on Electron Microscopy and Materials of the University of Cádiz
14 shared publications - Bertrand Lacroix
Departamento de Física Aplicada I, Escuela Politécnica Superior, Universidad de Sevilla, Virgen de África 7, 41011 Sevilla, Spain
11 shared publications - Rafael Garcia
IMEYMAT: Institute of Research on Electron Microscopy and Materials of the University of Cádiz, Cádiz, Spain
9 shared publications - Eduardo Blanco
Department of Condensed-Matter Physics, Faculty of Science, University of Cadiz, Puerto Real, 11510 Cadiz, Spain
6 shared publications Fabien Paumier
6 shared publicationsThierry Girardeau
6 shared publications
Latest Publications
- Open Access
- 12 June 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (24) , 34462-34479
Nb-Doped VO 2 -Based Coatings on Glass: Substrate Effects, Thermochromic Performance, and an Effective Transition Temperature for Smart-Glazing Applications
Niobium-doped VO2 thin films were deposited on soda-lime and borosilicate glass substrates to investigate the coupled effects of dopant concentration, substrate chemistry, and thermal processing on microstructure, thermochromic performance, and metal–insulator transition (MIT) kinetics. Coatings with nominal Nb contents of 3, 4.5, and 6 at. % were fabricated using controlled mono- and multilayer codeposition strategies followed by rapid thermal annealing. Structural and morphological analyses confirm VO2(M) as the dominant phase on both substrates, while revealing a strong substrate-dependent stability of secondary phases driven by Na diffusion, especially in soda-lime glass. Advanced scanning-transmission electron microscopy image and spectroscopic-related techniques demonstrate that Nb exhibits a less homogeneous spatial distribution than other dopants (such as W) under comparable processing conditions, leading to compositional modulations and multistep MIT behavior, particularly on soda-lime substrates. In contrast, borosilicate glass enables enhanced grain coalescence, reduced Na-induced phase instability, and a more uniform Nb incorporation. These microstructural differences directly impact the optical response. Borosilicate-supported coatings exhibit a more favorable balance between luminous transmittance (Tlum) and solar modulation efficiency (ΔTsol), while films on soda-lime glass show a progressive degradation of ΔTsol at higher Nb contents. Despite a lower Tc reduction efficiency compared to W, Nb doping preserves or even improves Tlum at elevated concentrations. Finally, an application-oriented effective transition temperature, Teff, is proposed as a more realistic metric for assessing the suitability of VO2-based coatings for smart-glazing applications.
- 12 June 2026
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 18 (24) , 34462-34479
Open AccessNb-Doped VO 2 -Based Coatings on Glass: Substrate Effects, Thermochromic Performance, and an Effective Transition Temperature for Smart-Glazing Applications
Niobium-doped VO2 thin films were deposited on soda-lime and borosilicate glass substrates to investigate the coupled effects of dopant concentration, substrate chemistry, and thermal processing on microstructure, thermochromic performance, and metal–insulator transition (MIT) kinetics. Coatings with nominal Nb contents of 3, 4.5, and 6 at. % were fabricated using controlled mono- and multilayer codeposition strategies followed by rapid thermal annealing. Structural and morphological analyses confirm VO2(M) as the dominant phase on both substrates, while revealing a strong substrate-dependent stability of secondary phases driven by Na diffusion, especially in soda-lime glass. Advanced scanning-transmission electron microscopy image and spectroscopic-related techniques demonstrate that Nb exhibits a less homogeneous spatial distribution than other dopants (such as W) under comparable processing conditions, leading to compositional modulations and multistep MIT behavior, particularly on soda-lime substrates. In contrast, borosilicate glass enables enhanced grain coalescence, reduced Na-induced phase instability, and a more uniform Nb incorporation. These microstructural differences directly impact the optical response. Borosilicate-supported coatings exhibit a more favorable balance between luminous transmittance (Tlum) and solar modulation efficiency (ΔTsol), while films on soda-lime glass show a progressive degradation of ΔTsol at higher Nb contents. Despite a lower Tc reduction efficiency compared to W, Nb doping preserves or even improves Tlum at elevated concentrations. Finally, an application-oriented effective transition temperature, Teff, is proposed as a more realistic metric for assessing the suitability of VO2-based coatings for smart-glazing applications.
- Open Access
- 8 February 2026
- Published by Elsevier in Applied Surface Science
- Vol. 729
Thermochromic behavior of Ta-doped VO2 thin films: Influence of configuration, pulsed oxygen and dopant ratio
- 8 February 2026
- Published by Elsevier in Applied Surface Science
- Vol. 729
Open AccessThermochromic behavior of Ta-doped VO2 thin films: Influence of configuration, pulsed oxygen and dopant ratio
- Open Access
- 2 September 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 192
Optical and electrical properties of thermochromic VO2 thin film combined with Au or Zr-containing compounds nanoparticles
- 2 September 2025
- Published by Elsevier in Optics & Laser Technology
- Vol. 192
Open AccessOptical and electrical properties of thermochromic VO2 thin film combined with Au or Zr-containing compounds nanoparticles
- Open Access
- 16 July 2025
- Published by Elsevier in Results in Engineering
- Vol. 27
Energy-efficient W-doped VO2-based smart glasses by glancing angle co-deposition and subsequent rapid thermal annealing
- 16 July 2025
- Published by Elsevier in Results in Engineering
- Vol. 27
Open AccessEnergy-efficient W-doped VO2-based smart glasses by glancing angle co-deposition and subsequent rapid thermal annealing
- 18 September 2024
- Published by Elsevier in Surfaces and Interfaces
- Vol. 54
Low temperature dependence of electrical resistivity in obliquely sputter-deposited transition metal thin films
- 18 September 2024
- Published by Elsevier in Surfaces and Interfaces
- Vol. 54
Low temperature dependence of electrical resistivity in obliquely sputter-deposited transition metal thin films
- Open Access
- 30 May 2023
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 35 (11) , 4435-4448
Facile Fabrication of High-Performance Thermochromic VO2-Based Films on Si for Application in Phase-Change Devices
This work reports on an alternative and advantageous procedure to attain VO2-based thermochromic coatings on silicon substrates. It involves the sputtering of vanadium thin films at glancing angles and their subsequent fast annealing in an air atmosphere. By adjusting thickness and porosity of films as well as the thermal treatment parameters, high VO2(M) yields were achieved for 100, 200, and 300 nm thick layers treated at 475 and 550 °C for reaction times below 120 s. Comprehensive structural and compositional characterization by Raman spectroscopy, X-ray diffraction, and scanning-transmission electron microscopies combined with analytical techniques such as electron energy-loss spectroscopy bring to the fore the successful synthesis of VO2(M) + V2O3/V6O13/V2O5 mixtures. Likewise, a 200 nm thick coating consisting exclusively of VO2(M) is also achieved. Conversely, the functional characterization of these samples is addressed by variable temperature spectral reflectance and resistivity measurements. The best results are obtained for the VO2/Si sample with changes in reflectance of 30-65% in the near-infrared at temperatures between 25 and 110 °C. Similarly, it is also proven that the achieved mixtures of vanadium oxides can be advantageous for certain optical applications in specific infrared windows. Finally, the features of the different structural, optical, and electrical hysteresis loops associated with the metal-insulator transition of the VO2/Si sample are disclosed and compared. These remarkable thermochromic performances hereby accomplished highlight the suitability of these VO2-based coatings for applications in a wide range of optical, optoelectronic, and/or electronic smart devices.
- 30 May 2023
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 35 (11) , 4435-4448
Open AccessFacile Fabrication of High-Performance Thermochromic VO2-Based Films on Si for Application in Phase-Change Devices
This work reports on an alternative and advantageous procedure to attain VO2-based thermochromic coatings on silicon substrates. It involves the sputtering of vanadium thin films at glancing angles and their subsequent fast annealing in an air atmosphere. By adjusting thickness and porosity of films as well as the thermal treatment parameters, high VO2(M) yields were achieved for 100, 200, and 300 nm thick layers treated at 475 and 550 °C for reaction times below 120 s. Comprehensive structural and compositional characterization by Raman spectroscopy, X-ray diffraction, and scanning-transmission electron microscopies combined with analytical techniques such as electron energy-loss spectroscopy bring to the fore the successful synthesis of VO2(M) + V2O3/V6O13/V2O5 mixtures. Likewise, a 200 nm thick coating consisting exclusively of VO2(M) is also achieved. Conversely, the functional characterization of these samples is addressed by variable temperature spectral reflectance and resistivity measurements. The best results are obtained for the VO2/Si sample with changes in reflectance of 30-65% in the near-infrared at temperatures between 25 and 110 °C. Similarly, it is also proven that the achieved mixtures of vanadium oxides can be advantageous for certain optical applications in specific infrared windows. Finally, the features of the different structural, optical, and electrical hysteresis loops associated with the metal-insulator transition of the VO2/Si sample are disclosed and compared. These remarkable thermochromic performances hereby accomplished highlight the suitability of these VO2-based coatings for applications in a wide range of optical, optoelectronic, and/or electronic smart devices.
- Open Access
- 21 February 2023
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 254
Towards the optimization of a simple route for the fabrication of energy-efficient VO2-based smart coatings
- 21 February 2023
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 254
Open AccessTowards the optimization of a simple route for the fabrication of energy-efficient VO2-based smart coatings
- Open Access
- 15 February 2023
- Published by Elsevier in Energy and Buildings
- Vol. 285
A simple two-step approach to the fabrication of VO2-based coatings with unique thermochromic features for energy-efficient smart glazing
- 15 February 2023
- Published by Elsevier in Energy and Buildings
- Vol. 285
Open AccessA simple two-step approach to the fabrication of VO2-based coatings with unique thermochromic features for energy-efficient smart glazing
- Open Access
- 31 August 2022
- Published by Elsevier in Surfaces and Interfaces
- Vol. 34
Atmospheric flash annealing of low-dimensional vanadium nanolayers sputtered on glass substrates
- 31 August 2022
- Published by Elsevier in Surfaces and Interfaces
- Vol. 34
Open AccessAtmospheric flash annealing of low-dimensional vanadium nanolayers sputtered on glass substrates
- Open Access
- 27 August 2022
- Published by Elsevier in Applied Surface Science
- Vol. 605
Texture in ITO films deposited at oblique incidence by ion beam sputtering
- 27 August 2022
- Published by Elsevier in Applied Surface Science
- Vol. 605
Open AccessTexture in ITO films deposited at oblique incidence by ion beam sputtering