Chenglei Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Chenglei Li has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Yingzeng Yin
National Key Laboratory of Radar Detection and Sensing, Xidian University, Xian, Shaanxi, China
2 shared publications - Ziyang Wang
Beihang University
2 shared publications - Qiong Wu
Jiangnan University
1 shared publication
Latest Publications
- Open Access
- 6 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 125565-125575
A Metasurface-Based Low-Profile Array Decoupling Technology to Enhance Isolation in MIMO Antenna Systems
In this paper, a metasurface-based coupling reduction method is presented with the advantage of low profile for the MIMO antenna array. Unlike other metasurface-based decoupling technologies, this proposed metasurface for decoupling is loaded in the same layer as the coupled two-element patch antennas. Hence, the profile of the proposed decoupled array is greatly reduced compared to that of other published metasurface-based decoupled arrays. In this design, the two patch antennas with a short edge-to-edge distance of approximately$0.06~\lambda $ are surrounded by the period split ring resonator (SRR) elements. Next, two prototypes are fabricated; the test results show that the isolation performance for the decoupled array is better than that of a coupled array without SRRs, and the value of$\vert \text{S}21\vert $ improves from −8 dB to −25 dB in a wide band of 5.0-6.0 GHz with$\vert \text{S}21\vert < -25$ dB. The impedance matching bandwidths for two arrays without and with SRRs are approximately 700 MHz (12.7%) and 1500 MHz (27%), respectively, with$\vert \text{S}11\vert < -10$ dB. In other words, a high-isolation MIMO array with the advantages of a low profile and a compact size is realized. It is exciting that the peak gains for the proposed decoupled array are improved by approximately 2 dB in the entire working band range. In addition, the efficiencies of the decoupled array increase by 15% compared to those of the coupled array, and the envelope correlation coefficient (ECC) also greatly improves. Therefore, the signs suggest that this proposed metasurface-based decoupling method is an efficient measure for MIMO array applications in the future.- 6 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 125565-125575
Open AccessA Metasurface-Based Low-Profile Array Decoupling Technology to Enhance Isolation in MIMO Antenna Systems
In this paper, a metasurface-based coupling reduction method is presented with the advantage of low profile for the MIMO antenna array. Unlike other metasurface-based decoupling technologies, this proposed metasurface for decoupling is loaded in the same layer as the coupled two-element patch antennas. Hence, the profile of the proposed decoupled array is greatly reduced compared to that of other published metasurface-based decoupled arrays. In this design, the two patch antennas with a short edge-to-edge distance of approximately$0.06~\lambda $ are surrounded by the period split ring resonator (SRR) elements. Next, two prototypes are fabricated; the test results show that the isolation performance for the decoupled array is better than that of a coupled array without SRRs, and the value of$\vert \text{S}21\vert $ improves from −8 dB to −25 dB in a wide band of 5.0-6.0 GHz with$\vert \text{S}21\vert < -25$ dB. The impedance matching bandwidths for two arrays without and with SRRs are approximately 700 MHz (12.7%) and 1500 MHz (27%), respectively, with$\vert \text{S}11\vert < -10$ dB. In other words, a high-isolation MIMO array with the advantages of a low profile and a compact size is realized. It is exciting that the peak gains for the proposed decoupled array are improved by approximately 2 dB in the entire working band range. In addition, the efficiencies of the decoupled array increase by 15% compared to those of the coupled array, and the envelope correlation coefficient (ECC) also greatly improves. Therefore, the signs suggest that this proposed metasurface-based decoupling method is an efficient measure for MIMO array applications in the future. - Open Access
- 26 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 61797-61805
A Meta-Surface Antenna Array Decoupling (MAAD) Design to Improve the Isolation Performance in a MIMO System
In this paper, a design to reduce the mutual coupling between two closely MIMO antennas is presented. A metasurface superstrate consisting of periodic circular split ring resonator (CSRR) elements is placed above the coupled two-element patch antennas to improve the isolation performance. The propagation of the electromagnetic wave from antenna 1 to antenna 2 causing mutual coupling will be blocked since the loading of metasurface, which can be considered as a negative-permeability medium. First, the size of the CSRR element is determined by properly designing the range of negative permeability in the desire band. Thereafter, a decoupled MIMO array with a high isolation performance is realized with an intolerable matching curve. Then, some measures are employed on each patch to enhance the matching performance, such as etching slots and loading short probes on the patches. Next, two prototypes for the coupled and decoupled arrays are fabricated and measured to verify the improvement of the isolation performance. Measured results show that the value of |S21| for the decoupled array has been greatly improved from -8 dB to less than -20 dB within the entire working band of 5.58-6.0 GHz. Meanwhile, the match bandwidth of |S11| <; -15 dB for the decoupled array is approximately 420 MHz, which has also been improved in the desire band compared with the coupled array. In addition, the measured gains for the decoupled array are improved by approximately 1.8 dB as compared to the coupled array, whereas the efficiencies are increased by 16% which is higher than the coupled array. Moreover, the envelope correlation coefficient (ECC) for the decoupled array is reduced from 0.17 to 0.06 within the entire band of interest. Therefore, all measured results demonstrate that the proposed MAAD design is a good candidate for the improvement of MIMO antenna arrays.
- 26 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 61797-61805
Open AccessA Meta-Surface Antenna Array Decoupling (MAAD) Design to Improve the Isolation Performance in a MIMO System
In this paper, a design to reduce the mutual coupling between two closely MIMO antennas is presented. A metasurface superstrate consisting of periodic circular split ring resonator (CSRR) elements is placed above the coupled two-element patch antennas to improve the isolation performance. The propagation of the electromagnetic wave from antenna 1 to antenna 2 causing mutual coupling will be blocked since the loading of metasurface, which can be considered as a negative-permeability medium. First, the size of the CSRR element is determined by properly designing the range of negative permeability in the desire band. Thereafter, a decoupled MIMO array with a high isolation performance is realized with an intolerable matching curve. Then, some measures are employed on each patch to enhance the matching performance, such as etching slots and loading short probes on the patches. Next, two prototypes for the coupled and decoupled arrays are fabricated and measured to verify the improvement of the isolation performance. Measured results show that the value of |S21| for the decoupled array has been greatly improved from -8 dB to less than -20 dB within the entire working band of 5.58-6.0 GHz. Meanwhile, the match bandwidth of |S11| <; -15 dB for the decoupled array is approximately 420 MHz, which has also been improved in the desire band compared with the coupled array. In addition, the measured gains for the decoupled array are improved by approximately 1.8 dB as compared to the coupled array, whereas the efficiencies are increased by 16% which is higher than the coupled array. Moreover, the envelope correlation coefficient (ECC) for the decoupled array is reduced from 0.17 to 0.06 within the entire band of interest. Therefore, all measured results demonstrate that the proposed MAAD design is a good candidate for the improvement of MIMO antenna arrays.