Neel Gupta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Neel Gupta has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Brijes Mishra
Department of Mining Engineering, West Virginia University, Morgantown, USA
2 shared publications Brijes Mishra
1 shared publicationCody Vining
RESPEC, Rapid City, SD (United States)
1 shared publication- Debashis Das1 shared publication
Ernest Hardin
1 shared publicationEvan Keffeler
RESPEC, Rapid City, SD (United States)
1 shared publication
Latest Publications
- Open Access
- 1 September 2021
- Published by Elsevier in International Journal of Mining Science and Technology
- Vol. 31 (5) , 953-961
Understanding the influence of petrographic parameters on strength of differently sized shale specimens using XRD and SEM
- 1 September 2021
- Published by Elsevier in International Journal of Mining Science and Technology
- Vol. 31 (5) , 953-961
Open AccessUnderstanding the influence of petrographic parameters on strength of differently sized shale specimens using XRD and SEM
- 19 November 2020
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (5) , 1575-1595
Influence of stress-induced microcracks on viscoplastic creep deformation in Marcellus shale
- 19 November 2020
- Published by Springer Nature in Acta Geotechnica
- Vol. 16 (5) , 1575-1595
Influence of stress-induced microcracks on viscoplastic creep deformation in Marcellus shale
- 27 July 2020
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 39 (1) , 213-236
Experimental Investigation of the Influence of Bedding Planes and Differential Stress on Microcrack Propagation in Shale Using X-Ray CT Scan
- 27 July 2020
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 39 (1) , 213-236
Experimental Investigation of the Influence of Bedding Planes and Differential Stress on Microcrack Propagation in Shale Using X-Ray CT Scan
- Open Access
- 25 February 2020
- Published by West Virginia University Libraries
Fundamental Mechanism of Time Dependent Failure in Shale
In underground coal mines, mining activity disturbs the natural equilibrium state of in-situ stresses. The induced and in-situ stresses deform the rockmass surrounding the mine openings. Primary roof supports impede the deformation of the rockmass overlying the entries. However, failure can occur in the bolted rockmass, causing fatalities and injuries. The rockmass failure is erratic, and its occurrence often varies from a few days to months and years after the opening of the entry. One of the often-neglected factors in this process is the effect of time on the stability of mine openings, which can often be observed in the propagation of failure in the rockmass. Coal-measure rocks have exhibited time-dependent strength reduction in laboratory creep tests. However, the exact mechanism responsible for this time-dependent reduction in strength is not clear. Therefore, this thesis investigated the fundamental reason for macroscopic creep deformation in shale through microscopic visualization using an X-ray computed tomography (CT) technique. An approach was formulated based on the following experiments. · Conduct compressive strength tests and X-ray powdered diffraction (XRD) analysis on core specimens · Perform triaxial creep tests at different triaxial stress states · Determine the geometry of the microcracks using X-ray CT image processing · Perform triaxial creep and recovery test with X-ray CT scan of shale specimens The mineralogical analysis, using XRD, showed that the shale contained calcite, as well as a minor percentage of quartz, feldspar, and illite. The uniaxial and triaxial compressive strength tests showed brittle failure, with a high modulus of stiffness and a low Poisson’s ratio in the elastic region. The creep behavior of shale was analyzed under constant triaxial stress. As shale is an anisotropic rock, specimens were tested with both parallel and perpendicular bedding orientations to the major principal stress. The triaxial experiments showed that both types of specimens experienced creep failure; however, the creep deformation was unpredictable. The time to reach creep failure did not show any correlation with the level of applied stress. The results of secondary creep strain rate did not follow Norton’s creep law; the degree of determination (R2) between the logarithm of secondary creep strain rate and logarithm of applied differential stress was significantly small. In addition, the nature of creep deformation in brittle shale was different from other brittle rocks, such as quartz and granite. In both parallel and perpendicular-bedded shale specimens, the increase in confining pressure changed the inelastic volumetric strain,
- 25 February 2020
- Published by West Virginia University Libraries
Open AccessFundamental Mechanism of Time Dependent Failure in Shale
In underground coal mines, mining activity disturbs the natural equilibrium state of in-situ stresses. The induced and in-situ stresses deform the rockmass surrounding the mine openings. Primary roof supports impede the deformation of the rockmass overlying the entries. However, failure can occur in the bolted rockmass, causing fatalities and injuries. The rockmass failure is erratic, and its occurrence often varies from a few days to months and years after the opening of the entry. One of the often-neglected factors in this process is the effect of time on the stability of mine openings, which can often be observed in the propagation of failure in the rockmass. Coal-measure rocks have exhibited time-dependent strength reduction in laboratory creep tests. However, the exact mechanism responsible for this time-dependent reduction in strength is not clear. Therefore, this thesis investigated the fundamental reason for macroscopic creep deformation in shale through microscopic visualization using an X-ray computed tomography (CT) technique. An approach was formulated based on the following experiments. · Conduct compressive strength tests and X-ray powdered diffraction (XRD) analysis on core specimens · Perform triaxial creep tests at different triaxial stress states · Determine the geometry of the microcracks using X-ray CT image processing · Perform triaxial creep and recovery test with X-ray CT scan of shale specimens The mineralogical analysis, using XRD, showed that the shale contained calcite, as well as a minor percentage of quartz, feldspar, and illite. The uniaxial and triaxial compressive strength tests showed brittle failure, with a high modulus of stiffness and a low Poisson’s ratio in the elastic region. The creep behavior of shale was analyzed under constant triaxial stress. As shale is an anisotropic rock, specimens were tested with both parallel and perpendicular bedding orientations to the major principal stress. The triaxial experiments showed that both types of specimens experienced creep failure; however, the creep deformation was unpredictable. The time to reach creep failure did not show any correlation with the level of applied stress. The results of secondary creep strain rate did not follow Norton’s creep law; the degree of determination (R2) between the logarithm of secondary creep strain rate and logarithm of applied differential stress was significantly small. In addition, the nature of creep deformation in brittle shale was different from other brittle rocks, such as quartz and granite. In both parallel and perpendicular-bedded shale specimens, the increase in confining pressure changed the inelastic volumetric strain,