ISIhor P. Studenyak

Ihor P. Studenyak

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ihor P. Studenyak has a total of 159 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Synthesis and Optical Properties of Ag–Ga–S Quantum Dots

    by Yuriy Azhniuk, Bohdana Lopushanska, Oleksandr Selyshchev, Yevhenii Havryliuk, Artem Pogodin, Oleksandr Kokhan, Alexander Ehm, Vasyl Lopushansky, Ihor Studenyak, Dietrich R.T. Zahn

    Ag–Ga–S quantum dots (QDs) are obtained by colloidal synthesis in aqueous solutions with glutathione ligands at mild conditions. The QDs can be assigned to metastable orthorhombic, rhombohedral, or rocksalt‐type phases, assuming a significant internal pressure within crystallites, while the conventional tetragonal AgGaS2 phase is less likely formed. Similarly to these metastable phases, the QDs reveal a relatively narrow indirect bandgap contrary to the wide and direct bandgap of tetragonal AgGaS2. Size‐selected fractions of the colloidal solutions are separated by repeated centrifuging with addition of 2‐propanol. The QD size is evaluated from atomic force microscopy, while the crystallite size determined using the Scherrer formula is underestimated. X‐ray photoemission spectroscopy reveals that the QD composition changes from nearly stoichiometric for the fraction with the largest QDs toward Ag deficient and S rich for smaller QDs. The synthesized QDs are characterized by the absorption edge blueshift with decreasing QD size. A blueshift of the photoluminescence (PL) peak with decreasing QD size is observed as well as a nonmonotonous size dependence of the PL intensity. Raman spectra of the Ag–Ga–S QDs are discussed compared to those of bulk crystals and a strong contribution of surface phonons is revealed.


  • Structural, electrical and optical properties of ion-conducting Na6PS5Cl, Na6PS5Br, and Na7PS6 compounds

    by I.P. Studenyak, A.I. Pogodin, V.I. Studenyak, O.P. Kokhan, Yu.M. Azhniuk, D. Solonenko, L. Daróczi, S. Kökényesi, D.R.T. Zahn


  • INTERACTION IN THE Ag6PS5I–Ag7GeS5I AND Ag7GeS5I–Ag7SiS5I SYSTEMS

    by A.I. Pogodin, M.J. Filep, I.O Shender, O.P. Kokhan, I.P. Studenyak, А.і. Погодін, І.о. Шендер, І.п. Студеняк

    Argyrodites are a wide class of tetrahedrally close–packed ternary and quaternary compounds that have a large number of representatives. Argyrodite family compounds always include two types of cations: univalent (type A) and multivalent (type B). B type multivalent cations (3–5) are tetrahedrally coordinated by anions and form a rigid anionic framework, and the univalent A type cations are located in the cavities between them and have different occupancy of crystallographic positions (disordered sublattice). The most common are argyrodites based on four and five valence p–elements. Type A and B cations are subject to isomorphic substitution, which in combination with the proximity of the crystal lattice parameters causes a significant number of solid solutions between the compounds with the structure of argyrodite. These solid solutions are formed by both isovalent and heterovalent substitution, which is used to optimize the functional parameters of the studied materials. Argyrodite structure compounds can be used as optical, superionic, and thermoelectric materials. This work aims to study the physico–chemical interaction at isovalent Si4+↔Ge4+and heterovalent substitution of P5+↔Ge4+ within the Ag7SiS5I–Ag7GeS5I and Ag6PS5I–Ag7GeS5I systems. Several alloys in the Ag6PS5I–Ag7GeS5I and Ag7SiS5I – Ag7GeS5I systems were synthesized by a direct single–temperature method using the pre–synthesized quaternary argyrodites. The obtained samples were investigated by the methods of differential thermal (DTA), X–ray diffraction (XRD), and microstructural (MSA) analyses. Based on the obtained results, it was found that the Ag6PS5I–Ag7GeS5I section is partly quasi–binary due to the incongruent melting of Ag6PS5I. The liquidus of the system is formed by lines of primary crystallization of Ag2S and Ag7GeS5I crystals, which intersect at the point with coordinates: 6 mol. % Ag7GeS5I, 1009 K. The subsolidus part of the Ag6PS5I–Ag7GeS5I system is characterized by the formation of a continuous series of solid solutions. The phase diagram of the Ag7SiS5I–Ag7GeS5I system is characterized by unlimited solubility of components in liquid and solid phases. In the Ag6PS5I–Ag7GeS5I system a positive deviation from Vegard's law is observed.


  • PECULIARITIES OF SINGLE CRYSTAL GROWTH OF SOLID SOLUTION IN SYSTEMS Ag6PS5I‒Ag7GeS5I AND Ag7SiS5I‒Ag7GeS5I

    by A.I. Pogodin, M.J Filep, O.P. Kokhan, T.а. Malakhovska, I.A. Shender, I.P. Studenyak, А.і. Погодін, М.й. Філеп, І.о. Шендер, І.п. Студеняк

    The application of innovative resolutions that are technically grounded and economically acceptable with the use of environmentally friendly components is one of the important points at the present stage of human development to promote the ideas of efficient use of energy resources. Superionic conductors take a leading role in solving the problems of energy-saving technologies because electrochemical sensors and solid energy sources based on them can be created. Quaternary silver-containing compounds of argyrodite structure Ag6PS5I, Ag7SiS5I, and Ag7GeS5I have many advantages, in particular chemical stability, high values of ionic conductivity, the ability to form wide series of solid solutions due to the structural features. This work is devoted to the development and optimization of technology for obtaining high-quality single-crystal samples of solid solutions based on compounds of argyrodite structure formed in systems Ag6PS5I‒Ag7GeS5I та Ag7SiS5I‒Ag7GeS5I. The synthesis of solid solutions of the investigated systems was carried out by a direct single-temperature method from previously obtained quaternary compounds Ag6PS5I, Ag7SiS5I, and Ag7GeS5I. The maximal temperature of synthesis was 1273 K (exposure 72 h). Cooling to the experimentally selected annealing temperatures of 733 K (Ag6PS5I‒Ag7GeS5I) and 873 K (Ag7SiS5I‒Ag7GeS5I) was performed at a rate of 100 K/h. The annealing was performed for 120 hours. Crystal growth of solid solutions based on Ag6PS5I, Ag7SiS5I, and Ag7GeS5I phases was carried out by the directional crystallization from solution-melt by the Bridgman technique. The growth of single crystals was carried out in a three-zone furnace in a quartz container with a conical bottom. The optimal technological regimes for crystal growth of solid solutions of Ag6PS5I‒Ag7GeS5I and Ag7SiS5I‒Ag7GeS5I systems have been established. Grown single crystals of solid solutions Ag6+x(P1-xGex)S5I (х=0.25, 0.5, 0.75) and Ag7(Si1-xGex)S5I (х=0.2, 0.4, 0.6, 0.8) were dark gray color with metallic luster 30-40 mm long and 10-12 mm in diameter. Obtained crystals were investigated by X-ray diffraction analysis. Calculated lattice parameters change according to Vegard’s rule and confirm the formation of solid solutions in studied systems.


  • Open Access

    Influence of cation substitution on electrical conductivity of microcrystalline ceramics based on (Cu1-xAgx)7GeSe5I solid solutions

    by I.P. Studenyak, A.I. Pogodin, V.I. Studenyak, T.O. Malakhovska, M.J. Filep, O.P. Kokhan, V. Takats, S. Kökényesi

    Ceramic samples based on the microcrystalline powders (Cu1–хAgx)7GeSe5I (x = 0, 0.25, 0.5, 0.75, 1) were prepared by pressing them at the pressure close to 400 MPa and subsequent annealing at 873 K for 36 hours. Using the microstructural analysis, the average size of microcrystallites of these samples was determined. Investigation of electrical conductivity of ceramics based on (Cu1 хAgx)7GeSe5I solid solutions was carried out using the method of impedance spectroscopy in the frequency range from 10 Hz to 3×105 Hz and within the temperature range 293...383 K. Analysis of the Nyquist plots allowed determining the contributions of ionic and electronic components to the total electrical conductivity. The temperature dependence of ionic and electronic conductivity in Arrhenius coordinates is linear, which indicates their thermoactivation character. The compositional behaviour of ionic and electronic conductivity, as well as their activation energies have been studied. Their nonlinear character can be explained by the complex process of recrystallization and Cu+ ↔ Ag+ cation substitution within the cationic sublattice.

  • Open Access

    Influence of X7GeS5I (X = Ag, Cu) Superionic Nanoparticles on Structural Changes in Nematic Liquid Crystal

    by Peter Bury, Marek Veveričík, Peter Kopčanský, Milan Timko, Ihor P. Studenyak, Artem I. Pogodin

    The effect of two types of superionic nanoparticles; Cu7GeS5I and Ag7GeS5I, respectively on nematic liquid crystal (6CB) behavior under an external electric field is investigated. The response of both attenuation of surface acoustic waves propagating along with the substrate/liquid crystal interface and light transmission are used to study the structural changes induced by applied electric field. The increasing/decreasing regime as well as jumped change of applied field were used. The light transmission was investigated using linearly polarized laser beam (532 nm) propagating through the liquid crystal. Results obtained from both measurements for three different concentrations (0.01, 0.05 and 0.10 wt%) and in addition two different sizes of nanoparticles are compared and results, relying on structural changes, suspension stability and switching behavior are evaluated.


  • Electrical conductivity of composites based on 6CB liquid crystal and (Cu6PS5I)0.5(Cu7PS6)0.5 superionic nanoparticles

    by I. P. Studenyak, O. V. Kovalchuk, S. I. Poberezhets, M. M. Luchynets, A. I. Pogodin, M. Timko, P. Kopčanský

    In the frequency range of 6–106 Hz at a temperature of 293 K, the influence of (Cu6PS5I)0.5(Cu7PS6)0.5 superionic nanoparticles on electrical conductivity and dielectric properties of 6CB liquid crystal are investigated. Parameters of near-electrode and bulk processes are evaluated as well as their changes at introducing nanoparticles into the LC are investigated. It is shown that the effect of nanoparticles of solid solution (Cu6PS5I)0.5(Cu7PS6)0.5 is smaller than the effect of Cu6PS5I nanoparticles. It is suggested that the surface properties of solid solution nanoparticles are mainly determined by Cu7PS6 component of a solid solution. Significantly less interaction of nanoparticles of solid solution (Cu6PS5I)0.5(Cu7PS6)0.5 with molecules of 6CB LC than the interaction of Cu7PS6 nanoparticles with molecules of liquid crystal is established.


  • Open Access

    Crystal structure and electrical properties of Ag6PS5I single crystal

    by I.P. Studenyak, A.I. Pogodin, M.J. Filep, O.P. Kokhan, O.I. Symkanych, M. Timko, P. Kopčanský

    The single crystals of quaternary halogen Ag6PS5I were grown from the solution–melt by means of a vertical zone crystallization method. The crystal structure has been ascertained using the Rietveld method. Investigation of electrical conductivity was carried out using the impedance spectroscopy technique within the frequency range 1·101 – 3·105 Hz and temperature interval 293–383 K on gold contacts applied by chemical deposition from solution. Ionic (1.79·10-3 S/cm) and electronic (1.64·10-6 S/cm) components of electrical conductivity have been determined using the Nyquist plots. The mechanism of ionic conductivity for Ag6PS5I single crystal has been proposed which can be considered as ion diffusion through “channels” Ag2–Ag2.


  • Structural and optical study of glutathione-capped Ag–In–S nanocrystals

    by B.V. Lopushanska, Y. M. Azhniuk, D. Solonenko, V. V. Lopushansky, I.P. Studenyak, D. R. T. Zahn

    Aqueous synthesis of glutathione-capped Ag–In–S nanocrystals (NCs) at various [Ag]:[In]:[S] molar ratios was performed under mild conditions. The average NC size is determined from X-ray diffraction data. Size-selective fractioning of the colloidal solutions is performed by repeated centrifuging with addition of 2-propanol. Based on the optical absorption and photoluminescence (PL) measurements, the dependence of the bandgap and the PL maximum position on the NC size and composition is analyzed. The analysis of the size-fractioned Ag–In–S NC Raman spectra shows that for small NCs the [Ag]/[In] ratio affects the Raman features only slightly and confirms the increase of [S]/[Ag] ratio with the decrease in NC size.