Arup Biswas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Arup Biswas has a total of 66 co-authors. Here are the top co-authors by number of shared publications:
D. Bhattacharyya
6 shared publications- Dibyendu Bhattacharyya
Atomic and Molecular Physics Division Bhabha Atomic Research Centre Mumbai India
5 shared publications S. Rai
4 shared publicationsSimran Atwal
4 shared publicationsAbharana Nagendra
Atomic and Molecular Physics Division
2 shared publications- Kaustava Bhattacharyya
Chemistry Division, Bhabha Atomic Research Centre, Mumbai 400 085, India
2 shared publications
Latest Publications
- Open Access
- 12 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (6)
Ultra-soft magnetic properties in Ta/NiFe laminated system
An integrated magnetic flux concentrator (MFC) has become a choice for enhancing the sensitivity of a magnetic field sensor. However, the flux concentrator’s geometry and its ultra-soft magnetic properties are the key ingredients for successful implementation to improve the detectability of a magnetic sensor. In this report, the laminated stack of Ta/Ru/[NiFe(tNiFe)/Ta(tTa)]N/Ta of thickness 0.5 μm was investigated, where tNiFe, tTa, and N were varied to optimize ultra-soft magnetic properties of the film and compared them with the bulk NiFe film. Structural investigations revealed that incorporating an ultra-thin layer of Ta in the laminated stack suppresses the grain growth of the NiFe phase and improves the textured growth of the fcc(111) phase of the NiFe alloy. This results in dramatic improvement of the measured magnetic hysteresis loop of the laminated stack with a reduced coercivity field in the range of 0.4 ± 0.1 Oe, high linearity, and low saturation field (<10 Oe) while comparing them with the bulk film of NiFe of equivalent thicknesses. The laminated stack thickness of up to 4 μm was further investigated, and the bilinear M(H) loop was explained through antiferromagnetic (AFM) interlayer coupling between successive NiFe layers.
- 12 August 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (6)
Open AccessUltra-soft magnetic properties in Ta/NiFe laminated system
An integrated magnetic flux concentrator (MFC) has become a choice for enhancing the sensitivity of a magnetic field sensor. However, the flux concentrator’s geometry and its ultra-soft magnetic properties are the key ingredients for successful implementation to improve the detectability of a magnetic sensor. In this report, the laminated stack of Ta/Ru/[NiFe(tNiFe)/Ta(tTa)]N/Ta of thickness 0.5 μm was investigated, where tNiFe, tTa, and N were varied to optimize ultra-soft magnetic properties of the film and compared them with the bulk NiFe film. Structural investigations revealed that incorporating an ultra-thin layer of Ta in the laminated stack suppresses the grain growth of the NiFe phase and improves the textured growth of the fcc(111) phase of the NiFe alloy. This results in dramatic improvement of the measured magnetic hysteresis loop of the laminated stack with a reduced coercivity field in the range of 0.4 ± 0.1 Oe, high linearity, and low saturation field (<10 Oe) while comparing them with the bulk film of NiFe of equivalent thicknesses. The laminated stack thickness of up to 4 μm was further investigated, and the bilinear M(H) loop was explained through antiferromagnetic (AFM) interlayer coupling between successive NiFe layers.
- 30 May 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (11) , 7730-7743
Spectroscopic Ellipsometry Study of TiO2/LiPON and LNMC/LiPON Solid Electrode/Electrolyte Interfaces of Solid-State Batteries
- 30 May 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (11) , 7730-7743
Spectroscopic Ellipsometry Study of TiO2/LiPON and LNMC/LiPON Solid Electrode/Electrolyte Interfaces of Solid-State Batteries
- Open Access
- 24 February 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (8)
Self-diffusion and interface diffusion in crystalline and amorphous Ni/Ti multilayer: A molecular dynamics study
Diffusion phenomena in crystalline and amorphous Ni/Ti binary multilayer systems have been simulated by the molecular dynamics (MD) technique in a wide temperature range of 473–1600 K and compared with the experimental results. Evolution of the diffusion process and crystalline phase formation has been investigated as a function of annealing temperature. Formation of the B2-phase (austenite) of the NiTi alloy has been noticed at the interface for an amorphous multilayer system at a relatively lower temperature compared to the crystalline multilayer system, which corroborates well with our earlier experimental findings on this system. MD simulation has also helped to study the diffusion of Ni and Ti separately and it is observed that the diffusion of Ni and Ti in an amorphous system is higher than the corresponding diffusion in a crystalline system. A very interesting difference has been noticed with self-diffusion being dominant in Ti and interface diffusion in Ni. As a result, the formation of new FCC and BCC Ti phases has been observed in the amorphous Ti layer. Individual diffusion coefficients of Ni and Ti are estimated for both crystalline and amorphous systems, and it is observed that the variation of diffusion coefficients with temperature follows the Arrhenius-type relation, with lower activation energies obtained for the amorphous system over the crystalline system. Furthermore, the diffusion mechanism for both the systems is discussed. The above study gives important insight into the interface diffusion process of a technologically important multilayer system and would be immensely helpful in designing applications of such multilayers.
- 24 February 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 137 (8)
Open AccessSelf-diffusion and interface diffusion in crystalline and amorphous Ni/Ti multilayer: A molecular dynamics study
Diffusion phenomena in crystalline and amorphous Ni/Ti binary multilayer systems have been simulated by the molecular dynamics (MD) technique in a wide temperature range of 473–1600 K and compared with the experimental results. Evolution of the diffusion process and crystalline phase formation has been investigated as a function of annealing temperature. Formation of the B2-phase (austenite) of the NiTi alloy has been noticed at the interface for an amorphous multilayer system at a relatively lower temperature compared to the crystalline multilayer system, which corroborates well with our earlier experimental findings on this system. MD simulation has also helped to study the diffusion of Ni and Ti separately and it is observed that the diffusion of Ni and Ti in an amorphous system is higher than the corresponding diffusion in a crystalline system. A very interesting difference has been noticed with self-diffusion being dominant in Ti and interface diffusion in Ni. As a result, the formation of new FCC and BCC Ti phases has been observed in the amorphous Ti layer. Individual diffusion coefficients of Ni and Ti are estimated for both crystalline and amorphous systems, and it is observed that the variation of diffusion coefficients with temperature follows the Arrhenius-type relation, with lower activation energies obtained for the amorphous system over the crystalline system. Furthermore, the diffusion mechanism for both the systems is discussed. The above study gives important insight into the interface diffusion process of a technologically important multilayer system and would be immensely helpful in designing applications of such multilayers.
- 11 April 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (4) , 2213-2224
Multilayer and Graded Thin-Film Electrodes: Paving the Way for High-Capacity and Long-Lasting Li-Ion Batteries
- 11 April 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (4) , 2213-2224
Multilayer and Graded Thin-Film Electrodes: Paving the Way for High-Capacity and Long-Lasting Li-Ion Batteries
- 20 February 2024
- Published by Elsevier in Applied Surface Science
- Vol. 657
Improvement of high energy X-ray optical performance of W/Si supermirror by optimizing interface compounds using ultra-thin buffer layer
- 20 February 2024
- Published by Elsevier in Applied Surface Science
- Vol. 657
Improvement of high energy X-ray optical performance of W/Si supermirror by optimizing interface compounds using ultra-thin buffer layer
- 1 September 2021
- Published by Elsevier in Thin Solid Films
- Vol. 734
Evolution of the interface microstructure of short-period Cr/Ti multilayers with increase in number of bi-layers
- 1 September 2021
- Published by Elsevier in Thin Solid Films
- Vol. 734
Evolution of the interface microstructure of short-period Cr/Ti multilayers with increase in number of bi-layers
- Open Access
- 28 April 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (16) , 165304
Early recrystallization of Ni/Ti multilayer due to disorder in the Ni layer
Disorders present at the interfaces drive solid state amorphization (SSA) and recrystallization in Ni/Ti multilayers. In this communication, the effect of disorders present in the bulk Ni layers is studied on SSA and recrystallization. The disorder in the Ni layers is created by sputtering Ni layers of the Ni/Ti multilayers under the mixed ambience of argon and nitrogen. It has been observed recently that the neutron optical performances of Ni/Ti graded multilayers or supermirrors can be improved by sputtering of Ni layers under the mixed ambience of argon and nitrogen. In this work, Ni/Ti periodic multilayers deposited under pure argon ambience and under mixed ambience of argon and nitrogen have been annealed under vacuum at 200 °C, 400 °C, and 600 °C for 2 h. All the annealed multilayer samples along with as-deposited multilayers are characterized by x-ray diffraction and grazing incidence x-ray reflectivity measurements in specular and non-specular modes. Atomic diffusion within the layers and across interfaces has been studied as a function of annealing temperature for both sets of multilayers. It is found that the interstitial nitrogen atoms present in the Ni layers play a crucial role in the diffusivity at room temperature as well as high temperature and thus influence the SSA and recrystallization phenomena.
- 28 April 2020
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 127 (16) , 165304
Open AccessEarly recrystallization of Ni/Ti multilayer due to disorder in the Ni layer
Disorders present at the interfaces drive solid state amorphization (SSA) and recrystallization in Ni/Ti multilayers. In this communication, the effect of disorders present in the bulk Ni layers is studied on SSA and recrystallization. The disorder in the Ni layers is created by sputtering Ni layers of the Ni/Ti multilayers under the mixed ambience of argon and nitrogen. It has been observed recently that the neutron optical performances of Ni/Ti graded multilayers or supermirrors can be improved by sputtering of Ni layers under the mixed ambience of argon and nitrogen. In this work, Ni/Ti periodic multilayers deposited under pure argon ambience and under mixed ambience of argon and nitrogen have been annealed under vacuum at 200 °C, 400 °C, and 600 °C for 2 h. All the annealed multilayer samples along with as-deposited multilayers are characterized by x-ray diffraction and grazing incidence x-ray reflectivity measurements in specular and non-specular modes. Atomic diffusion within the layers and across interfaces has been studied as a function of annealing temperature for both sets of multilayers. It is found that the interstitial nitrogen atoms present in the Ni layers play a crucial role in the diffusivity at room temperature as well as high temperature and thus influence the SSA and recrystallization phenomena.
- 28 October 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (16) , 165312
Study of interface correlation in W/C multilayer structure by specular and non-specular grazing incidence X-ray reflectivity measurements
W/C/W tri-layer thin film samples have been deposited on c-Si substrates in a home-built Ion Beam Sputtering system at 1.5 × 10−3 Torr Ar working pressure and 10 mA grid current. The tri-layer samples have been deposited at different Ar+ ion energies between 0.6 and 1.2 keV for W layer deposition and the samples have been characterized by specular and non-specular grazing incidence X-ray reflectivity (GIXR) measurements. By analyzing the GIXR spectra, various interface parameters have been obtained for both W-on-C and C-on-W interfaces and optimum Ar+ ion energy for obtaining interfaces with low imperfections has been found. Subsequently, multilayer W/C samples with 5-layer, 7-layer, 9-layer, and 13-layer have been deposited at this optimum Ar+ ion energy. By fitting the specular and diffused GIXR data of the multilayer samples with the parameters of each interface as fitting variables, different interface parameters, viz., interface width, in-plane correlation length, interface roughness, and interface diffusion have been estimated for each interface and their variation across the depth of the multilayers have been obtained. The information would be useful in realizing W/C multilayers for soft X-ray mirror application in the <100 Å wavelength regime. The applicability of the “restart of the growth at the interface” model in the case of these ion beam sputter deposited W/C multilayers has also been investigated in the course of this study.
- 28 October 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (16) , 165312
Study of interface correlation in W/C multilayer structure by specular and non-specular grazing incidence X-ray reflectivity measurements
W/C/W tri-layer thin film samples have been deposited on c-Si substrates in a home-built Ion Beam Sputtering system at 1.5 × 10−3 Torr Ar working pressure and 10 mA grid current. The tri-layer samples have been deposited at different Ar+ ion energies between 0.6 and 1.2 keV for W layer deposition and the samples have been characterized by specular and non-specular grazing incidence X-ray reflectivity (GIXR) measurements. By analyzing the GIXR spectra, various interface parameters have been obtained for both W-on-C and C-on-W interfaces and optimum Ar+ ion energy for obtaining interfaces with low imperfections has been found. Subsequently, multilayer W/C samples with 5-layer, 7-layer, 9-layer, and 13-layer have been deposited at this optimum Ar+ ion energy. By fitting the specular and diffused GIXR data of the multilayer samples with the parameters of each interface as fitting variables, different interface parameters, viz., interface width, in-plane correlation length, interface roughness, and interface diffusion have been estimated for each interface and their variation across the depth of the multilayers have been obtained. The information would be useful in realizing W/C multilayers for soft X-ray mirror application in the <100 Å wavelength regime. The applicability of the “restart of the growth at the interface” model in the case of these ion beam sputter deposited W/C multilayers has also been investigated in the course of this study.