Lin Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Lin Chen has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Emma Kendrick
School of Metallurgy and Materials, University of Birmingham, Edgbaston, Birmingham B15 2TT, UK
6 shared publications - Brij Kishore
School of Metallurgy and Materials, University of Birmingham, Edgbaston B15 2TT, UK
4 shared publications - Claire E. J. Dancer
University of Birmingham
2 shared publications - Marc Walker
University of Warwick
2 shared publications - Peter Raymond Slater
School of Chemistry, University of Birmingham, Edgbaston, Birmingham B15 2TT, UK
2 shared publications - Tengfei Song
School of Metallurgy and Materials, University of Birmingham, Edgbaston, Birmingham B15 2SE, UK
2 shared publications
Latest Publications
- Open Access
- 25 February 2025
- Published by Wiley in Advanced Energy Materials
- Vol. 15 (46)
Sustainable Recovery and Reuse of Hard Carbon From Scrap and End‐of‐Life Sodium‐Ion Batteries
As Sodium‐ion battery (SIB) technology progresses toward commercial viability, sustainable end‐of‐life (EOL) management is critical. Methods for recycling key components such as hard carbon (HC), a negative electrode material, remain underexplored. This study introduces a direct and efficient recycling approach for HC from production scrap and EOL cells using “ice‐stripping” followed by a low‐temperature binder negation at 300 °C under nitrogen. The effects of temperature on HC structural integrity and electrochemical performance are comprehensively characterized using XRD, Wide‐Angle X‐ray Scattering (WAXS), and XPS. Heating above 400 °C induces irreversible damage to HC's graphene layers and modifies the carbon surfaces, resulting in poor electrochemical performance. However, HC reclaimed at 300 °C retains near‐pristine electrochemical performance, with capacities of 243 mAh g⁻¹ (scrap) and 228 mAh g⁻¹ (EOL) after 50 cycles. Full‐cell configurations demonstrates robust cycling stability, with 86% and 89% capacity retention after 200 cycles for HC derived from scrap and EOL cells, respectively. This work highlights the potential of lower‐temperature, direct recycling to enable a circular economy for SIBs. The findings set a benchmark for developing sustainable recycling methods for HC and other SIB components.
- 25 February 2025
- Published by Wiley in Advanced Energy Materials
- Vol. 15 (46)
Open AccessSustainable Recovery and Reuse of Hard Carbon From Scrap and End‐of‐Life Sodium‐Ion Batteries
As Sodium‐ion battery (SIB) technology progresses toward commercial viability, sustainable end‐of‐life (EOL) management is critical. Methods for recycling key components such as hard carbon (HC), a negative electrode material, remain underexplored. This study introduces a direct and efficient recycling approach for HC from production scrap and EOL cells using “ice‐stripping” followed by a low‐temperature binder negation at 300 °C under nitrogen. The effects of temperature on HC structural integrity and electrochemical performance are comprehensively characterized using XRD, Wide‐Angle X‐ray Scattering (WAXS), and XPS. Heating above 400 °C induces irreversible damage to HC's graphene layers and modifies the carbon surfaces, resulting in poor electrochemical performance. However, HC reclaimed at 300 °C retains near‐pristine electrochemical performance, with capacities of 243 mAh g⁻¹ (scrap) and 228 mAh g⁻¹ (EOL) after 50 cycles. Full‐cell configurations demonstrates robust cycling stability, with 86% and 89% capacity retention after 200 cycles for HC derived from scrap and EOL cells, respectively. This work highlights the potential of lower‐temperature, direct recycling to enable a circular economy for SIBs. The findings set a benchmark for developing sustainable recycling methods for HC and other SIB components.
- Open Access
Effects of Storage Voltage upon Sodium-Ion Batteries
Sodium-ion batteries (SIBs) are gaining attention as a safer, more cost-effective alternative to lithium-ion batteries (LIBs) due to their use of abundant and non-critical materials. A notable feature of SIBs is their ability to utilize aluminum current collectors, which are resistant to oxidation, allowing for safer storage at 0 V. However, the long-term impacts of such storage on their electrochemical performance remain poorly understood. This study systematically investigates how storage conditions at various states of charge (SOCs) affect open circuit voltage (OCV) decay, internal resistance, and post-storage cycling stability in two different Na-ion chemistries: Prussian white//hard carbon and layered oxide//hard carbon. Electrochemical Impedance Spectroscopy before and after storage shows a pronounced increase in internal resistance and a corresponding decline in cycling performance when SIBs are stored in a fully discharged state (0 V), particularly for layered oxide-based cells, illustrating the sensitivity of different SIB chemistries to storage conditions. Additionally, a novel reformation protocol is proposed that reactivates cell capacity by rebuilding the solid electrolyte interphase (SEI) layer, offering a recovery path after prolonged storage. These insights into the long-term storage effects on SIBs provide new guidelines for optimizing storage and transport conditions to minimize performance degradation, making them more viable for commercial applications.
Open AccessEffects of Storage Voltage upon Sodium-Ion Batteries
Sodium-ion batteries (SIBs) are gaining attention as a safer, more cost-effective alternative to lithium-ion batteries (LIBs) due to their use of abundant and non-critical materials. A notable feature of SIBs is their ability to utilize aluminum current collectors, which are resistant to oxidation, allowing for safer storage at 0 V. However, the long-term impacts of such storage on their electrochemical performance remain poorly understood. This study systematically investigates how storage conditions at various states of charge (SOCs) affect open circuit voltage (OCV) decay, internal resistance, and post-storage cycling stability in two different Na-ion chemistries: Prussian white//hard carbon and layered oxide//hard carbon. Electrochemical Impedance Spectroscopy before and after storage shows a pronounced increase in internal resistance and a corresponding decline in cycling performance when SIBs are stored in a fully discharged state (0 V), particularly for layered oxide-based cells, illustrating the sensitivity of different SIB chemistries to storage conditions. Additionally, a novel reformation protocol is proposed that reactivates cell capacity by rebuilding the solid electrolyte interphase (SEI) layer, offering a recovery path after prolonged storage. These insights into the long-term storage effects on SIBs provide new guidelines for optimizing storage and transport conditions to minimize performance degradation, making them more viable for commercial applications.
- Open Access
- 12 July 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Improved Lifetime of Na-Ion Batteries With a Water-Scavenging Electrolyte Additive
The lifetime of sodium-ion batteries is strongly affected by degradation species and contaminants such as H2O and HF, which are produced during formation and cycling. In this work, the use of low levels of N, N-diethyltrimethylsilylamine (DETMSA), as an electrolyte additive, shows an improvement in the stability and cycle life of a hard carbon vs. layered oxide sodium-ion battery. Approximately 80% of the capacity is retained after 500 cycles, which is almost double the performance of the standard electrolyte. The additive works by reducing the surface ageing constituents, as observed through XPS of the surfaces and the change in resistance after cycling. DETMSA is slowly consumed over time; however, the extensive improvement in cycle life shows that low level of impurities and degradation species have a big impact upon cycle life.
- 12 July 2022
- Published by Frontiers Media SA in Frontiers in Energy Research
- Vol. 10
Open AccessImproved Lifetime of Na-Ion Batteries With a Water-Scavenging Electrolyte Additive
The lifetime of sodium-ion batteries is strongly affected by degradation species and contaminants such as H2O and HF, which are produced during formation and cycling. In this work, the use of low levels of N, N-diethyltrimethylsilylamine (DETMSA), as an electrolyte additive, shows an improvement in the stability and cycle life of a hard carbon vs. layered oxide sodium-ion battery. Approximately 80% of the capacity is retained after 500 cycles, which is almost double the performance of the standard electrolyte. The additive works by reducing the surface ageing constituents, as observed through XPS of the surfaces and the change in resistance after cycling. DETMSA is slowly consumed over time; however, the extensive improvement in cycle life shows that low level of impurities and degradation species have a big impact upon cycle life.
- Open Access
- 18 September 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (85) , 12925-12928
Electrochemical formation protocols for maximising the life-time of a sodium ion battery
Optimised electrochemical formation protocols with targeted voltage windows increased the stability and resistance of the SEI, resulting in improved capacity retention while significantly reducing formation time for long-life Na-ion batteries.
- 18 September 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (85) , 12925-12928
Open AccessElectrochemical formation protocols for maximising the life-time of a sodium ion battery
Optimised electrochemical formation protocols with targeted voltage windows increased the stability and resistance of the SEI, resulting in improved capacity retention while significantly reducing formation time for long-life Na-ion batteries.
- Open Access
- 17 August 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (78) , 11609-11612
Nanozeolite ZSM-5 electrolyte additive for long life sodium-ion batteries
Hard-carbon electrolyte interface stabilisation with a nano-zeolite ZSM-5 electrolyte additive. Unwanted degradation products are trapped within the zeolite cage preventing compositional changes at the interface, maximising the life-time of a sodium-ion battery.
- 17 August 2020
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 56 (78) , 11609-11612
Open AccessNanozeolite ZSM-5 electrolyte additive for long life sodium-ion batteries
Hard-carbon electrolyte interface stabilisation with a nano-zeolite ZSM-5 electrolyte additive. Unwanted degradation products are trapped within the zeolite cage preventing compositional changes at the interface, maximising the life-time of a sodium-ion battery.
- Open Access
- 29 April 2020
- Published by Springer Nature in Nature Communications
- Vol. 11 (1) , 1-10
Operando visualisation of battery chemistry in a sodium-ion battery by 23Na magnetic resonance imaging
Sodium-ion batteries are a promising battery technology for their cost and sustainability. This has led to increasing interest in the development of new sodium-ion batteries and new analytical methods to non-invasively, directly visualise battery chemistry. Here we report operando 1H and 23Na nuclear magnetic resonance spectroscopy and imaging experiments to observe the speciation and distribution of sodium in the electrode and electrolyte during sodiation and desodiation of hard carbon in a sodium metal cell and a sodium-ion full-cell configuration. The evolution of the hard carbon sodiation and subsequent formation and evolution of sodium dendrites, upon over-sodiation of the hard carbon, are observed and mapped by 23Na nuclear magnetic resonance spectroscopy and imaging, and their three-dimensional microstructure visualised by 1H magnetic resonance imaging. We also observe, for the first time, the formation of metallic sodium species on hard carbon upon first charge (formation) in a full-cell configuration.
- 29 April 2020
- Published by Springer Nature in Nature Communications
- Vol. 11 (1) , 1-10
Open AccessOperando visualisation of battery chemistry in a sodium-ion battery by 23Na magnetic resonance imaging
Sodium-ion batteries are a promising battery technology for their cost and sustainability. This has led to increasing interest in the development of new sodium-ion batteries and new analytical methods to non-invasively, directly visualise battery chemistry. Here we report operando 1H and 23Na nuclear magnetic resonance spectroscopy and imaging experiments to observe the speciation and distribution of sodium in the electrode and electrolyte during sodiation and desodiation of hard carbon in a sodium metal cell and a sodium-ion full-cell configuration. The evolution of the hard carbon sodiation and subsequent formation and evolution of sodium dendrites, upon over-sodiation of the hard carbon, are observed and mapped by 23Na nuclear magnetic resonance spectroscopy and imaging, and their three-dimensional microstructure visualised by 1H magnetic resonance imaging. We also observe, for the first time, the formation of metallic sodium species on hard carbon upon first charge (formation) in a full-cell configuration.
- 29 April 2016
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 46 (9) , 907-915
Nanosized 0.3Li2MnO3·0.7LiNi1/3Mn1/3Co1/3O2 synthesized by CNTs-assisted hydrothermal method as cathode material for lithium ion battery
- 29 April 2016
- Published by Springer Nature in Journal of Applied Electrochemistry
- Vol. 46 (9) , 907-915
Nanosized 0.3Li2MnO3·0.7LiNi1/3Mn1/3Co1/3O2 synthesized by CNTs-assisted hydrothermal method as cathode material for lithium ion battery