T. Murugan
T. Murugan has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
B Senthil Kumar
Gandhigram Rural Institute–Deemed University
1 shared publicationB. Senthil Kumar
Gandhigram Rural Institute–Deemed University
1 shared publication
Latest Publications
- 5 May 2022
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 45 (9-10) , 2230-2242
Experimental investigation of mechanical and dynamic mechanical properties of sansevieria roxburghiana /epoxy composite using Taguchi design
The focus of this research was to study how process parameters including fibre alignment, fibre length, fibre volume percentage and alkali pretreatment affected the mechanical and dynamic mechanical characteristics (DMA) of the sansevieria fibre composite. The nonwoven fabric was produced through the needle punching technique. 18 composite samples have been produced according to L18 Taguchi design. Four different process parameters were considered for investigation, such as fibre length, fibre volume fraction, the concentration of alkali and fibre alignment. Using Design S/ N ratio analysis, the optimized process parameters for achieving maximum tensile, flexural and compression properties of the composite were measured. In the case of DMA analysis, three different parameters have been calculated only for selected samples such as storage modulus, loss modulus and loss factor. Variance analyses were carried out to measure the statistical influence of the process parameters on response. After this, validation of experiments was also done. SEM study was also carried out to understand the damage pattern of the composite sample.
- 5 May 2022
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 45 (9-10) , 2230-2242
Experimental investigation of mechanical and dynamic mechanical properties of sansevieria roxburghiana /epoxy composite using Taguchi design
The focus of this research was to study how process parameters including fibre alignment, fibre length, fibre volume percentage and alkali pretreatment affected the mechanical and dynamic mechanical characteristics (DMA) of the sansevieria fibre composite. The nonwoven fabric was produced through the needle punching technique. 18 composite samples have been produced according to L18 Taguchi design. Four different process parameters were considered for investigation, such as fibre length, fibre volume fraction, the concentration of alkali and fibre alignment. Using Design S/ N ratio analysis, the optimized process parameters for achieving maximum tensile, flexural and compression properties of the composite were measured. In the case of DMA analysis, three different parameters have been calculated only for selected samples such as storage modulus, loss modulus and loss factor. Variance analyses were carried out to measure the statistical influence of the process parameters on response. After this, validation of experiments was also done. SEM study was also carried out to understand the damage pattern of the composite sample.
- 5 February 2021
- Published by Springer Nature
- p. 219-231
Studies on Influence of Reinforcement Characteristics on Mechanical Properties of Banana Fiber Nonwoven Composite Structures
- 5 February 2021
- Published by Springer Nature
- p. 219-231
Studies on Influence of Reinforcement Characteristics on Mechanical Properties of Banana Fiber Nonwoven Composite Structures