VGViktor Gorbov

Viktor Gorbov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Viktor Gorbov has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Investigations of the Emission Characteristics of a Dual-Fuel Gas Turbine Combustion Chamber Operating Simultaneously on Liquid and Gaseous Fuels

    by Serhiy Serbin, Badri Diasamidze, Viktor Gorbov, Jerzy Kowalski

    This study is dedicated to investigations of the working process in a dual-fuel low-emission combustion chamber for a floating vessel’s gas turbine. As the object of the research, a low-emission gas turbine combustion chamber with partial premixing of fuel and air inside the outer and inner radial-axial swirls was chosen. The method of the research is based on the numerical solution of the system of differential equations which represent the physical process of mass and energy conservation and transformations and species transport for a multi-component chemically reactive turbulent system, considering nitrogen oxides formation and a discrete ordinates model of radiation. The chemistry kinetics is presented by the 6-step mechanism of combustion. Seven fuel supply operating modes, varying from 100% gaseous fuel to 100% liquid fuel, have been analysed. This analysis has revealed the possibility of the application of computational fluid dynamics for problems of dual-fuel combustion chambers for the design of a floating vessel’s gas turbine. Moreover, the study has shown the possibility of working in different transitional gaseous and liquid fuel supply modes, as they satisfy modern ecological requirements. The dependencies of the averaged temperature, NO, and CO concentrations along the length of the low-emission gas turbine combustion chamber for different cases of fuel supply are presented. Depending on the different operating modes, the calculated emission of nitrogen oxides NO and carbon monoxide CO at the outlet cross-section of a flame tube are different, but, they lie in the ranges of 31‒50 and 23‒24 mg/nm3 on the peak of 100% liquid fuel supply mode. At operating modes where a gaseous fuel supply prevails, nitrogen oxide NO and carbon monoxide CO emissions lie in the ranges of 1.2‒4.0 and 0.04‒18 mg/nm3 respectively.


  • Gas Turbine Tubular Coilpipes Regenerators Optimized According to the Minimum Mass Criterion

    by Viktor Gorbov, Sergey Movchan, Denis Solomonyuk, Ukraine State Enterprise "gas Turbine Scientific Production Complex "zorya"-"mashproekt"

    The aim of this work is to determine the effect of the elements, which do not participate in heat transfer, on the mass of the regenerator of a gas turbine plant X, as well as to define the restrictions that are imposed on the regenerator design based on the conditions of manufacturability, placement at the facility and transportability. This goal is achieved using an algorithm for finding rational geometric parameters of the heat exchange matrix with minimization of the regenerator mass by Newton's method. It has been determined that the mass of the heat exchange matrix can be 0.48-0.58 of the mass of the regenerator. This makes it necessary, even at the initial design stages, to take into account the effect of the above factors on the mass of the regenerator and the choice of the rational geometrical parameters. A significant result of the studies performed is determination of the effect of dimensional restrictions and requirements for the shape of the regenerator to be increased in its mass. The values of the geometrical parameters of the heat exchange matrix were obtained, at which the mass of the regenerator takes on a minimum value. The significance of the work is that the obtained relationships between the mass of the regenerator and its geometry makes it possible to reduce the metal consumption of the regenerator and the gas turbine plant, which allows designing the heat exchangers for power plants.

  • Open Access

    Decreasing the mass indices of gas turbine engines regenerators by means of choosing rational parameters

    by Viktor Gorbov, Denis Solomonuk

    The purpose of the conducted research was to develop a method for determining parameters of GTE regenerator, which would ensure at the initial stages of designing a minimum mass of the heat exchanger with the assigned values of efficiency. We obtained dependences that establish relationships between the regenerator and the GTE, which allow analyzing the influence of effectiveness and pressure losses in regenerator on the efficiency of GTE and the mass of the regenerator. Relationship between parameters of the regenerator and performance efficiency of regenerative GTE was described by functional dependence, where energy parameters of the regenerator are collected in a single complex. It was established that the magnitude of effectiveness of the regenerator is associated with efficiency by inversely proportional function, and pressure losses – by linear function. Effectiveness of the regenerator is associated with the mass of the heat exchanger and the geometry of heat exchange surface by exponential dependence, and relative pressure losses – by algebraic irrational function. Based on these dependences, the algorithm for selecting rational energy and geometrical parameters of regenerators of GTE was developed. It was found that by selecting rational values of effectiveness of regenerator and pressure losses, it is possible to provide for a significant decrease in mass of the regenerator with a constant value of performance efficiency of GTE. The obtained results of calculations of regenerators of GTE with different structural solutions allow a designer engineer to choose rational values of effectiveness of the regenerator, pressure losses, and initial gas temperature. Comparison of complex regenerative GTE by the mass of regenerator at constant values of performance efficiency was conducted. Based on the analysis of results of calculations, the stage dependence of specific mass of regenerator on the assigned increase in performance efficiency of regenerative GTE was obtained, which gives the possibility to estimate the mass of tubular regenerator at the initial stages of designing.Implementation of the obtained results into the practice of designing regenerative GTE will make it possible to ensure the choice of their rational parameters and to decrease the time of designing.