Kai Bin Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Kai Bin Yu has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- A. Ozgur Yazaydin
Department of Chemical Engineering, University College London, London, WC1E 7JE, United Kingdom
2 shared publications - Andrey G. Kalinichev
Laboratoire SUBATECH (UMR 6457—IMT Atlantique, Nantes Université, CNRS/IN2P3), 44300 Nantes, France
1 shared publication Fu Guo
Beijing University of Techonlogy,Faculty of Materials and Manufacturing,Beijing,China
1 shared publication- Geoffrey M. Bowers
Department of Chemistry and Biochemistry, St. Mary’s College of Maryland, St. Mary’s City, Maryland 20686, United States
1 shared publication - Mai Thanh Nguyen
Division of Materials Science and Engineering, Faculty of Engineering, Hokkaido University, Hokkaido 060-8628, Japan
1 shared publication - Narasimhan Loganathan
Michigan State University
1 shared publication
Latest Publications
- 10 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 8, 1-3
Enhanced bonding of Ag NPs paste on electroplating nanostructured Cu substrate in the air at low temperature
The applicability of wide bandage semiconductors at high temperatures promotes the development of high-temperature die-attach materials, such as silver nanoparticles (Ag NPs) paste. To enhance the bonding between Ag NPs and Cu substrate through an interdiffusion process, the Cu substrate was modified by electroplating a novel upright shell-like nanostructure. The optimized Cu substrate was then sintered with Ag NPs paste, in which the diffusion distance could achieve about 1.5 μm at 300 °C for 20 min. This sufficient interfacial diffusion is attributed to the numerous reactive positions and compatible sintering driving force between Ag NPs and modified Cu substrate caused by the upright shell-like Cu nanostructure.
- 10 August 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 8, 1-3
Enhanced bonding of Ag NPs paste on electroplating nanostructured Cu substrate in the air at low temperature
The applicability of wide bandage semiconductors at high temperatures promotes the development of high-temperature die-attach materials, such as silver nanoparticles (Ag NPs) paste. To enhance the bonding between Ag NPs and Cu substrate through an interdiffusion process, the Cu substrate was modified by electroplating a novel upright shell-like nanostructure. The optimized Cu substrate was then sintered with Ag NPs paste, in which the diffusion distance could achieve about 1.5 μm at 300 °C for 20 min. This sufficient interfacial diffusion is attributed to the numerous reactive positions and compatible sintering driving force between Ag NPs and modified Cu substrate caused by the upright shell-like Cu nanostructure.
- 1 October 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (20) , 16515-16526
Diffusion Behavior of Methane in 3D Kerogen Models
- 1 October 2021
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 35 (20) , 16515-16526
Diffusion Behavior of Methane in 3D Kerogen Models
- Open Access
- 4 May 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 124 (20) , 11015-11022
Does Confinement Enable Methane Hydrate Growth at Low Pressures? Insights from Molecular Dynamics Simulations
Natural methane hydrates are estimated to be the largest source of unexploited hydrocarbon-fuel. The ideal conditions for methane hydrate formation are low temperatures and high pressures. On the other hand; recent experimental studies suggest that porous materials, thanks to the confinement effects, can enable methane hydrate formation at milder condi-tions, although there has not been a consensus on this. A number of studies have investigated methane hydrate growth in confinement by employing molecular simulations; however; these were carried out at either very high pressures or very low temperatures. Therefore; the effects of confinement on methane hydrate growth at milder conditions have not been elaborated by molecular simulations yet. In order to address this, we carried out a systematic study by performing molec-ular dynamics (MD) simulations of methane water systems. Using a direct phase coexistence approach, microsecond scale MD simulations in the isobaric-isothermal (NPT) ensemble were performed to study the behaviour of methane hydrates in bulk and in confined nanospace of hydroxylated silica pores at external pressures ranging from 1 to 100 bar and at a simulation temperature that corresponds to 2 °C experimental temperature. We validated the combination of the TIP4P/Ice water and TraPPE-UA methane models to correctly predict the behaviour of methane hydrate in accordance to their phase equilibria. We also demonstrated that the dispersion corrections applied to short-range interactions lead to artificially induced hydrate growth. We observed that in the confinement of a hydroxylated silica pore, a convex-shaped methane nanobuble forms and methane hydrate growth primarily takes place in the center of the pore rather than the surfaces where a thin water layer exists. Most importantly, our study showed that in nanopores, methane hydrate growth can indeed take place at pressures which would be too low for the growth of methane hydrates in the bulk.
- 4 May 2020
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 124 (20) , 11015-11022
Open AccessDoes Confinement Enable Methane Hydrate Growth at Low Pressures? Insights from Molecular Dynamics Simulations
Natural methane hydrates are estimated to be the largest source of unexploited hydrocarbon-fuel. The ideal conditions for methane hydrate formation are low temperatures and high pressures. On the other hand; recent experimental studies suggest that porous materials, thanks to the confinement effects, can enable methane hydrate formation at milder condi-tions, although there has not been a consensus on this. A number of studies have investigated methane hydrate growth in confinement by employing molecular simulations; however; these were carried out at either very high pressures or very low temperatures. Therefore; the effects of confinement on methane hydrate growth at milder conditions have not been elaborated by molecular simulations yet. In order to address this, we carried out a systematic study by performing molec-ular dynamics (MD) simulations of methane water systems. Using a direct phase coexistence approach, microsecond scale MD simulations in the isobaric-isothermal (NPT) ensemble were performed to study the behaviour of methane hydrates in bulk and in confined nanospace of hydroxylated silica pores at external pressures ranging from 1 to 100 bar and at a simulation temperature that corresponds to 2 °C experimental temperature. We validated the combination of the TIP4P/Ice water and TraPPE-UA methane models to correctly predict the behaviour of methane hydrate in accordance to their phase equilibria. We also demonstrated that the dispersion corrections applied to short-range interactions lead to artificially induced hydrate growth. We observed that in the confinement of a hydroxylated silica pore, a convex-shaped methane nanobuble forms and methane hydrate growth primarily takes place in the center of the pore rather than the surfaces where a thin water layer exists. Most importantly, our study showed that in nanopores, methane hydrate growth can indeed take place at pressures which would be too low for the growth of methane hydrates in the bulk.
- Open Access
- 13 April 2020
- Published by American Chemical Society (ACS)
Scalable and green synthesis of metal and metal alloy nanoparticles in a solid matrix
- 13 April 2020
- Published by American Chemical Society (ACS)
Open AccessScalable and green synthesis of metal and metal alloy nanoparticles in a solid matrix