Steven M. Kuznicki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Steven M. Kuznicki has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
James A. Sawada
Department of Chemical and Materials Engineering, University of Alberta, Edmonton, Alberta, Canada T6G 2V4
7 shared publicationsAfrooz Farjoo
Department of Chemical and Materials Engineering, 12-372 Donadeo Innovation Center for Engineering, University of Alberta, Edmonton, AB T6G 1H9, Canada
4 shared publicationsFarnaz Mani
Department of Chemical and Materials Engineering, University of Alberta, Edmonton, Alberta, T6G 2V4, Canada
2 shared publicationsFarzad Yazdanbakhsh
Department of Chemical and Materials Engineering, University of Alberta, Edmonton, Alberta, Canada T6G 2V4
2 shared publications- Maria Ophelia Jarligo
Institut für Energie- und Klimaforschung (IEK-1), Forschungszentrum Jülich GmbH, Jülich, Germany
2 shared publications Sabereh Rezaei
2 shared publications
Latest Publications
- Open Access
Hydrogen Separation by Natural Zeolite Composite Membranes: Single and Multicomponent Gas Transport
Single and multicomponent gas permeation tests were used to evaluate the performance of metal-supported clinoptilolite membranes. The efficiency of hydrogen separation from lower hydrocarbons (methane, ethane, and ethylene) was studied within the temperature and pressure ranges of 25–600 °C and 110–160 kPa, respectively. The hydrogen separation factor was found to reduce noticeably in the gas mixture compared with single gas experiments at 25 °C. The difference between the single and multicomponent gas results decreased as the temperature increased to higher than 300 °C, which is when the competitive adsorption–diffusion mechanism was replaced by Knudsen diffusion or activated diffusion mechanisms. To evaluate the effect of gas adsorption, the zeolite surface isotherms of each gas in the mixture were obtained from 25 °C to 600 °C. The results indicated negligible adsorption of individual gases at temperatures higher than 300 °C. Increasing the feed pressure resulted in a higher separation efficiency for the individual gases compared with the multicomponent mixture, due to the governing effect of the adsorptive mechanism. This study provides valuable insight into the application of natural zeolites for the separation of hydrogen from a mixture of hydrocarbons.
Open AccessHydrogen Separation by Natural Zeolite Composite Membranes: Single and Multicomponent Gas Transport
Single and multicomponent gas permeation tests were used to evaluate the performance of metal-supported clinoptilolite membranes. The efficiency of hydrogen separation from lower hydrocarbons (methane, ethane, and ethylene) was studied within the temperature and pressure ranges of 25–600 °C and 110–160 kPa, respectively. The hydrogen separation factor was found to reduce noticeably in the gas mixture compared with single gas experiments at 25 °C. The difference between the single and multicomponent gas results decreased as the temperature increased to higher than 300 °C, which is when the competitive adsorption–diffusion mechanism was replaced by Knudsen diffusion or activated diffusion mechanisms. To evaluate the effect of gas adsorption, the zeolite surface isotherms of each gas in the mixture were obtained from 25 °C to 600 °C. The results indicated negligible adsorption of individual gases at temperatures higher than 300 °C. Increasing the feed pressure resulted in a higher separation efficiency for the individual gases compared with the multicomponent mixture, due to the governing effect of the adsorptive mechanism. This study provides valuable insight into the application of natural zeolites for the separation of hydrogen from a mixture of hydrocarbons.
- 28 October 2016
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 95 (3) , 500-507
H2 separation using pressed clinoptilolite and mixed copper‐clinoptilolite disc membranes
- 28 October 2016
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 95 (3) , 500-507
H2 separation using pressed clinoptilolite and mixed copper‐clinoptilolite disc membranes
- 5 October 2016
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 94 (11) , 2219-2224
H2 separation using tubular stainless steel supported natural clinoptilolite membranes
Disk membranes generated from high‐purity natural clinoptilolite mineral rock have shown promising hydrogen separation performance. To scale up production of these types of membranes for industrial gas separation, a coating strategy was devised. A mixture of natural clinoptilolite and aluminum silicate was deposited on the inner surface of porous stainless steel tubes by the slip casting technique. Phase composition and morphology of the coating materials were investigated using X‐ray diffraction. The performance was evaluated for a range of gases using single gas permeation tests at different temperatures and pressures. Introduction of the second layer significantly improved the performance of the membrane system. The experiments on the double‐layered membranes measured a hydrogen permeance of 1.65 × 10−7 mol · m−2 · s−1 · Pa−1 at 300 °C. H2/CO2 and H2/C2H6 single gas selectivity was 10.2 and 8.45 respectively at 25 °C and feed pressure of 110 kPa. These results show that natural zeolite coated stainless steel tubular membranes have high potential for large‐scale gas separation at high temperature requirements.
- 5 October 2016
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 94 (11) , 2219-2224
H2 separation using tubular stainless steel supported natural clinoptilolite membranes
Disk membranes generated from high‐purity natural clinoptilolite mineral rock have shown promising hydrogen separation performance. To scale up production of these types of membranes for industrial gas separation, a coating strategy was devised. A mixture of natural clinoptilolite and aluminum silicate was deposited on the inner surface of porous stainless steel tubes by the slip casting technique. Phase composition and morphology of the coating materials were investigated using X‐ray diffraction. The performance was evaluated for a range of gases using single gas permeation tests at different temperatures and pressures. Introduction of the second layer significantly improved the performance of the membrane system. The experiments on the double‐layered membranes measured a hydrogen permeance of 1.65 × 10−7 mol · m−2 · s−1 · Pa−1 at 300 °C. H2/CO2 and H2/C2H6 single gas selectivity was 10.2 and 8.45 respectively at 25 °C and feed pressure of 110 kPa. These results show that natural zeolite coated stainless steel tubular membranes have high potential for large‐scale gas separation at high temperature requirements.
- 1 April 2016
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 224, 208-216
Spontaneous formation of silver nanoparticles on the vanadium silicate EVS-10
- 1 April 2016
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 224, 208-216
Spontaneous formation of silver nanoparticles on the vanadium silicate EVS-10
- 10 December 2015
- Published by IWA Publishing in Water Science & Technology
- Vol. 73 (6) , 1409-1417
A clinoptilolite-PDMS mixed-matrix membrane for high temperature water softening
A mixed-matrix membrane composed of polydimethylsiloxane as the continuous phase and clinoptilolite, a naturally occurring zeolite, as the active phase has been used to decrease the conductivity of water by more than 80% across the membrane. Testing was carried out using a cross-flow configuration at temperatures as high as 160 °C using a constant trans-membrane pressure of 8 bar. The simple fabrication method for the membrane, the durability of the system under the test conditions, and a suitable flux rate make such membranes promising candidates for industrial wastewater treatment.
- 10 December 2015
- Published by IWA Publishing in Water Science & Technology
- Vol. 73 (6) , 1409-1417
A clinoptilolite-PDMS mixed-matrix membrane for high temperature water softening
A mixed-matrix membrane composed of polydimethylsiloxane as the continuous phase and clinoptilolite, a naturally occurring zeolite, as the active phase has been used to decrease the conductivity of water by more than 80% across the membrane. Testing was carried out using a cross-flow configuration at temperatures as high as 160 °C using a constant trans-membrane pressure of 8 bar. The simple fabrication method for the membrane, the durability of the system under the test conditions, and a suitable flux rate make such membranes promising candidates for industrial wastewater treatment.
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 138, 685-688
Manipulation of the pore size of clinoptilolite for separation of ethane from ethylene
- 1 December 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 138, 685-688
Manipulation of the pore size of clinoptilolite for separation of ethane from ethylene
- 1 September 2015
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 214, 32-40
A comparison of the adsorptive behaviour of ETS-10, 13X, and highly siliceous ZSM-5
- 1 September 2015
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 214, 32-40
A comparison of the adsorptive behaviour of ETS-10, 13X, and highly siliceous ZSM-5
- 25 August 2015
- Published by Wiley in AIChE Journal
- Vol. 61 (12) , 4367-4376
PtZn‐ETS‐2: A novel catalyst for ethane dehydrogenation
Catalysts having unprecedented selectivity toward ethane dehydrogentation were prepared by combining platinum and zinc on the surface of the titanate ETS‐2. This high surface area, sodium titanate ion exchanger affords high metal dispersion, presents many active sites to the gas stream, and is free of any pore structure that can influence mass transfer to and away from the active sites. It was determined that the addition of zinc to platinum‐loaded ETS‐2 changes the electronic properties of the metals and significantly improves the specificity of the catalyst. By changing the zinc‐to‐platinum ratio, and by manipulating the space velocity of the gas, the production of side products and coke can be suppressed or eliminated. © 2015 American Institute of Chemical Engineers AIChE J, 61: 4367–4376, 2015
- 25 August 2015
- Published by Wiley in AIChE Journal
- Vol. 61 (12) , 4367-4376
PtZn‐ETS‐2: A novel catalyst for ethane dehydrogenation
Catalysts having unprecedented selectivity toward ethane dehydrogentation were prepared by combining platinum and zinc on the surface of the titanate ETS‐2. This high surface area, sodium titanate ion exchanger affords high metal dispersion, presents many active sites to the gas stream, and is free of any pore structure that can influence mass transfer to and away from the active sites. It was determined that the addition of zinc to platinum‐loaded ETS‐2 changes the electronic properties of the metals and significantly improves the specificity of the catalyst. By changing the zinc‐to‐platinum ratio, and by manipulating the space velocity of the gas, the production of side products and coke can be suppressed or eliminated. © 2015 American Institute of Chemical Engineers AIChE J, 61: 4367–4376, 2015
- 1 February 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 123, 444-449
Breakthrough performances of metal-exchanged nanotitanate ETS-2 adsorbents for room temperature desulfurization
- 1 February 2015
- Published by Elsevier in Chemical Engineering Science
- Vol. 123, 444-449
Breakthrough performances of metal-exchanged nanotitanate ETS-2 adsorbents for room temperature desulfurization
- 13 September 2014
- Published by IWA Publishing in Water Science & Technology
- Vol. 70 (8) , 1412-1418
Natural clinoptilolite composite membranes on tubular stainless steel supports for water softening
Disk membranes generated from high-purity natural clinoptilolite mineral rock have shown promising water desalination and de-oiling performance. In order to scale up production of these types of membranes for industrial wastewater treatment applications, a coating strategy was devised. A composite mixture of natural clinoptilolite from St. Cloud (Winston, NM, USA) and aluminum phosphate was deposited on the inner surface of porous stainless steel tubes by the slip casting technique. The commercial porous stainless steel tubes were pre-coated with a TiO2 layer of about 10 μm. Phase composition and morphology of the coating materials were investigated using X-ray diffraction and scanning electron microscopy. Water softening performance of the fabricated membranes was evaluated using Edmonton (Alberta, Canada) municipal tap water as feed source. Preliminary experimental results show a high water flux of 7.7 kg/(m2 h) and 75% reduction of hardness and conductivity in a once-through membrane process at 95 °C and feed pressure of 780 kPa. These results show that natural zeolite coated, stainless steel tubular membranes have high potential for large-scale purification of oil sands steam-assisted gravity drainage water at high temperature and pressure requirements.
- 13 September 2014
- Published by IWA Publishing in Water Science & Technology
- Vol. 70 (8) , 1412-1418
Natural clinoptilolite composite membranes on tubular stainless steel supports for water softening
Disk membranes generated from high-purity natural clinoptilolite mineral rock have shown promising water desalination and de-oiling performance. In order to scale up production of these types of membranes for industrial wastewater treatment applications, a coating strategy was devised. A composite mixture of natural clinoptilolite from St. Cloud (Winston, NM, USA) and aluminum phosphate was deposited on the inner surface of porous stainless steel tubes by the slip casting technique. The commercial porous stainless steel tubes were pre-coated with a TiO2 layer of about 10 μm. Phase composition and morphology of the coating materials were investigated using X-ray diffraction and scanning electron microscopy. Water softening performance of the fabricated membranes was evaluated using Edmonton (Alberta, Canada) municipal tap water as feed source. Preliminary experimental results show a high water flux of 7.7 kg/(m2 h) and 75% reduction of hardness and conductivity in a once-through membrane process at 95 °C and feed pressure of 780 kPa. These results show that natural zeolite coated, stainless steel tubular membranes have high potential for large-scale purification of oil sands steam-assisted gravity drainage water at high temperature and pressure requirements.