Asma Qdemat
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Asma Qdemat has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Emmanuel Kentzinger
Jülich Centre for Neutron Science for Quantum Materials and Collective Phenomena (JCNS-2), Forschungszentrum Jülich GmbH 1 , 52425 Jülich
3 shared publications - Dominika Zákutná
Department of Inorganic Chemistry, Faculty of Science, Charles University, Hlavova 2030/8, 12843 Prague 2, Czech Republic
2 shared publications Dominique Dresen
Department für Chemie, Universität zu Köln, Greinstr. 4-6, 50939 Köln, Germany
2 shared publications- Erik Wetterskog
Department of Engineering Sciences , Uppsala University, The Ångström Laboratory , Box 534, SE-751 21 Uppsala , Sweden
2 shared publications - German Salazar-Alvarez
Department of Materials Science and Engineering, Ångström Laboratory, Uppsala University, Lägerhyddsvägen 1 75237, Uppsala, Sweden
2 shared publications - Sabrina Disch
Faculty of Chemistry University of Duisburg‐Essen Essen Germany
2 shared publications
Latest Publications
- Open Access
- 1 May 2026
- Published by AIP Publishing in APL Materials
- Vol. 14 (5)
Anisotropy-driven interfacial magnetism in Ru-deficient SrRuO3 thin films
While stoichiometric SrRuO3 (SRO) is a metallic itinerant ferromagnet with relatively homogeneous magnetization, Ru deficiency provides a powerful route to alter its electronic transport and depth-dependent magnetic properties. Ru-deficient SRO thin films grown by radio frequency high-oxygen pressure sputtering were investigated using a combination of x-ray reflectivity, polarized neutron reflectometry, off-specular neutron scattering, scanning transmission electron microscopy with energy-dispersive x-ray spectroscopy, electrical transport, and magnetometry. Structural and compositional analyses reveal that Ru deficiency is intrinsic to the films, with an enhanced deficiency at the interfaces. As a result, coherent electronic transport is suppressed and saturation magnetization is reduced, while the Curie temperature remains largely unaffected, placing Ru-deficient SRO in a regime consistent with ferromagnetic insulator-like behavior. Depth- and lateral-resolved magnetic measurements further indicate that the interfacial regions remain ferromagnetic, with a reduced in-plane magnetic projection consistent with enhanced perpendicular magnetic anisotropy that keeps the local magnetization predominantly out-of-plane. Our results establish Ru deficiency as a key control parameter governing transport, magnetization, and anisotropy in SRO thin films and highlight defect and interface engineering as powerful routes to tailor interfacial magnetism in correlated oxide heterostructures.
- 1 May 2026
- Published by AIP Publishing in APL Materials
- Vol. 14 (5)
Open AccessAnisotropy-driven interfacial magnetism in Ru-deficient SrRuO3 thin films
While stoichiometric SrRuO3 (SRO) is a metallic itinerant ferromagnet with relatively homogeneous magnetization, Ru deficiency provides a powerful route to alter its electronic transport and depth-dependent magnetic properties. Ru-deficient SRO thin films grown by radio frequency high-oxygen pressure sputtering were investigated using a combination of x-ray reflectivity, polarized neutron reflectometry, off-specular neutron scattering, scanning transmission electron microscopy with energy-dispersive x-ray spectroscopy, electrical transport, and magnetometry. Structural and compositional analyses reveal that Ru deficiency is intrinsic to the films, with an enhanced deficiency at the interfaces. As a result, coherent electronic transport is suppressed and saturation magnetization is reduced, while the Curie temperature remains largely unaffected, placing Ru-deficient SRO in a regime consistent with ferromagnetic insulator-like behavior. Depth- and lateral-resolved magnetic measurements further indicate that the interfacial regions remain ferromagnetic, with a reduced in-plane magnetic projection consistent with enhanced perpendicular magnetic anisotropy that keeps the local magnetization predominantly out-of-plane. Our results establish Ru deficiency as a key control parameter governing transport, magnetization, and anisotropy in SRO thin films and highlight defect and interface engineering as powerful routes to tailor interfacial magnetism in correlated oxide heterostructures.
- Open Access
- 14 September 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (38) , 24912-24923
Impact of coating type on structure and magnetic properties of biocompatible iron oxide nanoparticles: insights into cluster organization and oxidation stability
This research investigates the impact of various coatings on superparamagnetic iron oxide nanoparticles. The coatings stabilize the nanoparticles, influencing their magnetic behaviour, agglomeration, and oxidation stability.
- 14 September 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (38) , 24912-24923
Open AccessImpact of coating type on structure and magnetic properties of biocompatible iron oxide nanoparticles: insights into cluster organization and oxidation stability
This research investigates the impact of various coatings on superparamagnetic iron oxide nanoparticles. The coatings stabilize the nanoparticles, influencing their magnetic behaviour, agglomeration, and oxidation stability.
- 15 October 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (42) , 23356-23363
Neither Sphere nor Cube—Analyzing the Particle Shape Using Small-Angle Scattering and the Superball Model
- 15 October 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (42) , 23356-23363
Neither Sphere nor Cube—Analyzing the Particle Shape Using Small-Angle Scattering and the Superball Model
- Open Access
- 24 May 2021
- Published by American Chemical Society (ACS) in ChemRxiv
Neither Sphere nor Cube - Analyzing the Particle Shape Using Small-Angle Scattering and the Superball Model
Accurate characterization of the nanocrystal shape with high statistical relevance is essential for exploiting the strongly shape-dependent properties of cuboidal nanoparticles towards applications. This work presents the development of a new small-angle scattering form factor based on the superball geometry. The superball quantifies the characteristic rounding of corners and edges of cuboidalnanoparticles with a single parameter. Applied to small-angle scattering data of sufficiently monodisperse nanoparticles, the superball form factor enables differentiation between the effects of extendedparticle size distribution and irregular particle shape. The quantitative application of the superball form factor is validated against microscopy data for a series of monodisperse nanoparticles and implemented into the user-friendly, open source software Sasview.
- 24 May 2021
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessNeither Sphere nor Cube - Analyzing the Particle Shape Using Small-Angle Scattering and the Superball Model
Accurate characterization of the nanocrystal shape with high statistical relevance is essential for exploiting the strongly shape-dependent properties of cuboidal nanoparticles towards applications. This work presents the development of a new small-angle scattering form factor based on the superball geometry. The superball quantifies the characteristic rounding of corners and edges of cuboidalnanoparticles with a single parameter. Applied to small-angle scattering data of sufficiently monodisperse nanoparticles, the superball form factor enables differentiation between the effects of extendedparticle size distribution and irregular particle shape. The quantitative application of the superball form factor is validated against microscopy data for a series of monodisperse nanoparticles and implemented into the user-friendly, open source software Sasview.
- Open Access
- 13 May 2020
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 10 (31) , 18339-18347
Self assembled monolayer of silica nanoparticles with improved order by drop casting
This paper reports on the formation of large area, self assembled, highly ordered monolayers of stearyl alcohol grafted silica nanospheres of ≈50 nm diameter on a silicon substrate based on the drop-casting method. Our novel approach to achieve improved order uses stearyl alcohol as an assistant by adding it to the colloidal NanoParticle (NP) dispersion from which the monolayers are formed. Additionally, a heat treatment step is added, to melt the stearyl alcohol in the monolayer and thereby give the particles more time to further self-assemble, leading to additional improvement in the monolayer quality. The formation of the monolayers is significantly affected by the concentration of the NPs and the stearyl alcohol, the volume of the drop as well as the time of the heat treatment. A high surface coverage and uniform monolayer film of SiO2 NPs is achieved by appropriate control of the above-mentioned preparation parameters. Structural characterization of the obtained SiO2 NP monolayer was done locally by Scanning Electron Microscopy (SEM), and globally by X-ray reflectivity (XRR) and grazing incidence small-angle X-ray scattering (GISAXS), where the data was reproduced by simulation within the Distorted Wave Born Approximation (DWBA). In conclusion, our modified drop-casting method is a simple, inexpensive method, which provides highly ordered self-assembled monolayers of silica particles, if combined with a compatible additive and a heat treatment step. This method might be more general and also applicable to different particles after finding an appropriate additive.
- 13 May 2020
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 10 (31) , 18339-18347
Open AccessSelf assembled monolayer of silica nanoparticles with improved order by drop casting
This paper reports on the formation of large area, self assembled, highly ordered monolayers of stearyl alcohol grafted silica nanospheres of ≈50 nm diameter on a silicon substrate based on the drop-casting method. Our novel approach to achieve improved order uses stearyl alcohol as an assistant by adding it to the colloidal NanoParticle (NP) dispersion from which the monolayers are formed. Additionally, a heat treatment step is added, to melt the stearyl alcohol in the monolayer and thereby give the particles more time to further self-assemble, leading to additional improvement in the monolayer quality. The formation of the monolayers is significantly affected by the concentration of the NPs and the stearyl alcohol, the volume of the drop as well as the time of the heat treatment. A high surface coverage and uniform monolayer film of SiO2 NPs is achieved by appropriate control of the above-mentioned preparation parameters. Structural characterization of the obtained SiO2 NP monolayer was done locally by Scanning Electron Microscopy (SEM), and globally by X-ray reflectivity (XRR) and grazing incidence small-angle X-ray scattering (GISAXS), where the data was reproduced by simulation within the Distorted Wave Born Approximation (DWBA). In conclusion, our modified drop-casting method is a simple, inexpensive method, which provides highly ordered self-assembled monolayers of silica particles, if combined with a compatible additive and a heat treatment step. This method might be more general and also applicable to different particles after finding an appropriate additive.