Chengrui Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Chengrui Liu has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Dayi Wang
China Academy of Space Technology, Beijing Institute of Spacecraft System Engineering, Beijing, China
3 shared publications Dayi Wang
Beijing Institute of Control Engineering, Beijing 100190, China
1 shared publication- Donghua Zhou
Southeast University
1 shared publication Duan Wenjie
Beijing Institute of Control Engineering Beijing China
1 shared publication- Fangzhou Fu
School of Aeronautics and Astronautics, Sun Yat-sen University, Shenzhen, China
1 shared publication Hanyu Liang
Beijing Institute of Control Engineering,Science and Technology on Space Intelligent Control Laboratory,Beijing,China
1 shared publication
Latest Publications
- 2 October 2024
- Published by Elsevier in Automatica
- Vol. 171
Reconfigurability evaluation and design for control systems with actuator fault and saturation
- 2 October 2024
- Published by Elsevier in Automatica
- Vol. 171
Reconfigurability evaluation and design for control systems with actuator fault and saturation
- 17 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Fault Diagnosis with Spacecraft High-Dimensional Data Based on Machine Learning
In order to ensure the safe, reliable and stable operation of spacecraft, this paper studies the fault diagnosis of spacecraft high-dimensional data by applying the machine learning technology, aiming at the characteristics of spacecraft, such as closed-loop fault propagation, few fault samples and limitation of on-orbit computing capability. For the experimental data under the typical failure modes of spacecraft sensors and actuators, this paper will use some machine learning algorithms like K-Nearest Neighbor (KNN), Bayesian classifier, KNN based on Principal Component Analysis (PCA+KNN), to analyze fault diagnosis and to make a comparative analysis of the results. The results show as follows: it can reach better accuracy by using supervised learning algorithms in fault diagnosis classification; the dimensionality reduction can accelerate the calculation, but at the same time it will lose diagnostic accuracy, especially for highly-coupled and high-dimensional data; in the algorithm design, the task requirements and application conditions should be considered comprehensively, meanwhile the optimal fault diagnosis model can be selected by balancing the accuracy and computing time.
- 17 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Fault Diagnosis with Spacecraft High-Dimensional Data Based on Machine Learning
In order to ensure the safe, reliable and stable operation of spacecraft, this paper studies the fault diagnosis of spacecraft high-dimensional data by applying the machine learning technology, aiming at the characteristics of spacecraft, such as closed-loop fault propagation, few fault samples and limitation of on-orbit computing capability. For the experimental data under the typical failure modes of spacecraft sensors and actuators, this paper will use some machine learning algorithms like K-Nearest Neighbor (KNN), Bayesian classifier, KNN based on Principal Component Analysis (PCA+KNN), to analyze fault diagnosis and to make a comparative analysis of the results. The results show as follows: it can reach better accuracy by using supervised learning algorithms in fault diagnosis classification; the dimensionality reduction can accelerate the calculation, but at the same time it will lose diagnostic accuracy, especially for highly-coupled and high-dimensional data; in the algorithm design, the task requirements and application conditions should be considered comprehensively, meanwhile the optimal fault diagnosis model can be selected by balancing the accuracy and computing time.
- 25 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Informatics
- Vol. 15 (11) , 5867-5876
Probability Analysis of Fault Diagnosis Performance for Satellite Attitude Control Systems
In this paper, we focus our study on analysis of fault diagnosis performance for satellite attitude control systems subject to $l_{2}$ -norm bounded process disturbances and measurement noises, which concerns with fault detectability and fault isolability. For an observer-based fault detection (FD), a major concern is to answer if the choice of a threshold satisfies an acceptable trade-off between fault detection rate (FDR) and false alarm rate (FAR). The smaller a threshold is, the better is the FDR, but the poorer is the FAR. In addition to this, knowledge of fault isolability is useful for answering how difficult it is to isolate a fault from another one. The main contributions of this work are the probabilistic performance evaluation of the FD system in the context of FAR and a contribution analysis based method of fault isolation. Firstly, an extended $H_{i}/H_{\infty}$ optimization based FD scheme is applied to the satellite attitude control systems and a recursive algorithm is presented to the implementation of online FD. Secondly, regarding the uncertain statistical characteristics of the unknown inputs, randomized algorithms are developed to verify the achievable FAR for a prescribed given threshold. Especially, without knowing the $l_{2}$ -norm boundedness of the unknown inputs, a probabilistic estimation of worst case threshold is also obtained to guarantee an acceptable level of FAR. Thirdly, a contribution analysis based method of fault isolation is proposed for satellite attitude control systems. Finally, the effectiveness of the proposed algorithms is verified through a satellite attitude control system.- 25 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Informatics
- Vol. 15 (11) , 5867-5876
Probability Analysis of Fault Diagnosis Performance for Satellite Attitude Control Systems
In this paper, we focus our study on analysis of fault diagnosis performance for satellite attitude control systems subject to $l_{2}$ -norm bounded process disturbances and measurement noises, which concerns with fault detectability and fault isolability. For an observer-based fault detection (FD), a major concern is to answer if the choice of a threshold satisfies an acceptable trade-off between fault detection rate (FDR) and false alarm rate (FAR). The smaller a threshold is, the better is the FDR, but the poorer is the FAR. In addition to this, knowledge of fault isolability is useful for answering how difficult it is to isolate a fault from another one. The main contributions of this work are the probabilistic performance evaluation of the FD system in the context of FAR and a contribution analysis based method of fault isolation. Firstly, an extended $H_{i}/H_{\infty}$ optimization based FD scheme is applied to the satellite attitude control systems and a recursive algorithm is presented to the implementation of online FD. Secondly, regarding the uncertain statistical characteristics of the unknown inputs, randomized algorithms are developed to verify the achievable FAR for a prescribed given threshold. Especially, without knowing the $l_{2}$ -norm boundedness of the unknown inputs, a probabilistic estimation of worst case threshold is also obtained to guarantee an acceptable level of FAR. Thirdly, a contribution analysis based method of fault isolation is proposed for satellite attitude control systems. Finally, the effectiveness of the proposed algorithms is verified through a satellite attitude control system.- Open Access
- 1 December 2018
- Published by Springer Nature in Advances in Astronautics Science and Technology
- Vol. 1 (2) , 197-206
The Study on Reconfigurability Condition of Spacecraft Control System
- 1 December 2018
- Published by Springer Nature in Advances in Astronautics Science and Technology
- Vol. 1 (2) , 197-206
Open AccessThe Study on Reconfigurability Condition of Spacecraft Control System
- Open Access
- 16 August 2016
- Published by Wiley in Asian Journal of Control
- Vol. 19 (1) , 372-381
Integral Sliding Mode Fault‐Tolerant Control for Spacecraft With Uncertainties and Saturation
An integral sliding mode fault‐tolerant control method is proposed to deal with faults with matched uncertainties, unmatched uncertainties, and input saturation. Integral sliding mode, control allocation, and parameter identification are included in this method. The Lyapunov stability conditions of the integral sliding mode control for uncertainties and input saturation, respectively, are obtained, which denote the robustness extent of the controller. The direct method for control allocation is improved by adding a judgement before calculating for each facet. Finally, the fault‐tolerant scheme is applied to a six‐wheel spacecraft and simulations are given to show its effectiveness.
- 16 August 2016
- Published by Wiley in Asian Journal of Control
- Vol. 19 (1) , 372-381
Open AccessIntegral Sliding Mode Fault‐Tolerant Control for Spacecraft With Uncertainties and Saturation
An integral sliding mode fault‐tolerant control method is proposed to deal with faults with matched uncertainties, unmatched uncertainties, and input saturation. Integral sliding mode, control allocation, and parameter identification are included in this method. The Lyapunov stability conditions of the integral sliding mode control for uncertainties and input saturation, respectively, are obtained, which denote the robustness extent of the controller. The direct method for control allocation is improved by adding a judgement before calculating for each facet. Finally, the fault‐tolerant scheme is applied to a six‐wheel spacecraft and simulations are given to show its effectiveness.
- Open Access
- 2 March 2015
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2015, 1-6
Methods for Fault Diagnosability Analysis of a Class of Affine Nonlinear Systems
The fault diagnosability analysis for a given model, before developing a diagnosis algorithm, can be used to answer questions like “can the faultbe detected by observed states?” and “can it separate faultfrom faultby observed states?” If not, we should redesign the sensor placement. This paper deals with the problem of the evaluation of detectability and separability for the diagnosability analysis of affine nonlinear system. First, we used differential geometry theory to analyze the nonlinear system and proposed new detectability criterion and separability criterion. Second, the related matrix between the faults and outputs of the system and the fault separable matrix are designed for quantitative fault diagnosability calculation and fault separability calculation, respectively. Finally, we illustrate our approach to exemplify how to analyze diagnosability by a certain nonlinear system example, and the experiment results indicate the effectiveness of the fault evaluation methods.- 2 March 2015
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2015, 1-6
Open AccessMethods for Fault Diagnosability Analysis of a Class of Affine Nonlinear Systems
The fault diagnosability analysis for a given model, before developing a diagnosis algorithm, can be used to answer questions like “can the faultbe detected by observed states?” and “can it separate faultfrom faultby observed states?” If not, we should redesign the sensor placement. This paper deals with the problem of the evaluation of detectability and separability for the diagnosability analysis of affine nonlinear system. First, we used differential geometry theory to analyze the nonlinear system and proposed new detectability criterion and separability criterion. Second, the related matrix between the faults and outputs of the system and the fault separable matrix are designed for quantitative fault diagnosability calculation and fault separability calculation, respectively. Finally, we illustrate our approach to exemplify how to analyze diagnosability by a certain nonlinear system example, and the experiment results indicate the effectiveness of the fault evaluation methods. - Open Access
- 1 January 2014
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2014 (1)
Reconfigurability Analysis Method for Spacecraft Autonomous Control
As a critical requirement for spacecraft autonomous control, reconfigurability should be considered in design stage of spacecrafts by involving effective reconfigurability analysis method in guiding system designs. In this paper, a novel reconfigurability analysis method is proposed for spacecraft design. First, some basic definitions regarding spacecraft reconfigurability are given. Then, based on function tree theory, a reconfigurability modeling approach is established to properly describe system’s reconfigurability characteristics, and corresponding analysis procedure based on minimal cut set and minimal path set is further presented. In addition, indexes of fault reconfigurable degree and system reconfigurable rate for evaluating reconfigurability are defined, and the methodology for analyzing system’s week links is also constructed. Finally, the method is verified by a spacecraft attitude measuring system, and the results show that the presented method cannot only implement the quantitative reconfigurability evaluations but also find the weak links, and therefore provides significant improvements for spacecraft reconfigurability design.
- 1 January 2014
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2014 (1)
Open AccessReconfigurability Analysis Method for Spacecraft Autonomous Control
As a critical requirement for spacecraft autonomous control, reconfigurability should be considered in design stage of spacecrafts by involving effective reconfigurability analysis method in guiding system designs. In this paper, a novel reconfigurability analysis method is proposed for spacecraft design. First, some basic definitions regarding spacecraft reconfigurability are given. Then, based on function tree theory, a reconfigurability modeling approach is established to properly describe system’s reconfigurability characteristics, and corresponding analysis procedure based on minimal cut set and minimal path set is further presented. In addition, indexes of fault reconfigurable degree and system reconfigurable rate for evaluating reconfigurability are defined, and the methodology for analyzing system’s week links is also constructed. Finally, the method is verified by a spacecraft attitude measuring system, and the results show that the presented method cannot only implement the quantitative reconfigurability evaluations but also find the weak links, and therefore provides significant improvements for spacecraft reconfigurability design.