NYNathan Lee Young

Nathan Lee Young

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nathan Lee Young has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effects of model dimensionality (2D vs. 3D) on simulated groundwater flow conditions in post-glacial marine clay deposits in the context of slope stability analysis

    by Julián Ospina, Nathan L. Young, Jean-Michel Lemieux, Pascal Locat

    Traditional slope stability analyses rely on 2D cross-section models that assume rivers act as groundwater divides. However, these simplifications may misrepresent groundwater flow and affect calculated factors of safety. This study evaluates when such assumptions are appropriate by comparing 2D and 3D hydrogeological models for slopes of meandering rivers in postglacial marine clays. Results show that for models representing one side of a valley, 2D modeling is appropriate or conservative for straight slopes without an underlying till layer, as hydraulic head differences remain below 0.5 m. If a till layer is present, imposing a no-flow boundary beneath the river produces higher simulated heads (up to ∼3 m) yielding conservative factors of safety at the cut banks for meandering and straight slopes. However, in most cases, when a till layer is present, groundwater flow beneath the river necessitates modelling both valley sides to avoid unrealistic flow paths. In such cases, 2D models that include both sides of the valley remain suitable for straight slopes with underlying till, as well as at the point bar in meandering slopes, regardless of till presence. In all other configurations, 2D models produce lower hydraulic heads and factors of safety by up to 10% relative to 3D simulations.

  • Modelling the impact of deep fractures on groundwater flow and slope stability in post-glacial marine clays (Quebec, Canada)

    by Julián Ospina, Nathan Lee Young, Jean-Michel Lemieux, John Molson, Ariane Locat, Pascal Locat

    It is usually assumed that post-glacial marine clay deposits, such as those found in Quebec, are generally intact below a shallow fractured crust (3–5 m depth). However, recent work has shown the presence of hydraulically-active fractures to depths of down to 16 m. In light of this finding, the potential impacts of these fractures on groundwater flow dynamics and slope stability are explored by comparing field data with the results of transient and steady-state groundwater models with and without fractures. Two slope geometries that exhibit contrasting groundwater flow directions and different fracture scenarios were considered. The results of the hydrogeological modelling were then imported into a slope stability model to determine how the hydraulic effects of these fractures impact slope stability. Results show that fractures increase hydraulic head when they act as preferential pathways for infiltration, but can also reduce hydraulic head by acting as pathways for water to more quickly exit the formation within the slope face. Therefore, from a hydrogeological perspective, fractures could improve or reduce slope stability depending on the groundwater flow system. As this study only addressed the hydrogeological impact of the fractures, future work should focus on the coupled hydromechanical impacts of these features.


  • Open Access

    Deep Hydraulically‐Active Fractures in Sensitive Clay Deposits: Implications for Groundwater Flow and Slope Stability

    by Nathan L. Young, Julian Andres Ospina, Jean‐Michel Lemieux, Pascal Locat

    Landslides in sensitive post‐glacial marine clays are one of the major geological hazards in Canada, Norway and Sweden. Current hydrogeological conceptual models used for slope stability analyses in these deposits consider simple groundwater flow conditions within a homogenous, isotropic, massive clay deposits, where fractures are surficial features that only exist within a 1–5 m‐thick weathered zone. This study uses cross‐correlation analysis on hydraulic head data from a large network of vibrating‐wire piezometers in clay deposits along the St. Lawrence River and in the Saguenay‐Lac St‐Jean Lowlands, in Quebec, Canada, to show that hydraulically‐active fractures are present to depths of up to 16 m at 4 (possibly 6) of the 7 locations studied. These findings suggest that current conceptual models have a high likelihood of misrepresenting local flow systems, and that further field and modeling work is needed to characterize the extent and influence of these fracture networks.


  • Long‐Term, High‐Resolution Permafrost Monitoring Reveals Coupled Energy Balance and Hydrogeologic Controls on Talik Dynamics Near Umiujaq (Nunavik, Québec, Canada)

    by Philippe Fortier, Nathan L. Young, Jean‐Michel Lemieux, Michelle A. Walvoord, Richard Fortier

    Rising temperatures in the Arctic and subarctic are driving the rapid thaw of permafrost by reducing permafrost cooling, increasing active layer thickness, and promoting talik formation. In this study, the cyrohydrogeology of a permafrost mound located within the discontinuous permafrost zone near Umiujaq (Nunavik, Québec, Canada) is characterized through the analysis of a dataset covering more than two decades of monitoring. This dataset captures a high degree of interannual variability in air temperature and ground thermal conditions, as well as the dynamics of a supra‐permafrost talik. Data indicate that variable saturation and advective heat transport directly contribute to the expansion and contraction of the talik. Data further indicate the presence of two distinct thermo‐hydrologic settings resulting from differences in surface conditions, as well as subsurface thermal and flow regimes. The first, found at the top of the mound feature, is characterized by very low moisture contents (3/m3), while the second, found at the side of the mound feature, shows higher annual moisture contents that strongly influence the dynamics of heat and groundwater flow. The data were synthesized into a detailed conceptual model of the cyrohydrogeological dynamics that highlights the important role of hydrogeological characterization and long‐term data sets in understanding the effects of groundwater flow on seasonal frost and permafrost dynamics. Specifically, the results presented here show that in the absence of long‐term data sets, longer‐period transient phenomena such as talik expansion and contraction may be misrepresented as uni‐directional feedback loops, as opposed to highly dynamic temporary phenomena.


  • Pumping Optimization Under Uncertainty in an Island Freshwater Lens Using a Sharp‐Interface Seawater Intrusion Model

    by Cécile Coulon, Jean‐Michel Lemieux, Alexandre Pryet, Peter Bayer, Nathan L. Young, John Molson

    Pumping optimization under uncertainty is a powerful approach for the management of groundwater resources, and its implementation would be valuable in island aquifers where freshwater lenses are affected by seawater intrusion. Sharp‐interface numerical models are especially well suited for the task as they offer fast simulation times, but to date they have not been used because of a lack of guidelines and due to the specific challenges associated with this approach. This study presents a methodology for pumping optimization under uncertainty for island freshwater lenses using a sharp‐interface model (MODFLOW‐SWI2) and demonstrates it for a real case (Magdalen Islands, Quebec, Canada). The total pumping in a well field was maximized while avoiding well salinization due to upconing. To do so, the sharp interface simulated below the pumping wells was corrected successively for cell‐to‐well upconing and for dispersion. Pumping optimization under uncertainty was then conducted using PESTPP‐OPT, considering parameter and observation uncertainty, and was repeated for 23 reliability levels to illustrate a large range of risk‐averse, tolerant and neutral stances. The maximum pumping was obtained as a function of risk of well salinization. This approach enabled quantification of the tradeoffs between pumping and risk, allocation of pumping amongst wells, and an examination of the ability of the well field to meet the water demand while maintaining an acceptable level of risk. Ultimately, this framework allows groundwater managers to select the final pumping scenario themselves, depending on their attitude toward risk.


  • Field performance of four vibrating-wire piezometer installation methods

    by Nathan Young, Jean-Michel Lemieux, Laura Mony, Alexandra Germain, Pascal Locat, Denis Demers, Ariane Locat, Jacques Locat

    Vibrating-wire piezometers provide a number of advantages over the traditional hydraulic piezometer design. There are currently many methods and configurations for installing vibrating-wire piezometers, the most common being: single piezometers in sand packs (SP), multilevel piezometers in sand packs (MLSP), and fully grouted multilevel piezometers using either bentonite (FGB) or cement−bentonite grout (FGCB). This study assesses the performance of these four different installation methods at a field site possessing complex stratigraphy, including glacial and marine sediments. To accomplish this objective, pore pressure data recorded between December 2017 and July 2019 were analyzed. Data indicate that SP, MLSP, and FGB piezometers performed most reliably, because piezometers installed at the same depth with these methods recorded similar pressure variations that were coherent with the hydrogeological setting. Of the two fully grouted installations using cement−bentonite grout, one installation failed completely due to a hydraulic short circuit, likely caused by preferential flow occurring along the wires of the embedded instruments. The lack of a standard method for mixing cement−bentonite grout at the time of construction likely contributed to the failure of the FGCB installations, as the grout mixture used in this study was likely too viscous to provide a suitable seal.


  • Bias in hydraulic head measurements from multilevel vibrating-wire piezometers with excessively permeable backfill

    by Nathan L. Young, Jean-Michel Lemieux, Pascal Locat, Denis Demers, Hugo Delottier, Laura Mony


  • Hydrogeology of a complex Champlain Sea deposit (Quebec, Canada): implications for slope stability

    by Alexandra Germain, Nathan Lee Young, Jean-Michel Lemieux, Ariane Locat, Hugo Delottier, Philippe Fortier, Serge Leroueil, Pascal Locat, Denis Demers, Jacques Locat, et al.

    The thick sequences of marine clayey deposits that blanket the St. Lawrence Lowlands in south-eastern Canada are highly susceptible to landslides. With 89% of the population of the province of Quebec living in this region, improving our understanding of the mechanisms causing landslides in these sediments is a matter of public security. To accomplish this goal, instruments were deployed at a field site in Sainte-Anne-de-la-Pérade, Quebec, Canada to monitor atmospheric, soil, and groundwater conditions. Field and laboratory measurements of soil geotechnical and hydraulic properties were also performed. Results indicate that the groundwater and pore pressure dynamics at the site cannot be explained using simplified site conceptual models. Further analysis indicates that groundwater dynamics and pore pressures in the massive clay deposits on site are determined by (i) the highly heterogeneous nature of the local geological materials, (ii) the contrasting hydraulic and geotechnical properties of these materials, (iii) the presence of two unconfined aquifers at the site, one surficial and one at depth, and (iv) the presence of the Sainte-Anne River. These results were used to create a new conceptual model that illustrates the complex groundwater flow system present on site and shows the importance of including hydrogeologic context in slope stability analysis.


  • Open Access

    A Conceptual Model for Anticipating the Impact of Landscape Evolution on Groundwater Recharge in Degrading Permafrost Environments

    by N. L. Young, J.‐M. Lemieux, H. Delottier, R. Fortier, P. Fortier

    Temperatures in the arctic and subarctic are rising at more than twice the rate of the global average, driving the accelerated thawing of permafrost across the region. The impacts of permafrost degradation have been studied in the discontinuous permafrost zone at Umiujaq, in northern Quebec, Canada, for over 30 years, but the effects of changing land cover on groundwater recharge are not well understood. The water table fluctuation method was used to compute groundwater recharge using 4 years of water level data and soil moisture readings from five field sites characteristic of different stages of permafrost degradation and vegetation invasion. Results indicate that as vegetation grows taller, groundwater recharge increases, likely due to increased snow thickness. Results were then combined with a preexisting conceptual model that describes the evolution from tundra to shrubland and forests to create a new model for describing how groundwater recharge is affected by landscape evolution.