Yan Jiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yan Jiao has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Ping Mao
National & Local Joint Engineering Research Center for Mineral Salt Deep Utilization, Key Laboratory for Palygorskite Science and Applied Technology of Jiangsu Province, School of Chemical Engineering, Huaiyin Institute of Technology, Huaian 223003, China
2 shared publications - Aotian Gu
Jiangsu Key Laboratory of Chemical Pollution Control and Resources Reuse, School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
1 shared publication - Cheng-Yan Huang
Jiangsu Key Laboratory of Intelligent Atmospheric Environment Monitoring and Carbon–Pollution Co‐Control Jiangsu Collaborative Innovation Center of Atmospheric Environment and Equipment Technology School of Environmental Science and Engineering Nanjing University of Information Science & Technology Nanjing Jiangsu P. R. China
1 shared publication - Chunhui Gong
Key Laboratory of Nuclear and Radiation Environment Monitoring and Control for Ecological Environment Protection in Jiangsu Province, School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
1 shared publication - Danxia Zhao
Institute of Environmental Engineering Technology, School of Life Sciences, Taizhou University, Taizhou 318000, Zhejiang, P.R. China
1 shared publication Ji-Li Ni
Jiangsu Key Laboratory of Chemical Pollution Control and Resources Reuse, School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing, 210094, China
1 shared publication
Latest Publications
- 11 September 2023
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 328, 124332
Peroxymonosulfate activation by ZIF-67-Derived bimetallic sulfide/carbon composite (CoFeS-NC) for efficient degradation of the emerging contaminant ceftiofur sodium
- 11 September 2023
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 328, 124332
Peroxymonosulfate activation by ZIF-67-Derived bimetallic sulfide/carbon composite (CoFeS-NC) for efficient degradation of the emerging contaminant ceftiofur sodium
- Open Access
- 1 January 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-8
Visible Light Excited Catalysis and Reusability Performances of TiO2@Pr:Y2SiO5 Upconversion Materials
To get high efficiency photodegradation on pollutants under visible light, Pr(III) doped Y2SiO5 upconversion materials and anatase TiO2 nanofilm coated Pr:Y2SiO5 composite have been prepared by using a sol-gel method. XRD and SEM test results indicated that TiO2 nanofilm was well coated on Pr:Y2SiO5 to form TiO2@Pr:Y2SiO5 composite particles with the sizes of 0.5–1.0 μm. To avoid secondary pollution resulting from incomplete recovery of catalyst particles, TiO2@Pr:Y2SiO5 was loaded on the glass fiber filters by using a dip-coating method. It is found that the catalyst particles were embedded into the carrier firmly, even after having been reused for 6 times. The luminescence intensities of TiO2@Pr:Y2SiO5 were getting down sharply with the coating contents of TiO2 increased, which was attributed to the adsorption of the luminescence by the TiO2 film in situ. As a result, TiO2@Pr:Y2SiO5 with 4% TiO2, which presented lowest luminescence intensity, showed the highest efficiency on the photodegradation of nitrobenzene wastewater. The catalysts loaded on glass fiber filters showed excellent reusability on the photodegradation of nitrobenzene and presented a photodegradation rate of 95% at the first time and up to 75.9% even after 6 times of reusing by the treatment time of 12 h.
- 1 January 2017
- Published by Wiley in Journal of Nanomaterials
- Vol. 2017, 1-8
Open AccessVisible Light Excited Catalysis and Reusability Performances of TiO2@Pr:Y2SiO5 Upconversion Materials
To get high efficiency photodegradation on pollutants under visible light, Pr(III) doped Y2SiO5 upconversion materials and anatase TiO2 nanofilm coated Pr:Y2SiO5 composite have been prepared by using a sol-gel method. XRD and SEM test results indicated that TiO2 nanofilm was well coated on Pr:Y2SiO5 to form TiO2@Pr:Y2SiO5 composite particles with the sizes of 0.5–1.0 μm. To avoid secondary pollution resulting from incomplete recovery of catalyst particles, TiO2@Pr:Y2SiO5 was loaded on the glass fiber filters by using a dip-coating method. It is found that the catalyst particles were embedded into the carrier firmly, even after having been reused for 6 times. The luminescence intensities of TiO2@Pr:Y2SiO5 were getting down sharply with the coating contents of TiO2 increased, which was attributed to the adsorption of the luminescence by the TiO2 film in situ. As a result, TiO2@Pr:Y2SiO5 with 4% TiO2, which presented lowest luminescence intensity, showed the highest efficiency on the photodegradation of nitrobenzene wastewater. The catalysts loaded on glass fiber filters showed excellent reusability on the photodegradation of nitrobenzene and presented a photodegradation rate of 95% at the first time and up to 75.9% even after 6 times of reusing by the treatment time of 12 h.
- 18 March 2016
- Published by Walter de Gruyter GmbH in Zeitschrift für Naturforschung B
- Vol. 71 (4) , 311-315
Synthesis and structure of a cobalt coordination polymer based on 2,8-di(pyridin-4-yl)dibenzothiophene and 4,4-dicarboxydiphenylsulfone
- 18 March 2016
- Published by Walter de Gruyter GmbH in Zeitschrift für Naturforschung B
- Vol. 71 (4) , 311-315
Synthesis and structure of a cobalt coordination polymer based on 2,8-di(pyridin-4-yl)dibenzothiophene and 4,4-dicarboxydiphenylsulfone